Methyl substituent

A monosubstituted cyclohexane, e.g. methylcyclohexane, exists theoretically in two isomeric forms with a chair-form ring, and the methyl substituent either axial or equatorial. Since these rapidly interconverl through a CH3... 

The regioselectivity of the reaction appears to be determined by a balance of electronic and steric factors. For acrylate and propiolate esters, the carb-oxylate group is found preferentially at C3 of the carbazole product[6-8]. Interestingly, a 4-methyl substituent seems to reinforce the preference for the EW group to appear at C3 (compare Entries 4 and 5 in Table 16.2). For disubstituted acetylenic dicnophiles, there is a preference for the EW group to be at C2 of the carbazole ring[6]. This is reinforced by additional steric bulk in the other substituent[6,9]. 

Nitraminothiazoles are sufficiently acidic to be alkylated by diazomethane the methyl substituent is introduced on the exocyclic nitrogen (194). When sulfathiazole is methylated with diazomethane in ether, a mixture of ring-methylated and amino-methylated products is obtained, the ratio being 30 70 (85). With anion 31 (R = p-NO CsH4SO -) the ratio becomes 15 85 (195). 

An interesting rearrangement of the (4-methyl-2-thiazolyl)thioureas (263) has recently been reported (Scheme 160) (303). The reaction mechanism is currently under investigation. This reaction does not occur if the 4-methyl substituent in the thiazole ring of 263 is replaced by an hydrogen, which suggests an electrophilic attack on C-5 as the mechanism of this reaction. 

A bathochromic shift of about 5 nm results for the 320-nm band when a methyl substituent is introduced either in the 4- or 5-posiiion, The reverse is observed when the methyl is attached to nitrogen (56). Solvent effects on this 320-nm band suggest that in the first excited state A-4-thiazoline-2-thione is less basic than in the ground state (61). Ultraviolet spectra of a large series of A-4-thiazoline-2-thiones have been reported (60. 73). 

The introduction of a methyl substituent into the empirical calculations may be performed according to two main different models the pseudoheteroatomic model and the hyperconjugated model (161-166). Both approximations have been used in rr-electron methods (HMO, w, PPP). On the other hand, in the all-valence-electrons... 

Isoamyl acetate is the common name of the substance most responsible for the characteris tic odor of bananas Wnte a structural formula for isoamyl acetate given the information that it IS an ester in which the carbonyl group bears a methyl substituent and there is a 3 methylbutyl group attached to one of the oxygens... 

Together these two products contain all eight carbons of the starting alkene The two carbonyl carbons correspond to those that were doubly bonded m the original alkene One of the doubly bonded carbons therefore bears two methyl substituents the other bears a hydrogen and a tert butyl group The alkene is identified as 2 4 4 trimethyl 2 pentene (CH3)2C=CHC(CH3)3 as shown m Figure 6 15... 

Because substitution in toluene occurs primarily at positions ortho and para to methyl we say that a methyl substituent is an ortho, para director... 

Our analysis of substituent effects has so far centered on two groups methyl and triflu oromethyl We have seen that a methyl substituent is activating and ortho para directing A trifluoromethyl group is strongly deactivating and meta directing What about other substituents ... 

The structure of vitamin D2 is the same as that of vitamin D3 except that vitamin D2 has a double bond between C 22 and C 23 and a methyl substituent at C 24... 

The 1950s and 1960s saw the development of orally active progestins based on the synthesis of steroids that lack the C19-angular methyl substituent (19-norsteroids). The commercial production of these compounds for the regulation of menstmal disorders began in 1957, and for oral contraception in 1960. 

Interest in the synthesis of 19-norsteroids as orally active progestins prompted efforts to remove the C19 angular methyl substituent of readily available steroid precursors. Industrial applications include the direct conversion of androsta-l,4-diene-3,17-dione [897-06-3] (92) to estrone [53-16-7] (26) by thermolysis in mineral oil at about 500°C (136), and reductive elimination of the angular methyl group of the 17-ketal of the dione [2398-63-2] (93) with lithium biphenyl radical anion to form the 17-ketal of estrone [900-83-4] (94) (137). 

Besides the aforementioned chemical methods, microbial degradations have been used to remove the C19 angular methyl substituent of readily available steroid precursors. For example, 19-hydroxysterols, such as 3P-acetoxy-19-hydroxy-5-cholestene [750-59-4] (107), can be converted to estrone by Mocardia sp. in yields up to 70% (120,145,146). 

Substituted PPVs have been prepared using similar techniques. The earliest reports described methyl substituents (104,105), and more recentiy alkoxy substituents on the aromatic ring have been incorporated into the polymer stmctures (107—109). The advantage of long-chain alkoxy (butoxy or hexyloxy) substituents is that not only is the precursor polyelectrolyte soluble, but after conversion the substituted PPV is also soluble (110—112). 

There appear to be no reports of direct radical attack on the pyridopyrimidine ring system, but radical bromination of methyl substituents in the 7-position of the pyridine ring has been utilized in the synthesis of deaza analogues of natural products (62JCS4678, 79JHC133). 

Studies on covalent hydration of N-heterocycles (67AG(E)919,76AHC(20)117) have revealed the diagnostic value of alkyl substituents in structural assignments due to their steric hindrance effects in addition reactions. C-Methyl substituents are therefore also considered as molecular probes to solve fine-structural problems in the pteridine field. The derivatives... 

The reactivities of the isoxazoles are compared with those of benzene and some five-membered ring heterocycles in Table 7. Isoxazole is more reactive than benzene (by 4.3 log units) and isothiazole (0.8) and is less reactive than 1-methylpyrazole, furan, thiophene and 1-methylpyrrole. A 5-methyl substituent activates the nucleus more than does a... 

It was found that utilization of QAS with increased steric accessibility of exchange center, containing nitrogen atom with three methyl substituents and one super lipophilic substituent, - tris(2,3,4-dodecyloxy)benzyl, - leads to dramatic, up to 7 orders, increase of ISE s selectivity towards sulfate in the presence of single-charged anions. Incorporation of hexyl 4-trifluoro-acetylbenzoate into membrane leads to additional substantial increase - up to 4 orders - in sulfate selectivity. 

MQ Silicone rubbers having only methyl substituent groups on tbe polymer chain (polydimethyl siloxanes). 

FVMQ Silicone rubbers having fluoro and methyl substituent groups on the polymer chain (the fluorosilicones)... 

---