Magnesium excess

Important chemical characteristics of the soil include the total exchange capacity for cations, expressed as total meq of cations per 100 gm of soil, and the base status, which is the percentage saturation of the negative charge with cations such as calcium, magnesium and sodium. The more productive soils are about 80% saturated with calcium and magnesium. Excessive hydrogen and aluminum saturation (much over 15%) is termed soil acidity. Excess sodium saturation (12% or more) leads to dispersiveness of the soil and poor productivity. 

Resting on the top of the crucible is an Inconel can charged with raw ZrCU. The total amount of ZrCU charged here and possibly present on the air-cooling coils from a previous run is 236 kg, an amount that provides a magnesium excess of 10 or 15 percent for the reduction reaction... 

The most frequent cause of hypermagnesemia is renal failure, particularly with the intake of medications containing magnesium. Elderly patients are at particular risk for magnesium excess owing to decreased renal function and a tendency for increased laxative and antacid use in this population. 2 Medications with high levels of magnesium include... 

Magnesium excess affects the central nervous system (CNS) and neuromuscular and cardiac systems. People who have hypermagnesemia usually have diarrhea, may feel flushed and drowsy, and perspire profusely. Vomiting, weakness, diminished... 

If an excess of magnesium is used, magnesium silicide, Mg2Si, is also produced.) The silicon obtained is a light brown hygroscopic powder. Crystalline or metallic silicon is obtained industrially by the reduction of silica with carbon in an electric arc furnace ... 

The precautions stated are to avoid uptake of oxygen, nitrogen and other impurities which render the metal brittle the excess magnesium and magnesium chloride can be removed by volatilisation above 1300 K. 

Reaction (1) usually proceeds readily provided the magnesium is activated with iodine and the water content does not exceed one per cent. Subsequent interaction between the magnesium ethoxide and water gives the highly insoluble magnesium hydroxide only a slight excess of magnesium is therefore necessary. 

Formamide. Commercial formamide may contain excess of formic acid. It is purified by passing ammonia gas into the mixture until a slight alkaline reaction is obtained. The ammonium formate thus formed is precipitated by the addition of acetone the filtrate, after drying over anhydrous magnesium sulphate, is distilled under reduced pressure. Pure formamide has b.p. IO571I mm. 

Prepare a Grignard reagent from 24 -5 g. of magnesium turnings, 179 g. (157 ml.) of n-heptyl bromide (Section 111,37), and 300 ml. of di-n-butyl ether (1). Cool the solution to 0° and, with vigorous stirring, add an excess of ethylene oxide. Maintain the temperature at 0° for 1 hour after the ethylene oxide has been introduced, then allow the temperature to rise to 40° and maintain the mixture at this temperature for 1 hour. Finally heat the mixture on a water bath for 2 hours. Decompose the addition product and isolate the alcohol according to the procedure for n-hexyl alcohol (Section 111,18) the addition of benzene is unnecessary. Collect the n-nonyl alcohol at 95-100°/12 mm. The yield is 95 g. 

Ethyl n-butyrate. Use a mixture of 88 g. (92 ml.) of n-butyric acid, 23 g. (29 ml.) of ethanol and 9 g. (5 ml.) of concentrated sulphuric acid. Reflux for 14 hours. Pour into excess of water, wash several times with water, followed by saturated sodium bicarbonate solution until all the acid is removed, and finally with water. Dry with anhydrous magnesium sulphate, and distU. The ethyl n-but3rrate passes over at 119 5-120-5°, Yield 40 g. An improved yield can be obtained by distilhng the reaction mixture through an efficient fractionating column until the temperature rises to 125°, and purifying the crude ester as detailed above under methyl acetate. 

Place 100 g. of adipic acid in a 750 ml. round-bottomed flask and add successively 100 g. (127 ml.) of absolute ethyl alcohol, 250 ml. of sodium-dried benzene and 40 g. (22 ml.) of concentrated sulphuric acid (the last-named cautiously and with gentle swirling of the contents of the flask). Attach a reflux condenser and reflux the mixture gently for 5-6 hours. Pour the reaction mixture into excess of water (2-3 volumes), separate the benzene layer (1), wash it with saturated sodium bicarbonate solution until eflfervescence ceases, then with water, and dry with anhydrous magnesium or calcium sulphate. Remove most of the benzene by distillation under normal pressure until the temperature rises to 100° using the apparatus of Fig. II, 13, 4 but substituting a 250 ml. Claisen flask for the distilling flask then distil under reduced pressure and collect the ethyl adipate at 134-135°/17 mm. The yield is 130 g. 

Add 4 0 g. (4 0 ml.) of pure anihne dropwise to a cold solution of ethyl magnesium bromide (or iodide) prepared from 1 Og. of magnesium, 5 0 g. (3-5 ml.) of ethyl bromide (or the equivalent quantity of ethyl iodide), and 30 ml. of pure, sodium-dried ether. When the vigorous evolution of ethane has ceased, introduce 0 02 mol of the ester in 10 ml. of anhydrous ether, and warm the mixture on a water bath for 10 minutes cool. Add dilute hydrochloric acid to dissolve the magnesium compounds and excess of aniline. Separate the ethereal layer, dry it with anhydrous magnesium sulphate and evaporate the ether. Recrystallise the residual anihde, which is obtained in almost quantitative yield, from dilute alcohol or other suitable solvent. 

Di lve 20 g. of the cyano ester in 100 ml. of rectified spirit and add a solution of 19 2 g. of pure potassium cyanide in 40 ml. of water. Allow to stand for 48 hours, then distil oflF the alcohol on a water bath. Add a large excess of concentrated hydrochloric acid and heat under reflux for 3 hours. Dilute with water, saturate the solution with ammonium sulphate, and extract with four 75 ml. portions of ether. Dry the combined ethereal extracts with anhydrous sodium or magnesium sulphate, and distil off the ether. RecrystaUise the residual acid from excess concentrated hydrochloric acid, and dry in the air. The yield of pure ew-dimethyl-succinic acid, m.p. 141-142°, is 12 g. 

The experimental details for mono-M-propylanillne are as follows. Reflux a mixture of 230 g. of aniline and 123 g. of n-propyl bromide for 8-10 hours. Allow to cool, render the mixture alkafine, and add a solution of 150 g. of zinc chloride in 150 g. of water. Cool the mixture and stir after 12 hours, filter at the pump and drain well. Extract the thick paste several times with boiling light petroleum, b.p. 60-80° (it is best to use a Soxhlet apparatus), wash the combined extracts successively with water and dilute ammonia solution, and then dry over anhydrous potassium carbonate or anhydrous magnesium sulphate. Remove the solvent on a water bath, and distil the residue from a Claisen flask with fractionating side arm (well lagged). Collect the n-propyl-aniline at 218-220° the yield is 80 g. Treat the pasty solid zincichloride with an excess of. sodium hydroxide solution and steam distil 130 g. of pure aniline are recovered. 

Make a thin paste of 21 5 g. of finely-powdered o-tolidine (a commercial product) with 300 ml. of water in a 1-litre beaker, add 25 g. (21 ml.) of concentrated hydrochloric acid, and warm until dissolved. Cool the solution to 10° with ice, stir mechanically, and add a further 25 g. (21 ml.) of concentrated hydrochloric acid (1) partial separation of o tolidine dihydrochloride will occur. Add a solution of 15 g, of sodium nitrite in 30 ml. of water as rapidly as possible, but keep the temperature below 15° a slight excess of nitrous acid is not harmful in this preparation. Add the clear, orange tetrazonium solution to 175 ml. of 30 per cent, hypophosphorous acid (2), and allow the mixture to stand, loosely stoppered, at room temperature for 16-18 hours. Transfer to a separatory funnel, and remove the upper red oily layer. Extract the aqueous layer with 50 ml, of benzene. Dry the combined upper layer and benzene extract with anhydrous magnesium sulphate, and remove the benzene by distillation (compare Fig. II, 13, 4) from a Widmer or similar flask (Figs. II, 24, 3-5) heat in an oil bath to 150° to ensure the removal of the last traces of benzene. Distil the residue at ca. 3 mm. pressure and a temperature of 155°. Collect the 3 3 -dimethyldiphenyl as a pale yellow liquid at 114-115°/3 mm. raise the bath temperature to about 170° when the temperature of the thermometer in the flask commences to fall. The yield is 14 g. 

Triturate 20 g. of dry o-toluidine hydrochloride and 35 5 g. of powdered iodine in a mortar and then grind in 17 -5 g. of precipitated calcium carbonate. Transfer the mixture to a conical flask, and add 100 ml. of distilled water with vigorous shaking of the flask. Allow the mixture to stand for 45 minutes with occasional agitation, then heat gradually to 60-70° for 5 minutes, and cool. Transfer the contents of the flask to a separatory funnel, extract the base with three 80 ml. portions of ether, diy the extract with anhydrous calcium chloride or magnesium sulphate, and remove the excess of solvent. The crude 5-iodo-2-aminotoluene separates in dark crystals. The yield is 32 g. Recrystallise from 50 per cent, alcohol nearly white crystals, m.p. 87°, are obtained. 

---