Hydration calcium hydroxide

Neutralization. The choice of a reagent for pH adjustment depends on cost ease and safety of storage and handling effectiveness, eg, for removing heavy metals, buffet characteristics of the pH titration curve as they affect pH control and avadabihty. The three principal reagents for neutralization of acid wastes are sodium hydroxide, sodium carbonate, and hydrated calcium hydroxide. 

SYNS BELL MINE BIOCALC CALCIUM DIHYDROXIDE CALCIUM HYDRATE CALCIUM HYDROXIDE (ACGIH, OSHA) CALVIT CARBOXIDE O HYDRATED LIME KALKHYDRATE O KEMIKAL O UMBUX UME MILK LIME WATER MILK OF LIME SLAKED UME... 

The first applications of glass fibres in concrete-like composites were published by Biryukovitch et al. (1965), who carried out tests on elements with high alumina cement. The paste made with that cement is characterized by pH from 11.8 up to 12.05 with total amount of alkalis from only 0.15% to 0.20% and during hydration calcium hydroxide does not appear. In the... 

Some carbonates are important industrial chemicals. Calcium carbonate occurs naturally in several forms, including limestone, and is used in the production of quicklime, calcium oxide CaO, slaked (or hydrated) lime, calcium hydroxide Ca(OH)2 and cement. 

Tricalcium phosphate, Ca2(P0 2> is formed under high temperatures and is unstable toward reaction with moisture below 100°C. The high temperature mineral whidockite [64418-26-4] although often described as P-tricalcium phosphate, is not pure. Whidockite contains small amounts of iron and magnesium. Commercial tricalcium phosphate prepared by the reaction of phosphoric acid and a hydrated lime slurry consists of amorphous or poody crystalline basic calcium phosphates close to the hydroxyapatite composition and has a Ca/P ratio of approximately 3 2. Because this mole ratio can vary widely (1.3—2.0), free lime, calcium hydroxide, and dicalcium phosphate may be present in variable proportion. The highly insoluble basic calcium phosphates precipitate as fine particles, mosdy less than a few micrometers in diameter. The surface area of precipitated hydroxyapatite is approximately... 

The hydrolysis process, ie, reaction with water, for lime is called slaking and produces hydrated lime, Ca(OH)2. Calcium hydroxide is a strong base but has limited aqueous solubiHty, 0.219 g Ca(OH)2/100 g H2O, and is therefore often used as a suspension. As an alkaH it finds widespread iadustrial appHcatioa because it is cheaper than sodium hydroxide. 

Precipitated Calcium Carbonate. Precipitated calcium carbonate can be produced by several methods but only the carbonation process is commercially used in the United States. Limestone is calcined in a kiln to obtain carbon dioxide and quicklime. The quicklime is mixed with water to produce a milk-of-lime. Dry hydrated lime can also be used as a feedstock. Carbon dioxide gas is bubbled through the milk-of-lime in a reactor known as a carbonator. Gassing continues until the calcium hydroxide has been converted to the carbonate. The end point can be monitored chemically or by pH measurements. Reaction conditions determine the type of crystal, the size of particles, and the size distribution produced. 

In hydrations at ordinary temperatures (27) pure C S and P-C2S, corresponding to the aHte and beHte phases ia Pordand cements, respectively, react with water to form calcium hydroxide and a single calcium siHcate hydrate (C—S—H). Using cement chemists notation... 

Fig. 5. The early hydration reactions of tricalcium aluminate in the presence of gypsum and calcium hydroxide. Initial molar proportions l-C A ...

Po22olans contain reactive siUca which reacts with cement and water by combining with the calcium hydroxide released by the hydration of the calcium siUcates to produce additional calcium sihcate hydrate. If sufficient siUca is added, about 30% of the weight of cement, the calcium hydroxide can... 

The composition of the Hquid phase during the early hydration of Portiand cements is controlled mainly by the solution of calcium, sulfate, sodium, and potassium ions. Very Httie alumina, siHca, or iron are present in solution. Calcium hydroxide, as calcium oxide, and gypsum, as calcium sulfate, alone have solubihties of about 1.1 and 2.1 g/L at 25°C, respectively. In the presence of alkaHes released in the first 7 min, the composition tends to be governed by the equiHbrium ... 

Bleaching Powder. This material, known siace 1798, is made by chlorination of slightly moist hydrated lime, calcium hydroxide [1305-62-0] Ca(OH)2- It has the empirical formula Ca(OCl)2 CaCl2 Ca(OH)2 2H20. Its compositioa, loag a subject of coatroversy, was estabHshed by phase studies, microscopy, and x-ray diffraction techniques (241). The initial chlorination products are monobasic calcium chloride [14031-38-4] and dibasic calcium hypochlorite [12394-14-8] ... 

Kalk-hiitte,/. lime kiln, -hydrat, n. hydrate of lime (calcium hydroxide). 

Also quicklime, unslaked lime, and calcium oxide. Hydrated lime is calcium hydroxide (Ca(OH)2). ... 

Cowan Teeter (1944) reported a new class of resinous substances based on the zinc salts of dimerized unsaturated fatty acids such as linoleic and oleic acid. The latter is referred to as dimer acid. Later, Pellico (1974) described a dental composition based on the reaction between zinc oxide and either dimer or trimer acid. In an attempt to formulate calcium hydroxide cements which would be hydrolytically stable, Wilson et al. (1981) examined cement formation between calciimi hydroxide and dimer acid. They found it necessary to incorporate an accelerator, alimiiniiun acetate hydrate, Al2(OH)2(CHgCOO)4.3H2O, into the cement powder. 

Calcium hydroxide is known as hydrated lime or slaked lime, and it is used extensively in some applications because it is less expensive than NaOH or KOH. It reacts with C02 to form CaC03, which binds particles of sand and gravel together in mortar and cement. 

In Investigation 9-A, you will collect solubility data and use these data to determine a Ksp for calcium hydroxide, Ca(OH)2. When you calculate Ksp, you assume that the dissolved ionic compound exists as independent hydrated ions that do not affect one another. This assumption simplifies the investigation, but it is not entirely accurate. Ions do interfere with one another. As a result, the value of Ksp that you calculate will be just an approximation. iCp values that are calculated from data obtained from experiments such as Investgation 9-A are generally higher than the actual values. 

Calcium hydroxide [Ca (OH) ] is known as slaked or hydrated lime and is formed by exposing calcium oxide to water. Slaked lime is less caustic than quick lime. Therefore, it is used to line football fields. (Unslaked lime, CaO, is very caustic when wet, and if it is used on playing fields, players may receive caustic burns.) Calcium hydroxide has many uses, including as an ingredient for stonemasons mortar, cements, whitewash, and soil conditioner (high pH), as a food additive, and as a human depilatory. 

---