Chloro formates

Fig. 3. Deeaspidin extends, and pveillumination shortens, the lag in onset of ATP formation. Chloro--plasts were suspended in SO irM sorbitol, SO wM trioine-KOH pH 8.S, 3 mM MgCl2 and 0.1 wM methyl viologen with IS g chi nil ". Stringently dark conditions were main tained in the room and throughout the storage, transfer and incubation periods. After the appro--priate dark or pre-illumination treatments, luciferin-luciferase, diddenosine pen-taphosphate, ADP, Pi and lO M valinomycin were added. The start of the 1 Hz flash sequences is indicated by the upward pointed arrow, the end by the downward arrow. A fresh sample was prepared for each treatment, except for curve 4, which is...

The anhydrous chloride is prepared by standard methods. It is readily soluble in water to give a blue-green solution from which the blue hydrated salt CuClj. 2H2O can be crystallised here, two water molecules replace two of the planar chlorine ligands in the structure given above. Addition of dilute hydrochloric acid to copper(II) hydroxide or carbonate also gives a blue-green solution of the chloride CuClj but addition of concentrated hydrochloric acid (or any source of chloride ion) produces a yellow solution due to formation of chloro-copper(ll) complexes (see below). 

The conversion of an aliphatic carboxylic acid into the a-bromo- (or a-chloro ) acid by treatment with bromine (or chlorine) in the presence of a catal3rtic amount of phosphorus tribromide (or trichloride) or of red phosphorus is known as the Hell-Volhard-Zelinsky reaction. The procedure probably involves the intermediate formation of the acyl halide, since it is known that halogens react more rapidly with acyl haUdes than with the acids themselves ... 

The success of the last reaction depends upon the inertness of the ester carbonyl groups towards the organocadmium compound with its aid and the use of various ester acid chlorides, a carbon chain can be built up to any reasonable length whilst retaining a reactive functional group (the ester group) at one end of the chain. Experimental details are given for l-chloro-2-hexanone and propiophenone. The complete reaction (formation of ketones or keto-esters) can be carried out in one flask without isolation of intermediates, so that the preparation is really equivalent to one step. 

Formic acid behaves differently. The expected octadienyl formate is not formed. The reaction of butadiene carried out in formic acid and triethylamine affords 1,7-octadiene (41) as the major product and 1,6-octadiene as a minor product[41-43], Formic acid is a hydride source. It is known that the Pd hydride formed from palladium formate attacks the substituted side of tt-allylpalladium to form the terminal alkene[44] (see Section 2.8). The reductive dimerization of isoprene in formic acid in the presence of Et3N using tri(i)-tolyl)phosphine at room temperature afforded a mixture of dimers in 87% yield, which contained 71% of the head-to-tail dimers 42a and 42b. The mixture was treated with concentrated HCl to give an easily separable chloro derivative 43. By this means, a- and d-citronellol (44 and 45) were pre-pared[45]. 

Chloro 1 3 butadiene (chloroprene) is the monomer from which the elastomer neoprene IS prepared 2 Chloro 1 3 butadiene is the thermodynamically controlled product formed by addi tion of hydrogen chloride to vinylacetylene (H2C=CHC=CH) The principal product under conditions of kinetic control is the allenic chlonde 4 chloro 1 2 butadiene Suggest a mechanism to account for the formation of each product... 

The organic iodine compounds have lower heats of formation and greater reactivities than their chloro and bromo analogues. As ia the case of the inorganic iodides, their iadexes of refraction and specific gravities are higher than the corresponding chloro and bromo derivatives (121). 

Bromination of isoprene using Br2 at —5 ° C in chloroform yields only /n j -l,4-dibromo-2-methyl-2-butene (59). Dry hydrogen chloride reacts with one-third excess of isoprene at —15 ° C to form the 1,2-addition product, 2-chloro-2-methyl-3-butene (60). When an equimolar amount of HCl is used, the principal product is the 1,4-addition product, l-chloro-3-methyl-2-butene (61). The mechanism of addition is essentially all 1,2 with a subsequent isomerization step which is catalyzed by HCl and is responsible for the formation of the 1,4-product (60). The 3,4-product, 3-bromo-2-methyl-1-butene, is obtained by the reaction of isoprene with 50% HBr in the presence of cuprous bromide (59). Isoprene reacts with the reactive halogen of 3-chlorocyclopentene (62). 

Pigment Red 144 [5280-784] 20735 disa2o condensation coupling of dia2oti2ed 2,5-dichloroaniline with 3-hydroxy-2-napthoic acid, foUowed by acid chloride formation and reaction with 2-chloro-/)-phen5iene- diamine... 

Almost all IDA derived chain extenders are made through ortho-alkylation. Diethyltoluenediamine (DE I DA) (C H gN2) (53), with a market of about 33,000 t, is the most common. Many uses for /-B I DA have been cited (1,12). Both DE I DA and /-B I DA are especially useful in RIM appHcations (49,53—55). Di(methylthio)-TDA, made by dithioalkylation of TDA, is used in cast urethanes and with other TDI prepolymers (56). Styrenic alkylation products of TDA are said to be useful, eg, as in the formation of novel polyurethane—polyurea polymers (57,58). Progress in understanding aromatic diamine stmcture—activity relationships for polyurethane chain extenders should allow progress in developing new materials (59). Chlorinated IDA is used in polyurethane—polyurea polymers of low hysteresis (48) and in reinforced polyurethane tires (60). The chloro-TDA is made by hydrolysis of chloro-TDI, derived from TDA (61). 

The l-chloro-2-propanol isomer represents about 85% of the chlorohydrin produced. In order to minimise the formation of dichlotide coproduct and ether, the reactant compositions are chosen such that the effluent Hquid contains 4—5 wt % propylene chlorohydrin. Under these conditions, the yield of chlorohydrin, dichloride, and ether from the reactants is reported to be 87—90, 6—9, and 2%, respectively (109,110,112). 

Hypochlorous acid reacts very rapidly and quantitatively with a slight excess of free ammonia forming monochloramine, NH2CI, which reacts at a slower rate with additional HOCl forming dichloramine, NHCI2. Trichloramine is formed when three moles of HOCl are added per mole of ammonia between pH 3—4 (100). Hypochlorous acid in the form of chlorine or hypochlorite is used in water treatments to oxidize ammonia by the process of break-point chlorination, which is based on formation of unstable dichloramine. The instabiHty of NHCI2 is caused by presence of HOCl and NCl (101,102). The reaction is most rapid at a pH of about 7.5 (103). Other nitrogen compounds such as urea, creatinine, and amino acids are also oxidized by hypochlorous acid, but at slower rates. Unstable iV-chloro compounds are intermediates in deammination of amino acids (104,105). 

Formation of Cyclic Carbonates. In the absence of water, chlorohydrins such as 2-chloroethanol and l-chloro-2-propanol react with an alkah carbonate or bicarbonate to produce cycHc carbonates such as ethylene carbonate [96-49-1] and propylene carbonate [108-32-7] ia yields of up to 80%... 

Alkoxyl tion. The nucleophilic replacement of an aromatic halogen atom by an alkoxy group is an important process, especially for production of methoxy-containing iatermediates. Alkoxylation is preferred to alkylation of the phenol wherever possible, and typically iavolves the iateraction of a chloro compound, activated by a nitro group, with the appropriate alcohol ia the presence of alkaU. Careful control of alkaU concentration and temperature are essential, and formation of by-product azoxy compounds is avoided by passiag air through the reaction mixture (21). 

The use of free-radical reactions for this mode of ring formation has received rather more attention. The preparation of benzo[Z)]thiophenes by pyrolysis of styryl sulfoxides or styryl sulfides undoubtedly proceeds via formation of styrylthiyl radicals and their subsequent intramolecular substitution (Scheme 18a) (75CC704). An analogous example involving an amino radical is provided by the conversion of iV-chloro-iV-methylphenylethylamine to iV-methylindoline on treatment with iron(II) sulfate in concentrated sulfuric acid (Scheme 18b)(66TL2531). 

In comparison to N—S bond formation, O—N bond formation by essentially oxidative procedures has found few applications in the synthesis of five-membered heterocycles. The 1,2,4-oxadiazole system (278) was prepared by the action of sodium hypochlorite on A(-acylamidines (277) (76S268). The A -benzoylamidino compounds (279) were also converted into the 1,2,4-oxadiazoles (280) by the action of r-butyl hypochlorite followed by base. In both cyclizations A -chloro compounds are thought to be intermediates (76BCJ3607). 

Another example of the analogy between pyrazole and chlorine is provided by the alkaline cleavage of l-(2,4-dinitrophenyl)pyrazoles. As occurs with l-chloro-2,4-dinitrobenzene, the phenyl substituent bond is broken with concomitant formation of 2,4-dinitrophenol and chlorine or pyrazole anions, respectively (66AHC(6)347). Heterocyclization of iV-arylpyrazoles involving a nitrene has already been discussed (Section 4.04.2.1.8(i)). Another example, related to the Pschorr reaction, is the photochemical cyclization of (515) to (516) (80CJC1880). An unusual transfer of chlorine to the side-chain of a pyrazole derivative was observed when the amine (517 X = H, Y = NH2) was diazotized in hydrochloric acid and subsequently treated with copper powder (72TL3637). The product (517 X = Cl, Y = H) was isolated. 

---