Alkylation carbon

Silyl enol ethers are other ketone or aldehyde enolate equivalents and react with allyl carbonate to give allyl ketones or aldehydes 13,300. The transme-tallation of the 7r-allylpalladium methoxide, formed from allyl alkyl carbonate, with the silyl enol ether 464 forms the palladium enolate 465, which undergoes reductive elimination to afford the allyl ketone or aldehyde 466. For this reaction, neither fluoride anion nor a Lewis acid is necessary for the activation of silyl enol ethers. The reaction also proceed.s with metallic Pd supported on silica by a special method[301j. The ketene silyl acetal 467 derived from esters or lactones also reacts with allyl carbonates, affording allylated esters or lactones by using dppe as a ligand[302]... 

Substituents on both sides of the double bond are considered separately. Additional vinyl carbons are treated as if they were alkyl carbons. The method is applicable to alicyclic alkenes in small rings carbons are counted twice, i.e., from both sides of the double bond where applicable. The constant in the equation is the chemical shift for ethylene. The effect of other substituent groups is tabulated below. 

Dialkyl peroxydicarboaates are used primarily as free-radical iaitiators for viayl monomer po1ymeri2ations (18,208). Dialkyl peroxydicarboaate decompositioas are accelerated by certaia metals, coaceatrated sulfuric acid, and amines (44). Violent decompositions can occur with neat or highly concentrated peroxides. As with most peroxides, they Hberate iodine from acidified iodides. In the presence of copper ions and suitable substrates, dialkyl peroxydicarbonates have been used to synthesi2e alkyl carbonates (44) ... 

Carbon Substituents. Alkyl groups at positions 2 and 4 of a pyridine ring are more reactive than either those at the 3-position of a pyridine ring or those attached to a benzene ring. Carbanions can be formed readily at alkyl carbons attached at the 2- and 4-positions. This increased chemical reactivity has been used to form 2- and 4-(phenylpropyl)pyridines, eg, 4-(3-phenylpropyl)pyridine [2057-49-0] (21) (24). 

The physical properties of selected carbonates are given in Table 7. The lower alkyl carbonates are neutral, colodess Hquids with a mild sweet odor. Aryl carbonates are normally soHds. 

Reaction with Water. The alkyl carbonate esters, especially the lower ones, hydroly2e very slowly in water when compared to the carbonochloridic esters (chloroformates). Under alkaline conditions, the rates of hydrolysis are similar to those of the corresponding acetic acid esters. 

N-Alkylations, especially of oxo-di- and tetra-hydro derivatives, e.g. (28)->(29), have been carried out readily using a variety of reagents such as (usual) alkyl halide/alkali, alkyl sulfate/alkali, alkyl halide, tosylate or sulfate/NaH, trialkyloxonium fluoroborate and other Meerwein-type reagents, alcohols/DCCI, diazoalkanes, alkyl carbonates, oxalates or malon-ates, oxosulfonium ylides, DMF dimethyl acetal, and triethyl orthoformate/AcjO. Also used have been alkyl halide/lithium diisopropylamide and in one case benzyl chloride on the thallium derivative. In neutral conditions 8-alkylation is observed and preparation of some 8-nucleosides has also been reported (78JOC828, 77JOC997, 72JOC3975, 72JOC3980). 

Halide ions may attack 5-substituted thiiranium ions at three sites the sulfur atom (Section 5.06.3.4.5), a ring carbon atom or an 5-alkyl carbon atom. In the highly sterically hindered salt (46) attack occurs only on sulfur (Scheme 62) or the S-methyl group (Scheme 89). The demethylation of (46) by bromide and chloride ion is the only example of attack on the carbon atom of the sulfur substituent in any thiiranium salt (78CC630). Iodide and fluoride ion (the latter in the presence of a crown ether) prefer to attack the sulfur atom of (46). cis-l-Methyl-2,3-di-t-butylthiiranium fluorosulfonate, despite being somewhat hindered, nevertheless is attacked at a ring carbon atom by chloride and bromide ions. The trans isomer could not be prepared its behavior to nucleophiles is therefore unknown (74JA3146). 

Table 2.3 shows very obvious parallels with the TMS scale of C shifts. Thus, the shifts (Table 2.3) decrease in size in the sequence nitroso, nitro, imino, amino, following the corresponding behaviour of the shifts of carbonyl, carboxy, alkenyl and alkyl carbon atoms (Table 2.2). 

Tackifiers. Phenolic resins are added to increase strength, oils resistance and resiliency of NBR adhesives. On the other hand, tack and adhesive properties can be improved by adding chlorinated alkyl carbonates. To impart tack, hydrogenated rosin resins and coumarone-indene resins can be added. 

While the initial surface species formed on lithium in alkyl carbonates consist of ROC02Li compounds, these species react with water to form Li,CO, C02, and ROH. This reaction gradually changes the composition of the surface films formed on... 

For example, the reaction enthalpy for the reduction of PC proceeding at lithium amalgam to form propylene gas and lithium carbonate is estimated to be -I41kcal (molPC)-1 [149]. PC is reduced at noble-metal electrodes at potentials below 1.5 V vs. Li, and yields lithium alkyl carbonates when lithium salts are the supporting electrolytes. Reduction occurs at 0.7-0.8 V vs. Li with Bu4NC104as supporting electrolyte [150],... 

Kinetic stability of lithium and the lithiated carbons results from film formation which yields protective layers on lithium or on the surfaces of carbonaceous materials, able to conduct lithium ions and to prevent the electrolyte from continuously being reduced film formation at the Li/PC interphase by the reductive decomposition of PC or EC/DMC yielding alkyl-carbonates passivates lithium, in contrast to the situation with DEC where lithium is dissolved to form lithium ethylcarbonate [149]. EMC is superior to DMC as a single solvent, due to better surface film properties at the carbon electrode [151]. However, the quality of films can be increased further by using the mixed solvent EMC/EC, in contrast to the recently proposed solvent methyl propyl carbonate (MPC) which may be used as a single sol-... 

Li PC / LiAsF6 FTIR, XPS, IR alkyl carbonates, Li2C03 (from water), LiF [149]... 

In contrast to DEC/LiC104 solutions, where typical reaction products of carbonate solvents including alkyl carbonates, alkoxides, and Li2C03 are formed at the lithium surface, DEC/LiPF6 solutions yield LiF and Li20 only [168]. 

Nucleophilic substitution at an alkyl carbon is said to alkylate the nucleophile. For example, the above reaction between RI and NMe3 is an alkylation of tri-methylamine. Similarly, nucleophilic substitution at an acyl carbon is an acylation of the nucleophile. 

A. Attack by NH2, NHR, or NR2 at an Alkyl Carbon 10-44 Alkylation Of Amines Amino-de-halogenation (alkyl)... 

Hydrogen as Leaving Group A. Substitution by Haiogen 14-1 Halogenation at an Alkyl Carbon Halogenation or Halo-de-hydrogenation... 

This was also accomplished with BaRu(0)2(OH)3. The same type of conversion, with lower yields (20-30%), has been achieved with the Gif system There are several variations. One consists of pyridine-acetic acid, with H2O2 as oxidizing agent and tris(picolinato)iron(III) as catalyst. Other Gif systems use O2 as oxidizing agent and zinc as a reductant. The selectivity of the Gif systems toward alkyl carbons is CH2 > CH > CH3, which is unusual, and shows that a simple free-radical mechanism (see p. 899) is not involved. ° Another reagent that can oxidize the CH2 of an alkane is methyl(trifluoromethyl)dioxirane, but this produces CH—OH more often than C=0 (see 14-4). ... 

---