Scrutiny

However, of all the petroleum products, jet fuel is the one receiving the most careful scrutiny. 

When water is produced along with oil, the separation of water from oil invariably leaves some water in the oil. The current oil-in-water emission limit into the sea is commonly 40 ppm. Oily water disposal occurs on processing platforms, some drilling platforms, and at oil terminals. The quality of water disposed from terminals remains an area of scrutiny, especially since the terminals are often near to local habitation and leisure resorts. If the engineer can find a means of reducing the produced water at source (e.g. water shut-off or reinjection of produced water into reservoirs) then the surface handling problem is much reduced. 

The computer also can leam from a defect-free test piece by rutming such a piece in a readmode. For example, if a drilled hole for lubrication purposes is present at the same location on all parts, the computer will recognise this signal and accept it on all test pieces. The computer will actually be comparing the test piece under scrutiny with standard non-defect master. In addition a reference test piece should be used to check that the specified reference defects really will be detected. This is needed to adjust the settings and sensitivity of the system. 

The practical goal of EPR is to measure a stationary or time-dependent EPR signal of the species under scrutiny and subsequently to detemiine magnetic interactions that govern the shape and dynamics of the EPR response of the spin system. The infomiation obtained from a thorough analysis of the EPR signal, however, may comprise not only the parameters enlisted in the previous chapter but also a wide range of other physical parameters, for example reaction rates or orientation order parameters. 

RE is generated at two frequencies one is fixed at the free nnclear frequency appropriate to die sort of nnclei under scrutiny and the second is swept. These two frequencies are mnltiplied to obtain the sum and the difference frequencies, which are nsed to irradiate the sample. The experiment can be understood... 

As of the year 1998, small quantities of sassafras oil are still being sold on retail shelves without any scrutiny. Usually in 1-4oz sizes. Anything larger is usually sold only through distributors and manufacturers. And as of 1998, the DEA has informed most of these distributors that they (the DEA) want lists kept or sales reported of most, if not all, sassafras oil purchases. Mind you it is not illegal to buy the oil. It s just that you will be put on a list if you do. The operative term here is Watched Substance . Solution have someone else buy it for you. 

This catalyst has not been given a fair shake in underground literature and, as of this book s printing, is still relatively safe to purchase, A prudent chemist will most likely stock up on this chemical because the eventuality of more intense scrutiny is inevitable. The best way to make this product is to start with NaBH4 which is much more safe to buy. However, the way to go about making this catalyst is not very safe unless strict adherence to safety is used. 

Surface Area Determination The surface-to-volume ratio is an important powder property since it governs the rate at which a powder interacts with its surroundings. Surface area may be determined from size-distribution data or measured directly by flow through a powder bed or the adsorption of gas molecules on the powder surface. Other methods such as gas diffusion, dye adsorption from solution, and heats of adsorption have also been used. It is emphasized that a powder does not have a unique surface, unless the surface is considered to be absolutely smooth, and the magnitude of the measured surface depends upon the level of scrutiny (e.g., the smaller the gas molecules used for gas adsorption measurement the larger the measured surface). 

However, given that reconciliation will not always adjust measurements, even when they contain large random and gross error, the adjustments will not necessarily indicate that gross error is present. Further, the constraints may also be incorrect due to simphfications, leaks, and so on. Therefore, for specific model development, scrutiny of the individual measurement adjustments coupled with reconciliation and model building should be used to isolate gross errors. 

An interesting, broad-spectrum journal founded in 1997 by Roy is Materials Research Innovations., one of its objectives is to bypass normal methods of editorial scrutiny submitting authors who have published a sufficient number of papers in other, peer-reviewed, journals are assumed, in effect, to have reviewed themselves. 

If a worker is overexposed to lead and should be removed from the job due to exposure, the standard specifies medical removal benefits and more [5]. If a worker claims to have been overexposed to lead, will you be prepared to defend that claim If a worker notifies regulators that he or she has been exposed to lead, will your program stand up to scrutiny ... 

The change does not need to be reviewed and approved by the same individuals who reviewed and approved the original document. The important factor is that the same functions or organizations review and approve the change. The reason is to subject the document to the same scrutiny as the original by personnel as qualified as those who examined the original. Providing your procedures specify the review and approval authorities in terms of functions or positions and not names, the requirement is easily satisfied. 

The assessor s skills and outlook affect results. Personnel conducting baseline PSM assessments should have the skills and experience that promote a bcdance between objectivity and familiarity with the programs and processes under scrutiny. 

Nach-forschung, /. research, investigation, inquiry, search, scrutiny, -frage, /. inquiry (Com.) demand. 

Trade secrets are creative works (usually methods, processes, or designs) that are not covered by the strict definition of an invention required for a legal patent. Or they are actual inventions that a company or individual does not want to expose to public scrutiny through the patent process (since the published patent must contain a written description of the invention). 

Insurers are aware of the importance of a management that, at all levels, is fully conscious of the fire and other hazards within its premises and consequently acts in a highly responsible way. An opinion of the standard of management is an important part of the insurance surveyor s report referred to earlier, and is obtained by observation of conditions in the premises and a scrutiny of the organization and systems that are in operation. 

Square brackets are commonly used for two purposes to denote concentrations and also to include the whole of a complex ion for the latter purpose curly brackets (braces) are sometimes used. With careful scrutiny there should be no confusion regarding the sense in which the square brackets are used with complexes there will be no charge signs inside the brackets. 

---