Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Resonance Raman spectroscopy technique

The photophysics and photochemical reactions of 2-(l-hydro3yethyl)-9,10-anthraquinone have been studied by a combination of femtosecond transient absorption, nanosecond transient absorption and nanosecond time-resolved resonance Raman spectroscopy techniques, as well as DFT calculations. In acetonitrile, intersystem crossing to the triplet excited state is the predominating process. In isopropanol, photoreduction to a ketyl radical intermediate is observed. In neutral or moderately acidic aqueous solutions, a photoredox reaction occurs after initial protonation of the carbonyl ojqrgen, while under stronger acidic conditions photohydration takes over. ... [Pg.151]

It will be shown that, upon interaction with water or ammonia, the T -like symmetry of the Ti(IV) centers in TS-1 is strongly distorted, as testified by UV-Vis, XANES, resonant Raman spectroscopies [45,48,52,58,64,83,84], and by ab initio calculations [52,64,74-76,88]. As in Sect. 3 for the dehydrated catalyst, the discussion follows the different techniques used to investigate the interaction. [Pg.50]

With recent developments in analytical instrumentation these criteria are being increasingly fulfilled by physicochemical spectroscopic approaches, often referred to as whole-organism fingerprinting methods.910 Such methods involve the concurrent measurement of large numbers of spectral characters that together reflect the overall cell composition. Examples of the most popular methods used in the 20th century include pyrolysis mass spectrometry (PyMS),11,12 Fourier transform-infrared spectrometry (FT-IR), and UV resonance Raman spectroscopy.16,17 The PyMS technique... [Pg.322]

The identification of xanthophylls in vivo is a complex task and should be approached gradually with the increasing complexity of the sample. In the case of the antenna xanthophylls, the simplest sample is the isolated LHCII complex. Even here four xanthophylls are present, each having at least three major absorption transitions, 0-0, 0-1, and 0-2 (Figure 7.4). Heterogeneity in the xanthophyll environment and overlap with the chlorophyll absorption add additional complexity to the identification task. No single spectroscopic method seems suitable to resolve the overlapping spectra. However, the combination of two spectroscopic techniques, low-temperature absorption and resonance Raman spectroscopy, has proved to be fruitful (Ruban et al., 2001 Robert et al., 2004). [Pg.119]

Resonance Raman Spectroscopy as a Complement to Other Techniques for Making Electronic Band Assignments for (Re2X8)2 Ions... [Pg.225]

The historical development and elementary operating principles of lasers are briefly summarized. An overview of the characteristics and capabilities of various lasers is provided. Selected applications of lasers to spectroscopic and dynamical problems in chemistry, as well as the role of lasers as effectors of chemical reactivity, are discussed. Studies from these laboratories concerning time-resolved resonance Raman spectroscopy of electronically excited states of metal polypyridine complexes are presented, exemplifying applications of modern laser techniques to problems in inorganic chemistry. [Pg.454]

The first laser Raman spectra were inherently time-resolved (although no dynamical processes were actually studied) by virtue of the pulsed excitation source (ruby laser) and the simultaneous detection of all Raman frequencies by photographic spectroscopy. The advent of the scanning double monochromator, while a great advance for c.w. spectroscopy, spelled the temporary end of time resolution in Raman spectroscopy. The time-resolved techniques began to be revitalized in 1968 when Bridoux and Delhaye (16) adapted television detectors (analogous to, but faster, more convenient, and more sensitive than, photographic film) to Raman spectroscopy. The advent of the resonance Raman effect provided the sensitivity required to detect the Raman spectra of intrinsically dilute, short-lived chemical species. The development of time-resolved resonance Raman (TR ) techniques (17) in our laboratories and by others (18) has led to the routine TR observation of nanosecond-lived transients (19) and isolated observations of picosecond-timescale events by TR (20-22). A specific example of a TR study will be discussed in a later section. [Pg.466]

The use of surface-enhanced resonance Raman spectroscopy (SERRS) as an identification tool in TLC and HPLC has been investigated in detail. The chemical structures and common names of anionic dyes employed as model compounds are depicted in Fig. 3.88. RP-HPLC separations were performed in an ODS column (100 X 3 mm i.d. particla size 5 pm). The flow rate was 0.7 ml/min and dyes were detected at 500 nm. A heated nitrogen flow (200°C, 3 bar) was employed for spraying the effluent and for evaporating the solvent. Silica and alumina TLC plates were applied as deposition substrates they were moved at a speed of 2 mm/min. Solvents A and B were ammonium acetate-acetic acid buffer (pH = 4.7) containing 25 mM tributylammonium nitrate (TBAN03) and methanol, respectively. The baseline separation of anionic dyes is illustrated in Fig. 3.89. It was established that the limits of identification of the deposited dyes were 10 - 20 ng corresponding to the injected concentrations of 5 - 10 /ig/ml. It was further stated that the combined HPLC-(TLC)-SERRS technique makes possible the safe identification of anionic dyes [150],... [Pg.468]

Probing Metalloproteins Electronic absorption spectroscopy of copper proteins, 226, 1 electronic absorption spectroscopy of nonheme iron proteins, 226, 33 cobalt as probe and label of proteins, 226, 52 biochemical and spectroscopic probes of mercury(ii) coordination environments in proteins, 226, 71 low-temperature optical spectroscopy metalloprotein structure and dynamics, 226, 97 nanosecond transient absorption spectroscopy, 226, 119 nanosecond time-resolved absorption and polarization dichroism spectroscopies, 226, 147 real-time spectroscopic techniques for probing conformational dynamics of heme proteins, 226, 177 variable-temperature magnetic circular dichroism, 226, 199 linear dichroism, 226, 232 infrared spectroscopy, 226, 259 Fourier transform infrared spectroscopy, 226, 289 infrared circular dichroism, 226, 306 Raman and resonance Raman spectroscopy, 226, 319 protein structure from ultraviolet resonance Raman spectroscopy, 226, 374 single-crystal micro-Raman spectroscopy, 226, 397 nanosecond time-resolved resonance Raman spectroscopy, 226, 409 techniques for obtaining resonance Raman spectra of metalloproteins, 226, 431 Raman optical activity, 226, 470 surface-enhanced resonance Raman scattering, 226, 482 luminescence... [Pg.457]

The reaction sequence of Eq. 23-37 can be slowed by lowering the temperature. Thus, at 70K illumination of rhodopsin leads to a photostationary state in which only rhodopsin, bathorhodopsin, and a third form, isorhodopsin, are present in a constant ratio.510 Isorhodopsin (maximum absorption at 483 nm)513 contains 9-ds-retinal and is not on the pathway of Eq. 23-37. Resonance Raman spectroscopy at low temperature supports a distorted all-frans structure for the retinal Schiff base in bathorhodopsin.510 The same technique suggests the trans geometry of the C = N bond shown in Eqs. 23-38 and 23-39. Simple Schiff bases of 11-cz s-retinal undergo isomerization just as rapidly as does rhodopsin.514... [Pg.1330]

A range of techniques, i.e. Mossbauer, magnetic circular dichroism, ESR and resonance Raman spectroscopy together with EXAFS results on two 3Fe proteins, have been applied to the problem of the structure of these three-iron clusters. These results have been comprehensively and critically reviewed.741... [Pg.632]

The combination of several spectroscopic techniques, but particularly with involvement of resonance Raman spectroscopy, offers an effective way of studying the nature of the intervalence state in a wide variety of complexes ranging from linear-chain... [Pg.64]

Since the results obtained by matrix isolation Raman spectroscopy have been reviewed extensively (88-90), only two typical examples are discussed here to show the utility of this technique. It should be noted that both works took advantage of resonance Raman spectroscopy to detect Raman signals using low laser power. [Pg.182]


See other pages where Resonance Raman spectroscopy technique is mentioned: [Pg.177]    [Pg.177]    [Pg.11]    [Pg.136]    [Pg.124]    [Pg.286]    [Pg.37]    [Pg.150]    [Pg.151]    [Pg.464]    [Pg.13]    [Pg.390]    [Pg.197]    [Pg.136]    [Pg.49]    [Pg.233]    [Pg.236]    [Pg.465]    [Pg.601]    [Pg.101]    [Pg.623]    [Pg.156]    [Pg.1280]    [Pg.1312]    [Pg.61]    [Pg.75]    [Pg.705]    [Pg.368]    [Pg.285]    [Pg.424]    [Pg.440]    [Pg.453]    [Pg.428]    [Pg.579]    [Pg.231]    [Pg.424]    [Pg.33]    [Pg.388]    [Pg.219]   


SEARCH



Raman techniques

Resonance Raman

Resonant Raman spectroscopy

Spectroscopy techniques

© 2024 chempedia.info