Nitrile oxide, Functionalized

As was mentioned earlier, furoxans are often encountered as unwanted byproducts in nitrile oxide cycloadditions. There are, however, some efforts to exploit this facile C—C forming dimerization for synthesis. In one case, an intramolecular hwtnitrile oxide) cycloaddition was used for a synthesis of biotin (322a). More recently, the intramolecular dimerization was employed for the construction of medium- and large-size rings. This was feasible if one of the two nitrile oxide functionalities was relatively hindered and stable (see Section 6.1.4). Unsymmetrical... 

Another route involving intramolecular cycloaddition of nitrone and nitrile oxide functionalities of the indole derivative (166) gave a novel class of mitomycin analogues which are dihydro- and tetrahydroisooxazolo[3, 4 3,4]pyrrolo[l,2-a]indole (167) and (168) (Equation (8)) <89TL1421>. 

Isoxazoles (Problem 36) have taken on increased significance as synthetic targets, because they are found in the structures of some recently discovered naturally occurring molecules that show promise as antibiotics (see Real Life 20-2). Isoxazoles may be prepared by reaction of aUcynes with compounds containing the unusual nitrile oxide functional group ... 

A variety of 1-azirines are available (40-90%) from the thermally induced extrusion (>100 °C) of triphenylphosphine oxide from oxazaphospholines (388) (or their acyclic betaine equivalents), which are accessible through 1,3-dipolar cycloaddition of nitrile oxides (389) to alkylidenephosphoranes (390) (66AG(E)1039). Frequently, the isomeric ketenimines (391) are isolated as by-products. The presence of electron withdrawing functionality in either or both of the addition components can influence the course of the reaction. For example, addition of benzonitrile oxide to the phosphorane ester (390 = C02Et) at... 

Asymmetric cycloaddition of functionalized alkenes to nitrile oxides and nitrones 98YGK11. 

Accordingly, cyclic nitronates can be a useful synthetic equivalent of functionalized nitrile oxides, while reaction examples are quite limited. Thus, 2-isoxazoline N-oxide and 5,6-dihydro-4H-l,2-oxazine N-oxide, as five- and six-membered cyclic nitronates, were generated in-situ by dehydroiodination of 3-iodo-l-nitropropane and 4-iodo-l-nitrobutane with triethylamine and trapped with monosubstituted alkenes to give 5-substituted 3-(2-hydroxyethyl)isoxazolines and 2-phenylperhydro-l,2-oxazino[2,3-fe]isoxazole, respectively (Scheme 7.26) [72b]. Upon treatment with a catalytic amount of trifluoroacetic acid, the perhydro-l,2-oxazino[2,3-fe]isoxazole was quantitatively converted into the corresponding 2-isoxazoline. Since a method for catalyzed enantioselective nitrone cycloadditions was established and cyclic nitronates should behave like cyclic nitrones in reactivity, there would be a good chance to attain catalyzed enantioselective formation of 2-isoxazolines via nitronate cycloadditions. 

The intramolecular cycloaddition of a nitrile oxide (a 1,3-dipole) to an alkene is ideally suited for the regio- and stereocontrolled synthesis of fused polycyclic isoxazolines.16 The simultaneous creation of two new rings and the synthetic versatility of the isoxa-zoline substructure contribute significantly to the popularity of this cycloaddition process in organic synthesis. In spite of its high degree of functionalization, aldoxime 32 was regarded as a viable substrate for an intramolecular 1,3-dipolar cycloaddition reaction. Indeed, treatment of 32 (see Scheme 17) with sodium hypochlorite... 

Intramolecular nitrone cycloadditions often require higher temperatures as nitrones react more sluggishly with alkenes than do nitrile oxides and the products contain a substituent on nitrogen which may not be desirable. Conspicuously absent among various nitrones employed earlier have been NH nitrones, which are tautomers of the more stable oximes. However, Grigg et al. [58 a] and Padwa and Norman [58b] have demonstrated that under certain conditions oximes can undergo addition to electron deficient olefins as Michael acceptors, followed by cycloadditions to multiple bonds. We found that intramolecular oxime-olefin cycloaddition (lOOC) can occur thermally via an H-nitrone and lead to stereospecific introduction of two or more stereocenters. This is an excellent procedure for the stereoselective introduction of amino alcohol functionality via N-0 bond cleavage. 

Nitro compounds are versatile precursors for diverse functionalities. Their conversion into carbonyl compounds by the Nef reaction and into amines by reduction are the most widely used processes in organic synthesis using nitro compounds. In addition, dehydration of primary nitro compounds leads to nitrile oxides, a class of reactive 1,3-dipolar reagents. Nitro compounds are also good precursors for various nitrogen derivatives such as nitriles, oximes, hydroxylamines, and imines. These transformations of nitro compounds are well established and are used routinely in organic synthesis. 

The reaction of nitroalkenes or nitroalkanes with TiCl4 and Me3SiN3 gives a-azido functionalized hydroxamoyl chlorides, which act as precursors of nitrile oxides (Eq. 6.34).59... 

Eguchi and Ohno have used silyl nitronate induced 1,3-dipolar cycloaddition for functionalization of fullerene C60 (Eq. 8.76).127a Nitrile oxides also undergo 1,3-dipolar cycloaddition... 

Recently, Denmark and coworkers have developed a new strategy for the construction of complex molecules using tandem [4+2]/[3+2]cycloaddition of nitroalkenes.149 In the review by Denmark, the definition of tandem reaction is described and tandem cascade cycloadditions, tandem consecutive cycloadditions, and tandem sequential cycloadditions are also defined. The use of nitroalkenes as heterodienes leads to the development of a general, high-yielding, and stereoselective method for the synthesis of cyclic nitronates (see Section 5.2). These dipoles undergo 1,3-dipolar cycloadditions. However, synthetic applications of this process are rare in contrast to the functionally equivalent cycloadditions of nitrile oxides. This is due to the lack of general methods for the preparation of nitronates and their instability. Thus, as illustrated in Scheme 8.29, the potential for a tandem process is formulated in the combination of [4+2] cycloaddition of a donor dienophile with [3+2]cycload-... 

A wide range of aliphatic nitrile oxides 370a-k and 372a-e, variously functionalized on the side chain, were added to MCP and its derivatives, on the route for the synthesis of functionalized dihydropyridones (Tables 29 and 30) [92]. 

New applications of nitrile oxide 1,3-DC have been reported. Soluble, single-wall carbon nanotubes (SWNT) 32 functionalized with pentyl esters at the tips and pyridyl isoxazoline rings along the walls were prepared using pentyl ester-SWNT as dipolarophile. The complex... 

Dipolar addition of ethyl propiolate to the nitrile oxide 285, prepared by chlorination of the corresponding oxime, gave, after removal of protecting groups, the C-glycosyl-isoxazole205 (286). These reactions further demonstrate the utility of anomerically functionalized C-/3-D-ribofuranosyl derivatives that can be prepared from the versatile aldehyde 100. 

Specific properties of nitrile oxides depend on the structure of the functional group, which have highly polarized C-N and N-0 bonds (Scheme 1.1). 

The latter procedure was used in syntheses of stable nitrile oxides such as P,P-diphenylacrylonitrile oxide and 2,6-diphenylbenzonitrile oxide (22), a series of functionally substituted 2,6-dimethylbenzonitrile oxides (29), as well as 2,4,6-triethylbenzene-l,3-dicarbonitrile oxide (29), stable bis(nitrile oxides) of a novel structure 6, in which two benzene rings, bearing hindered fulmido groups are connected with a bridge (30), tetrachloroisophthalo- and terephthalonitrile oxides (31). Stable o-sullamoylbenzonitrile oxides with only one shielding substituent were also prepared using NaOCl/NaOH in a two-phase system (20, 32). 

Cycloaddition with nitrile oxides occur with compounds of practically any type with a C=C bond alkenes and cycloalkenes, their functional derivatives, dienes and trienes with isolated, conjugated or cumulated double bonds, some aromatic compounds, unsaturated and aromatic heterocycles, and fullerenes. The content of this subsection is classified according to the mentioned types of dipolarophiles. Problems of relative reactivities of dienophiles and dipoles, regio- and stereoselectivity of nitrile oxide cycloadditions were considered in detail by Jaeger and... 

Formation of mixtures of the above type, which is common with internal olefins, do not occur with many functionalized alkenes. Thus, tertiary cinnamates and cinnamides undergo cycloadditions with benzonitrile oxides to give the 5-Ph and 4-Ph regioisomers in a 25-30 75-70 ratio. This result is in contrast to that obtained when methyl cinnamate was used as the dipolarophile (177). 1,3-Dipolar cycloaddition of nitrile oxides to ethyl o -hydroxycinnamate proceeds regiose-lectively to afford the corresponding ethyl fra s-3-aryl-4,5-dihydro-5-(2-hydro-xyphenyl)-4-isoxazolecarboxylates 36 (178). Reaction of 4-[( )-(2-ethoxycarbo-nylvinyl)] coumarin with acetonitrile oxide gives 37 (R = Me) and 38 in 73% and 3% yields, respectively, while reaction of the same dipolarophile with 4-methoxy-benzonitrile oxide affords only 37 (R = 4-MeOCr>H4) (85%) (179). 

Fullerenes Cycloaddition reactions are very popular for functionalization of fullerenes. Such reactions of fullerenes are compiled and discussed in detail in Reference 253. During the last 10 to 15 years, several communications appeared concerning [3 + 2] cycloaddition of nitrile oxides to fullerene C60- Nitrile oxides, generated in the presence of C60, form products of 1,3-cycloaddition, fullerene isoxazolines, for example, 89. The products were isolated by gel permeation chromatography and appear by and 13 C NMR spectroscopy to be single isomers. Yields of purified products are ca 30%. On the basis of 13C NMR, structures with Cs symmetry are proposed. These products result from addition of the nitrile oxide across a 6,6 ring fusion (254). 

The cycloaddition of Weinreb amide functionalized nitrile oxide with a range of dipolarophiles has been studied. N-Methoxy-N-methylcarbonocyanidic amide, nitrile oxide 207 (i.e., a nitrile oxide of Weinreb amide type derivative) was generated from 2-chloro-2-(hydroxyimino)-N-methoxy-N-methylacetamide as intermediate and used in situ. Thus, addition of 3-bromo-l-propyne as dipolarophile to this precursor of 207, followed by quenching with triethylamine, gave 5-(bromo-methyl)-N-(methoxy)-N-methyl-3-isoxazolecarboxamide 208 in 55% to 60% yield (367). 

Rather than the expected [3 + 2] cycloaddition, a novel ene-like cycloisomerization occurs on deprotonation of allyltrimethylsilyl-oxime compounds, when the j3-sp2 carbon atom of the allyltrimethylsilyl moiety is tethered to the oxime unit. The resulting nitrile oxide group serves as an enophile, and the final cyclized product still has two functional groups suitable for further manipulations. Thus, ene-like cycloisomerization of allyltrimethylsilyl-oxime 375 with NaOCl in CH2CI2 gives 82% of cyclized product 376 (423). See also Reference 424. 

A total synthesis of functionalized 8,14-seco steroids with five- and six-membered D rings has been developed (467). The synthesis is based on the transformation of (S)-carvone into a steroidal AB ring moiety with a side chain at C(9), which allows the creation of a nitrile oxide at this position. The nitrile oxides are coupled with cyclic enones or enol derivatives of 1,3-diketones, and reductive cleavage of the obtained cycloadducts give the desired products. The formation of a twelve-membered ring compound has been reported in the cycloaddition of one of the nitrile oxides with cyclopentenone and as the result of an intramolecular ene reaction, followed by retro-aldol reaction. 

Actually, nitronates are the closest related derivatives of nitronic acids, that is, aci forms of AN, which exist in labile equilibrium with true AN. Some derivatives of nitronic acids, —CH=N(0)0X, where OX is the good leaving group, are evident intermediates in the most well-developed procedures for the synthesis of nitrile oxides from primary AN. In this chapter, special emphasis is given to particular nitronates, which are generated from a-functionalized AN and can also be considered as precursors of a-functionalized nitrile oxides. 

As can be seen from Scheme 3.88, nitrile oxides can be generated in the reactions of acids or bases with other alkyl nitronates derived from a-functionalized nitro compounds (300, 301). 

These polymers show lower water uptake than the analogous sulfonated poly(arylene ether sulfone) materials, possibly suggesting some interaction between the aromatic nitrile and sulfonic acid. The phosphine oxide functional moiety could also be used as a compatibilizer with other materials. Sulfonated poly(arylene ether phosphine oxide sulfone) terpoly-mers have been prepared both with sulfonated triphenyl phosphine oxide and with triphenyl phosphine oxide with 3,3 -disulfonate-4,4 —dichlorodiphenyl sulfone as the sulfonic acid bearing monomer. Block copolymers containing phosphine oxide appear to avoid the ether—ether interchange that results when non—phosphine oxide blocks are utilized, and this is being further pursued. ... 

---