Extraction, commercial processes standard

Dual-Solvent Fractional Extraction As discussed in Commercial Process Schemes, under Introduction and Overview, fractional extraction often may be viewed as combining product purification with product recovery by adding a washing section to the stripping section of a standard extraction process. In the stripping section, the mass transfer we focus on is the transfer of the product solute from the wash solvent into the extraction solvent. If we assume dilute conditions and use shortcut calculations for illustration, the extraction factor is given by... 

Several standard DNA isolation kits are commercially available, including the QIAamp DNA Stool Mini Kit and the DNeasy Plant Mini Kit made by Qiagen. Both of these products are based on silica gel membrane technology and allow for the extraction of total DNA from processed foods and raw foodstuffs, respectively. In... 

The quality of extracted citrus juices depends on enzyme reactions that occur not only in the fruit during the development period, but also in the juice during processing. When juice is extracted from citrus fruit, enzymes are released from their normal restraint in the cell. Several of these enzymes catalyze reactions that adversely affect taste and appearance of the juice. Unless the reactions are controlled, the juice products will not meet the standards of quality set up by the USDA Food Safety and Quality Service. The two reactions of commercial importance are the hydrolysis of pectin to pectic acid, which clarifies juice, and the lactonization of limonoic acid A-ring lactone to the bitter compound, limonin. Research efforts to identify and characterize the reactions, to isolate and purify the enzymes, and to develop methods to control the reactions are described in this review. 

From a commercial point of view, there is an environmental downside to the commonly used solvent extraction of aqueous solutions, namely that the extracted aqueous layer needs to be processed (often by no more than stripping volatile solvents) before being sent on to standard wastewater treatment systems. 

The analysis of phytochemicals is a tedious process involving several steps in which care must be taken to avoid degradation and contamination. Recent advancements in extraction, concentration, purification and analytical procedures of phytochemicals have been made, but additional developments are needed to assist in the identification and quantification of the diverse array of phytochemicals present in plants and foods, as well as metabolites in biological samples. Specifically there is a need to automate sample extraction, clean-up, and concentration steps to facilitate the screening of phytochemicals develop analytical methods with improved sensitivity, resolution and throughput that utilize less organic solvents and develop concentration and purification methods to produce analytical standards that are not available commercially. Continued advancements in sample preparation and analytical techniques will assist researchers in their quest to identify and quantify the vast array of phytochemicals present in plants... 

Supercritical fractionation of a liquid lipid feed material is usually carried out in a packed column. Standard columns are not available commercially and have to be custom built either in-house or by manufacturers of extraction units. Lab-scale and pilot-scale supercritical columns, 0.6-13.6 m high with internal diameters of 14.3-68 mm are available in research labs around the world and have been used for the processing of deodorizer distillates (56, 57, 86-90), vegetable and fish oils (91-105), cocoa butter, and milkfat (106-109). A schematic diagram of a typical SCCO2 fractionation column (2.8 m, 2.54 cm o.d.), which was designed and built... 

Cotton fibers are single cells composed primarily ( 96%) of the polymer cellulose. In our laboratory (5), cotton fibers were dissolved directly in the solvent DMAC-LiCl. This procedure solubilizes fiber cell wall components directly without prior extraction or derivatization, processes that could lead to degradation of high MW components. MW determinations have been carried out by a size-exclusion chromatography (SEC) system using commercial columns and instrumentation with DMAC-LiCl as the mobile phase. Incorporation of viscometry and refractive index (RI) detectors (6) allowed application of the universal calibration concept (7) to obtain MW distributions (MWDs) based on well-characterized narrow-distribution polystyrene standards (5). The universal calibration concept used by incorporation of dual detectors bypasses the need for cellulose standards. There are no cellulose standards available. Polystyrene standards for a wide range of MWs dissolved readily in DMAC-0.5% LiCl with no activation necessary. 

---