Cyclic maleic anhydride

Bulk mixed metal oxide catalytic materials consist of multiple metal oxide components. Such mixed metal oxide catalysts find wide application as selective oxidation catalysts for the synthesis of chemical intermediates. For example, bulk iron-molybdate catalysts are employed in the selective oxidation of CH3OH to H2CO [122], bulk bismuth-molybdates are the catalysts of choice for selective oxidation of CH2=CHCH3 to acrolein (CH2=CHCHO) and its further oxidation to acrylic acid (CH2=CHCOOH) [123], selective ammoxidation of CH2=CHCH3 to acrylonitrile (CH2=CHCN) [123], and selective oxidation of linear CH3CH2CH2CH3 to cyclic maleic anhydride consisting of a flve-membered ring (four carbons and one O atom) [124]. The characterization of the surface... 

COT is prepared by the polymerization of ethyne at moderate temperature and pressure in the presence of nickel salts. The molecule is non-planar and behaves as a typical cyclic olefin, having no aromatic properties. It may be catalytically hydrogenated to cyclo-octene, but with Zn and dil. sulphuric acid gives 1,3,6-cyclooclairiene. It reacts with maleic anhydride to give an adduct, m.p. 166 C, derived from the isomeric structure bicyclo-4,2,0-octa-2,4,7-triene(I) ... 

After acyl halides acid anhydrides are the most reactive carboxylic acid derivatives Three of them acetic anhydride phthahc anhydride and maleic anhydride are mdus trial chemicals and are encountered far more often than others Phthahc anhydride and maleic anhydride have their anhydride function incorporated into a nng and are referred to as cyclic anhydrides... 

In the case of vinylfurans and vinylpyrroles there is the possibility of cycloaddition involving either the cyclic diene system or the diene system including the double bond. 2-Vinylfuran reacts in high yield with maleic anhydride in ether at room temperature to form the adduct involving the exocyclic double bond. Similarly, 2- and 3-vinylpyrroles react with 7T-electron-deficient alkenes and alkynes under relatively mild conditions to give the corresponding tetrahydro- and dihydro-indoles (Scheme 51) (80JOC4515). 

The classic method for controlling stereochemistry is to perform reactions on cyclic substrates. A rather lengthy but nonetheless efficient example in the prostaglandin field uses bicyclic structures for this purpose. Bisacetic acid derivative S is available in five steps from Diels-Alder reaction of trans-piperylene and maleic anhydride followed by side-chain homologation. Bromolactonization locks the molecule as bicyclic intermediate Esterification, reductive dehalogen-... 

Cyclic 1,3-diacetoxy-l,3-dienes can be generated in situ from cyclic 1,3-diketones under the influence of isopropenyl acetate. The dienes then undergo Diels-Alder reactions with maleic anhydride giving as products 1-acetoxybicycloalkane dicarboxylic anhydride derivatives (10). The procedure is also successful with cyclic 1,2- and 1,4-diketones as well as cyclic a,j3-unsaturated ketones. The products, after hydrolysis to... 

Mechanistic studies have been designed to determine if the concerted cyclic TS provides a good representation of the reaction. A systematic study of all the E- and Z-decene isomers with maleic anhydride showed that the stereochemistry of the reaction could be accounted for by a concerted cyclic mechanism.19 The reaction is only moderately sensitive to electronic effects or solvent polarity. The p value for reaction of diethyl oxomalonate with a series of 1-arylcyclopentenes is —1.2, which would indicate that there is little charge development in the TS.20 The reaction shows a primary kinetic isotope effect indicative of C—H bond breaking in the rate-determining step.21 There is good agreement between measured isotope effects and those calculated on the basis of TS structure.22 These observations are consistent with a concerted process. 

The most effective agents for diphosphate formation were NHj)HCOO, H2O2 and SCN-. The formation of the cyclic triphosphate was favoured by maleic anhydride or pantoyl lactone, with Ca2+ being added in both cases. 

The double bond of maleic anhydride may undergo free radical polymerization with the proper initiator. Polymers of maleic anhydride (or copolymers made with another monomer) are commercially available (Polysciences). They consist of a linear hydrocarbon backbone (formed from the polymerization of the vinyl groups) with cyclic anhydrides repeating along the chain. Such polymers are highly reactive toward amine-containing molecules. 

Maleic acid is a linear four carbon molecule with carboxylate groups on both ends and a double bond between the central carbon atoms. The anhydride of maleic acid is a cyclic molecule containing five atoms. Although the reactivity of maleic anhydride is similar to other cyclic anhydrides, the products of maleylation are much more unstable toward hydrolysis, and the site of unsaturation lends itself to additional side reactions. Acylation products of amino groups with maleic anhydride are stable at neutral pH and above, but they readily hydrolyze at acid pH values around pH 3.5 (Butler et al., 1967). Maleylation of sulfhydryls and the phe-nolate of tyrosine are even more sensitive to hydrolysis. Thus, maleic anhydride is an excellent reversible blocker of amino groups to temporarily mask them from reactivity while another... 

Microwave heating has also been employed for performing retro-Diels-Alder cycloaddition reactions, as exemplified in Scheme 6.94. In the context of preparing optically pure cross-conjugated cydopentadienones as precursors to arachidonic acid derivatives, Evans, Eddolls, and coworkers performed microwave-mediated Lewis acid-catalyzed retro-Diels-Alder reactions of suitable exo-cyclic enone building blocks [193, 194], The microwave-mediated transformations were performed in dichloromethane at 60-100 °C with 0.5 equivalents of methylaluminum dichloride as catalyst and 5 equivalents of maleic anhydride as cyclopentadiene trap. In most cases, the reaction was stopped after 30 min since continued irradiation eroded the product yields. The use of short bursts of microwave irradiation minimized doublebond isomerization. 

Reactions of furan (5) under solvent-free conditions, catalyzed by Montmorillonite K10, have been described by Cintas [27]. The reaction with methyl vinyl ketone (32) produced Michael addition in positions 2 and 5, whereas reaction with symmetrically substituted cyclic dienophiles produced a mixture of the endo and exo adducts with the kinetically favored endo adduct predominating, except when maleic anhydride (39) was used as the dienophile (Scheme 9.2). 

Cyclic olefin-based resists, 15 180 Cyclic olefin copolymers (COCs), 10 180 properties of, 10 181t Cyclic olefin-maleic anhydride (COMA) copolymers, 15 177 Cyclic olefin polymers (COP), 10 180 26 945... 

Cyclic acid anhydrides such as maleic, dodecylsuccinic, hexahydrophthalic, phthalic, phyromellitic, etc. are widely employed as curing agents for epoxy resins. They form esters with epoxy resins. These resins have better thermal stability and good electrical insulation and chemical resistance expect to alkalis. 

Crosslinking of amine- or hydroxy-terminated PAMAM dendrimers using cyclic anhydride - amine or cyclic anhydride - hydroxy addition reactions was employed for preparation of crosslinked thin films of very low permeability [73], Polyanhydrides, such as maleic anhydride-methyl vinyl ether copolymers, were used as crosslinking components. In the case of amine-terminated PAMAM, crosslinking and chemical stability were further increased by imidization of the maleamic acid groups retro-Michael eliminations were followed by Michael additions to further crosslink the film. 

When the cyclic anhydride is maleic anhydride, the product understandably becomes an unsaturated polyether ester somewhat similar to traditional unsaturated polyester resins (UPRs). 

Apart from the alkenyl succinic anhydrides, other cyclic anhydrides are solids, requiring the use of a delivery solvent, or a solid-state reaction. Apart from succinic anhydride, phthalic (PA) (Figure 4.2a) (Risi and Arseneau, 1958) and maleic anhydride (MA) have also been extensively studied (Figure 4.2b) (Clemons etal., 1992). Goethals and Stevens (1994) have reported reaction of wood with glutaric (Figure 4.2c) or cyclohexane-1,2-dicarboxylic anhydride (Figure 4.2d) and subsequent reaction with epichlorohydrin. 

In the butane route, a chemically complicated three-step process is needed to get from the feed to EDO. The two feeds, oxygen (air is used) and butane, are fed to a fluid bed reactor admixed with a catalyst. In a fluid bed reactor, the feeds and catalyst move continuously and, in this case, at a uniform temperature that allows optimum conditions for the catalyst to do its work. Butane and oxygen react to form maleic anhydride (MA), a cyclic compound. The fixed bed reactor effluent gases are taken off overhead, cooled, and filtered to remove entrained catalyst particles. The gases are then... 

The unlikely molecule in Figure 20—1 is a cyclic anhydride known by several names 2-butene-1,4-dicarboxylic acid anhydride cis-butene-dioic acid anhydride maleic anhydride (MA) and when youVe been in the business a long time, maleic. ... 

Maleic anhydride is a cyclic anhydride with one double bond in the ring and two double-bonded oxygens hanging off the ring. The resulting reactivity leads to maleics use in making polymers, unsaturated polyesters, alkyd resins, plasticizers, and dicarboxylic acids. 

The copolymerization of styrene and maleic anhydride was studied by the spintrapping technique using 2-methyl-2-nitrosopropane as a spin trap. Four types of ESR spectra were obtained, of which three corresponded to trapping of the growing polymer chain at a centre originating from the styrene part or from two centres originating from the maieic anhydride part. The fourth EPR spectrum may be due to a cyclic flve-membered aminoxyl or a six-membered 1,2-oxazine radical cation. ... 

The diacylation of isopropenyl acetate with anhydrides of dicarboxylic acids is applicable for the synthesis of several other cyclic jS-triketones in moderate yield. - It has been used for the synthesis of 2-acetylcyclohexane-l,3-dione (40% yield), 2-acetyl-4-methylcyclopentane-l,3-dione (10% yield), 2-acetyl-4,4-dimethylcyclopentane-l,3-dione (10% yield), 2-acetyl-5,5-dimethylcyclohexane-l,3-dione (10% yield), 2-acetylcyclo-heptane-l,3-dione (12% yield) and 2-acetylindane-l,3-dione (26% yield). Maleic anhydrides under more drastic conditions give acetylcyclopent-4-ene-l,3-diones in yields from 5% to 12%. The corresponding acylation of the enol acetate of 2-butanone with succinic anhydride has been used to prepare 2-methylcyclopentane-l,3-dione, an important intermediate in steroid synthesis. - ... 

Maleic anhydride derivatives are readily making it possible to perform their transformations into photochromic N-alkyl-substituted dithienylma-leimides with primary amines. This method was used to prepare cyclic imides 187 in anhydrous methanol or ethanol at 20-80°C in 67-90% yields (02ZOR1390) and N-alkyl(aryl) derivatives 188 based on thieno[3,2-b]pyr-role (03IZV1719) in 70-90% yields. 

Some monomers with no tendency toward homopolymerization are found to have some (not high) activity in copolymerization. This behavior is found in cationic copolymerizations of tetrahydropyran, 1,3-dioxane, and 1,4-dioxane with 3,3-bis(chloromethyl)oxetane [Dreyfuss and Dreyfuss, 1969]. These monomers are formally similar in their unusual copolymerization behavior to the radical copolymerization behavior of sterically hindered monomers such as maleic anhydride, stilbene, and diethyl fumarate (Sec. 6-3b-3), but not for the same reason. The copolymerizability of these otherwise unreactive monomers is probably a consequence of the unstable nature of their propagating centers. Consider the copolymerization in which M2 is the cyclic monomer with no tendency to homopolymerize. In homopolymerization, the propagation-depropagation equilibrium for M2 is completely toward... 

Potassium carboxylate groups introduced onto the surface of carbon fibers initiated anionic polymerization of epoxides (e.g., styrene oxide, epichlorohydrin, and glycidyl phenyl ethers) and cyclic acid anhydrides (e.g., maleic anhydride, succinic anhydride, and phthalic anhydride) in the presence of 18-crown-6 [41]. 

The stereoselectivity of monosubstituted dipolarophiles has also been studied with cyclic nitronates (Table 2.30) (84). In most cases, an exo selectivity was observed. The ratio between the endo and exo adducts can be correlated to the size of the substituents on the dipolarophile. Because of the endo preference observed with acrolein, it is believed that there is a slight electronic preference for the endo orientation in the transition state, in the absence of steric hindrance. In line with these results is the observation that, for 49, maleic anhydride reacts with complete exo selectivity, in contrast the cycloaddition with 47 (69). 

---