Phases mixed-mode

Spikmans, V., Lane, S. J., Tjaden, U. R., and van der Greef, J., Automated capillary electrochromatography tandem mass spectrometry using mixed mode reversed phase ion-exchange chromatography columns, Rapid. Com-mun. Mass Spectrom., 13, 141, 1999. 

In reality, many proteins demonstrate mixed mode interactions (e.g., additional hydrophobic or silanol interactions) with a column, or multiple structural conformations that differentially interact with the sorbent. These nonideal interactions may distribute a component over multiple gradient steps, or over a wide elution range with a linear gradient. These behaviors may be mitigated by the addition of mobile phase modifiers (e.g., organic solvent, surfactants, and denaturants), and optimization (temperature, salt, pH, sample load) of separation conditions. 

There are a wide variety of three-phase fluidized bioreactor designs possible. The conventional reactor, shown in Fig. 9, is fluidized by both gas and liquid entering at the bottom of the reactor and leaving at the top and is the most common type of three-phase fluidized bed bioreactor. This reactor may be configured to operate with little axial liquid mixing or in a well-mixed mode by adding a recycle stream. The airlift reactor or draft tube fluidized bed reactor, Fig. 10, is also frequently used. In this reactor, gas is injected at the bottom of a draft tube placed in the center of the... 

The disc holder was machined to fit into the stainless steel flange in such a way that it directs the gas to consecutively sweep both faces of the catalyst disc, with an expansion volume in-between. This configuration provided good gas-phase mixing in the cell, thus allowing the reactor to be characterized as a CSTR. This mode of internal mixing eliminates the need for internal moving parts or external recycle loops and pumps. 

Mills and Thurman [105] studied the mixed mode isolation of Triazine metabolites from soils using automated solid phase extraction with methanohwater (4 lu/u) extracts of the sample. Methanol is evaporated from the extract and the metabolites are collected on an octadecyl resin (Cl8) column. The analytes are eluted with ethyl acetate leaving the impurities on the C18 resin column. The detection limit of this method is 0-lgg kg 1-... 

Ferguson et al. [18] reported on the application of a mixed-mode HPLC separation, coupled with ESI-MS for the comprehensive analysis of NPEOs and nonylphenol (NP) concentrations and distributions in sediment and sewage samples. The mixed-mode separation, which operates with both size-exclusion and reversed-phase mechanisms, allows the resolution of NPEO ethoxymers prior to introduction to... 

The mixed mode of sorption of the dye l,l -dioctadecyl-3,3,3, 3 -tetramethylindocar-bocyanine pechlorate (Dil) at the interface of an ODS stationary phase and ACN-water mobile phase was studied by single-molecule resolution and fluorescence imaging techniques. The measurements indicated that minimally four types of adsorption sites are present on the surface of the ODS stationary phase. The desorption times of the dye are different at the different adsorption sites resulting in a deformed peak shape [152],... 

Single-molecule resolution and fluorescence imaging were employed for the investigation of the mixed-mode adsorption of Dil at the interface of an ODS stationary phase and ACN-water mobile phase. It has been established that the increase in the... 

The cinchona alkaloid-based CSPs are actually mixed-mode RP/weak anion-exchange phases and HILICAVAX phases, respectively. The surface layer of these... 

Nogueira, R., Lubda, D., Leitner, A., Bicker, W, Maier, N.M., Lammerhofer, M., and Lindner, W, Silica-based monohthic columns with mixed-mode reversed-phase/weak anion-exchange selectivity principle for high-performance liquid chromatography, J. Sep. ScL, 29, 966, 2006. 

A pivotal step in the analytical process is sample preparation. Frequently liquid-liquid extractions (LLEs) are used. Solvents, pH, and multiple back extractions are all manipulated to increase selectivity and decrease unwanted contaminants before injection on the GC system. Solid phase extraction (SPE) is more convenient than it used to be because of an increase in commercially available SPE columns. SPE columns are packed with an inert material that binds the drug of interest, allowing impurities to pass through. As with LEE, solvent choices and pH affect retention and recovery. There are three commercially available types of SPE columns, diatomaceous earth (which uses the same principles as LLE), polystyrene-divinylbenzene copolymer, and mixed mode bonded silica (Franke and de Zeeuw, 1998). 

The recent development of mixed-mode stationary phases may provide new approaches for the separation of neuroactive steroids from biological matrices. These stationary phases typically embed a charged functional group within the nonpolar carbon chains typically employed in RP separations, and as such separations based on both RP and ion-exchange characteristics can be designed. Examples of this column type are the Primesep line of columns from SIELC Technologies. This separation approach maybe quite useful for the separation of steroid sulfates from complex mixtures. 

The CEC phases must be capable of carrying a charge to generate an EOE and appropriate moieties to facilitate the chromatographic processes. Silica-based reversed-phase packing materials have been most widely used in CEC. The use of polymeric and mixed-mode bonded particles has also been reported. Eor the silica-based phases, the carbon chains bonded on the silica surface provide the retention and selectivity for analytes, and the residual silanol groups on the surface of the silica are ionizable and generate the EOF. 

---