Perchlorates solubility

Chromium Perchlorate.—By dissolving chromium hydroxide in perchloric acid, and subsequent cautious evaporation, short green deliquescent needles of chromium perchlorate, soluble in alcohol, arc obtained. Two bluish-green perchlorates, probably derivatives of the hex-aquo base, [Cr(H20)e](0104)3 and [Cr(H20)6](C104)3.3lI 0, liave been described. ... 

Nitrated pitch Ammonium perchlorate Soluble glutinous... 

Solid Compounds. The tripositive actinide ions resemble tripositive lanthanide ions in their precipitation reactions (13,14,17,20,22). Tetrapositive actinide ions are similar in this respect to Ce . Thus the duorides and oxalates are insoluble in acid solution, and the nitrates, sulfates, perchlorates, and sulfides are all soluble. The tetrapositive actinide ions form insoluble iodates and various substituted arsenates even in rather strongly acid solution. The MO2 actinide ions can be precipitated as the potassium salt from strong carbonate solutions. In solutions containing a high concentration of sodium and acetate ions, the actinide ions form the insoluble crystalline salt NaM02(02CCH2)3. The hydroxides of all four ionic types are insoluble ... 

The precipitated acetyHde must be decomposed with hydrochloric acid after the titration as a safety measure. Concentrated solutions of silver nitrate or silver perchlorate form soluble complexes of silver acetyHde (89). Ammonia and hydrogen sulfide interfere with the silver nitrate method which is less... 

Perchlorates. Iron(II) perchlorate hexahydrate [13922-23-8], Fe(C10 2 6H20, is prepared by dissolving iron in cold, dilute perchloric acid or by dissolving FeS in perchloric acid. It crystallizes in hygroscopic, light green hexagonal prisms which are stable in dry air and extremely soluble (0.978 g/mL H2O at 0°C) in water and alcohol. It is susceptible to air oxidation in aqueous solution and decomposes above 100°C. Yellow iron(III) perchlorate... 

The chlorides, bromides, nitrates, bromates, and perchlorate salts ate soluble in water and, when the aqueous solutions evaporate, precipitate as hydrated crystalline salts. The acetates, iodates, and iodides ate somewhat less soluble. The sulfates ate sparingly soluble and ate unique in that they have a negative solubitity trend with increasing temperature. The oxides, sulfides, fluorides, carbonates, oxalates, and phosphates ate insoluble in water. The oxalate, which is important in the recovery of lanthanides from solutions, can be calcined directly to the oxide. This procedure is used both in analytical and industrial apptications. 

Chlorine heptoxide is more stable than either chlorine monoxide or chlorine dioxide however, the CX C) detonates when heated or subjected to shock. It melts at —91.5°C, bods at 80°C, has a molecular weight of 182.914, a heat of vapori2ation of 34.7 kj/mol (8.29 kcal/mol), and, at 0°C, a vapor pressure of 3.2 kPa (23.7 mm Hg) and a density of 1.86 g/mL (14,15). The infrared spectmm is consistent with the stmcture O CIOCIO (16). Cl O decomposes to chlorine and oxygen at low (0.2—10.7 kPa (1.5—80 mm Hg)) pressures and in a temperature range of 100—120°C (17). It is soluble in ben2ene, slowly attacking the solvent with water to form perchloric acid it also reacts with iodine to form iodine pentoxide and explodes on contact with a flame or by percussion. Reaction with olefins yields the impact-sensitive alkyl perchlorates (18). 

The silver perchlorate [7783-93-9] salt, AgClO, is dehquescent and forms a light-sensitive monohydrate that can be dehydrated at 43°C and is soluble in a variety of organic solvents. Explosions of silver perchlorate have been reported (40—42). Gold forms organic perchlorate [42774-61-8] complexes as well as complexes with silver, eg, (CgH )2AgAu(CgF )2C104. 

The quaHtative determination of water-soluble perchlorates by precipitation using methylene blue yields a violet precipitate (105). Using potassium, mbidium, or cesium salts for precipitation from ethanol—water solutions can serve as a quaHtative determination of perchlorates (106). 

Only three simple silver salts, ie, the fluoride, nitrate, and perchlorate, are soluble to the extent of at least one mole per Hter. Silver acetate, chlorate, nitrite, and sulfate are considered to be moderately soluble. AH other silver salts are, at most, spatingly soluble the sulfide is one of the most iasoluble salts known. SHver(I) also forms stable complexes with excess ammonia, cyanide, thiosulfate, and the haUdes. Complex formation often results ia the solubilization of otherwise iasoluble salts. Silver bromide and iodide are colored, although the respective ions are colorless. This is considered to be evidence of the partially covalent nature of these salts. 

Perhalates. Whereas silver perchlorate [7783-93-9] AgClO, and silver periodate [15606-77-6] AglO, are well known, silver perbromate [54494-97-2] AgBrO, has more recendy been described (18). Silver perchlorate is prepared from silver oxide and perchloric acid, or by treating silver sulfate with barium perchlorate. Silver perchlorate is one of the few silver salts that is appreciably soluble in organic solvents such as glycerol, toluene, and chlorobenzene. 

The Chilean nitrate deposits are located in the north of Chile, in a plateau between the coastal range and the Andes mountains, in the Atacama desert. These deposits are scattered across an area extending some 700 km in length, and ranging in width from a few kilometers to about 50 km. Most deposits are in areas of low rehef, about 1200 m above sea level. The nitrate ore, caUche, is a conglomerate of insoluble and barren material such as breccia, sands, and clays (qv), firmly cemented by soluble oxidized salts that are predominandy sulfates, nitrates, and chlorides of sodium, potassium, and magnesium. Cahche also contains significant quantities of borates, chromates, chlorates, perchlorates, and iodates. 

Oxo Ion Salts. Salts of 0x0 ions, eg, nitrate, sulfate, perchlorate, hydroxide, iodate, phosphate, and oxalate, are readily obtained from aqueous solution. Thorium nitrate is readily formed by dissolution of thorium hydroxide in nitric acid from which, depending on the pH of solution, crystalline Th(N02)4 5H20 [33088-17 ] or Th(N02)4 4H20 [33088-16-3] can be obtained (23). Thorium nitrate is very soluble in water and in a host of oxygen-containing organic solvents, including alcohols, ethers, esters, and ketones. Hydrated thorium sulfate, Th(S0 2 H20, where n = 9, 8, 6, or 4, is... 

Production of cellulose esters from aromatic acids has not been commercialized because of unfavorable economics. These esters are usually prepared from highly reactive regenerated cellulose, and their physical properties do not differ markedly from cellulose esters prepared from the more readily available aHphatic acids. Benzoate esters have been prepared from regenerated cellulose with benzoyl chloride in pyridine—nitrobenzene (27) or benzene (28). These benzoate esters are soluble in common organic solvents such as acetone or chloroform. Benzoate esters, as well as the nitrochloro-, and methoxy-substituted benzoates, have been prepared from cellulose with the appropriate aromatic acid and chloroacetic anhydride as the impelling agent and magnesium perchlorate as the catalyst (29). 

Other mixed esters, eg, cellulose acetate valerate [55962-79-3] cellulose propionate valerate [67351-41-17, and cellulose butyrate valerate [53568-56-2] have been prepared by the conventional anhydride sulfuric acid methods (25). Cellulose acetate isobutyrate [67351-38-6] (44) and cellulose propionate isobutyrate [67351-40-0] (45) have been prepared with a 2inc chloride catalyst. Large amounts of catalyst and anhydride are required to provide a soluble product, and special methods of delayed anhydride addition are necessary to produce mixed esters containing the acetate moiety. Mixtures of sulfuric acid and perchloric acid are claimed to be effective catalysts for the preparation of cellulose acetate propionate in dichi oromethane solution at relatively low temperatures (46) however, such acid mixtures are considered too corrosive for large-scale productions. 

The mixture of diastereomers has been separated into its two principal components by Izatt, Haymore, Bradshaw and Christensen who had previously identified the two principal diastereomers as the cis-syn-cis and cis-anti-cis isomers. Their previous separation technique involved a protracted chromatography on alumina but the new method relied upon the difference in water solubility between the lead perchlorate and hydroniur perchlorate complexes. The lead perchlorate complex is essentially insoluble in aqueous solution and precipitates from it. Using this method, one may obtain 39% of the high-melting polymorph (mp 83—84°) and 44% of the low-melting compound (mp 62—63°). Note that the former also exists in a second crystalline form, mp 69—70°. 

Muricinine, CijHj g02N(0Me)2. Isolated as the perchlorate, m.p. 206-8°. The base does not contain a dioxymethylene group, is soluble in alkalis and gives a green colour with ferric chloride. ... 

From a spurious angostura bark, Troger isolated an unnamed alkaloid, ( jjHjgOjNj, m.p. 167°, soluble in alkali or acid and giving a a ystallinc perchlorate and methiodide. 

First, mention should be made of the metathetical reaction, replacing an anion of a pyrylium salt by another-, when the solubility of the latter salt is lower than that of the former, the conversion is easy. In the opposite case, one has to find a solvent in which the solubilities are reversed (perchlorates are less soluble in water than chloroferrates or iodides, but in concentrated hydrochloric or hydroidic acids, respectively, the situation is reversed For preparing chlorides which are usually readily soluble salts, one can treat the less soluble chloroferrates with hydrogen sulfide or hydroxylamine. Another method is to obtain the pseudo base in an organic solvent and to treat it with an anhydrous acid. 

An interesting application of this reaction was the use of macro-molecular anhydrides, namely, styrene-maleic anhydride or vinyl acetate-maleic anhydride copolymers in the presence of perchloric acid as catalyst, these copolymers acylate mesityl oxide or d rpnone to macromolecular pyrylium salts which, with aryl substituents, are fluorescent.No crystalline products could be obtained from succinic anhydride because of the solubility and ease of decarboxylation. 

---