Transesterification intermediates

Uses Hardening agent for foran resin catalyst for esterification, transesterification intermediate for dye chemistry when neutralized, it becomes hydrotrope in the detergent industry... 

RandomiZation/Interesterification. Transesterification occurs when a carboxyUc acid (acidolysis) or alcohol (alcoholysis) reacts with an ester to produce a different ester (20). Ester—ester interchange is also a form of transesterification. If completely unsaturated triglyceride oil (UUU) reacts with a totally saturated fat (SSS) in the presence of an active catalyst such as sodium, potassium, or sodium alkoxide, triglycerides of intermediate composition may be formed. 

Linalool can be converted to geranyl acetone (63) by the CarroU reaction (34). By transesterification with ethyl acetoacetate, the intermediate ester thermally rearranges with loss of carbon dioxide. Linalool can also be converted to geranyl acetone by reaction with methyl isopropenyl ether. The linalyl isopropenyl ether rearranges to give the geranyl acetone. 

Structurally the difference between PEN and PET is in the double (naphthenic) ring of the former compared to the single (benzene) ring of the latter. This leads to a stiffer chain so that both and are higher for PEN than for PET (Tg is 124°C for PEN, 75°C for PET is 270-273°C for PEN and 256-265°C for PET). Although PEN crystallises at a slower rate than PET, crystallization is (as with PET) enhanced by biaxial orientation and the barrier properties are much superior to PET with up to a fivefold enhancement in some cases. (As with many crystalline polymers the maximum rate of crystallisation occurs at temperatures about midway between Tg and in the case of both PEN and PET). At the present time PEN is significantly more expensive than PET partly due to the economies of scale and partly due to the fact that the transesterification route used with PEN is inherently more expensive than the direct acid routes now used with PET. This has led to the availability of copolymers and of blends which have intermediate properties. 

For the dihydroxylation of the achiral enyne 11, Corey and co-workers have used the AD-mix-a, and without isolation of the intermediate diol 12, obtained the hydroxylactone 13 which is formed through an intramolecular transesterification ... 

To a —78 C solution of 23.1 mL (100 mmol) of triisopropyl borate and 8.15 mL (110 mmol) of 3-chloro-l-propene in 100 inL of dry THF is added dropwisc via a cannula over 0.5 h a solution of LDA (110 mmol prepared in 200 mL of THF from 110 mmol of diisopropylamine and 47.9 mL of 2.3 M butyllithium in hexane), This mixture is stirred for an additional 0.5 h at — 78 "C then a solution of 75.9 ntL of 2.9 M anhyd hydrogen chloride in diethyl ether is added and the mixture is allowed to warm to 25 °C. The mixture is concentrated in vacuo (20 Torr) and the residue extracted with three 100-mL portions of pentane, Filtration under nitrogen followed by distillation under reduced pressure provides 18.0 g (88%) of diisopropyl l-chloro-2-propenylboronate bp 95-96 "C/25 Torr. Transesterification of this intermediate with 1.3-propanediol provides the title compound in almost quantitative yield bp 110-112°C/20Torr. 

The C10-C,8 fatty acids and fatty acid methyl esters, important intermediates for the production of surfactants, are almost exclusively produced by hydrolysis or a transesterification reaction of animal or vegetable fats and fatty oils. 

Transesterification of fat triglycerides is the predominant method for manufacture of mixed fatty acid methyl esters, and direct esterification of fatty acids (FA) is practiced if very selective cuts of product, in general as an intermediate detergent range alcohol, are desired. Methyl cocoate is a mobile, oily liquid above 25 °C with a yellow tint and a characteristic fatty pungent odor. FAME sulfonation to FAMES is technically possible but been rarely applied up to now (1990) (Table 13). 

For the delicate transesterification of a p-Lactam intermediate (for carbacephalosphorin skeleton), where originally hydrolysis of methyl ester was done homogeneously and then formation of the benzyl (or substituted benzyl) ester was done separately, Doecke et al. (1991) have devised a mild and efficient methodology using PTC. A dual use of a PT catalyst, Bu4NBr, in one pot was made in a CH2CI2 - H2O system. In the first step 5N NaOH was used, then the pH was adjusted to 7.2 to 7.8 and subsequently benzyl (or substituted benzyl) bromide was added. 

Hynninen and coworkers <99JCS(PT1)2403> used a similar approach to prepare phytochlorin-C6o diad 38 (Scheme 11). The protocol employed the pyrolysis of the natural chlorophyll a molecule 35, followed by transesterification and demetallation to furnish derivative 36. Subsequent oxidation of 36 with OsCU and NaI04 has allowed the synthesis of the formyl derivative 37, which was further used as precursor of the azomethinic ylide intermediate in the 1,3-DC reaction with Cm leading to the formation of diad 38. Photochemical studies revealed that this diad underwent a fast intramolecular photoinduced electron transfer in polar solvents such a benzonitrile <99JACS9378>. 

These transesterifications are believed to proceed through the initial formation of a highly reactive a-oxo ketene intermediate, with the elimination of the alcohol component of the acetoacetic ester being the limiting factor. Subsequent trapping of the... 

The Suzuki coupling of soluble polyethylene glycol (PEG)-bound bromothiophene 71 and p-formylphenylboronic acid provided biaryl 72 [56]. Due to the high solubilizing power of PEG, the reaction was conducted as a liquid-phase synthesis. Treatment of 72 with o-pyridinediaminc resulted in a two-step-one-pot heterocyclization through an imine intermediate. Nitrobenzene served as an oxidant in the ring closure step. Finally, transesterification with NaOMe in MeOH resulted in l//-imidazole[4,5-e]pyridine 73. 

Since FAS can be produced either from vegetable oil based or petrochemical-based fatty alcohol (Fig. 4.9), both types have been evaluated in a life-cycle analysis with a positive overall result for the natural based product. With vegetable-based fatty alcohol sulfate, the analysis starts with the harvesting of the oil fruits (palm kernels or coconuts) and their processing to isolate the desired plant oil. Subsequent transesterification and hydrogenation of the methyl ester intermediates lead to the fatty alcohols, which are finally sulfated to produce the desired product. Based on this analysis the environmental impact of vegetable oil based fatty alcohol sulfate compared with the petrochemical based product is as follows ... 

Thus, the best compromises for Boc and Fmoc chemistries seem to be cyclohexyl and 2,4-dimethylpent-3-yl (Dmpn), which is of intermediate stability, and the removal of which by trifluoromethanesulfonic acid with the aid of thioanisole (see Section 6.22) leads to minimal imide formation (see Section 6.13). Points to note are that acidolysis of esters by hydrogen fluoride can lead to fission at the oxy-car-bonyl bond instead of the alkyl-oxy bond, thus generating acylium ions that can react with nucleophiles (see Sections 6.16 and 6.22), and that benzyl esters may undergo transesterification if left in methanol. The side reactions of cyclization (see Section 6.16) and acylation of anisole (see Section 6.22) caused by acylium ion formation do not occur at the side chain of aspartic acid.47-51... 

Smith et al. [64] prepared a series of PET/PTT copolyesters, and found that addition of the other component suppressed the melting point of the respective homopolymer. Between 37 and 60 % PTT content, the copolymers became amorphous and did not show any melting endotherms in the differential thermal analyzer scans. A similar behavior was observed by Balakrishnan and coworkers [102] in PET/PTT copolyesters prepared by the transesterification of PET with PDO, and by the copolymerization of EG and PDO with DMT [103, 104], The non-crystallizing behavior of copolymers with intermediate contents of the respective component is similar to that of a eutectic mixture, indicating formation of random copolyesters. The 7 g and solubility temperature of the copolyesters were, however, continuous and went through minima with increasing PTT content [64],... 

The boronic acid ester B was synthesized by transesterification of the corresponding pinacolester A with (lR,2R)-l,2-dicyclohexyl-l,2-dihydroxyethane. Stereoselective chlorination of B was carried out with (dichloromethyl) lithium and zinc chloride. Reaction of the obtained chloroboronic ester C with lithio 1-decyne followed by oxidation of the intermediate D with alkaline hydrogen peroxide afforded the propargylic alcohol E. Treatment with acid to saponify the tert-butyl ester moiety and to achieve ring closure, produced lactone F. Finally, Lindlar-hydrogenation provided japonilure 70 in an excellent yield and high enantiomeric purity. 

Thus, their activities are necessary for the continuos replication transcription and DNA repair. Topi catalyzes a reaction of transesterification, which produces an intermediate form called "cleavable complex", in which a tyrosine enzyme is attached to the 3 single-strand DNA. After the passage of the new synthesized strand, the topi recloses the cutting. TopII works the same way, but catalyzes the opening and closing of DNA strands [7],... 

Chiral sulfinates are important intermediates that are widely applied in the synthesis of other classes of chiral organosulfur compounds and in their configurational correlations. Optically active sulfinates were first prepared in 1925 by Phillips (100) in two ways. The first consisted in the transesterification of racemic alkyl p-toluenesulfin-ates with chiral alcohols such as (-)-menthol and (-)-2-octanol yielding a mixture of two optically active sulfinates as shown in eq. [26]. The... 

Histidine residues are efficient nucleophiles in aqueous solution at pH 7, much more so than lysines, and this is the basis for the site-selective functionalization of lysine residues in folded polypeptides and proteins [24, 25]. p-Nitrophenyl esters react with His residues in a two-step reaction to form an acyl intermediate under the release of p-nitrophenol followed by the reaction of the intermediate with the most potent nucleophile in solution to form the reaction product. In aqueous solution the reaction product is the carboxylic acid since the hydroxide ion is the most efficient nucleophile at pH 7. If there is an alcohol present the reaction product will be an ester and the overall reaction is a transesterification reaction. 

As shown in previous sections, NHCs promote acyl transfer in transesterification reactions. In a similar manner, O C acyl transfer can be achieved with substrates such as 351 in the presence of 0.9 mol% of triazolium pre-catalyst 353 and KHMDS (Scheme 53). Moderate yields are obtained by varying substitution of the oxazole from R = Me, Ph, t-Bu, and t-Pr [171], Deprotonation of the triazolium salt followed by nucleophilic addition to the carbonate moiety of the oxazole results in enolate intermediate LXXXIII and activated carboxylate LXXXIV. Enolate addition and regeneration of the active catalyst provides quaternary stereocenters 352. 

Figure 4. Transesterification reaction mechanism of group II introns. Nucleophilic attack leads to the pentavalent phosphorus intermediate which subsequently decomposes to yield the cleavage products.

Peterson and Scarrah 165) reported the transesterification of rapeseed oil by methanol in the presence of alkaline earth metal oxides and alkali metal carbonates at 333-336 K. They found that although MgO was not active for the transesterification reaction, CaO showed activity, which was enhanced by the addition of MgO. In contrast, Leclercq et al. 166) showed that the methanolysis of rapeseed oil could be carried out with MgO, although its activity depends strongly on the pretreatment temperature of this oxide. Thus, with MgO pre-treated at 823 K and a methanol to oil molar ratio of 75 at methanol reflux, a conversion of 37% with 97% selectivity to methyl esters was achieved after 1 h in a batch reactor. The authors 166) showed that the order of activity was Ba(OH)2 > MgO > NaCsX zeolite >MgAl mixed oxide. With the most active catalyst (Ba(OH)2), 81% oil conversion, with 97% selectivity to methyl esters after 1 h in a batch reactor was achieved. Gryglewicz 167) also showed that the transesterification of rapeseed oil with methanol could be catalyzed effectively by basic alkaline earth metal compounds such as calcium oxide, calcium methoxide, and barium hydroxide. Barium hydroxide was the most active catalyst, giving conversions of 75% after 30 min in a batch reactor. Calcium methoxide showed an intermediate activity, and CaO was the least active catalyst nevertheless, 95% conversion could be achieved after 2.5 h in a batch reactor. MgO and Ca(OH)2 showed no catalytic activity for rapeseed oil methanolysis. However, the transesterification reaction rate could be enhanced by the use of ultrasound as well as by introduction of an appropriate co-solvent such as THF to increase methanol solubility in the phase containing the rapeseed oil. 

Scheme 10.2 Homogeneous acid-catalyzed reaction mechanism for the transesterification of triglycerides (1) protonation of the carbonyl group by the acid catalyst (2) nucleophilic attack of the alcohol, forming a tetrahedral intermediate (3) proton migration and breakdown of the intermediate. The sequence is repeated twice.

Figure 6.10 Active sites of lipase (1), triflinctional (thio)urea derivatives (38 39) mimicking the acive site of serine hydrolases (2), and acetyl-catalyst intermediate of the biomimetic transesterification between vinyl trifluoroacetate methanol and 2-propanol, respectively (3).

A pentopyranoside-fused butenolide is the key intermediate for the synthesis of the natural micotoxin patulin [226, 227]. Its synthesis involves Wittig olefination of a 3,4-di-O-protected arabinopyran-2-uloside, followed by protecting group removal and dehydration (Scheme 47). In other research, the glucopyranosid-2-uloside 190 was converted into the butenolide derivative 191 by aldol condensation with diethyl malonate and transesterification [228]. The latter was shown to be prone to autoxi-dation, leading to 192. Subsequent Michael addition with hydroxide ion, followed by decarboxylation, furnishes C-branched-chain sugar 193. 

---