Filtrate, definition

This expression shows the relationship between filtration time and filtrate volume. The equation is applicable to both incompressible or compressible calces, because at constant AP the values and x are constant. For constant AP, an increase in the filtrate volume results in a reduction in the filtration rate. If we assume a definite filtering apparatus and set up a constant temperature and filtration pressure, then the values of Rf, r , fi and AP will be constant. We now take note of the well-known filtration constants K and C, which are derived from the above expressions ... 

Constants K and C can be readily obtained from experiments conducted on a prototype machine, from whence the volume of filtrate obtained for a definite time interval (for a specified filter, at the same pressure and temperature) can be calculated. If process parameters are varied, new constants K and C can be estimated from the above expressions. The last expression can be further modified by denoting the constant r as = CVK, and substituting ... 

The permeability relative to a pure liquid, usually water, may be determined with the help of different devices that operate on the principle of measurement of filtrate volume obtained over a definite time interval at known pressure drop and filtration area. The permeability is usually expressed in terms of the hydraulic resistance of the filter medium. This value is found from ... 

The characteristics of the pump relate the applied pressure on the cake to the flowrate at the exit face of the filter medium. The cake resistance determines the pressure drop. During filtration, liquid flows through the porous filter cake in the direction of decreasing hydraulic pressure gradient. The porosity (e) is at a minimum at the point of contact between the cake and filter plate (i.e., where x = 0) and at a maximum at the cake surface (x = L) where sludge enters. A schematic definition of this system is illustrated in Figure 2. 

The exact relationship can be derived from experiments in a device called a compression-permeability cell. Once this relationship is defined, the integral of the right side of Equation 34 may be evaluated analytically (or if the relationship is in the form of a curve, the evaluation may be made graphically). The interrelation between W and Pj is established by the pump characteristics, which define q = f(W) in Equation 34. Filtration time may then be determined from the following definition ... 

Reealling that by definition v = volume of eake deposited/volume of elear filtrate eolleeted, then the rate of deposition of eake, 2cake, is given by... 

During operation, the filter eake builds up and is periodieally diseharged. The time taken to build up eake ean be estimated by integrating equation 4.87 but first it is neeessary to derive a relationship between eake thiekness and filtrate volume, viz. by definition... 

The direct synthetic process is described in U.S. Patent 2,772,280. A solution of 73.3 g (0.332 mol) of (3-aminoxyalanine ethyl ester dihydrochloride in 100 ml of water was stirred in a 500 ml 3-necked round-bottomed flask cooled in an ice-bath. To the above solution was added over a 30-minute period 65.6 g (1.17 mols) of potassium hydroxide dissolved in 100 ml of water. While the pH of the reaction mixture was 7 to 10.5, a red color appeared which disappeared when the pH reached 11 to 11.5. The light yellow solution was allowed to stand at room temperature for 14 hour and then added to 1,800 ml of 1 1 ethanol-isopropanol. The reaction flask was washed twice with 10 ml portions of water and the washings added to the alcohol solution. The precipitated salts were filtered out of the alcohol solution and the filtrate cooled to 5°C in a 5 liter 3-necked round-bottomed flask. To the cold, well-stirred solution was added dropwise over a 35-minute period sufficient glacial acetic acid to bring the pH of the alcohol solution to 6.0. When the pH of the solution had reached 7 to 7.5, the solution was seeded and no further acetic acid added until Crystallization of the oil already precipitated had definitely begun. The crystalline precipitate was collected on a filter, washed twice with 1 1 ethanol-isopropanol and twice with ether. The yield of 4-amino-3-isoxazolidone was 22.7 g. 

Water soluble protein with a relative molecular mass of ca. 32600, which particularly contains copper and zinc bound like chelate (ca. 4 gram atoms) and has superoxide-dismutase-activity. It is isolated from bovine liver or from hemolyzed, plasma free erythrocytes obtained from bovine blood. Purification by manyfold fractionated precipitation and solvolyse methods and definitive separation of the residual foreign proteins by denaturizing heating of the orgotein concentrate in buffer solution to ca. 65-70 C and gel filtration and/or dialysis. 

Definition of Ej and E2 eonformations of the a subunit of Na,K-ATPase involves identification of cleavage points in the protein as well as association of cleavage with different rates of inactivation of Na,K-ATPase and K-phosphatase activities [104,105]. In the Ei form of Na,K-ATPase the cleavage patterns of the two serine proteases are clearly distinct. Chymotrypsin cleaves at Leu (C3), Fig. 3A, and both Na,K-ATPase and K-phosphatase are inactivated in a monoexponential pattern [33,106]. Trypsin cleaves the E form rapidly at Lys ° (T2) and more slowly at Arg (T3) to produce the characteristie biphasic pattern of inactivation. Localization of these splits was determined by sequencing N-termini of fragments after isolation on high resolution gel filtration columns [107]. 

Traditionally, the definition of suspended solids as used in the characterization of wastewater is defined according to the method used in the analysis of total suspended solids (TSS), e.g., as described in Standard Methods for the Examination of Water and Wastewater (1998). This definition of suspended solids is based on a filtration—or sometimes also centrifugation—procedure and is, therefore, appropriate for particles having a diameter > 1-0.5 pm (Figure 3.5). 

One could go on with examples such as the use of a shirt rather than sand reduce the silt content of drinking water or the use of a net to separate fish from their native waters. Rather than that perhaps we should rely on the definition of a chemical equilibrium and its presence or absence. Chemical equilibria are dynamic with only the illusion of static state. Acetic acid dissociates in water to acetate-ion and hydrated hydrogen ion. At any instant, however, there is an acid molecule formed by recombination of acid anion and a proton cation while another acid molecule dissociates. The equilibrium constant is based on a dynamic process. Ordinary filtration is not an equilibrium process nor is it the case of crystals plucked from under a microscope into a waiting vial. 

When we think of paper we think of it primarily as a writing and printing medium, and then perhaps as a wrapping and packaging material. However, because many other products—for example, tissue, board, filtration media, surgical wrap, etc.—are made by essentially the same process, a broader definition is more appropriate. For the purpose of this text therefore, paper will be defined in... 

The operating rates of each process were fixed at 22 700 annual tonnes. The yield of gross product to Class I or prime product was estimated by this author and is included in Table 16.4. Semi-washed PET flake will contain some extraneous material, by definition. All processes will lose some potential ethylene glycol due to decomposition. Hydrolysis processes are expected to lose isophthalates in the crystallization step. The methanolysis and glycolysis with filtration processes generally recover more materials for inclusion with product. Simple glycolysis recovers the most, but still loses some ethylene glycol. 

---