Deprotonation thermodynamic

Thermodynamic equilibrium constant for amine deprotonation Thermodynamic equilibrium constant for thiol sulfonate protonation... 

Such a simplification is not justified in deprotonation. To reduce the number of rate coefficients of deprotonation, thermodynamic constraints have to be accounted for. In the sequence consisting of protonation of an olefin, Oj, isomerization of the resulting carbenium ion by elementary steps involving one type of carbenium ion, and deprotonation of the isomer carbenium ion into an olefin, O2 the isomerization equilibrium relation... 

Thermodynamic Enolate- Reversible deprotonation to give the most stable enolate more highly substituted C=C of the enol form... 

In theory two carbanions, (189) and (190), can be formed by deprotonation of 3,5-dimethylisoxazole with a strong base. On the basis of MINDO/2 calculations for these two carbanions, the heat of formation of (189) is calculated to be about 33 kJ moF smaller than that of (190), and the carbanion (189) is thermodynamically more stable than the carbanion (190). The calculation is supported by the deuterium exchange reaction of 3,5-dimethylisoxazole with sodium methoxide in deuterated methanol. The rate of deuterium exchange of the 5-methyl protons is about 280 times faster than that of the 3-methyl protons (AAF = 13.0 kJ moF at room temperature) and its activation energy is about 121 kJ moF These results indicate that the methyl groups of 3,5-dimethylisoxazole are much less reactive than the methyl group of 2-methylpyridine and 2-methylquinoline, whose activation energies under the same reaction conditions were reported to be 105 and 88 kJ moF respectively (79H(12)1343). 

In the discussion of the relative acidity of carboxylic acids in Chapter 1, the thermodynamic acidity, expressed as the acid dissociation constant, was taken as the measure of acidity. It is straightforward to determine dissociation constants of such adds in aqueous solution by measurement of the titration curve with a pH-sensitive electrode (pH meter). Determination of the acidity of carbon acids is more difficult. Because most are very weak acids, very strong bases are required to cause deprotonation. Water and alcohols are far more acidic than most hydrocarbons and are unsuitable solvents for generation of hydrocarbon anions. Any strong base will deprotonate the solvent rather than the hydrocarbon. For synthetic purposes, aprotic solvents such as ether, tetrahydrofuran (THF), and dimethoxyethane (DME) are used, but for equilibrium measurements solvents that promote dissociation of ion pairs and ion clusters are preferred. Weakly acidic solvents such as DMSO and cyclohexylamine are used in the preparation of strongly basic carbanions. The high polarity and cation-solvating ability of DMSO facilitate dissociation... 

It has been found that there is often a correlation between the rate of deprotonation (kinetic acidity) and the thermodynamic stability of the carbanion (thermodynamic acidity). Because of this relationship, kinetic measurements can be used to construct orders of hydrocarbon acidities. These kinetic measurements have the advantage of not requiring the presence of a measurable concentration of the carbanion at any time instead, the relative ease of carbanion formation is judged from the rate at which exchange occurs. This method is therefore applicable to very weak acids, for which no suitable base will generate a measurable carbanion concentration. 

There have been numerous studies of the rates of deprotonation of carbonyl compounds. These data are of interest not only because they define the relationship between thermodynamic and kinetic acidity for these compounds, but also because they are necessary for understanding mechanisms of reactions in which enolates are involved as intermediates. Rates of enolate formation can be measured conveniently by following isotopic exchange using either deuterium or tritium ... 

Chemists have estabhshed that a Dieckmann condensation will not succeed unless the final keto-ester product is deprotonated by a base. In our example, this would be a reaction between EtO" and the keto-ester (it is necessary, therefore, to use excess EtO ). What reaction products are generated by this proton transfer Obtain the energies of the reactants and products, and calculate the energy for this final proton transfer. Is this reaction thermodynamically favorable or unfavorable Does this step make the overall condensation reaction favorable or unfavorable ... 

For the deprotonation of less acidic precursors, which do not lead to mesomerically stabilized anions, butyllithium/TMEDA in THF or diethyl ether, or the more reactive, but more expensive,. seobutyllithium under these conditions usually are the most promising bases. Het-eroatomic substitution on the allylic substrate, which docs not contribute to the mesomeric or inductive stabilization often facilitates lithiation dramatically 58. In lithiations, in contrast to most other metalations, the kinetic acidity, caused by complexing heteroatom substituents, may override the thermodynamic acidity, which is estimated from the stabilization of the competing anions. These directed lithiations59 should be performed in the least polar solvent possible, e.g.. diethyl ether, toluene, or even hexane. 

The lithium-(-)-sparteine complex, generated by deprotonation of 1-methylindene, does not lose its configuration in diethyl ether solution even at room temperature80 presumably, the observed major diastcreonier is the thermodynamically determined product. Substitution with carbonyl compounds leads to 1-substituted (fl)-l-methyl-l//-indenes with >95% ee in high yields81. 

The preparation of cyclopentadienes with up to four trimethylsilyl groups can be performed easily on a large scale starting with monomeric cyclopentadiene by repeated metalation with n-butyllithium and treating the resulting anion with chlorotrimethylsilane [84], Any complication caused by formation of regioisomers does not occur, since all trimethylsilyl-substituted cyclopentadienes are fluxional by virtue of proto- and silatropic shifts [85], Upon deprotonation with n-butyllithium the thermodynamically most favorable anion is formed selectively (Eqs. 20, 21). Thus, metalation of bis(trimethylsilyl)cyclopentadiene 74, which exists preferentially as the 5,5-isomer, selectively affords the 1,3-substituted anion 75. Similarly, tris(trimethylsilyl)cyclopentadiene 76, which is found to be mainly as the 2,5,5-isomer, affords the 1,2,4-substituted anion 77. 

The physical nature of the sulfate complexes formed by plutonium(III) and plutonium(IV) in 1 M acid 2 M ionic strength perchlorate media has been inferred from thermodynamic parameters for complexation reactions and acid dependence of stability constants. The stability constants of 1 1 and 1 2 complexes were determined by solvent extraction and ion-exchange techniques, and the thermodynamic parameters calculated from the temperature dependence of the stability constants. The data are consistent with the formation of complexes of the form PuSOi,(n-2)+ for the 1 1 complexes of both plutonium(III) and plutonium(IV). The second HSO4 ligand appears to be added without deprotonation in both systems to form complexes of the form PuSOifHSOit(n"3) +. ... 

FIG. 4 Thermodynamic equilibria for the interfacial distribution of a solute X which can be ionized n times, and X being its most acidic (or deprotonated) and its most basic (or protonated) forms, respectively. X and are the dissociation constants in the aqueous and organic phase, respectively, and P is the partition coefficient of the various species between the two phases. 

The fundamental aspects of the structure and stability of carbanions were discussed in Chapter 6 of Part A. In the present chapter we relate the properties and reactivity of carbanions stabilized by carbonyl and other EWG substituents to their application as nucleophiles in synthesis. As discussed in Section 6.3 of Part A, there is a fundamental relationship between the stabilizing functional group and the acidity of the C-H groups, as illustrated by the pK data summarized in Table 6.7 in Part A. These pK data provide a basis for assessing the stability and reactivity of carbanions. The acidity of the reactant determines which bases can be used for generation of the anion. Another crucial factor is the distinction between kinetic or thermodynamic control of enolate formation by deprotonation (Part A, Section 6.3), which determines the enolate composition. Fundamental mechanisms of Sw2 alkylation reactions of carbanions are discussed in Section 6.5 of Part A. A review of this material may prove helpful. 

Full exploitation of the synthetic potential of enolates requires control over the regioselectivity of their formation. Although it may not be possible to direct deprotonation so as to form one enolate to the exclusion of the other, experimental conditions can often be chosen to favor one of the regioisomers. The composition of an enolate mixture can be governed by kinetic or thermodynamic factors. The enolate ratio is governed... 

Under conditions of thermodynamic control, however, it is the enolate corresponding to deprotonation of the y-carbon that is present in the greater amount. 

In principle, one can calculate pKa by making use of the thermodynamic cycle as shown in Figure 10-1 and a relationship between the free energy of deprotonation in aqueous phase and pKa,... 

Studies of the thermodynamics of formation of complexes of zinc with 2,2 -bipyridine in the presence of halide and thiocyanate ions in DMF has been carried out.205 The zinc complexes of 2,2 -bipyridine with A-(benzenesulfonyl)glycine and A-(toluene- -sulfonyl)glycine were synthesized and infrared data implied a structural analogy with the cadmium complexes. This suggests that the zinc promotes sulfonamide nitrogen deprotonation in the amino acid ligands in the solid state.206... 

The more favorable partitioning of [1+ ] to form [l]-OH than to form [2] must be due, at least in part, to the 4.0 kcal mol-1 larger thermodynamic driving force for the former reaction (Kadd = 900 for conversion of [2] to [l]-OH, Table 1). However, thermodynamics alone cannot account for the relative values of ks and kp for reactions of [1+] that are limited by the rate of chemical bond formation, which may be as large as 600. A ratio of kjkp = 600 would correspond to a 3.8 kcal mol-1 difference in the activation barriers for ks and kp, which is almost as large as the 4.0 kcal mol 1 difference in the stability of [1]-OH and [2]. However, only a small fraction of this difference should be expressed at the relatively early transition states for the reactions of [1+], because these reactions are strongly favored thermodynamically. These results are consistent with the conclusion that nucleophile addition to [1+] is an inherently easier reaction than deprotonation of this carbocation, and therefore that nucleophile addition has a smaller Marcus intrinsic barrier. However, they do not allow for a rigorous estimate of the relative intrinsic barriers As — Ap for these reactions. 

The partitioning of ferrocenyl-stabilized carbocations [30] between nucleophile addition and deprotonation (Scheme 18) has been studied by Bunton and coworkers. In some cases the rate constants for deprotonation and nucleophile addition are comparable, but in others they favor formation of the nucleophile adduct. However, the alkene product of deprotonation of [30] is always the thermodynamically favored product.120. In other words, the addition of water to [30] gives an alcohol that is thermodynamically less stable than the alkene that forms by deprotonation of [30], but the reaction passes over an activation barrier whose height is equal to, or smaller than, the barrier for deprotonation of [30], These data require that the intrinsic barrier for thermoneutral addition of water to [30] (As) be smaller than the intrinsic barrier for deprotonation of [30] (Ap). It is not known whether the magnitude of (Ap — As) for the reactions of [30] is similar to the values of (Ap - As) = 4-6 kcal mol 1 reported here for the partitioning of a-methyl benzyl carbocations. 

The partitioning of simple tertiary carbocations, ring-substituted 1-phenylethyl carbocations, and cumyl carbocations between deprotonation and nucleophilic addition of solvent strongly favors formation of the solvent adduct. The more favorable partitioning of these carbocations to form the solvent adduct is due, in part, to the greater thermodynamic stability of the solvent... 

Fowle et al. (2000) have measured the sorption by a soil bacterium (B. subtilis) of uranyl in 0.1 M NaC104 at 25°C as a function of pH, time, and solid solute ratio, using a batch technique. The stoichiometiy and thermodynamic stability of the important uranyl-surface complexes indicated that uranyl formed two different surface complexes, one involving neutral phosphate functional groups, and another with deprotonated carboxyl functional groups, on the bacterial cell wall ... 

---