Pyrroles from

It is conceivable that related ligands, e.g. dehydrocorrins, could be obtained from pyrrolic units using pathways similar to those used for porphyrins and could be hydrogenated to corrins. This has indeed been achieved (I.D. Dicker, 1971), but it is, of course, impossible to introduce the nine chiral centres of cobyrinic acid by such procedures. 

The material in the succeeding chapters describes both the synthesis of the indole ring and means of substituent modification which are especially important in indole chemistry. The first seven chapters describe the preparation of indoles from benzenoid precursors. Chapter 8 describes preparation of indoles from pyrroles by annelation reactions. These syntheses can be categorized by using the concept of bond disconnection to specify the bond(s) formed in the synthesis. The categories are indicated by the number and identity of the bond(s) formed. This classification is given in Scheme 1.1. 

Indoles are usually constructed from aromatic nitrogen compounds by formation of the pyrrole ring as has been the case for all of the synthetic methods discussed in the preceding chapters. Recently, methods for construction of the carbocyclic ring from pyrrole derivatives have received more attention. Scheme 8.1 illustrates some of the potential disconnections. In paths a and b, the syntheses involve construction of a mono-substituted pyrrole with a substituent at C2 or C3 which is capable of cyclization, usually by electrophilic substitution. Paths c and d involve Diels-Alder reactions of 2- or 3-vinyl-pyrroles. While such reactions lead to tetrahydro or dihydroindoles (the latter from acetylenic dienophiles) the adducts can be readily aromatized. Path e represents a category Iley cyclization based on 2 -I- 4 cycloadditions of pyrrole-2,3-quinodimcthane intermediates. 

A mild and effective method for obtaining N- acyl- and N- alkyl-pyrroles and -indoles is to carry out these reactions under phase-transfer conditions (80JOC3172). For example, A-benzenesulfonylpyrrole is best prepared from pyrrole under phase-transfer conditions rather than by intermediate generation of the potassium salt (81TL4901). In this case the softer nature of the tetraalkylammonium cation facilitates reaction on nitrogen. The thallium salts of indoles prepared by reaction with thallium(I) ethoxide, a benzene-soluble liquid. 

Electron donation from pyrrole-like nitrogen, or to a lesser extent from analogous sulft or oxygen atoms, helps electrophilic attack at azole carbon atoms, but as the number c heteroatoms in the ring increases, the tendency toward electrophilic attack at both C an N decreases rapidly. 

ROTHEMUND Porphine Synthesis Porphine synthesis from pyrrols and aldehydes... 

The N " -BOC group can be removed under the usual conditions for removing the BOC group CF3COOH and HF. It can also be removed with hydrazine and NH3/ MeOH. NaOMe/MeOH/THF has been used to remove the BOC group from pyrroles in 66-99% yield. Thermolysis at 180° cleaves the BOC group from indoles and pyrroles in 92-99% yield. 

The unsaturated tetraoxaquaterene (accompanied by linear condensation products) was first synthesized in 18.5% yield by the acid-catalyzed condensation of furan with acetone in the absence of added lithium salts. Other ketones also condensed with furan to give analogous products in 6-12% yield.A corresponding macrocycle was also prepared in 9% yield from pyrrole and cyclohexanone. The macrocyclic ether products have also been obtained by condensation of short linear condensation products having 2, 3, or 4 furan rings with a carbonyl compound. ... 

The cooled mixture is transferred to a 3-1. separatory funnel, and the ethylene dichloride layer is removed. The aqueous phase is extracted three times with a total of about 500 ml. of ether. The ether and ethylene chloride solutions are combined and washed with three 100-ml. portions of saturated aqueous sodium carbonate solution, which is added cautiously at first to avoid too rapid evolution of carbon dioxide. The non-aqueous solution is then dried over anhydrous sodium carbonate, the solvents are distilled, and the remaining liquid is transferred to a Claisen flask and distilled from an oil bath under reduced pressure (Note 5). The aldehyde boils at 78° at 2 mm. there is very little fore-run and very little residue. The yield of crude 2-pyrrolealdehyde is 85-90 g. (89-95%), as an almost water-white liquid which soon crystallizes. A sample dried on a clay plate melts at 35 0°. The crude product is purified by dissolving in boiling petroleum ether (b.p. 40-60°), in the ratio of 1 g. of crude 2-pyrrolealdehyde to 25 ml. of solvent, and cooling the solution slowly to room temperature, followed by refrigeration for a few hours. The pure aldehyde is obtained from the crude in approximately 85% recovery. The over-all yield from pyrrole is 78-79% of pure 2-pyrrolealdehyde, m.p. 44 5°. 

Pyrrolealdehyde has been prepared from pyrrole, chloroform, and potassium hydroxide from pyrrolemagnesium iodide and ethyl, propyl, or isoamyl formate and, by the method here described, from pyrrole, phosphorus oxychloride, and dimethylformamide. Smith has suggested a possible intermediate in this process. The method has also been applied to substituted pyrroles and is similar to that described in this series for the preparation of -dimethylaminobenzaldehyde from di-methylaniline. ... 

Under conditions more similar to those of the Reimer-Tiemann reaction 3-bromopyridine was obtained from pyrrole and bromo-form. Treatment of pyrrole with chloroform and aqueous alkali gave pyrrole-2-aldehyde curiously, the formation of 3-chloropyridine under these conditions does not appear to have been reported, in spite of being frequently quoted. However, indole gave both indole-3-aldehyde and 3-chloroquinoline under these conditions [Eq. (10)]. 

The Mitsunobu reaction was applied to the synthesis of pyrrolo[l,2-d [, 2,4]triazines from pyrrole derivative 71. Thus reduction of 71 gave alcohol 72, which on treatment with diethylazodicarboxylate and triphenyl phosphine gave 74 via the open chain intermediate 73. Hydrolysis of 74 gave 75 (84AG517) (Scheme 18). 

HydroxyNPYR [ ] has been identified as a urinary metabolite of NPYR in the rat (up to 1% of the dose), but was not detected when NPYR was incubated with subcellular fractions from rat liver and lung (13, 20). It has been proposed that further metabolism of leads to dimethy 1 amine, [ ], another urinary metabolite of NPYR, 2-Pyrrolidinone [3 ] has also been detected in the urine of rats treated with NPYR. Its origin has not been conclusively established, but it may form from pyrrol id inone-2-oxime (i6). 

The enzymes catalyzing the Kolbe-Schmitt carboxylation seem to occur ubiquitously. Some of them, such as 2,6-dihydroxybenzoate decarboxylase and pyrrole-2-carboxylate decarboxylase, catalyze efficiently the reverse carboxylation reaction and accumulate high concentration of 2,6-dihydroxybenzoate from 1,3-dihydroxybenzene and pyrrole-2-carboxylate from pyrrole, respectively, in the... 

An efficient synthesis of rigid tricyclic (5 5 5) nitrogen heterocycles 64 has been achieved via sequential and tandem Ugi/intramolecular Diels-Alder (IMDA) cycloaddition of pyrrole derivatives <2004JOC1207> and the trienes 477 were prepared by the acylaton of amines 475 with the anhydride 476. The amines 475 were in turn prepared starting from pyrrole-2-carbaldehyde. The triene 477 on heating in toluene at 80 °C for 15 h underwent the IMDA to afford the tricyclic compound 64 as a single diastereomer in quantitative yield. The sterically bulky N-substitutent on the triene 477 promoted cycloaddition under milder condition at 65 °C in toluene to provide the tricyclic compound 64 in quantitative yield (Scheme 108). 

Diaz-Ortiz and co-workers carried out microwave cycloadditions to synthesize pyrazolo[3,4-A]pyridines, including tricyclic derivative 149 obtained from pyrrole 147 using A-methylmaleimide 148 as the dienophile (Equation 34)... 

Nitrogen-containing carbon replicas of SBA-15 and MLV prepared from pyrrole as carbon precursor... 

Subsequently, other publications have appeared involving the DA reactions of porphyrins with other dienes. For instance, the reaction of meso-tetrakis(pentafluorophenyl)porphyrin Id with the diene generated from pyrrole-fused 3-sulfolene gave rise to the isoindole-fused chlorin derivative 8 accompanied by a mixture of stereoisomeric bacteriochlorins 9 (Scheme 2) <98CC2355>. 

---