Timing Attributes

The default test protocol inferred by TC has four phases Scan Shift, Parallel Measure, Parallel Capture, and Scan-Out Strobe. Each test pattern has all these phases. The length of the scan shift phase is equal to the length of the longest scan chain in the design. The remaining three phases are of one cycle with the test clock being pulsed in only during scan shift and the parallel capture cycle. Shown below are the values of the bi-directionals in the different phases  

If there is an ASIC vendor restriction that test default bidir delay occur before the active clock edge, you have the following options  

Use a strobe before the clock protocol. This protocol is automatically inferred by TC when the test default.strobe is set before the active clock edge. In this protocol file the parallel measure and the parallel capture cycles are combined into one. 

Use the TC variable, test no three state conflicts after capture to hold the values of the bi-directional ports in the parallel capture cycle from the parallel measure cycle. 

---

The diuretic properties of ethacrynic acid (95) were at one time attributed to its role as a Michael... 

The a-blocker phentolamine (83-3) was used fairly extensively as an antihypertensive agent prior to the availability of more effective and far better tolerated drugs. Some of the most important side effects from use of this drug, such as fluid retention and tachycardia, were at that time attributed to compensatory mechanisms, casting a cloud on all a-blockers. The use of this class of agents for controlling elevated blood... 

There have been many reports of the wandering of polonium from open sources, behavior at one time attributed to an aggregate recoil mechanism (84), but more recent observations with curie quantities indicate that contamination only spreads when volatile compounds, for instance polonium tetrachloride, are involved. 

It is also important to note Corvino s excessive, lengthy, and jealous tirade on fidelity, his quick reversal of form, and, finally, his warm sympathy for his wife. These emotional transitions demand a sophisticated comic touch and a delicate sense of timing, attributes found only in great character actors. 

The book was cursed This unexpected croak from Aunt Fortunata made me jump—she was still not dead Nicolo died of a rotting finger, and popular superstition at the time attributed that to a paper cut he had received when handling a forbidden book, one of the titles on theindex. ... 

The effect on your study of the effect of stress on quality of care is a huge increase in cost and time attributed to the consent process. Each hospital that you selected to include in your survey had to certify independently that they are disclosing the bare minimum of only that information which is absolutely vital to your study in an Internal Review Board. After jumping through all the hoops, your study reaches significant conclusions and you learned a valuable lesson. You must plan your research in advance, have prepared consent forms, have an IRB waiver or know how to rapidly access the IRB, and be ready to start your study immediately. Most important, by following the HIPAA requirements you kept the private information of patients private and your perseverance advanced the field of study. 

Iftheissuance of apatent is delayed because of appellate review by the Board of Patent Appeals and Interferences or by a federal court, and the appeal is successful, the patent term is extended for a period of the appeal (up to 5 years). The extension is reduced by any time attributable to appellate review before the expiration of 3 years from the filing date of the application and for the period of time the applicant did not act with "due diligence." 35... 

Cattell s most important historical multi-way paper is that in which he defines multi-way arrays [Cattell 1952], He defines object, circumstance/time, attribute, scale and observer as the five ways for an idealized psychological multi-way array and quickly reduces this to person-attribute-circumstance three-way arrays for practical reasons. Figure 4.1 gives a simplified view of Cattell s first three-way array. Discussion of T, S, O, P, R and Q techniques is outside the scope of this book the figure is only given as an illustration. A real multi-way solution for analyzing such arrays was not given in the paper. 

FIGURE 11.1. The change in heat transfer coefficient with time attributed to chemical reaction fouling... 

The depressing effect on nitrate formation of highly carbonaceous residues, added to soils, should be mentioned here even though discussed elsewhere in this book (Chapter 6). The lack of nitrate accumulation in soils treated with such materials was at one time attributed to their depressing effect on the microorganisms. There is little or no evidence in support of this viewpoint. Rather, it would seem that lack of nitrite and nitrate formation under such conditions can be attributed primarily to the competition for ammonia by the mass of rapidly growing bacteria, fungi, actinomycetes, and crop, if present. The autotrophs would be poor competitors for the very limited supply of ammonia, and if they did get a portion of it, the heterotrophs would not allow nitrate to accumulate. 

Salvioli, in 1880, found that the intestinal mucous membrane exerts a very pronounced effect on peptone and that the latter rapidly disappears from the solution. This fact, was confirmed later by Hofmeister and by other observers, and was for a long time attributed to a synthetic reaction. It was thought that peptone, in contact with the waU of the intestine, was reformed into albumin. In 1899, Cappareli attributed this transformation to an enzymic action, and Cohnheim, in 1901, proved that this disappearance of the peptone results, not from a condensation, but from a decomposition which is produced by a cial enzyme to which he gave the name of erepsin. The final products of digestion of peptone are non-biuretic substances corresponding, consequently, to an advanced hydrolysis, and are composed chiefly of amino-acids. 

In the historical evolution of the subject the variation of electrical conductivity with increasing dilution was for some time attributed... 

External microdialysis probes fabricated in-house were used in these experiments. Initial studies found that the addition of ethylenediamine tetraacetic acid (EDTA) to the derivatizing reagent was necessary to prevent divalent cations (Mg + and Ca +) present in the cerebral spinal fluid from decreasing the EOE. Using the device, separations could be carried out at 1.8 min intervals however, the effective temporal resolution was estimated to be between 2 and 4 min due to delay times attributed to the dead volume in the system. Increases in perfusion flow rates led to a decreased delay time but reduced recovery through the probe was observed. 

Although the Ordinary Petri Nets are a powerfirl modelling tool, many extensions and abbreviations exist. So for example Timed Petri Nets allow the incorporation of time attributes into the model. For modelling of various random phenomena Stochastic Petri Nets can be used. Colored Petri Nets (Jensen, K. 1997) allow the token differentiation due to the association of a color (value) with each token. They also give the possibility to model a system in which cooperate continuous-time variables and discrete events, which can occur on a stochastic basis. CPN allow thus to make the model more concise than the ordinary Petri Nets and also to include temporal and stochastic proprieties. 

Figure 2.12a shows a CV for the oxidation of Fe(CN)5 recorded on EPPG and another at a cleaved surface of HOPG [16]. The best result of fitting the experimental HOPG voltammogram to the linear diffusion simulation (DigiSim ) is shown in Figure 2.12b. Both the experimental forward and back peaks are wider than predicted theoretically and the experimental back peak is significantly smaller than predicted. This poor experimental fit was previously observed by McCreery et al. [74] who, at the time, attributed the voltammetric behavior to a potential-dependent transfer coefficient on a homogeneous surface. Even though this resulted in a better fit between simulation and experiment, there is no obvious theoretical basis for a potential-dependent transfer coefficient.

Fig. 4.19 300 K Mossbauer spectra of the samples milled for 16, 32, 48 and 64 h. One notes a quadrupolar component for 64 h milling time attributed to wustite-like phase originated from reduction effects during milling procedure [159]...

Set the timing attributes for scan testing of the design appropriately, to avoid simulation mismatches. Set test default bldlr delay to a value after the rising edge of the capture clock. This variable specifies the time when data is applied to the bi-directionals in the input mode. 

Careful patient selection prevents unsafe levels of alveolar hypoventilation with subsequent hypoxemia and hypercapnea, especially if the tidal volume leakage is >20%. Any compensatory increase in respiratory rate and shortened expiratory time, attributable to the air leakage, may aggravate dynamic hyperinflation, especially among patients with airflow obstruction (15). Ventilator-supported speech has been reported in patients with neuromuscular diseases (NMD) and intact bulbar function (16-19). The physiologic characteristics that enable this population to tolerate ventilator-supported speech include little or no decrease in chest wall or lung compliance and the absence of airflow obstmction. Therefore, patients with NMD may be ventilated with a deflated or cuffless tracheostomy tube accepting the modest compromise in alveolar ventilation (16,20-22). Patient populations, such as those with chronic obstructive pulmonary disease may be able to tolerate cuff deflation for short periods provided there is adequate supervision. 

The change by a manufacturer of automated teller machine rollers from one anaerobic adhesive to another to meet performance requirements is examined. Topics covered include assembly procedures, testing and cost savings in the two years that Hiawatha Rubber has been using the anaerobic adhesive, only two bonded rollers out of about 16,000 units have failed - each time attributed to improper application of the adhesive. Details are given. HIAWATHA RUBBER CO. 

If demand increases by a factor of k, the optimal lot size increases by a factor of y/k. The number of orders placed per year should also increase by a factor of y/k. Flow time attributed to cycle inventory should decrease by a factor of y/k. 

BuUd Back Better signifies an ideal reconstruction and recovery process that delivers resilient, sustainable, and efficient recovery solutions to disaster-affected communities. The motivation behind the Build Back Better concept is to make commimities stronger and more resilient following a disaster event. Statistics from the United Nations Enviromnent Programme in 2008 show an increase in the number of natural disasters over time attributing to growing populations. 

---