Hydroxide phenolic

Arsenic, phosphorus, fluorides, petroleum oils, calcium oxide and hydroxide, phenols... 

The presence of -OH group In phenols activates the aromatic ring towards electrophilic substitution and directs the Incoming group to ortho and para positions due to resonance effect. Reimer-Tiemann reaction of phenol 5delds sallcylaldehyde. In presence of sodium hydroxide, phenol generates phenoxlde Ion which Is even more reactive than phenol. Thus, In alkaline medium, phenol undergoes Kolbe s reaction. 

Experiment 2. Effect of Molar Ratio of Sodium Hydroxide to Phenol of Phenolic Resin on Strength Properties of Lignin-Phenolic Resin Adhesives. Sodium hydroxide has been the predominant chemical used as a catalyst in resol resin technology. Through variation in the amounts of the catalyst and the method of catalyst addition, a wide variety of resin systems can be formulated. This experiment examined the properties of phenolic resins formulated with various sodium hydroxide/phenol ratios and their effects on the bond properties of structural flakeboards made with lignin-phenolic resin adhesive systems. Variables for resin preparation were four molar ratios of sodium hydroxide/phenol (i.e., 0.2, 0.45,0.7, and 0.95). The formaldehyde/phenol ratio and solids content were fixed at 3/1 and 42%, respectively. 

Molar Ratios of Sodium Hydroxide/Phenol. Table II summarizes the effect of varying molar ratios of NaOH/phenol on pH, viscosity, solid content, specific gravity, gel time, and molecular weight of the resins. The GPC chromatograms of the phenolic resins reacted at different NaOH/phenol ratios are given in Figure 4. 

For example, oxidation of acenaphthene by red lead in acetic acid gives 7-acenaphthenol acetate, from which 7-acenaphthenol is obtained by saponification with methanolic sodium hydroxide. Phenols may be prepared indirectly from aromatic aldehydes by oxidation with peracetic acid followed by hydrolysis of the resulting aryl formate. "... 

From Sulphonic Acids.—As previously stated, the methods of formation of phenols are wholly different from those of alcohols, and, together with their reactions, prove the constitution to be as we have given it, viz.. Ring—OU. The synthesis which is most generally used industrially is that from sulphonic acids, i. 520). When a salt of benzene sulphonic acid is fused with potassium or sodium hydroxide, phenol is formed together with a sulphite salt of the metal, according to the following reaction ... 

The pH of EMLA cream is 9.4 (the excipient contains sodium hydroxide). Phenol is more active in an acid environment. Impregnating the skin, for 1 hour, with a mixture at pH 9.4 will change the physiological balance of the skin, its acidity, its permeability and the activity of phenol. 

Sodium tetrahydridoborate sodium hydroxide Phenols from phenolketones... 

Potassium hydroxide Phenols from 2-pyrones Cation specificity... 

Magnesium carbonate hydroxide Phenol-formaldehyde resin Styrene/acrylates copolymer... 

Alkyl-aryl ethers are often synthesized by carefully controlling solubility. Both the alkyl halide and phenol are dissolved in dichloromethane then the solution is mixed with an aqueous solution of sodium hydroxide. Phenol, a poor nucleophile, reacts with sodium hydroxide in the aqueous phase to form the phenoxide ion, a good nucleophile. Alkyl-aryl ethers can be synthesized by treating the sodium salt of a phenol with an alkyl halide. The following example illustrates the Williamson synthesis of allyl-aryl ethers. The Bu N+Br is used to facilitate reaction between the polar phenoxide salt and the hydrophobic alkyl halide in the mixed solvent. 

Cuprous oxide sodium hydroxide Phenols from ar. chlorides... 

When reacted with sodium hydroxide, phenol forms a salt (sodium phenoxide) plus water. The reaction of sodium metal with phenol produces sodium phenoxide and hydrogen gas. 

Soybean meal Soidium hydroxide Phenol (erj stals Paraformaldehyde... 

C2H4N2O3, NH2CONHCOOH. Unknown in the free state as it breaks down immediately to urea and COi- The NH4, Ba, Ca, K and Na salts are known and are prepared by treating ethyl allophanate with the appropriate hydroxide. The esters with alcohols and phenols are crystalline solids, sparingly soluble in water and alcohol. They are formed by passing cyanic acid into alcohols or a solution of an alcohol or phenol in benzene. The amide of allophanic acid is biuret. Alcohols are sometimes isolated and identified by means of their allophanates. 

Cannot be used for alcohols, phenols or amines, with all of which it combines. Not advisable for acidic liquids, as ordinary calcium chloride always contains some calcium hydroxide owing to partial hydrolysis during preparation. Usually used for alcohols (see p. 88). Cannot be used for acidic compounds, nor for esters, which it would hydrolyse. 

Although the acetylation of alcohols and amines by acetic anhydride is almost invariably carried out under anhydrous conditions owing to the ready hydrolysis of the anhydride, it has been shown by Chattaway (1931) that phenols, when dissolved in aqueous sodium hydroxide solution and shaken with acetic anhydride, undergo rapid and almost quantitative acetylation if ice is present to keep the temperature low throughout the reaction. The success of this method is due primarily to the acidic nature of the phenols, which enables them to form soluble sodium derivatives, capable of reacting with the acetic... 

The above condensations occur only in alkaline solution, hence the need of an excess of sodium hydroxide in the phenol solutions. 

Place the distillate in a separating-funnel and extract the benzonitrile twice, using about 30 ml. of ether for each extraction. Return the united ethereal extracts to the funnel and shake with 10% sodium hydroxide solution to eliminate traces of phenol formed by decomposition of the benzenediazonium chloride. Then run off the lower aqueous layer, and shake the ethereal solution with about an equal volume of dilute sulphuric acid to remove traces of foul-smelling phenyl isocyanide (CaHjNC) which are always present. Finally separate the sulphuric acid as completely as possible, and shake the ether with water to ensure absence of acid. Run off the water and dry the benzonitrile solution over granular calcium chloride for about 20 minutes. 

When an aqueous solution of a diazonium salt is added to an alkaline solution of a phenol, coupling occurs with formation of an azo-compound (p. 188). If ho vc cr the ntiueous solution of the diazonium salt, t. . ., />-bromohenzene diazonium chloride, is mixed with an excess of an aromatic hydrocarbon, and aqueous sodium hydroxide then added to the vigorously stirred mixture, the diazotate which is formed, e.g., BrC,H N OH, dissolves in the hydrocarbon and there undergoes decomposition with the formation of nitrogen and two free radicals. The aryl free radical then reacts with the hydrocarbon to give a... 

Dissolve 3-8 g. of sodium in 75 mi. of rectified spirit, using otherwise the same conditions as in the preparation of anisole. Then add 15 g. of phenol, and to the clear solution add 13 2 ml. (19-1 g., n mois.) of ethyl bromide. Continue precisely as in the preparation of anisole, shaking the ethereal extract with sodium hydroxide solution as before in order to eliminate any unchanged phenol. Finally collect the fraction boiling at 168-172°. Yield, 14 g. 

Thus phenol when subjected to the Schotten Baumann reaction first dissolves in the sodium hydroxide to give sodium phenoxide, which then undergoes CgH COCl + NaOCgH, CgHaCOOCeHj XaCl... 

The reaction between 3,5 dinitrobenzoyl chloride and compounds containing the OH, NHj, or NH groups is very rapid, and therefore is particularly suitable for identification purposes cf. pp. 335, 338, 381). It is usual to have sodium hydroxide present during the reaction with phenols and amino-acids, but this is not necessary with alcohols if they are dry. 

The Schotten-Baumann reaction may also be carried out, using, for example, benzene sulphonyl chloride, CeH,SO,Cl (. e., the acid chloride of benzene sulphonic acid, C H5SOjOH) in place of benzoyl chloride, and similar deri a-tives are obtained. Thus when phenol is dissolved in an excess of 10% sodium hydroxide solution, and then shaken with a small excess of benzene sulphonyl... 

Required Phenol, 0-4 g. 10% sodium hydroxide, 2-5 ml. toluene-/)-sulphonyl chloride, 0-9 g. acetone, 4 ml. 

Solubility in sodium hydroxide solution. See Section 4, p. 329. Note also that phenols dissolve in NaOH solution to give phenoxides. 

C) Phenacyl and p-Bromophenacyl esters. Ammonium salts in aqueous-ethanolic solution do not however usually condense satisfactorily with phenacyl and />-bromophenacyl bromide. The aqueous solution of the ammonium salt should therefore be boiled with a slight excess of sodium hydroxide to remove ammonia, and the solution then cooled, treated with hydrochloric acid until just alkaline to phenol-phthalein, and then evaporated to dryness. The sodium salt is then treated as described (p. 349) to give the ester. Filter the ester, and wash with water to remove senium halide before recrystallisation. 

---