A Alkaline Hydrolysis

Alkaline Hydrolysis. -The low kinetic isotope effect observed in the protonation of carbanions formed in phosphonium salt hydrolysis leads to the idea that there is little breaking of the phosphorus-carbon bond and correspondingly little transfer of a proton to the incipient carbanion in the transition state (87) of the rate-determining step.  

It has been shown that alkaline hydrolysis of both isomers of (91) gives the same ring-expanded oxide (92) of unknown geometry, presumably because rapid pseudorotation leads to equilibration of the intermediates. Alkaline hydrolysis of the dialkoxyphosphetanium salts (93) proceeds with almost complete lack of stereospecificity. In this case the authors 

Similar steric arguments are used to explain the ratios of oxides formed when the benzylphosphonium salts (95) are treated with aqueous alkali.  

The basic hydrolysis of A - and A -phospholenium bromides gives mixtures of (96) and (97), the ratio depending upon the conditions used. Ylide (98) formation can compete with phosphorane generation, particularly in media where anions are stabilized by solvation. Under these 

Treatment of the A -phospholenium salt (99) with aqueous alkali gave predominantly benzene and the oxide (100). It is suggested that here ring constraint leads to poor overlap of the 7r-bond in the ring with the p-orbital of the incipient carbanion which would lead to ring opening. Pseudorotation of the initial adduct followed by loss of the phenyl from the apical position becomes competitive.  

---

Williams, A., Alkaline hydrolysis of substituted phenylcarbamates - Structure-reactivity relationships consistent with an E1B mechanism , J. Chem. Soc. Perkins, II, 808-812 (1972). 

A. Alkaline Hydrolysis VI 1,2-Diol Mono alkyl- and Momoaiyl ... 

Fig. 10 Relationship of percentage of dimer [62] to MEP in hydrolysis of M EP in 0.33 M NaOD. The equation for the curve is not given. The stated error in each point is 1.5% (e.g. (11.2 1.5) % dimer). [Reprinted with permission from Tetrahedron 43, Gorenstein et a/., Alkaline hydrolysis of methyl and ethyl ethylene phosphates . Copyright 1987, Pergamon Journals Ltd.]...

Scheme 6.8(a) Alkaline hydrolysis of poly(lactic acid) [32]. 

Cuenca, A. Alkaline hydrolysis of 2-phenoxyquinoxaline in reactive counterion micelles effects of head group size. Int. J. Chem. Kinet. 1998, 50(11), 777-783. 

Hammen equation A correlation between the structure and reactivity in the side chain derivatives of aromatic compounds. Its derivation follows from many comparisons between rate constants for various reactions and the equilibrium constants for other reactions, or other functions of molecules which can be measured (e g. the i.r. carbonyl group stretching frequency). For example the dissociation constants of a series of para substituted (O2N —, MeO —, Cl —, etc.) benzoic acids correlate with the rate constant k for the alkaline hydrolysis of para substituted benzyl chlorides. If log Kq is plotted against log k, the data fall on a straight line. Similar results are obtained for meta substituted derivatives but not for orthosubstituted derivatives. 

Amides (except urea and thiourea), imides and nitriles, after the above alkaline hydrolysis, give derivatives similarly to those from the alkaline solution obtained from ammonium salts (p. 360). (A) If the original compound is aromatic, acidification of the cold solution deposits the crystalline acid. (B) The cold solution, when carefully neutralised (p. 332) and treated with benzylthiuronium chloride, deposits the thiuromum salt. 

If the amide is an N-(mono- or di)-substituted amide, or the imide an N-substituted imide, the above alkaline hydrolysis will give a solution... 

It is frequently advisable in the routine examination of an ester, and before any derivatives are considered, to determine the saponification equivalent of the ester. In order to ensure that complete hydrolysis takes place in a comparatively short time, the quantitative saponi fication is conducted with a standardised alcoholic solution of caustic alkali—preferably potassium hydroxide since the potassium salts of organic acids are usuaUy more soluble than the sodium salts. A knowledge of the b.p. and the saponification equivalent of the unknown ester would provide the basis for a fairly accurate approximation of the size of the ester molecule. It must, however, be borne in mind that certain structures may effect the values of the equivalent thus aliphatic halo genated esters may consume alkali because of hydrolysis of part of the halogen during the determination, nitro esters may be reduced by the alkaline hydrolysis medium, etc. 

Method 2 (Alkaline hydrolysis). Use a solution of 15 g. of p-bromo-acetanihde in 30 ml. of boiling ethyl alcohol, and add a solution of 7 5 g. of potassium hydroxide in 10 ml. of water. Reflux for 40 minutes, dilute with 120 ml. of water, and distil vmtil 75 ml. of distillate (alcohol and water) are collected pour the residue into 150 ml, of cold water. 

Acetylene is also protected as propargyl alcohol (300)[2H], which is depro-tected by hydrolysis with a base, or oxidation with MnOi and alkaline hydrolysis. Sometimes, propargyl alcohols are isomerized to enals. Propargyl alcohol (300) reacts with 3-chloropyridazine (301) and EtiNH to give 3-diethylami-noindolizine (303) in one step via the enal 302[2I2]. Similarly, propargyl alcohol reacts with 2-halopyridines and secondary amines. 2-Methyl-3-butyn-2-ol (304) is another masked acetylene, and is unmasked by treatment with KOH or NaOH in butanol[205,206,213-2l5] or in situ with a phase-transfer cata-lyst[2l6]. 

Poly(acrylic acid) and Poly(methacrylic acid). Poly(acryHc acid) (8) (PAA) may be prepared by polymerization of the monomer with conventional free-radical initiators using the monomer either undiluted (36) (with cross-linker for superadsorber appHcations) or in aqueous solution. Photochemical polymerization (sensitized by benzoin) of methyl acrylate in ethanol solution at —78° C provides a syndiotactic form (37) that can be hydrolyzed to syndiotactic PAA. From academic studies, alkaline hydrolysis of the methyl ester requires a lower time than acid hydrolysis of the polymeric ester, and can lead to oxidative degradation of the polymer (38). Po1y(meth acrylic acid) (PMAA) (9) is prepared only by the direct polymerization of the acid monomer it is not readily obtained by the hydrolysis of methyl methacrylate. 

Anionic and nonionic polyacrylamides effectively remove suspended soHds such as silt and clay from potable water. SuppHers provide special grades which meet EPA/FDA regulations for residual acrylamides. A recent pubHcation (102) states that hydrolyzed polyacrylamides with narrow interchain charge distributions provide better performance in flocculation of clay. These polymers were prepared by alkaline hydrolysis. (See Flocculating agents.)... 

Under conditions of extreme acidity or alkalinity, acryhc ester polymers can be made to hydroly2e to poly(acryhc acid) or an acid salt and the corresponding alcohol. However, acryhc polymers and copolymers have a greater resistance to both acidic and alkaline hydrolysis than competitive poly(vinyl acetate) and vinyl acetate copolymers. Even poly(methyl acrylate), the most readily hydroly2ed polymer of the series, is more resistant to alkah than poly(vinyl acetate) (57). Butyl acrylate copolymers are more hydrolytically stable than ethyl acrylate copolymers (58). 

Displacement reactions with oxygen nucleophiles are of potential commercial interest. Alkaline hydrolysis provides 2-fluoro-6-hydroxypyridine [55758-32-2], a precursor to 6-fluoropyridyl phosphoms ester insecticides (410—412). Other oxygen nucleophiles such as bisphenol A and hydroquinone have been used to form aryl—pyridine copolymers (413). 

The presence of water in the carbonylation mixture makes it possible to halt the reaction after the second group migration (step 2). Oxidation of the intermediate boraglycol yields the corresponding ketone, and alkaline hydrolysis affords the secondary alcohol, R HOH. A blocking group of low... 

Many other polymerization processes have been patented, but only some of them appear to be developed or under development ia 1996. One large-scale process uses an acid montmorrillonite clay and acetic anhydride (209) another process uses strong perfiuorosulfonic acid reski catalysts (170,210). The polymerization product ia these processes is a poly(tetramethylene ether) with acetate end groups, which have to be removed by alkaline hydrolysis (211) or hydrogenolysis (212). If necessary, the product is then neutralized, eg, with phosphoric acid (213), and the salts removed by filtration. Instead of montmorrillonite clay, other acidic catalysts can be used, such as EuUer s earth or zeoHtes (214—216). 

There are four processes for industrial production of ahyl alcohol. One is alkaline hydrolysis of ahyl chloride (1). In this process, the amount of ahyl chloride, 20 wt % aqueous NaOH solution, water, and steam are controhed as they are added to the reactor and the hydrolysis is carried out at 150 °C, 1.4 MPa (203 psi) and pH 10—12. Under these conditions, conversion of ahyl chloride is 97—98%, and ahyl alcohol is selectively produced in 92—93% yield. The main by-products are diahyl ether and a small amount of high boiling point substance. The alkaU concentration and pH value are important factors. At high alkah concentrations, the amount of by-product, diahyl ether, increases and at low concentrations, conversion of ahyl chloride does not increase. 

A/-(4-Hydroxyphenyl)glycine can be prepared from 4-aminophenol and chloracetic acid (199,200) or by alkaline hydrolysis of the corresponding nitrile with subsequent elimination of ammonia (201). 

Sulfaguanidine is prepared by condensation of Ai-acetylsulfanilyl chloride with guanidine ia presence of alkali. The A/ -acetyl group is removed by acid or alkaline hydrolysis. 

Steric and inductive effects determine the rate of formation of the pentacovalent siUcon reaction complex. In alkaline hydrolysis, replacement of a hydrogen by alkyl groups, which have lower electronegativity and greater steric requirements, leads to slower hydrolysis rates. Replacement of alkyl groups with bulkier alkyl substituents has the same effect. Reaction rates decrease according to ... 

Carboxyhc acid ester, carbamate, organophosphate, and urea hydrolysis are important acid/base-catalyzed reactions. Typically, pesticides that are susceptible to chemical hydrolysis are also susceptible to biological hydrolysis the products of chemical vs biological hydrolysis are generally identical (see eqs. 8, 11, 13, and 14). Consequentiy, the two types of reactions can only be distinguished based on sterile controls or kinetic studies. As a general rule, carboxyhc acid esters, carbamates, and organophosphates are more susceptible to alkaline hydrolysis (24), whereas sulfonylureas are more susceptible to acid hydrolysis (25). 

At room temperature, ca 60 wt % ethylene oxide is needed to solubilize the fatty acids. Surface activity of the ethoxylates is moderate and less than that of alcohol or alkylphenol ethoxylates (84). The ethoxylates are low foamers, a useful property in certain appHcations. Emulsification is the most important function. Its importance is reflected in the wide range of lipophilic solubiHties available in the commercial products. Like all organic esters, fatty acid ethoxylates are susceptible to acid and alkaline hydrolysis. 

---