Diels cycloaddition

Breslow supported this suggestion by demonstrating that the cycloaddition can be further accelerated by adding anti cliaotropic salts such as lithium chloride, whereas chaotropic salts such as guanidium chloride led to a retardation " "" ". On the basis of these experiments Breslow excluded all other possible explanations for the special effect of water on the Diels-Alder reaction " . 

Alternatively, authors have repeatedly invoked the internal pressure of water as an explanation of the rate enhancements of Diels-Alder reactions in this solvent ". They were probably inspired by the well known large effects of the external pressure " on rates of cycloadditions. However, the internal pressure of water is very low and offers no valid explanation for its effect on the Diels-Alder reaction. The internal pressure is defined as the energy required to bring about an infinitesimal change in the volume of the solvents at constant temperature pi = (r)E / Due to the open and... 

Apart from the thoroughly studied aqueous Diels-Alder reaction, a limited number of other transformations have been reported to benefit considerably from the use of water. These include the aldol condensation , the benzoin condensation , the Baylis-Hillman reaction (tertiary-amine catalysed coupling of aldehydes with acrylic acid derivatives) and pericyclic reactions like the 1,3-dipolar cycloaddition and the Qaisen rearrangement (see below). These reactions have one thing in common a negative volume of activation. This observation has tempted many authors to propose hydrophobic effects as primary cause of ftie observed rate enhancements. 

Mechanistic investigations have focused on the two pericyclic reactions, probably as a consequence of the close mechanistic relation to the so successful aqueous Diels-Alder reaction. A kinetic inquest into the effect of water on several 1,3-dipolar cycloadditions has been performed by Steiner , van... 

Dramatic rate accelerations of [4 + 2]cycloadditions were observed in an inert, extremely polar solvent, namely in5 M solutions oflithium perchlorate in diethyl ether(s 532 g LiC104 per litre ). Diels-Alder additions requiring several days, 10—20 kbar of pressure, and/ or elevated temperatures in apolar solvents are achieved in high yields in some hours at ambient pressure and temperature in this solvent (P.A. Grieco, 1990). Also several other reactions, e.g, allylic rearrangements and Michael additions, can be drastically accelerated by this magic solvent. The diastereoselectivities of the reactions in apolar solvents and in LiClO EtjO are often different or even complementary and become thus steerable. 

As final examples, the intramolecular cyclopropane formation from cycloolefins with diazo groups (S.D. Burke, 1979), intramolecular cyclobutane formation by photochemical cycloaddition (p. 78, 297f., section 4.9), and intramolecular Diels-Alder reactions (p. 153f, 335ff.) are mentioned. The application of these three cycloaddition reactions has led to an enormous variety of exotic polycycles (E.J. Corey, 1967A). 

Malpass, 1977). Diels-Alder type [2 + 4]-cycloadditions are possible with certain hetero-"ene components (J.R. Malpass, 1977 S.F. Martin, 1980) or with highly reactive o-quinodimethanes as diene components (W. Oppoizer, I978A). 

Indoles are usually constructed from aromatic nitrogen compounds by formation of the pyrrole ring as has been the case for all of the synthetic methods discussed in the preceding chapters. Recently, methods for construction of the carbocyclic ring from pyrrole derivatives have received more attention. Scheme 8.1 illustrates some of the potential disconnections. In paths a and b, the syntheses involve construction of a mono-substituted pyrrole with a substituent at C2 or C3 which is capable of cyclization, usually by electrophilic substitution. Paths c and d involve Diels-Alder reactions of 2- or 3-vinyl-pyrroles. While such reactions lead to tetrahydro or dihydroindoles (the latter from acetylenic dienophiles) the adducts can be readily aromatized. Path e represents a category Iley cyclization based on 2 -I- 4 cycloadditions of pyrrole-2,3-quinodimcthane intermediates. 

Two types of cycloaddition reactions have found application for the Synthetic elaboration of indoles. One is Diels-Alder reactions of 2- and 3-vinylindoles which yield partially hydrogenated carbazoles. The second is cycloaddition reactions of 2,3-indolequinodimethane intermediates which also construct the carbazole framework. These reactions arc discussed in the following sections. 

Scheme 99) (416). The 4-acetyloxy-5-ary]thiazo]e or 4-methoxy-5-arylthiazole, which are models of the protomer (174b) do not give cycloaddition products under the same experimental conditions. This rules out the possibility of a Diels-Alder reaction involving the protomer (174b) (416). 

In contrast to oxazole, thiazole does not undergo the Diels-Alder cycloaddition reaction (331). This behavior can be correlated with the more dienic character of oxazole, relative to thiazole, as shown by quantochemical calculations (184). 

The alkene that adds to the diene is called the dienophile Because the Diels-Alder reaction leads to the formation of a ring it is termed a cycloaddition reaction The prod uct contains a cyclohexene ring as a structural unit... 

The Diels-Alder cycloaddition is one example of a pencyclic reaction, which is a one step reaction that proceeds through a cyclic transition state Bond formation occurs at both ends of the diene system and the Diels-Alder transition state involves a cyclic array of six carbons and six tt electrons The diene must adopt the s cis conformation m the transition state... 

The simplest of all Diels-Alder reactions cycloaddition of ethylene to 1 3 butadi ene does not proceed readily It has a high activation energy and a low reaction rate Substituents such as C=0 or C=N however when directly attached to the double bond of the dienophile increase its reactivity and compounds of this type give high yields of Diels-Alder adducts at modest temperatures... 

The product of a Diels-Alder cycloaddition always contains one more ring than was present m the reactants The dienophile maleic anhydride contains one ring so the product of Its addition to a diene contains two... 

Let us now examine the Diels-Alder cycloaddition from a molecular orbital perspective Chemical experience such as the observation that the substituents that increase the reac tivity of a dienophile tend to be those that attract electrons suggests that electrons flow from the diene to the dienophile during the reaction Thus the orbitals to be considered are the HOMO of the diene and the LUMO of the dienophile As shown m Figure 10 11 for the case of ethylene and 1 3 butadiene the symmetry properties of the HOMO of the diene and the LUMO of the dienophile permit bond formation between the ends of the diene system and the two carbons of the dienophile double bond because the necessary orbitals overlap m phase with each other Cycloaddition of a diene and an alkene is said to be a symmetry allowed reaction... 

Contrast the Diels-Alder reaction with a cycloaddition reaction that looks superfl cially similar the combination of two ethylene molecules to give cyclobutane... 

Its Strained triple bond makes benzyne a relatively good dienophile and when benzyne IS generated in the presence of a conjugated diene Diels-Alder cycloaddition occurs... 

The transition state for the first step of the Claisen rearrangement bears much m common with the transition state for the Diels-Alder cycloaddition Both involve a con certed six electron reorganization... 

Miscellaneous Reactions. Some hydantoin derivatives can serve as precursors of carbonium—immonium electrophiles (57). 5-Alkoxyhydantoins are useful precursors of dienophiles (17), which undergo Diels-Alder cycloadditions under thermal conditions or in the presence of acid catalysis (58). The pyridine ring of Streptonigrine has been constmcted on the basis of this reaction (59). 

Vinylboranes are interesting dienophiles in the Diels-Alder reaction. Alkenylboronic esters show moderate reactivity and give mixtures of exo and endo adducts with cyclopentadiene and 1,3-cyclohexadiene (441). Dichloroalkenylboranes are more reactive and dialkylalkenylboranes react even at room temperature (442—444). Dialkylalkenylboranes are omniphilic dienophiles insensitive to diene substitution (444). In situ formation of vinyl-boranes by transmetaHation of bromodialkylboranes with vinyl tri alkyl tin compounds makes possible a one-pot reaction, avoiding isolation of the intermediate vinylboranes (443). Other cycloadditions of alkenyl- and alkynylboranes are known (445). 

Cycloaddition Reactions. Methacrylates have been widely used as dienophiles in Diels-Alder reactions (22—24). 

Methacrylates have also found use in diastereoselective -ene reactions. Although not a cycloaddition reaction, this reaction is mechanistically related to the Diels-Alder reaction (37). 

Polyimides have been synthesized by Diels-Alder cycloaddition of bismaleimides and substituted biscydopentadienones (81,82). The iatermediate tricychc ketone stmcture spontaneously expeU carbon monoxide to form dihydrophthalimide rings, which are readily oxidized to imides ia the presence of nitrobenzene. 

The diene undergoes Diels-Alder cycloaddition with dienophiles. Polyimides have been synthesized from various imide-containing benzocyclobutenes and dienophiles (83—85). 

The synthesis of natural products containing the quinonoid stmcture has led to intensive and extensive study of the classic diene synthesis (77). The Diels-Alder cycloaddition of quinonoid dienophiles has been reported for a wide range of dienes (78—80). Reaction of (2) with cyclopentadiene yields (79) [1200-89-1] and (80) [5439-22-5]. The analogous 1,3-cyclohexadiene adducts have been the subject of C-nmr and x-ray studies, which indicate the endo—anti—endo stereostmcture (81). 

Characteristic reactions of singlet oxygen lead to 1,2-dioxetane (addition to olefins), hydroperoxides (reaction with aHyhc hydrogen atom), and endoperoxides (Diels-Alder "4 -H 2" cycloaddition). Many specific examples of these spectrally sensitized reactions are found iu reviews (45—48), earlier texts (15), and elsewhere iu the Engchpedia. 

Since diazaquinones are among the most powerful dienophiles, they undergo [4+2] cycloaddition (Diels-Alder) reactions with a great variety of dienes to give various heterocyclic systems accessible with difficulty by other methods. Diazaquinone reacts with butadiene and substituted butadienes, carbocyclic and heterocyclic dienes, 1-vinylcycloalkenes, polyaromatic compounds and vinylaromatic compounds to afford bicyclic and polycyclic bridgehead diaza systems, including diazasteroids (Scheme 56). 

Benzo[Z)]furans and indoles do not take part in Diels-Alder reactions but 2-vinyl-benzo[Z)]furan and 2- and 3-vinylindoles give adducts involving the exocyclic double bond. In contrast, the benzo[c]-fused heterocycles function as highly reactive dienes in [4 + 2] cycloaddition reactions. Thus benzo[c]furan, isoindole (benzo[c]pyrrole) and benzo[c]thiophene all yield Diels-Alder adducts (137) with maleic anhydride. Adducts of this type are used to characterize these unstable molecules and in a similar way benzo[c]selenophene, which polymerizes on attempted isolation, was characterized by formation of an adduct with tetracyanoethylene (76JA867). 

The distinction between these two classes of reactions is semantic for the five-membered rings Diels-Alder reaction at the F/B positions in (269) (four atom fragment) is equivalent to 1,3-dipolar cycloaddition in (270) across the three-atom fragment, both providing the 47t-electron component of the cycloaddition. Oxazoles and isoxazoles and their polyaza analogues show reduced aromatic character and will undergo many cycloadditions, whereas fully nitrogenous azoles such as pyrazoles and imidazoles do not, except in certain isolated cases. 

Just as in the Diels-Alder reaction, 1,4-dipolar cycloadditions lead to six-membered rings. Their principal use in five-membered heterocycles is for ring annulations giving [5,6] ring-fused systems. 

---