Nickel , oxidative addition

Other Specialty Chemicals. In fuel-ceU technology, nickel oxide cathodes have been demonstrated for the conversion of synthesis gas and the generation of electricity (199) (see Fuel cells). Nickel salts have been proposed as additions to water-flood tertiary cmde-oil recovery systems (see Petroleum, ENHANCED oil recovery). The salt forms nickel sulfide, which is an oxidation catalyst for H2S, and provides corrosion protection for downweU equipment. Sulfur-containing nickel complexes have been used to limit the oxidative deterioration of solvent-refined mineral oils (200). 

Dehalogenation of monochlorotoluenes can be readily effected with hydrogen and noble metal catalysts (34). Conversion of -chlorotoluene to Ncyanotoluene is accompHshed by reaction with tetraethyl ammonium cyanide and zero-valent Group (VIII) metal complexes, such as those of nickel or palladium (35). The reaction proceeds by initial oxidative addition of the aryl haHde to the zerovalent metal complex, followed by attack of cyanide ion on the metal and reductive elimination of the aryl cyanide. Methylstyrene is prepared from -chlorotoluene by a vinylation reaction using ethylene as the reagent and a catalyst derived from zinc, a triarylphosphine, and a nickel salt (36). 

An effect which is frequently encountered in oxide catalysts is that of promoters on the activity. An example of this is the small addition of lidrium oxide, Li20 which promotes, or increases, the catalytic activity of dre alkaline earth oxide BaO. Although little is known about the exact role of lithium on the surface structure of BaO, it would seem plausible that this effect is due to the introduction of more oxygen vacancies on the surface. This effect is well known in the chemistry of solid oxides. For example, the addition of lithium oxide to nickel oxide, in which a solid solution is formed, causes an increase in the concentration of dre major point defect which is the Ni + ion. Since the valency of dre cation in dre alkaline earth oxides can only take the value two the incorporation of lithium oxide in solid solution can only lead to oxygen vacaircy formation. Schematic equations for the two processes are... 

In all of these oxide phases it is possible that departures from the simple stoichiometric composition occur dirough variation of the charges of some of the cationic species. Furthermore, if a cation is raised to a higher oxidation state, by the addition of oxygen to tire lattice, a conesponding number of vacant cation sites must be formed to compensate tire structure. Thus in nickel oxide NiO, which at stoichiomen ic composition has only Ni + cations, oxidation leads to Ni + ion formation to counterbalance the addition of extra oxide ions. At the same time vacant sites must be added to the cation lattice to retain dre NaCl sUmcture. This balanced process can be described by a normal chemical equation thus... 

Perfluoroalkyl or -aryl halides undergo oxidative addition with metal vapors to form nonsolvated fluonnated organometallic halides and this topic has been die subject of a review [289] Pentafluorophenyl halides react with Rieke nickel, cobalt, and iron to give bispentafluorophenylmetal compounds, which can be isolated in good yields as liquid complexes [290] Rieke nickel can also be used to promote the reaction of pentafluorophenyl halides with acid halides [297] (equation 193)... 

The transition from non-protective internal oxidation to the formation of a protective external alumina layer on nickel aluminium alloys at 1 000-1 300°C was studied by Hindam and Smeltzer . Addition of 2% A1 led to an increase in the oxidation rate compared with pure nickel, and the development of a duplex scale of aluminium-doped nickel oxide and the nickel aluminate spinel with rod-like internal oxide of alumina. During the early stages of oxidation of a 6% A1 alloy somewhat irreproducible behaviour was observed while the a-alumina layer developed by the coalescence of the rodlike internal precipitates and lateral diffusion of aluminium. At a lower temperature (800°C) Stott and Wood observed that the rate of oxidation was reduced by the addition of 0-5-4% A1 which they attributed to the blocking action of internal precipitates accumulating at the scale/alloy interface. At higher temperatures up to 1 200°C, however, an increase in the oxidation rate was observed due to aluminium doping of the nickel oxide and the inability to establish a healing layer of alumina. 

A plausible mechanism accounting for the catalytic role of nickel(n) chloride has been advanced (see Scheme 4).10 The process may be initiated by reduction of nickel(n) chloride to nickel(o) by two equivalents of chromium(n) chloride, followed by oxidative addition of the vinyl iodide (or related substrate) to give a vinyl nickel(n) reagent. The latter species may then undergo transmetala-tion with a chromium(m) salt leading to a vinyl chromium(m) reagent which then reacts with the aldehyde. The nickel(n) produced in the oxidative addition step reenters the catalytic cycle. 

The catalytic activity of doped nickel oxide on the solid state decomposition of CsN3 decreased [714] in the sequence NiO(l% Li) > NiO > NiO(l% Cr) > uncatalyzed reaction. While these results are in qualitative accordance with the assumption that the additive provided electron traps, further observations, showing that ZnO (an rc-type semi-conductor) inhibited the reaction and that CdO (also an rc-type semi-conductor) catalyzed the reaction, were not consistent with this explanation. It was noted, however, that both NiO and CdO could be reduced by the product caesium metal, whereas ZnO is not, and that the reaction with NiO yielded caesium oxide, which is identified as the active catalyst. Detailed kinetic data for these rate processes are not available but the pattern of behaviour described clearly demonstrates that the interface reactions were more complicated than had been anticipated. 

Although, as has already been mentioned, under matrix conditions between 10 and 77 K, there is no oxidative addition of a chloroolefin to nickel or palladium atoms (141), it is evident that this is simply a function of reaction and processing conditions, as it has been shown (68) that oxidative addition to C-C or C-H bonds by nickel atoms leads to pseudocomplexes having Ni C H ratios of 2-5 1 2. Klabunde and co-workers investigated the oxidative addition-reactions of palladium atoms with alkyl halides (73) and benzyl chlorides (74). 

This cycle involves, first, a monoelectronic transfer from the nickel (0) complex to the aryl halide affording a Ni(I) complex and then an oxidative addition affording a 16 electron-nickel (II) which undergoes a nucleophilic substitution of Nu-, then a monoelectronic transfer occurs once again with a second aryl halide, and, last, a reductive elimination of the arylated nucleophile regenerates the active Ni(I) species. 

The bipyridyl ligand, with 80 %, gives the best catalyst, probably because it affords the best balance between the a-donor and rt-acceptor characters which favours respectively the oxidative addition of the aryl bromide and the reductive elimination of the aryl ether at the nickel center. 

Substantially more work has been done on reactions of square-planar nickel, palladium, and platinum alkyl and aryl complexes with isocyanides. A communication by Otsuka et al. (108) described the initial work in this area. These workers carried out oxidative addition reactions with Ni(CNBu )4 and with [Pd(CNBu )2] (. In a reaction of the latter compound with methyl iodide the complex, Pd(CNBu )2(CH3)I, stable as a solid but unstable in solution, was obtained. This complex when dissolved in toluene proceeds through an intermediate believed to be dimeric, which then reacts with an additional ligand L (CNBu or PPh3) to give PdL(CNBu )- C(CH3)=NBu I [Eq. (7)]. 

Scheme 4 Oxidative-addition of NCAs to zerovalent cobalt and nickel complexes...

In 1977, Fahey and Mahan described the first C-F oxidative addition of hexafluo-robenzene (C ) to the zerovalent nickel complex [Ni(cod)(PEt3)j] [11], The reaction was very slow and led, after several days at 30-35°C, to the formation of trani-[Ni(CgF3)(F)(PEt3)2] in very poor yield (7%). The use of [NiCPEtj) ] for the same reaction by Perutz and co-workers 20 years later allowed for a better conversion but the reaction rate remained slow (4 weeks were necessary to obtain 48% of the desired product) [12],... 

By oxidative addition of aryl sulphides to low-valent nickel complexes, a C—S bond cleavage occurs to form Ni11 thiolate complexes. For example, exposure of diaryl sulphides to [(But3P)3Ni0] leads to oxidative addition, with nickel inserting into the C—S bond (280).814... 

Presence of 5% of copper(II) chloride caused explosion to occur at 170°C [1]. Of the series of additives copper chromite, copper chloride, nickel oxide, iron oxide, magnesium oxide, the earlier members have the greatest effect in increasing the sensitivity of the perchlorate to heat, impact and friction. 

Initially we tried the standard approach, reduction of NiL, NiB, or NiC with 2.0 equivalents of potassium in refluxing THF. Finely divided black nickel powders were obtained however, they showed rather limited reactivity toward oxidative addition with carbon-halogen bonds. Similar results were found for palladium and platinum. 

However, when the reductions were carried out with lithium and a catalytic amount of naphthalene as an electron carrier, far different results were obtained(36-39, 43-48). Using this approach a highly reactive form of finely divided nickel resulted. It should be pointed out that with the electron carrier approach the reductions can be conveniently monitored, for when the reductions are complete the solutions turn green from the buildup of lithium naphthalide. It was determined that 2.2 to 2.3 equivalents of lithium were required to reach complete reduction of Ni(+2) salts. It is also significant to point out that ESCA studies on the nickel powders produced from reductions using 2.0 equivalents of potassium showed considerable amounts of Ni(+2) on the metal surface. In contrast, little Ni(+2) was observed on the surface of the nickel powders generated by reductions using 2.3 equivalents of lithium. While it is only speculation, our interpretation of these results is that the absorption of the Ni(+2) ions on the nickel surface in effect raised the work function of the nickel and rendered it ineffective towards oxidative addition reactions. An alternative explanation is that the Ni(+2) ions were simply adsorbed on the active sites of the nickel surface. 

There are few reports of oxidative addition to zerovalent transition metals under mild conditions three reports involving group 10 elements have appeared. Fischer and Burger reported the preparation of aTT -allylpalladium complex by the reaction of palladium sponge with allyl bromide(63). The Grignard-type addition of allyl halides to aldehydes has been carried out by reacting allylic halides with cobalt or nickel metal prepared by reduction of cobalt or nickel halides with manganese/iron alloy-thiourea(64). 

Klabunde has reported limited reactivity toward oxidative addition reactions of carbon halogen bonds with nickel slurries prepared by the metal vaporization technique(65). 

The activated nickel powder is easily prepared by stirring a 1 2.3 mixture of NiL and lithium metal under argon with a catalytic amount of naphthalene (1(7 mole % based on nickel halide) at room temperature for 12 h in DME. The resulting black slurry slowly settles after stirring is stopped and the solvent can be removed via cannula if desired. Washing with fresh DME will remove the naphthalene as well as most of the lithium salts. For most of the nickel chemistry described below, these substances did not affect the reactions and hence they were not removed. The activated nickel slurries were found to undergo oxidative addition with a wide variety of aryl, vinyl, and many alkyl carbon halogen bonds. 

The present reaction may be reasonably explained by the smooth oxidative addition of aryl halides to metallic nickel to give aryl nickel halides, followed by disproportionation to bisarylnickels, which upon reductive elimination afford the dehalogenative coupled products. Providing strong support for this mechanism, the intermediates, arylnickel halide and bisarylnickel (Ar=C F ), were isolated as the phosphine complexes. 

---