Lead enolates

Alternatively, the reaction may proceed through formation of a lead enolate derived from the enol followed by intramolecular rearrangement to the desired product (Scheme 2). It appears that the first and last mechanisms are operative, the product distribution reflecting a balance between the two dqiendent on temperature, solvent and substrate. In all three cases however the rate-determining step is the formation of the enol, a factor which heavily influences the choice of reaction conditions. 

Lead, like its neighbor tin, enjoys both the -t-2 and +4 oxidation state. In this case, Pb(II) is the normal metallic cation and the Pb(IV) state is rather unstable and very often oxidizing. As such, any species that might contain a bonded Pb(IV) and an enolate anion may mimic Pb(II) and an enoxyl cation. Metal-metal exchange reactions of lead enolates show both enolate and enoxyl cation behavior , depending on what is affixed to the metal. This quasi-enolate vs. enoxyl cation dichotomy is also seen for suitable mercury-and thallium-containing species. 

Section V.A.2). Lee and coworkers synthesized the alkoxyalkyl-substituted /3-diketonates Pb[RC(0)CHC(0)(CH2)30R ]2 (R = f-Bu, Me, OMe, i-Pr R = Me, Et), attempting to improve the volatility and stability of lead enolates . However, film growth experiments showed that these compounds are not volatile enough to give satisfactory deposition rates (100-200 Ah as compared to 1200 Ah for 23c). 

The reaction between ethyl Hthiopropiolate and the N-acylpyridinium salt formed by reaction of 4-methoxy-3-methyl-5-(triisopropylsilyl)pyridine 2363 with (+)-frafis-2-(a-cumyl)-cyclohexyl chloroformate (TCC chloro-formate) was the starting point in the synthesis of (-l-)-aUopumihotoxin 267A (1718) by Comins et al. (Scheme 301). The dihydropyridone product (—)- 2364 was obtained diastereoselectively (>96%) before hydrogenation to the saturated ester (+)-2365. However, some epimerization of the methyl substituent was apparent after cleavage of the TCC carbamate with lithium methoxide and cyclization to the indolizidinone (—)-2366 (dr 8 1). Acetoxylation at C-8 with lead tetraacetate was stereoselective, and introduced the acetate from the axial direction, possibly by stereoelec-tronicaUy-controUed intramolecular transfer of acetate from a lead—enol intermediate. The acetoxy product (—)-2367 was protodesilylated with formic acid, after which a one-pot tandem reduction with K-Selectride followed by hthium aluminum hydride gave diol (- -)-2368 with complete... 

The Claisen condensation is initiated by deprotonation of an ester molecule by sodium ethanolate to give a carbanion that is stabilized, mostly by resonance, as an enolate. This carbanion makes a nucleophilic attack at the partially positively charged carbon atom of the e.ster group, leading to the formation of a C-C bond and the elimination ofan ethanolate ion, This Claisen condensation only proceeds in strongly basic conditions with a pH of about 14. 

Here we will illustrate the method using a single example. The aldol reaction between an enol boronate and an aldehyde can lead to four possible stereoisomers (Figure 11.32). Many of these reactions proceed with a high degree of diastereoselectivity (i.e. syn anti) and/or enantioselectivity (syn-l syn-Tl and anti-l anti-lT). Bernardi, Capelli, Gennari,... 

Separations based upon differences in the chemical properties of the components. Thus a mixture of toluene and anihne may be separated by extraction with dilute hydrochloric acid the aniline passes into the aqueous layer in the form of the salt, anihne hydrochloride, and may be recovered by neutralisation. Similarly, a mixture of phenol and toluene may be separated by treatment with dilute sodium hydroxide. The above examples are, of comse, simple apphcations of the fact that the various components fah into different solubihty groups (compare Section XI,5). Another example is the separation of a mixture of di-n-butyl ether and chlorobenzene concentrated sulphuric acid dissolves only the w-butyl other and it may be recovered from solution by dilution with water. With some classes of compounds, e.g., unsaturated compounds, concentrated sulphuric acid leads to polymerisation, sulphona-tion, etc., so that the original component cannot be recovered unchanged this solvent, therefore, possesses hmited apphcation. Phenols may be separated from acids (for example, o-cresol from benzoic acid) by a dilute solution of sodium bicarbonate the weakly acidic phenols (and also enols) are not converted into salts by this reagent and may be removed by ether extraction or by other means the acids pass into solution as the sodium salts and may be recovered after acidification. Aldehydes, e.g., benzaldehyde, may be separated from liquid hydrocarbons and other neutral, water-insoluble hquid compounds by shaking with a solution of sodium bisulphite the aldehyde forms a sohd bisulphite compound, which may be filtered off and decomposed with dilute acid or with sodium bicarbonate solution in order to recover the aldehyde. 

A classical reaction leading to 1,4-difunctional compounds is the nucleophilic substitution of the bromine of cf-bromo carbonyl compounds (a -synthons) with enolate type anions (d -synthons). Regio- and stereoselectivities, which can be achieved by an appropiate choice of the enol component, are similar to those described in the previous section. Just one example of a highly functionalized product (W.L. Meyer, 1963) is given. 

Treatment of O-silyl enols with silver oxide leads to radical coupling via silver enolates. If the carbon atom bears no substituents, two such r -synthons recombine to symmetrical 1,4-dicarbonyl compounds in good vield (Y. Ito, 1975). 

The addition of large enolate synthons to cyclohexenone derivatives via Michael addition leads to equatorial substitution. If the cyclohexenone conformation is fixed, e.g. as in decalones or steroids, the addition is highly stereoselective. This is also the case with the S-addition to conjugated dienones (Y. Abe, 1956). Large substituents at C-4 of cyclic a -synthons direct incoming carbanions to the /rans-position at C-3 (A.R. Battersby, 1960). The thermodynamically most stable products are formed in these cases, because the addition of 1,3-dioxo compounds to activated double bonds is essentially reversible. 

If a Michael reaction uses an unsymmetrical ketone with two CH-groups of similar acidity, the enol or enolate is first prepared in pure form (p. llff.). To avoid equilibration one has to work at low temperatures. The reaction may then become slow, and it is advisable to further activate the carbon-carbon double bond. This may be achieved by the introduction of an extra electron-withdrawing silyl substituent at C-2 of an a -synthon. Treatment of the Michael adduct with base removes the silicon, and may lead as well to an aldol addition (G. Stork, 1973, 1974 B R.K. Boeckman, Jr., 1974). 

Only relatively few examples of interesting target molecules containing rings are known. These include caryophyllene (E.J. Corey, 1963 A, 1964) and cubane (J.C. Barborak, 1966). The photochemical [2 + 2]-cycloaddition applied by Corey yielded mainly the /ranr-fused isomer, but isomerization with base leads via enolate to formation of the more stable civ-fused ring system. 

Intramolecular reactions between donor and acceptor centres in fused ring systems provide a general route to bridged polycyclic systems. The cts-decalone mesylate given below contains two d -centres adjacent to the carbonyl function and one a -centre. Treatment of this compound with base leads to reversible enolate formation, and the C-3 carbanion substitutes the mesylate on C-7 (J. Gauthier, 1967 A. Belanger, 1968). 

The hydrogenolyaia of cyclopropane rings (C—C bond cleavage) has been described on p, 105. In syntheses of complex molecules reductive cleavage of alcohols, epoxides, and enol ethers of 5-keto esters are the most important examples, and some selectivity rules will be given. Primary alcohols are converted into tosylates much faster than secondary alcohols. The tosylate group is substituted by hydrogen upon treatment with LiAlH (W. Zorbach, 1961). Epoxides are also easily opened by LiAlH. The hydride ion attacks the less hindered carbon atom of the epoxide (H.B. Henhest, 1956). The reduction of sterically hindered enol ethers of 9-keto esters with lithium in ammonia leads to the a,/S-unsaturated ester and subsequently to the saturated ester in reasonable yields (R.M. Coates, 1970). Tributyltin hydride reduces halides to hydrocarbons stereoselectively in a free-radical chain reaction (L.W. Menapace, 1964) and reacts only slowly with C 0 and C—C double bonds (W.T. Brady, 1970 H.G. Kuivila, 1968). 

The following acid-catalyzed cyclizations leading to steroid hormone precursors exemplify some important facts an acetylenic bond is less nucleophilic than an olelinic bond acetylenic bonds tend to form cyclopentane rather than cyclohexane derivatives, if there is a choice in proton-catalyzed olefin cyclizations the thermodynamically most stable Irons connection of cyclohexane rings is obtained selectively electroneutral nucleophilic agents such as ethylene carbonate can be used to terminate the cationic cyclization process forming stable enol derivatives which can be hydrolyzed to carbonyl compounds without this nucleophile and with trifluoroacetic acid the corresponding enol ester may be obtained (M.B. Gravestock, 1978, A,B P.E. Peterson, 1969). 

A 1 3 arrangement of two carbonyl groups (compounds called P diketones) leads to a situation m which the keto and enol forms are of comparable stability... 

If the a carbon atom of an aldehyde or a ketone is a chnality center its stereo chemical integrity is lost on enolization Enolization of optically active sec butyl phenyl ketone leads to its racemization by way of the achiral enol form... 

The transition state involves the carbonyl oxygen of one carboxyl group—the one that stays behind—acting as a proton acceptor toward the hydroxyl group of the carboxyl that IS lost Carbon-carbon bond cleavage leads to the enol form of acetic acid along with a molecule of carbon dioxide... 

Finally, the importance of quinolinium salts to dye chemistry accounts for the long, productive history of their synthesis. The reaction of A/-methylformanihde with ketones, aldehydes, ketone enamines, or enol acetates in phosphoryl chloride leads to high yields of /V-methylquinolinium salts (60). 

Deprotonation of enols of P-diketones, not considered unusual at moderate pH because of their acidity, is faciUtated at lower pH by chelate formation. Chelation can lead to the dissociation of a proton from as weak an acid as an aUphatic amino alcohol in aqueous alkaU. Coordination of the O atom of triethanolamine to Fe(III) is an example of this effect and results in the sequestration of iron in 1 to 18% sodium hydroxide solution (Fig. 7). Even more striking is the loss of a proton from the amino group of a gold chelate of ethylenediamine in aqueous solution (17). 

Protonation of the a-carbanion (50), which is formed both in the reduction of enones and ketol acetates, probably first affords the neutral enol and is followed by its ketonization. Zimmerman has discussed the stereochemistry of the ketonization of enols and has shown that in eertain cases steric factors may lead to kinetically controlled formation of the thermodynamically less stable ketone isomer. Steroidal unsaturated ketones and ketol acetates that could form epimeric products at the a-carbon atom appear to yield the thermodynamically stable isomers. In most of the cases reported, however, equilibration might have occurred during isolation of the products so that definitive conclusions are not possible. 

In very dilute base or, preferably, in the presence of weak bases, the homoannular enolate (16) is formed which can be adsorbed in either a cis (17) or a trans (18) manner. In this case the presence of a methyl group results in a slight favoring of trans adsorption, thus leading to the formation of a slight excess of the m-product as is observed on hydrogeneration of A" -3-keto steroids in the presence of triethylamine. ... 

Dimethyl ketals and enol ethers are stable to the conditions of oxime formation (hydroxylamine acetate or hydroxylamine hydrochloride-pyridine). Thioketals and hemithioketals are cleaved to the parent ketones by cadmium carbonate and mercuric chloride. Desulfurization of thioketals with Raney nickel leads to the corresponding methylene compounds, while thioenol ethers give the corresponding olefin. In contrast, desulfurization of hemithioketals regenerates the parent ketone. ... 

---