Safety permit inspector

Safety permit inspector—inspects area and ensures that it is safe performs gas test and determines oxygen level ensures that equipment, vessels, and piping are cleared confirms required PPE signs permit and sets time limit. This function is performed by process technicians at many locations. 

The hot work permit must be filled out and signed before a safety inspector is called to review it and the work area. When the system is ready, the mechanical supervisor and safety inspector will show up to inspect the area. Chemical concentrations and potential hazards are assessed. The need for a standby will be determined by the mechanical supervisor and the operator. If everything is in order, the safety inspector will sign and post the permit and the work can be started. The permit must be displayed at the work site until the hot work operation is complete. The hot work permit must indicate ... 

BSEE administers the new regime s safety program. Its role defined by DOI is to process permits to drill as safely as possible, enforee safety and environmental regulations, provide sustained regulatory oversight that is focused on compliance by operators with all applicable environmental regulations, train inspectors, perform various shared responsibilities with BOEM and the CG, and implement... 

In 1850, the Inspection of Coal Mines Act was promulgated. The first mine inspectors were appointed and were given powers to enter mines to evaluate their safety. Accidents had to be reported within 24 hours, and only competent persons were permitted to work on the colliery as engine men, banksmen, and onsetters. Competent persons were defined as skilled males over the age of 18. 

Air receiver (this should be a certified pressure vessel with a safety valve and a rapture disc. It should be inspected and permitted for use by the local factory inspector). 

All three were rescued and recovered. The tank had been closed before the accident and was rusted inside. Rusting consumes oxygen. The oxygen level in an adjacent unopened tank was tested and the result was 4.5%. The normal level of oxygen in air is 21 %. The barge owner was fined as there were no safe work procedures and permit-to-work system as the law required. A second fine was applied because the workers had not been sent to a safety training course which had the Chief Inspector of Factories approval. 

The FRA s statement on enforcement notes that "[wjhile civil penalties are the primary enforcement tool under the federal railroad safety laws, more extreme measures are available under certain circumstances." Part 216 of the federal regulations provides legal powers for federal inspectors to require immediate rectification of defects with freight cars and locomotives, or the lowering of the maximum speed over a piece of track by means of issuance of Special Notices. Inspectors can require discontinuation of service over section of track by issuing of an Emergency Order. A 1980 amendment permitted very broad and sweeping... 

---