Phosphites phenyl

N-Phenyidiethanolamine. See Phenyidiethanolamine 1-Phenyl-3-(0,0-diethyl-thionophosphoryl)-1,2,4-triazole. See Triazophos Phenyl diisodecyl phosphite. See Diisodecylphenyl phosphite Phenyl dimethicone CAS 9005-12-3... 

The cyclometallation occurs at the phosphite phenyl group to form a 5-membered ring rather than at an ortho-position of the triarylphosphine which would lead to a more-strained, 4-membered metallocyde. 

In addition to stabilisers, antioxidants and ultra-violent absorbers may also be added to PVC compounds. Amongst antioxidants, trisnonyl phenyl phosphite, mentioned previously, is interesting in that it appears to have additional functions such as a solubiliser or chelator for PVC insoluble metal chlorides formed by reaction of PVC degradation products with metal stabilisers. Since oxidation is both a degradation reaction in its own right and may also accelerate the rate of dehydrochlorination, the use of antioxidants can be beneficial. In addition to the phenyl phosphites, hindered phenols such as octadecyl 3-(3,5-di-tcrt-butyl-4-hydroxyphenyI)propionate and 2,4,6-tris (2,5-di-rcrt-butyl-4-hydroxybenzyl)-1,3,5-trimethylbenzene may be used. 

More surprising, in view of its poor electrophilic character, is that phcnylnitrene, generated by deoxygenation of nitroso benzene with triethyl phosphite in a mixture of benzene and 2,2,2-trifluoroethanol, yields 1-phenyl-1//-azepine (26), a rare example of a stable 1-aryl-lH-azepine.170... 

Generation of phenylnitrcne by thermal decomposition of phenyl azide in the same solvent mixture, or by deoxygenation of nitrosobenzene with triethyl phosphite in the absence of the trifluoroethanol, fails to yield the 1//-azepine. The role of the alcohol in promoting l//-azepine formation is not understood. 

Ethyl 1 -phenyl-1,8b-dihydroazirino[2,l- ]isoquinoline-3-carboxylate (2), obtained by decomposition of azide 1 (see Section 3.2.1.1.1.1.) in the presence of triethyl phosphite, on heating under reflux in toluene, rearranges quantitatively to the 3//-3-benzazepine 3.82... 

P-coupling occurs in the formation of azophosphonic esters [ArN2PO(OCH3)2] from diazonium salts and dimethyl phosphite [HPO(OCH3)2] (Suckfull and Hau-brich, 1958). P-coupled intermediates are formed in the reaction between diazonium salts and tertiary phosphines, studied by Horner and Stohr (1953), and by Horner and Hoffmann (1956). The P-azo compound is hydrolyzed to triphenylphosphine oxide, but if a second equivalent of the tertiary phosphine is available, phenyl-hydrazine is finally obtained along with the phosphine oxide (Scheme 6-26 Horner and Hoffmann, 1958). It is likely that an aryldiazene (ArN = NH) is an intermediate in the hydrolysis step of the P-azo compounds. 

When excess amounts of the HHT of phenyl glycinate 42 were used with diphenyl phosphite, the preferred product was the novel cyclic derivative 45 (2). Presumably, ring-opening of the HHT produced intermediate 43 first, which lost an equivalent of glycinate formaldimine to give 44. The proximity of the activated phenyl carboxylate ester to the N-H in 44 presumably promoted intramolecular cyclization to 45 with loss of phenol (2). 

Many other examples have been prepared (2) from the corresponding aminomethyl heterocycles using the very versatile reaction between HHTs and diaryl phosphites, as demonstrated specifically above for the 5-phenyl-l,3,4-oxadiazole system. Conversion of the 2-aminomethyl-l,3,4-oxadiazole 68 to the required HHT intermediate 69 was accomplished... 

Potassium cyanide, 56, 20 Potassium diethyl phosphite, 58, 135, 138 Potassium 1,1,1,3,3,3-hexafluoro-2-phenyl-... 

Alkyldimethylphosphine-boranes 74 underwent enantioselective deprotonation employing (-)-sparteine/s-BuLi, followed by oxidation with molecular oxygen [91, 92] in the presence of triethyl phosphite (Scheme 12) to afford moderate yields of enantiomerically enriched alkyl(hydroxymethyl)methylphosphine-bo-ranes 76, with 91-93% ee in the case of a bulky alkyl group and 75-81% ee in the case of cyclohexyl or phenyl groups [93]. Except for the adamantyl derivative (in which the ee increased to 99%), no major improvement in the ee was observed after recrystallization. 

The 4-thiazolidinyl phosphonates 143 (Scheme 44) are known for their therapeutical properties, in particular as anti-inflammatory agents [5,89]. Their asymmetric synthesis by hydrophosphonylation of 3-thiazolines has been described using various chiral auxiliaries chiral phosphites such as (2S,4i )-2H-2-oxo-5,5-dimethyl-4-phenyl-l,3,2-dioxaphosphorinane (de = 2-8%) [90] or BINOL-phos-phite (de = 65-90%) [91] and also chiral catalyst such as titanium or lanthanide chiral complexes (ee = 29-98%) [92]. Hydrophosphonylation of C2-chiral3-thi-azolines has also been performed (de = 32-38%) [93]. 

Simpson and Burt have studied the same reactions in the presence of various amounts of ethanol and have plotted graphs of phosphonate (81 R = Ph) and phenyl acetylene produced against moles of alcohol added. Acetylene in the product reached a maximum (around 60%) when two moles of ethanol were added and stayed fairly constant beyond this, which suggests that the attack-on-halogen contribution to the mechanism is approximately 60%. The rest of the reaction presumably follows some other mechanism and the authors suggest the addition-elimination route (79) in view of the isolation of the phosphonate (83) from the reaction of tri(isopropyl) phosphite with the bromoacetylene (84). 

Similar results were obtained from a study of 2-phenyl-5-t-butyl-l,3 2-dioxaphosphorinane (111) in that the cw-isomer was thermodynamically more stable than the trans. However, in this case even the trans-isomer adopts a conformation (112) with the P-phenyl group and, perforce, the t-butyl group axial. A similar situation has already been noted in the phosphite (108), and it may be that the special case of a phenyl group produces some type of pseudo anomeric effect. 

Stabilisers are usually determined by a time-consuming extraction from the polymer, followed by an IR or UV spectrophotometric measurement on the extract. Most stabilisers are complex aromatic compounds which exhibit intense UV absorption and therefore should show luminescence in many cases. The fluorescence emission spectra of Irgafos 168 and its phosphate degradation product, recorded in hexane at an excitation wavelength of 270 nm, are not spectrally distinct. However, the fluorescence quantum yield of the phosphate greatly exceeds that of the phosphite and this difference may enable quantitation of the phosphate concentration [150]. The application of emission spectroscopy to additive analysis was illustrated for Nonox Cl (/V./V -di-/i-naphthyl-p-phcnylene-diamine) [149] with fluorescence ex/em peaks at 392/490 nm and phosphorescence ex/em at 382/516 nm. Parker and Barnes [151] have reported the use of fluorescence for the determination of V-phenyl-l-naphthylamine and N-phenyl-2-naphthylamine in extracted vulcanised rubber. While pine tar and other additives in the rubber seriously interfered with the absorption spectrophotometric method this was not the case with the fluoromet-ric method. 

Schrader prepared the ester (38) in 60% yield by reaction of sodium p-nitrophenate with diethyl chlorophosphate, using xylene as solvent for the reaction. He made it, but in lower yields, from p-nitrophenol and diethyl chlorophosphate, using, respectively, pyridine and sodium cyanide as acceptors for hydrogen chloride. Schrader also prepared it in 96% yield by nitrating diethyl phenyl phosphate at 0° C. or below. Under the conditions he used, Schrader claims that the nitro group is directed to the para position. No yield is given for the diethyl phenyl phosphate, which he presumably made from sodium phenate and diethyl chlorophosphate. Diethyl chlorophosphate may be prepared in high yield (30) from diethyl phosphite and chlorine. 

Chiral thioureas have been synthesized and used as ligands for the asymmetric hydroformylation of styrene catalyzed by rhodium(I) complexes. The best results were obtained with /V-phenyl-TV -OS )-(l-phenylethyl)thiourea associated with a cationic rhodium(I) precursor, and asymmetric induction of 40% was then achieved.387,388 Chiral polyether-phosphite ligands derived from (5)-binaphthol were prepared and combined with [Rh(cod)2]BF4. These systems showed high activity, chemo- and regio-selectivity for the catalytic enantioselective hydroformylation of styrene in thermoregulated phase-transfer conditions. Ee values of up to 25% were obtained and recycling was possible without loss of enantioselectivity.389... 

Electrophilic substitution of the ring hydrogen atom in 1,3,4-oxadiazoles is uncommon. In contrast, several reactions of electrophiles with C-linked substituents of 1,3,4-oxadiazole have been reported. 2,5-Diaryl-l,3,4-oxadiazoles are bromi-nated and nitrated on aryl substituents. Oxidation of 2,5-ditolyl-l,3,4-oxadiazole afforded the corresponding dialdehydes or dicarboxylic acids. 2-Methyl-5-phenyl-l,3,4-oxadiazole treated with butyllithium and then with isoamyl nitrite yielded the oxime of 5-phenyl-l,3,4-oxadiazol-2-carbaldehyde. 2-Chloromethyl-5-phenyl-l,3,4-oxadiazole under the action of sulfur and methyl iodide followed by amines affords the respective thioamides. 2-Chloromethyl-5-methyl-l,3,4-oxadia-zole and triethyl phosphite gave a product, which underwent a Wittig reation with aromatic aldehydes to form alkenes. Alkyl l,3,4-oxadiazole-2-carboxylates undergo typical reactions with ammonia, amines, and hydrazines to afford amides or hydrazides. It has been shown that 5-amino-l,3,4-oxadiazole-2-carboxylic acids and their esters decarboxylate. 

Rose and Lepper found that phosphites, especially o-substituted phenyl phosphites, enhance the catalytic activity of Pd(acac)2 or Pd(OAc)2 and affect the ratio of 47 to 48 (52). When Pd(OAc)2 and PPh3 (1 1) were used at 50°C for 1.5 hours, the yield was 20% and the ratio of 47 to 48 was... 

Preparation of 2,2,2-trimethoxy-3-phenyl-4-acetyl-5-methyl-A4-oxaphospholene — Preparation of an oxyphosphorane by reaction of a trialkyl phosphite with an a,(l-unsaturated carbonyl compound... 

Trimethyl phosphite (11.3 g, 0.091 mol) was added to a solution of 3-benzylidene-2,4-pentanedione (16.35 g, 0.091 mol) in dry methylene chloride. The solution was maintained under nitrogen for 24 h at 20°C and for an additional 5 h at 40°C. After this time, the solvent was evaporated, and the residue was dissolved in hexane. These actions were performed in the absence of moisture. The clear hexane solution was seeded with a crystal of the pure crystalline product (obtained by crystallization from hexane by standing for 2 weeks at 0°C), and after 8 h at 0°C the crystals precipitated yielding pure 2,2,2-tri-methoxy-3-phenyl-4-acetyl-5-methyl-A4-oxaphospholene (25.12 g, 88.4%) of mp 48-51°C. 

E)-2-Chlorovinyl phenyl ketone (1.83 g, 11 mmol) and triisopropyl phosphite (2.08 g, 10 mmol) were heated under an argon atmosphere for 1 h at 120 to 130°C. When all of the isopropyl chloride formed had distilled, the residue was chromatographed on a column of silica gel (18 g) being eluted with a 1 1 mixture of methylene chloride-ethyl acetate. The eluent was evaporated of solvent and the residue vacuum distilled to give pure diisopropyl (E)-2-benzoylvinylphosphonate (1.33 g, 45%). 

Plumb, J.B., Obrycki, R., and Griffith, C.E., Phosphonic acids and esters. XVI. Formation of dialkyl phenylphosphonates by the photoinitiated phenylation of trialkyl phosphites, ]. Org. Chem., 31, 2455, 1966. 

---