Supercritical fluids complexants

Purifications of elfamycins have been described in the Hterature using Craig distribution (2,34), chromatography on Sephadex LH-20 (2,14,26) and Amberlite XAD-2 (10,17,19,26), supercritical fluid extraction (37), and chromatography on an Ito multilayer cod planet centrifuge (26,38). and nmr assignments of most elfamycins have been accompHshed (3,24,26,32). The characteristic uv spectra permits some differentiation (12) and bathochromic shifts associated with Al " complexation have been used to quantify efrotomycin (2, R = CH ) in feed premixes (39,40). 

Mixtures can be identified with the help of computer software that subtracts the spectra of pure compounds from that of the sample. For complex mixtures, fractionation may be needed as part of the analysis. Commercial instmments are available that combine ftir, as a detector, with a separation technique such as gas chromatography (gc), high performance Hquid chromatography (hplc), or supercritical fluid chromatography (96,97). Instmments such as gc/ftir are often termed hyphenated instmments (98). Pyrolyzer (99) and thermogravimetric analysis (tga) instmmentation can also be combined with ftir for monitoring pyrolysis and oxidation processes (100) (see Analytical methods, hyphenated instruments). 

Separation Techniques. Current methods for separating fatty acids are by solvent crystaUi2ation or by the hydrophili2ation process. Other methods that have been used in the past, or perhaps could be used in the future, are panning and pressing, solvent extraction, supercritical fluid extraction, the use of metal salts in assisting in separation, separations using urea complexes, and adsorption/desorption. 

A method which uses supercritical fluid/solid phase extraction/supercritical fluid chromatography (SE/SPE/SEC) has been developed for the analysis of trace constituents in complex matrices (67). By using this technique, extraction and clean-up are accomplished in one step using unmodified SC CO2. This step is monitored by a photodiode-array detector which allows fractionation. Eigure 10.14 shows a schematic representation of the SE/SPE/SEC set-up. This system allowed selective retention of the sample matrices while eluting and depositing the analytes of interest in the cryogenic trap. Application to the analysis of pesticides from lipid sample matrices have been reported. In this case, the lipids were completely separated from the pesticides. 

Another application of SFC-GC was for the isolation of chrysene, a poly aromatic hydrocarbon, from a complex liquid hydrocarbon industrial sample (24). A 5 p.m octadecyl column (200 cm X 4.6 mm i.d.) was used for the preseparation, followed by GC analysis on an SE-54 column (25 m X 0.2 mm i.d., 0.33 p.m film thickness). The direct analysis of whole samples transferred from the supercritical fluid chromatograph and selective and multi-heart-cutting of a particular region as it elutes from the SFC system was demonstrated. The heart-cutting technique allows the possibility of separating a trace component from a complex mixture (Figure 12.21). 

Figure 12.21 SFC-GC heait-cut analysis of chrysene from a complex hydrocarbon mixture (a) SFC ttace (UV detection) (b) GC trace without heait-cut (100% transfer) (c) GC ti ace of heatt-cut fraction (flame-ionization detection used for GC experiments). Reprinted from Journal of High Resolution Chromatography, 10, J. M. Levy et al., On-line multidimensional supercritical fluid chromatography/capillaiy gas cluomatography , pp. 337-341, 1987, with permission from Wiley-VCFI.

One example of normal-phase liquid chromatography coupled to gas chromatography is the determination of alkylated, oxygenated and nitrated polycyclic aromatic compounds (PACs) in urban air particulate extracts (97). Since such extracts are very complex, LC-GC is the best possible separation technique. A quartz microfibre filter retains the particulate material and supercritical fluid extraction (SPE) with CO2 and a toluene modifier extracts the organic components from the dust particles. The final extract is then dissolved in -hexane and analysed by NPLC. The transfer at 100 p.1 min of different fractions to the GC system by an on-column interface enabled many PACs to be detected by an ion-trap detector. A flame ionization detector (PID) and a 350 p.1 loop interface was used to quantify the identified compounds. The experimental conditions employed are shown in Table 13.2. 

In order to reduce or eliminate off-line sample preparation, multidimensional chromatographic techniques have been employed in these difficult analyses. LC-GC has been employed in numerous applications that involve the analysis of poisonous compounds or metabolites from biological matrices such as fats and tissues, while GC-GC has been employed for complex samples, such as arson propellants and for samples in which special selectivity, such as chiral recognition, is required. Other techniques include on-line sample preparation methods, such as supercritical fluid extraction (SFE)-GC and LC-GC-GC. In many of these applications, the chromatographic method is coupled to mass spectrometry or another spectrometiic detector for final confirmation of the analyte identity, as required by many courts of law. 

In a different implementation (Fig. 10.3b), the recycling pump is fixed with respect to the zones. It is always located between zones IV and I where no solutes are present. In order to implement this idea, additional valves are needed, which makes the system more complex than the previous one. Its main interest is found when physical modulation is used, as in the supercritical fluid SMB, for which it can be shown that a great interest could be taken from a higher pressure in zone I [56]. The only way to obtain this result is to maintain the recycling pump immediately before zone I. 

If simple sample pretreatment procedures are insufficient to simplify the complex matrix often observed in process mixtures, multidimensional chromatography may be required. Manual fraction collection from one separation mode and re-injection into a second mode are impractical, so automatic collection and reinjection techniques are preferred. For example, a programmed temperature vaporizer has been used to transfer fractions of sterols such as cholesterol and stigmasterol from a reversed phase HPLC system to a gas chromatographic system.11 Interfacing gel permeation HPLC and supercritical fluid chromatography is useful for nonvolatile or thermally unstable analytes and was demonstrated to be extremely useful for separation of compounds such as pentaerythritol tetrastearate and a C36 hydrocarbon standard.12... 

The mass spectra of mixtures are often too complex to be interpreted unambiguously, thus favouring the separation of the components of mixtures before examination by mass spectrometry. Nevertheless, direct polymer/additive mixture analysis has been reported [22,23], which is greatly aided by tandem MS. Coupling of mass spectrometry and a flowing liquid stream involves vaporisation and solvent stripping before introduction of the solute into an ion source for gas-phase ionisation (Section 1.33.2). Widespread LC-MS interfaces are thermospray (TSP), continuous-flow fast atom bombardment (CF-FAB), electrospray (ESP), etc. Also, supercritical fluids have been linked to mass spectrometry (SFE-MS, SFC-MS). A mass spectrometer may have more than one inlet (total inlet systems). 

McNally ME, Wheeler JR. 1988. Supercritical fluid extraction coupled with supercritical fluid chromatography for the separation of sulfonylurea herbicides and their metabolites from complex matrices. J Chromatogr 435 63-71. 

The iridium catalyst was found to be sufficiently soluble for catalysis when in the form of the substrate complex, but precipitated quantitatively once all substrate had been consumed. Supercritical fluid extraction at that stage yielded the solvent- and metal-free product in crystalline form leaving the active and selective catalyst behind for... 

Saldana MDA, Li S, Guigard SE and Temelli F. 2006. Comparison of the solubility of (5-carotene in supercritical CO2 based on a binary and a multicomponent complex system. J Supercrit Fluids 37(3) 342— 349. 

The several theoretical and/or simulation methods developed for modelling the solvation phenomena can be applied to the treatment of solvent effects on chemical reactivity. A variety of systems - ranging from small molecules to very large ones, such as biomolecules [236-238], biological membranes [239] and polymers [240] -and problems - mechanism of organic reactions [25, 79, 223, 241-247], chemical reactions in supercritical fluids [216, 248-250], ultrafast spectroscopy [251-255], electrochemical processes [256, 257], proton transfer [74, 75, 231], electron transfer [76, 77, 104, 258-261], charge transfer reactions and complexes [262-264], molecular and ionic spectra and excited states [24, 265-268], solvent-induced polarizability [221, 269], reaction dynamics [28, 78, 270-276], isomerization [110, 277-279], tautomeric equilibrium [280-282], conformational changes [283], dissociation reactions [199, 200, 227], stability [284] - have been treated by these techniques. Some of these... 

More elaborate sample preparation is often needed for complex sample matrices, e.g., lotions and creams. Many newer SP technologies such as solid-phase extraction (SPE), supercritical fluid extraction (SFE), pressurized fluid extraction, accelerated solvent extraction (ASE), and robotics are frequently utilized (see Ref. [2]). Dosage forms such as suppositories, lotions, or creams containing a preponderance of hydrophobic matrices might require more elaborate SP and sample cleanup, such as SPE or liquid-liquid extraction. 

Supercritical fluids allow the formation of species that cannot be made in conventional solvents. For example, rj2-H2 complexes have been generated by direct reaction of hydrogen with a transition metal carbonyl complex [10]. In order to isolate these compounds, a continuous flow reactor was used and such compounds could be isolated with surprising ease. 

With the widening use of the liquid-liquid extraction for the separation of complex mixtures into their components, it has been necessary to develop fluids with highly selective characteristics. The metallurgical, nuclear, biotechnolgy and food industries are now major users of the technique, and many of the recent developments have originated in those fields. Some of the characteristics and properties of two classes of fluids of increasing importance-supercritical fluids and aqueous two-phase systems are described in this section. 

Jessop PG, Leitner W (1999) Metal-Complex Catalyzed Reactions. In Jessop PG, Leitner W (eds) Chemical Synthesis Using Supercritical Fluids. Wiley, Weinheim,... 

These Rh complexes have been the subject of intense interest due to their propensity for C-H activation of alkanes (Section 3.3.2.7). The noble gas complexes [CpRh(CO)L] and [Cp Rh(CO)L] (L = Kr, Xe) have also been studied in supercritical fluid solution at room temperature [120]. For both Kr and Xe, the Cp complex is ca. 20-30 times more reactive towards CO than the Cp analogue. Kinetic data and activation parameters indicated an associative mechanism for substitution of Xe by CO, in contrast to Group 7 complexes, [CpM(CO)2Xe] for which evidence supports a dissociative mechanism. 

---