Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

3- Hydroxyethyl formate

Br , citrate, CE, CN , E, NH3, SCN , S20 , thiourea, thioglycolic acid, diethyldithiocarba-mate, thiosemicarbazide, bis(2-hydroxyethyl)dithiocarbamate Acetate, acetylacetone, BE4, citrate, C20 , EDTA, E , formate, 8-hydroxyquinoline-5-sul-fonic acid, mannitol, 2,3-mercaptopropanol, OH , salicylate, sulfosalicylate, tartrate, triethanolamine, tiron... [Pg.1175]

Results obtained for two mixed plastics are summarized in Table 4. A balance exists between process temperature, plastics feed rate, and product yields (67). For example, lower temperatures increase wax formation due to incomplete depolymerization. Slower feed rates and increased residence times reduce wax formation and increase the yield of Hquids. The data summarized in Table 4 illustrate that the addition of PET to a HDPE PP PS mixture changes the performance of the Conrad process. Compared to the reference HDPE PP PS mixture, increased amounts of soHds ate formed. These are 95% terephthahc acid and 5% mono- and bis-hydroxyethyl esters. At higher temperatures, apparentiy enough water remains to promote decarboxylation. [Pg.232]

Emulsion polymerizations of vinyl acetate in the presence of ethylene oxide- or propylene oxide-based surfactants and protective coUoids also are characterized by the formation of graft copolymers of vinyl acetate on these materials. This was also observed in mixed systems of hydroxyethyl cellulose and nonylphenol ethoxylates. The oxyethylene chain groups supply the specific site of transfer (111). The concentration of insoluble (grafted) polymer decreases with increase in surfactant ratio, and (max) is observed at an ethoxylation degree of 8 (112). [Pg.466]

The pathways for thiamine biosynthesis have been elucidated only partiy. Thiamine pyrophosphate is made universally from the precursors 4-amino-5-hydroxymethyl-2-methylpytimidinepyrophosphate [841-01-0] (47) and 4-methyl-5-(2-hydroxyethyl)thiazolephosphate [3269-79-2] (48), but there appear to be different pathways ia the eadier steps. In bacteria, the early steps of the pyrimidine biosynthesis are same as those of purine nucleotide biosynthesis, 5-Aminoimidazole ribotide [41535-66-4] (AIR) (49) appears to be the sole and last common iatermediate ultimately the elements are suppHed by glycine, formate, and ribose. AIR is rearranged in a complex manner to the pyrimidine by an as-yet undetermined mechanism. In yeasts, the pathway to the pyrimidine is less well understood and maybe different (74—83) (Fig. 9). [Pg.92]

Etherification. Carbohydrates are involved in ether formation, both intramoleculady and intermoleculady (1,13). The cycHc ether, 1,4-sorbitan, an 1,4-anhydroalditol, has already been mentioned. 3,6-Anhydro-a-D-galactopyranosyl units are principal monomer units of the carrageenans. Methyl, ethyl, carboxymethyl, hydroxyethyl, and hydroxypropyl ethers of cellulose (qv) are all commercial materials. The principal starch ethers are the hydroxyethyl and hydroxypropylethers (see Cellulose ethers Starch). [Pg.481]

Active carbonyl compounds such as benzaldehyde attack the electron-rich double bond in DTDAFs to give a dipolar adduct, which immediately undergoes dissociation with formation of two molecules of 146 (64BSF2857 67LA155).Tlie existence of by-products such as benzoin led to the synthetic application of thiazolium salts in the acyloin condensation. For example, replacement of the classic cyanide ion by 3-benzyl-4-methyl-5(/3-hydroxyethyl) thiazolium salts allowed the benzoin-type condensation to take place in nonaqueous solvents (76AGE639) (Scheme 57). [Pg.168]

The dimerization reactions of 2-vinylindoles and their alcohol precursors have also been explored, giving rise to the formation of several dimeric structures, such as the 6,12-dihydroindolo[3,2-h]carbazole derivative 160, which was obtained on dimerization of 2-(a-hydroxyethyl)indole under acidic conditions (71JOC1759). [Pg.33]

Accordingly, cyclic nitronates can be a useful synthetic equivalent of functionalized nitrile oxides, while reaction examples are quite limited. Thus, 2-isoxazoline N-oxide and 5,6-dihydro-4H-l,2-oxazine N-oxide, as five- and six-membered cyclic nitronates, were generated in-situ by dehydroiodination of 3-iodo-l-nitropropane and 4-iodo-l-nitrobutane with triethylamine and trapped with monosubstituted alkenes to give 5-substituted 3-(2-hydroxyethyl)isoxazolines and 2-phenylperhydro-l,2-oxazino[2,3-fe]isoxazole, respectively (Scheme 7.26) [72b]. Upon treatment with a catalytic amount of trifluoroacetic acid, the perhydro-l,2-oxazino[2,3-fe]isoxazole was quantitatively converted into the corresponding 2-isoxazoline. Since a method for catalyzed enantioselective nitrone cycloadditions was established and cyclic nitronates should behave like cyclic nitrones in reactivity, there would be a good chance to attain catalyzed enantioselective formation of 2-isoxazolines via nitronate cycloadditions. [Pg.272]

Both for reaction in and IV the order with respect to catalyst is 0.5. The activation enthalpies are 96.6 3.4 and 97.6 3.4 kJ mol-1 respectively when Ti(OBu)4 is used as the catalyst. This is not too far from the activation enthalpies200 for the Sn(II)-cata-lyzed esterification of B with isophthalic acid (85.1 4.9) and with 2-hydroxyethyl hydrogen isophthalate (85.8 4.2). It is also close to the Ti(OBu)4-catalyzed esterification of benzoic acid with B (85.8 2.5)49. This is probably due to the formation of analogous intermediate complexes and similar catalytic mechanisms. On the other hand, the activation entropies of reactions III and IV are less negative than those of the reaction of benzoic or isophthalic acid with B. This probably corresponds to a stronger desolvation when the intermediary complex is formed and could be due to the presence of the sodium sulfonate group. [Pg.90]

No example of intramolecular displacement to give Co(I) has yet been reported. /3-Hydroxyethyl complexes are decomposed by alkali to give Co(I) and acetaldehyde, and it has been suggested (33) that this might proceed via the intermediate formation of the epoxide. But the results are more easily explained on the basis of the established mechanism involving the cis elimination of Co—H (see Section f). [Pg.408]

We have found that the chemical sulfation of N-methyl-N-(2-hydroxyethyl)nitrosamine resulted in the direct formation of the oxadiazolium ion. [Pg.14]

Fluidized aqueous suspensions of 15% by weight or more of hydroxyethyl-cellulose, hydrophobically modified cellulose ether, hydrophobically modified hydroxyethylcellulose, methylcellulose, hydroxypropylmethylcellulose, and polyethylene oxide are prepared by adding the polymer to a concentrated sodium formate solution containing xanthan gum as a stabilizer [278]. The xanthan gum is dissolved in water before sodium formate is added. Then the polymer is added to the solution to form a fluid suspension of the polymers. The polymer suspension can serve as an aqueous concentrate for further use. [Pg.246]

Carbodi-imides are used to mediate the formation of amide linkage betwen a carboxylate and an amine or phosphoramidate linkages between a phosphate and an amine [12]. The following is essentially the method of Rockwood [13] and is modified to give a phospho-diester link between the terminal monophosphate of the oligonucleotide and the hydroxyl group of 2-hydroxyethyl disulfide (HEDS) [14]. [Pg.519]

Fluid loss additives such as solid particles and water-thickening polymers may be added to the drilling mud to reduce fluid loss from the well bore to the formation. Insoluble and partially soluble fluid loss additives include bentonite and other clays, starch from various sources, crushed walnut hulls, lignite treated with caustic or amines, resins of various types, gilsonite, benzoic acid flakes, and carefully sized particles of calcium borate, sodium borate, and mica. Soluble fluid loss additives include carboxymethyl cellulose (CMC), low molecular weight hydroxyethyl cellulose (HEC), carboxy-methYlhydroxyethyl cellulose (CMHEC), and sodium acrylate. A large number of water-soluble vinyl copolymers and terpolymers have been described as fluid loss additives for drilling and completion fluids in the patent literature. However, relatively few appear to be used in field operations. [Pg.10]

Desiccation of gaseous ethylene oxide led to an explosion, (possibly involving formation of 2-hydroxyethyl perchlorate). [Pg.1426]

Partly saturated pyrazino[l,2-r-]pyrimidines were prepared by formation of the pyrazine ring. 2-Substituted-8-hydroxy-3,4-dihydro-177,277-pyrazino[l,2-r-]pyrimidin-l-ones were prepared by a [6+0] synthesis involving cyclization of 6-hydroxy-pyrimidine-4-(fV-hydroxyethyl)carboxamides <2005W02005/087766>. The 2/7-pyra-zino[l,2-c]pyrimidine-3-carboxamide 164 (Y = NH) was formed from [5+1] atom fragments via the uracil derivative 163 (Y = NH) and DMF-dimethyl acetal. Compounds 163 were prepared from 6-chloromethyluracil and glycine methyl ester 162 (Y = NH) (Scheme 20) <2004W02004/014354>. [Pg.280]

Heats of formations (A//f) of the possible two trans- and four cA-fused stereoisomers of the 9-hydroxyperhydropyr-imido[2,1 / 1,4]oxazine 287 derived from 3-(2-hydroxyethyl)-l,3-propanediamine and glyoxal were calculated by the AMI program. Experimentally, 287 was obtained as 3 1 cis—trans mixture the isomers were not separated < 1996H(43)1991 >. [Pg.298]


See other pages where 3- Hydroxyethyl formate is mentioned: [Pg.322]    [Pg.322]    [Pg.628]    [Pg.356]    [Pg.369]    [Pg.58]    [Pg.295]    [Pg.133]    [Pg.646]    [Pg.299]    [Pg.181]    [Pg.325]    [Pg.150]    [Pg.91]    [Pg.133]    [Pg.254]    [Pg.545]    [Pg.29]    [Pg.60]    [Pg.200]    [Pg.419]    [Pg.68]    [Pg.254]    [Pg.138]    [Pg.1154]    [Pg.16]    [Pg.17]    [Pg.18]    [Pg.32]    [Pg.179]    [Pg.195]    [Pg.6]    [Pg.195]   
See also in sourсe #XX -- [ Pg.138 , Pg.256 ]




SEARCH



Hydroxyethylation

© 2024 chempedia.info