Periphery

In place of the FC crystallizer shown, any other type of crystallizer can also be used. Even multistage systems or systems with thermocompression (TVR) or with 

The suspension produced can be removed from the crystallizer through the overflow. If this is not possible for overriding reasons, the feed solution can also be added in a feed-controlled manner to the liquid level in the crystallizer. 

The concentration of the suspension density in the crystallizer is still too low for separating in a centrifuge. As mentioned in this chapter, the standard suspension densities in the crystallizers are 15-25% by mass, while centrifuges only begin to work ideally from a level of 50-60%. For this reason, the suspensions are initially preconcentrated in static prethickeners or in hydrocydones. The tail flow from this equipment is either removed from the process or partly returned to the crystallizer if dilution of the suspension that is being produced is required. In any case, part of the mother liquor has to be removed from the process in order to discharge the impurities that must not be contained in the crystallized mass from the process. 

As mentioned above, the crystallisation process is not finished with the crystallisation step itself. The created suspension still has to be separated, the crystals have to be dried and packed. The vapours are to be condensed and the non-condensable 

Instead of the FC-type crystalliser any other type of crystalliser can be installed. Also multiple-effect units can be taken. Or, instead of using steam for heating it could be decided for mechanical or thermal vapour re-compression. In this example the vapours from the (last) crystalliser are condensed in a 

---

Austenitic Steel weld has a well defined transcrystalline (oriented) macrostructure with continuously changing orientation of the crystal axis - from the periphery towards the centre the angle between the axis of the crystal and the axis of the weld is changed from 90 to 0 degrees. Weld metal eould be possible to approximate in the form of a discrete combination of crystals with parallel axes of the crystallites. 

A method that has been rather widely used involves the determination of the force to detach a ring or loop of wire from the surface of a liquid. It is generally attributed to du Noiiy [42]. As with all detachment methods, one supposes that a first approximation to the detachment force is given by the surface tension multiplied by the periphery of the surface detached. Thus, for a ring, as illustrated in Fig. II-ll,... 

Bikerman [182] criticized the derivation of Eq. X-18 out of concern for die ignored vertical component of On soft surfaces a circular ridge is raised at the periphery of a drop (see Ref. 67) on harder solids there is no visible effect, but the stress is there. It has been suggested that the contact angle is determined by the balance of surface stresses rather than one of surface free energies, the two not necessarily being the same for a... 

Annulene satisfies the Huckel (4n+2) tt electron rule for aromaticity and many of its proper ties indicate aromaticity (Section 11 20) As shown in Figure 13 10a [18]annulene contains two different kinds of protons 12 he on the ring s periphery ( out side ) and 6 reside near the middle of the molecule ( inside ) The 2 1 ratio of outside/inside protons makes it easy to assign the signals in the NMR spectrum The outside protons have a chemical shift 8 of 9 3 ppm which makes them even less shielded than those of benzene The six inside protons on the... 

Isomers are distinguished by lettering the peripheral sides of the parent beginning with a for the side 1,2, and so on, lettering every side around the periphery. If necessary for clarity, the numbers of the attached position (1,2, for example) of the substituent ring are also denoted. The prefixes are cited in alphabetical order. The numbers and letters are enclosed in square brackets and placed immediately after the designation of the attached component. Examples are... 

Water loss in operating an HDR faciUty may result from either increased storage within the body of the reservoir or diffusion into the rock body beyond the periphery of the reservoir (38). When a reservoir is created, the joints which are opened immediately fill with water. Micropores or microcracks may fill much more slowly, however. Figure 11 shows water consumption during an extended pressurization experiment at the HDR faciUty operated by the Los Alamos National Laboratory at Fenton Hill, New Mexico. As the microcracks within the reservoir become saturated, the water consumption at a set pressure declines. It does not go to zero because diffusion at the reservoir boundary can never be completely elirninated. Of course, if a reservoir joint should intersect a natural open fault, water losses may be high under any conditions. 

NUh2 is the Nusselt number for uniform heat flux boundary condition along the flow direction and periphery. 

Cyclo dextrin Molecular weight Solubihty in water, g/100 mL r 1 Diameter of cavity, nm Diameter of outer periphery, nm... 

Histamine AND histamine antagonists). It is formed from histidine by the enzyme L-histidine decarboxylase. In the periphery, histamine is stored ia mast cells, basophils, cells of the gastric mucosa, and epidermal cells. In the CNS, histamine is released from nerve cells and acts as a neurotransmitter. The actions of histamine ate terrninated by methylation and subsequent oxidation via the enzymes histamine-/V-methyltransferase and monoamine oxidase. 

Neuropeptide Y. Neuropeptide Y [82785 5-3] (NPY) (255) is a 36-amiao acid peptide that is a member of a peptide family including peptide YY (PYY) [81858-94-8, 106338-42-5] (256) and pancreatic polypeptide (PPY) [59763-91-6] (257). In the periphery, NPY is present in most sympathetic nerve fibers, particulady around blood vessels and also in noradrenergic perivascular and selected parasympathetic nerves (66). Neurons containing NPY-like immunoreactivity ate abundant in the central nervous system, particulady in limbic stmctures. Coexistence with somatostatin and NADPH-diaphorase, an enzyme associated with NO synthesis, is common in the cortex and striatum. 

CJ-Receptors are localized ia the brain stem and limbic stmcture, regions associated with endocrine function (76). In the periphery, CJ-receptors are found in the Hver, heart, ileum, vas deferens, and on lymphocytes and thymocytes. Although there is insufficient evidence to clearly define the functional role of CNS CJ-sites, based on the effects of PCP and the interaction of haloperidol with CJ-sites, CJ-receptor ligands may be antipsychotics or used for the treatment of substance abuse. Several CJ-receptor ligands have shown neuroprotective effects in vivo. Ifenprodil (315) and CNS 1102 (316) are being developed for treatment of stroke (Table 18). 

OT receptors are localized ia the brain hypothalamus, limbic system, cortex, striatum, olfactory system, and brain stem. In the periphery, OT is best known for its stimulation of uterine smooth muscle and the milk ejection reflex. Thr , Om ]oxytocin(l—8),... 

RoUer-top cards have five to seven sets of workers and strippers to mix and card the fibers carried on the cylinder. The multiple transferring action and re-introduction of new groupings of fibers to the carding zones provides a doubling effect which enhances web uniformity. Stationary-top cards have strips of metallic clothing mounted on plates positioned concavely around the upper periphery of the cylinder. The additional carding surfaces thus estabhshed provide expanded fiber alignment with minimum fiber extraction. 

Microfibrils are laid down as ribbons having their flat faces parallel to the cell periphery. HemiceUuloses and lignin are deposited between the microfibrils... 

Normal Stress (Weissenberg Effect). Many viscoelastic fluids flow in a direction normal (perpendicular) to the direction of shear stress in steady-state shear (21,90). Examples of the effect include flour dough climbing up a beater, polymer solutions climbing up the inner cylinder in a concentric cylinder viscometer, and paints forcing apart the cone and plate of a cone—plate viscometer. The normal stress effect has been put to practical use in certain screwless extmders designed in a cone—plate or plate—plate configuration, where the polymer enters at the periphery and exits at the axis. 

---