Halides Subject

Oxygen halides are dealt with in Chapter 11, p. 334. Sulphur, selenium and tellurium form many halides, and only a brief introduction to the subject is given here. 

Materials that contain defects and impurities can exhibit some of the most scientifically interesting and economically important phenomena known. The nature of disorder in solids is a vast subject and so our discussion will necessarily be limited. The smallest degree of disorder that can be introduced into a perfect crystal is a point defect. Three common types of point defect are vacancies, interstitials and substitutionals. Vacancies form when an atom is missing from its expected lattice site. A common example is the Schottky defect, which is typically formed when one cation and one anion are removed from fhe bulk and placed on the surface. Schottky defects are common in the alkali halides. Interstitials are due to the presence of an atom in a location that is usually unoccupied. A... 

Metallic sodium. This metal is employed for the drying of ethers and of saturated and aromatic hydrocarbons. The bulk of the water should first be removed from the liquid or solution by a preliminary drying with anhydrous calcium chloride or magnesium sulphate. Sodium is most effective in the form of fine wire, which is forced directly into the liquid by means of a sodium press (see under Ether, Section II,47,i) a large surface is thus presented to the liquid. It cannot be used for any compound with which it reacts or which is affected by alkalis or is easily subject to reduction (due to the hydrogen evolved during the dehydration), viz., alcohols, acids, esters, organic halides, ketones, aldehydes, and some amines. 

A saturated alkyl group does not exhibit functionality. It is not a d -synthon, because the functional groups, e.g. halide or metal ions, are lost in the course of the reaction. It functions as an alkyl synthon. Alkenyl anions (R. West, 1961) on the other hand, constitute d -synthons, because the C = C group remains in the product and may be subject to further synthetic operations. 

The use of sensitizing dyes in photography has been the subject of many studies and constitutes. still now. one of the most studied areas in specialized periodic publications (125, 126) or in textbooks (88. 127). It can be ascertained that one hundred years after Vogel s discovery of spectral sensitization, the basic mechanisms of action of dyes on their silver halide support still remain not fully understood. However, the theoretical reasons explaining why among many other dye families practically only cyanine methine dyes appear to be spectral sensitizers (128) are better known. 

Sulfonate esters are subject to the same limitations as alkyl halides Competition from elimination needs to be considered when planning a functional group transforma tion that requires an anionic nucleophile because tosylates undergo elimination reactions just as alkyl halides do... 

The anion of a p keto ester may be alkylated at carbon with an alkyl halide and the product of this reaction subjected to ester hydrolysis and decarboxylation to give a ketone... 

Phosphoms halides are subject to reactions with active hydrogen compounds and result in the elimination of hydrogen halide. They are convenient reagents in the synthesis of many esters, amides, and related compounds. However, because the involved hydrogen halide frequendy catalyzes side reactions, it is usually necessary to employ a hydrogen halide scavenger to remove the by-product. 

Perfluoroalkyl or -aryl halides undergo oxidative addition with metal vapors to form nonsolvated fluonnated organometallic halides and this topic has been die subject of a review [289] Pentafluorophenyl halides react with Rieke nickel, cobalt, and iron to give bispentafluorophenylmetal compounds, which can be isolated in good yields as liquid complexes [290] Rieke nickel can also be used to promote the reaction of pentafluorophenyl halides with acid halides [297] (equation 193)... 

AC is interpreted as the difference in heat capacities between the transition state and the reactants, and it may be a valuable mechanistic tool. Most reported ACp values are for reactions of neutral reactants to products, as in solvolysis reactions of neutral esters or aliphatic halides. " Because of the slight curvature seen in the Arrhenius plots, as exemplified by Fig. 6-2, the interpretation, and even the existence, of AC is a matter of debate. The subject is rather specialized, so we will not explore it deeply, but will outline methods for the estimation of ACp. 

Lower oxidation states are rather sparsely represented for Zr and Hf. Even for Ti they are readily oxidized to +4 but they are undoubtedly well defined and, whatever arguments may be advanced against applying the description to Sc, there is no doubt that Ti is a transition metal . In aqueous solution Ti can be prepared by reduction of Ti, either with Zn and dilute acid or electrolytically, and it exists in dilute acids as the violet, octahedral [Ti(H20)6] + ion (p. 970). Although this is subject to a certain amount of hydrolysis, normal salts such as halides and sulfates can be separated. Zr and are known mainly as the trihalides or their derivatives and have no aqueous chemistry since they reduce water. Table 21.2 (p. 960) gives the oxidation states and stereochemistries found in the complexes of Ti, Zr and Hf along with illustrative examples. (See also pp. 1281-2.)... 

Chiral oxazolines developed by Albert I. Meyers and coworkers have been employed as activating groups and/or chiral auxiliaries in nucleophilic addition and substitution reactions that lead to the asymmetric construction of carbon-carbon bonds. For example, metalation of chiral oxazoline 1 followed by alkylation and hydrolysis affords enantioenriched carboxylic acid 2. Enantioenriched dihydronaphthalenes are produced via addition of alkyllithium reagents to 1-naphthyloxazoline 3 followed by alkylation of the resulting anion with an alkyl halide to give 4, which is subjected to reductive cleavage of the oxazoline moiety to yield aldehyde 5. Chiral oxazolines have also found numerous applications as ligands in asymmetric catalysis these applications have been recently reviewed, and are not discussed in this chapter. ... 

The irons are most useful in environments containing a plentiful supply of oxygen or oxidising agents anaerobic or reducing conditions may lead to rapid corrosion. Physical effects such as abrasion or sudden dimensional changes induced by temperature fluctuations may rupture the film and allow corrosion to take place. The iron will also be subject to corrosion by solutions containing anions, such as those of the halides, which can penetrate surface films relatively readily. 

Salts giving an alkaline reaction may be corrosive to the irons, and while neutral solutions can be handled safely there is usually little point in using high-silicon irons for these relatively innocuous solutions. The irons are useful in handling acidic solutions, subject to the restrictions already referred to regarding the halide, sulphite and phosphate ions. 

HSI anodes are subject to severe pitting by halide ions and this precludes their use in seawater or other environments in which these ions may be present in quantity. They are ideal for fresh-water applications (below 2(X)p.p.m. Cl"), although not for temperatures above 38°C. The addition of Mo or Cr to the alloy can improve performance under these conditions, with an upper limit of temperature of which may be affected by the... 

In extending this direct method of synthesis, we next investigated the possibility of preparing similarly constituted halides from 2-deoxy-D-arabino-hexose (2-deoxy-D-glucose) (21). The hexose was subjected to a partial anomerization procedure described by Bergmann and co-workers (1). The solid material obtained by this procedure is a mixture of the anomeric forms of 2-deoxy-D-arabino-hexose low temperature p-nitro-benzoylation of the latter in pyridine resulted in a mixture of crystalline, anomeric tetrakis-p-nitrobenzoates in a ratio of approximately 1 1. They were readily separable by fractional recrystallization, and treatment of either with an excess of hydrogen bromide in dichloromethane, or with... 

Before getting to the main subject of this chapter—the reactions of alkenes— let s take a brief look at how alkenes are prepared. The subject is a bit complex, though, so we ll return in Chapter 11 for a more detailed study. For the present, it s enough to realize that alkenes are readily available from simple precursors— usually alcohols in biological systems and either alcohols or alkyl halides in the laboratory. 

Because the Williamson synthesis is an S 2 reaction, it is subject to all the usual constraints, as discussed in Section 11.2. Primary halides and tosylates work best because competitive E2 elimination can occur with more hindered substrates. Unsymmetrical ethers should therefore be synthesized by reaction between the more hindered alkoxide partner and less hindered halide partner rather than vice versa. For example, terf-butyl methyl ether, a substance used in the 1990s as an octane booster in gasoline, is best prepared by reaction of tert-butoxide ion. with iodomethane rather than by reaction of methoxide ion with 2-chloro-2-methylpropane. 

Alkylation reactions are subject to the same constraints that affect all Sn2 reactions (Section 11.3). Thus, the leaving group X in the alkylating agent R—X can be chloride, bromide, iodide, or tosylate. The alkyl group R should be primary or methyl, and preferably should be allylic or benzylic. Secondary halides react poorly, and tertiary halides don t react at all because a competing E2 elimination of HX occurs instead. Vinylic and aryl halides are also unreactive because backside approach is sterically prevented. 

In the reaction of 88 with /(-phenethyl bromide, l-phenethyl-3-phenylpropyl methyl sulfoxide and bis-3-phenylpropyl sulfoxide, besides 3-phenylpropyl methyl sulfoxide are obtained118. Sulfoxides, bearing a /1-hydrogen to the sulfmyl function, give olefins upon thermolysis. Utilizing this reaction, Trost and Bridges120 alkylated benzyl phenyl sulfoxide, 3,4-methylenedioxybenzyl phenyl sulfoxide, phenylthiomethyl phenyl sulfoxide, phenylsulfinylmethyl phenyl sulfoxide and cyanomethyl phenyl sulfoxide with alkyl, allyl and benzyl halides and subjected these sulfoxides to thermolysis, obtaining olefins in one-pot processes. 

Dithiocarbamate complexes of copper have been sythesized at a high rate. Reports of new complexes include the morpholine-4- (44), thio-morpholine, AT-methylpiperazine-4-, and piperidine- (291) dithiocarba-mates. Novel, polymeric complexes of the type Cu(pipdtc)2 (CuBr) in = 4, or 6) and Cu(pipdtc)2 (CuCl)4 have been prepared by reactions of[Cu(pipdtc)2] with the respective copper halide in CHCla-EtOH (418). The crystal structures of the polymers are known to consist of sheets of individual [Cu(pipdtc)2] molecules linked to polymeric CuBr chains via Cu-S bonds. A series of copper(I) dtc complexes have been the subject of a Cu and Cu NQR-spectral study (440). 

The first chalcogenide halides of tin were reported in 1963 24). Although numerous publications since then have been devoted to this subject, the existence and true composition of some the compounds described here still seem questionable. It is, therefore, advisable to start with a discussion of the systems SnY-SnXji Y = S, Se, Te X = Cl, Br, I). 

The mechanism of the Arbusov reaction has been the subject of some study. Intermediates (4), isolated at low temperatures from the reaction of phosphonites with alkyl halides, show n.m.r. chemical shifts in the region of — 95 p.p.m. in a wide variety of solvents. ... 

---