Rhodium special

A platinum-rhodium ahoy is used as a catalyst at 1100°C. Approximately equal amounts of ammonia and methane with 75 vol % air are introduced to the preheated reactor. The catalyst has several layers of wire gauze with a special mesh size (approximately 100 mesh). 

Laister and Benham have shown that under more arduous conditions (immersion for 6 months in sea-water) a minimum thickness of 0-025 mm of silver is required to protect steel, even when the silver is itself further protected by a thin rhodium coating. In similar circumstances brass was completely protected by 0 012 5 mm of silver. The use of an undercoating deposit of intermediate electrode potential is generally desirable when precious metal coatings are applied to more reactive base metals, e.g. steel, zinc alloys and aluminium, since otherwise corrosion at discontinuities in the coating will be accelerated by the high e.m.f. of the couple formed between the coating and the basis metal. The thickness of undercoat may have to be increased substantially above the values indicated if the basis metal is affected by special defects such as porosity. 

It is not possible to plate rhodium directly on to reactive metals of the type mentioned above, in view of the acid nature of the electrolyte, but copper and its alloys, e.g. nickel-silver, brass, phosphor-bronze, beryllium-copper, which are of special importance in the electrical contact field, may be plated directly. Even in this case, however, an undercoat is generally desirable. 

Three of the rhodium(I) carbonyl complexes are particularly important and are selected for special study. 

Table 9.5 shows the concentrations of pollutant parameters found in the precious metals subcategory raw waste streams. The major constituents are silver and gold, which are much more commonly used in metal finishing industry operations than palladium and rhodium. Because of their high cost, precious metals are of special interest to metal finishers. 

Although palladium or platinum on charcoal are widely used, there is a preference for homogeneous reactions on both the laboratory and the industrial scale. Complexes of ruthenium (II) and rhodium (I), particularly with phosphine ligands, do have some importance in special applications [4], but... 

The new family of phospholes with 2,4,6-trialkylphenyl substituent on the phosphorus atom show, in many respects, a special reactivity. Due to the flattening of the P-pyramid, the arylphospholes exhibit aromaticity and hence underwent Friedel-Crafts reactions. The regioselective functionalization through reaction with phosphorus tribromide gave a variety of phospholes with an exocyclic P-moiety. Novel phosphole platinum and rhodium complexes were prepared and a part of them was tested in hydroformylation reactions. 

Whereas this important quotient is calculated solely from the product spectrum, process simplifications are a consequence of combining the rhodium catalyst with the special two-phase process. Compared with the conventional oxo process and with other variants (which, for example, include disadvantegeously thermal separation of the oxo reaction products from the catalyst) the procedure is considerably simplified (as shown in several papers, e.g., [2,12]). 

However, the decarbonylation reaction can be suppressed by the use of specially tailored chelating groups. Intermolecular processes involving dienes and salicylaldehydes are now known, and are thought to proceed via a double chelation mechanism, akin to the Jun-type system. Rhodium-catalyzed reactions lead to hydroacylated products, under relatively mild conditions (Equation (134)).117... 

The ruthenium [37] and rhodium [38] pre-catalysts have been prepared and isolated likewise, the 16- and 18-electron hydride species have been prepared and characterized [38-401. There is little practical advantage in using the catalysts in this form, other than for mechanistic studies or when special circumstances are required (e.g., neutral reaction conditions). 

Using two types of specially synthesized rhodium-complexes (12a/12b), pyruvate is chemically hydrogenated to produce racemic lactate. Within the mixture, both a d- and L-specific lactate dehydrogenase (d-/l-LDH) are co-immobilized, which oxidize the lactate back to pyruvate while reducing NAD+ to NADH (Scheme 43.4). The reduced cofactor is then used by the producing enzyme (ADH from horse liver, HL-ADH), to reduce a ketone to an alcohol. Two examples have been examined. The first example is the reduction of cyclohexanone to cyclohexanol, which proceeded to 100% conversion after 8 days, resulting in total TONs (TTNs) of 1500 for the Rh-complexes 12 and 50 for NAD. The second example concerns the reduction of ( )-2-norbornanone to 72% endo-norbor-nanol (38% ee) and 28% exo-norbornanol (>99% ee), which was also completed in 8 days, and resulted in the same TTNs as for the first case. 

The reaction of (TPP)Rh with terminal alkenes or alkynes is of special interest due to the cleavage of the carbon-carbon bond adjacent to either the alkene or the alkyne functionality and results in the ultimate formation of (TPP)Rh(R). This overall reaction implies activation of a relatively inert carbon-carbon bond, especially for the case of the terminal alkene. However, the ultimate formation of (P)Rh(R) is not surprising if one considers the relative stability of the rhodium carbon bond in this species(17). 

All metals in the neighborhood of rhodium on the periodic table are known to be active in hydroformylation. Rhodium is by far the most active metal being used in concentrations of 10-100 mg/kg, usually at temperatures below 140 °C. Typical concentrations of cobalt-based catalysts are in the range of 1 -10 g/kg at temperatures up to 190 °C to get sufficient space-time yield. Apart from some specialized applications, other metals are only of scientific interest because of their low activity. A proper comparison of metal activity is difficult because of the different requirements on the reaction conditions. A generally accepted rough order of activity is given in Table 1. 

A similar pattern has always been discussed for rhodium, with hydri-dotetracarbonylrhodium H-Rh(CO)4 as a real catalyst species. The equilibria between Rh4(CO)i2 and the extremely unstable Rh2(CO)s were measured by high pressure IR and compared to the respective equilibria of cobalt [15,16]. But it was only recently that the missing link in rhodium-catalyzed hydroformylation, the formation of the mononuclear hydridocomplex under high pressure conditions, has been proven. Even the equilibria with the precursor cluster Rh2(CO)8 could be determined quantitatively by special techniques [17]. Recent reviews on active cobalt and rhodium complexes, also ligand-modified, and on methods for the necessary spectroscopic in situ methods are given in [18,19]. 

Indirect electroreduction with Ni, Co, and Fe complexes has been well studied, and will be discussed first. Furthermore, the synthetic use of palladium, rhodium, and ruthenium complexes as mediators in the electroreduction of organic compounds are finding increasing apphcations. Metallic complexes derived from chromium, manganese, molybdenum, tungsten, and rhenium have also been used as mediators for special conversions. Recently, tin, zinc, and mercury... 

In most cases the catalytically active metal complex moiety is attached to a polymer carrying tertiary phosphine units. Such phosphinated polymers can be prepared from well-known water soluble polymers such as poly(ethyleneimine), poly(acryhc acid) [90,91] or polyethers [92] (see also Chapter 2). The solubility of these catalysts is often pH-dependent [90,91,93] so they can be separated from the reaction mixture by proper manipulation of the pH. Some polymers, such as the poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) block copolymers, have inverse temperature dependent solubihty in water and retain this property after functionahzation with PPh2 and subsequent complexation with rhodium(I). The effect of temperature was demonstrated in the hydrogenation of aqueous allyl alcohol, which proceeded rapidly at 0 °C but stopped completely at 40 °C at which temperature the catalyst precipitated hydrogenation resumed by coohng the solution to 0 °C [92]. Such smart catalysts may have special value in regulating the rate of strongly exothermic catalytic reactions. 

Species such as XXV, XXVI, or XXVII readily form coordination complexes when treated with AuCl, H20So(C0)j q, Idn(CO)3(r -C5Hj), Fe(C0)3(PhCH=CHC(0)CH3>, or [RhCl(CO)2]2 ( ) Tw results are of special interest. First, the skeletal nitrogen atoms in XXV-XXVII do not participate in the coordination process. Presumably, they are effectively shielded by the aryloxy units and are of low basicity. Second, coordinatlve crosslinking can occur when two phosphine residues bind to one metal atom. Ligand-exchange reactions were detected for the rhodium-bound species. The tri-osmium cluster adducts of XXV, XXVI, and XXVII are catalysts for the isomerization of 1-hexane to 2-hexene. 

A special type of reaction is observed with the platinum(IV) complex [PtI(Me)3] which cleaves the Af,N,Af, A -tetraphenyltetraaminoethylene under reduction to form the dimeric cyclometallated mono(NHC) complex of platinum(II) iodide [Eq. (31)]. Cyclometallation with the same ligand is also observed for ruthe-nium. Additional cyclometallations with various substituents of NHCs have been reported for ruthenium(II), rhodium(III), iridium(I), palladium(II), " and platinum(II). In the case of iridium, alkyl groups can be activated twice. In rare cases like for nickel(II) /x-bridging NHCs have been obtained. ... 

Abstract The purpose of this chapter is to present a survey of the organometallic chemistry and catalysis of rhodium and iridium related to the oxidation of organic substrates that has been developed over the last 5 years, placing special emphasis on reactions or processes involving environmentally friendly oxidants. Iridium-based catalysts appear to be promising candidates for the oxidation of alcohols to aldehydes/ketones as products or as intermediates for heterocyclic compounds or domino reactions. Rhodium complexes seem to be more appropriate for the oxygenation of alkenes. In addition to catalytic allylic and benzylic oxidation of alkenes, recent advances in vinylic oxygenations have been focused on stoichiometric reactions. This review offers an overview of these reactions... 

These solid-gas reactions represent, at the moment, the single path to 3-metalla -l,2-dioxolane complexes of rhodium and iridium. Complexes of this type have been widely proposed in catalytic cycles. However, it is unlikely that they take part in oxygenations with rhodium because of their high reactivity (see below) and the special conditions for their preparation. 

---