Crystallinity spectroscopy

Kummer S, Basche T and Brauchle C 1994 Terrylene in p-terphenyl a novel single crystalline system for single molecule spectroscopy at low temperatures Chem. Phys. Lett. 229 309-16... 

Protonated methanes and their homologues and derivatives are experimentally indicated in superacidic chemistry by hydrogen-deuterium exchange experiments, as well as by core electron (ESCA) spectroscopy of their frozen matrixes. Some of their derivatives could even be isolated as crystalline compounds. In recent years, Schmidbaur has pre-... 

IR spectroscopy is an inherently faster method than NMR and an IR spectrum is a superposition of the spectra of the various conformations rather than an average of them When 1 2 dichloroethane is cooled below its freezing point the crystalline matenal gives an IR spectrum consistent with a single species that has a center of symmetry At room temperature the IR spec trum of liquid 1 2 dichloroethane retains the peaks present in the solid but includes new peaks as well Explain these observations... 

Present day techniques for structure determination in carbohydrate chemistry are sub stantially the same as those for any other type of compound The full range of modern instrumental methods including mass spectrometry and infrared and nuclear magnetic resonance spectroscopy is brought to bear on the problem If the unknown substance is crystalline X ray diffraction can provide precise structural information that m the best cases IS equivalent to taking a three dimensional photograph of the molecule... 

Microscopy (qv) plays a key role in examining trace evidence owing to the small size of the evidence and a desire to use nondestmctive testing (qv) techniques whenever possible. Polarizing light microscopy (43,44) is a method of choice for crystalline materials. Microscopy and microchemical analysis techniques (45,46) work well on small samples, are relatively nondestmctive, and are fast. Evidence such as sod, minerals, synthetic fibers, explosive debris, foodstuff, cosmetics (qv), and the like, lend themselves to this technique as do comparison microscopy, refractive index, and density comparisons with known specimens. Other microscopic procedures involving infrared, visible, and ultraviolet spectroscopy (qv) also are used to examine many types of trace evidence. 

The ease of sample handling makes Raman spectroscopy increasingly preferred. Like infrared spectroscopy, Raman scattering can be used to identify functional groups commonly found in polymers, including aromaticity, double bonds, and C bond H stretches. More commonly, the Raman spectmm is used to characterize the degree of crystallinity or the orientation of the polymer chains in such stmctures as tubes, fibers (qv), sheets, powders, and films... 

More recently, Raman spectroscopy has been used to investigate the vibrational spectroscopy of polymer Hquid crystals (46) (see Liquid crystalline materials), the kinetics of polymerization (47) (see Kinetic measurements), synthetic polymers and mbbers (48), and stress and strain in fibers and composites (49) (see Composite materials). The relationship between Raman spectra and the stmcture of conjugated and conducting polymers has been reviewed (50,51). In addition, a general review of ft-Raman studies of polymers has been pubUshed (52). 

The crystalline mineral silicates have been well characterized and their diversity of stmcture thoroughly presented (2). The stmctures of siHcate glasses and solutions can be investigated through potentiometric and dye adsorption studies, chemical derivatization and gas chromatography, and laser Raman, infrared (ftir), and Si Fourier transform nuclear magnetic resonance ( Si ft-nmr) spectroscopy. References 3—6 contain reviews of the general chemical and physical properties of siHcate materials. 

Infrared Spectroscopy (ir). Infrared curves are used to identify the chemical functionality of waxes. Petroleum waxes with only hydrocarbon functionality show slight differences based on crystallinity, while vegetable and insect waxes contain hydrocarbons, carboxyflc acids, alcohols, and esters. The ir curves are typically used in combination with other analytical methods such as dsc or gc/gpc to characterize waxes. 

Barium can also be deterruined by x-ray fluorescence (XRF) spectroscopy, atomic absorption spectroscopy, and flame emission spectroscopy. Prior separation is not necessary. XRF can be appHed directly to samples of ore or products to yield analysis for barium and contaminants. AH crystalline barium compounds can be analy2ed by x-ray diffraction. 

The geometries of oxiranes have been determined mainly by X-ray diffraction on crystalline natural products, the oxirane ring being widespread in nature (Section 5.05.5.3). However, the detailed structure of the parent compound (Figure 1) has been secured by microwave spectroscopy and electron diffraction studies (64HC(l9-l)l). The strain in this... 

Smith, S.O., et al. Crystal versus solution structures of enzymes NMR spectroscopy of a crystalline serine protease. Science 244 961-964, 1989. 

Raman spectroscopy is a very convenient technique for the identification of crystalline or molecular phases, for obtaining structural information on noncrystalline solids, for identifying molecular species in aqueous solutions, and for characterizing solid—liquid interfaces. Backscattering geometries, especially with microfocus instruments, allow films, coatings, and surfaces to be easily measured. Ambient atmospheres can be used and no special sample preparation is needed. 

Solid state NMR is a relatively recent spectroscopic technique that can be used to uniquely identify and quantitate crystalline phases in bulk materials and at surfaces and interfaces. While NMR resembles X-ray diffraction in this capacity, it has the additional advantage of being element-selective and inherently quantitative. Since the signal observed is a direct reflection of the local environment of the element under smdy, NMR can also provide structural insights on a molecularlevel. Thus, information about coordination numbers, local symmetry, and internuclear bond distances is readily available. This feature is particularly usefrd in the structural analysis of highly disordered, amorphous, and compositionally complex systems, where diffraction techniques and other spectroscopies (IR, Raman, EXAFS) often fail. 

As with other diffraction techniques (X-ray and electron), neutron diffraction is a nondestructive technique that can be used to determine the positions of atoms in crystalline materials. Other uses are phase identification and quantitation, residual stress measurements, and average particle-size estimations for crystalline materials. Since neutrons possess a magnetic moment, neutron diffraction is sensitive to the ordering of magnetically active atoms. It differs from many site-specific analyses, such as nuclear magnetic resonance, vibrational, and X-ray absorption spectroscopies, in that neutron diffraction provides detailed structural information averaged over thousands of A. It will be seen that the major differences between neutron diffraction and other diffiaction techniques, namely the extraordinarily... 

Raman spectroscopy has provided information on catalytically active transition metal oxide species (e. g. V, Nb, Cr, Mo, W, and Re) present on the surface of different oxide supports (e.g. alumina, titania, zirconia, niobia, and silica). The structures of the surface metal oxide species were reflected in the terminal M=0 and bridging M-O-M vibrations. The location of the surface metal oxide species on the oxide supports was determined by monitoring the specific surface hydroxyls of the support that were being titrated. The surface coverage of the metal oxide species on the oxide supports could be quantitatively obtained, because at monolayer coverage all the reactive surface hydroxyls were titrated and additional metal oxide resulted in the formation of crystalline metal oxide particles. The nature of surface Lewis and Bronsted acid sites in supported metal oxide catalysts has been determined by adsorbing probe mole-... 

The diffusion, location and interactions of guests in zeolite frameworks has been studied by in-situ Raman spectroscopy and Raman microscopy. For example, the location and orientation of crown ethers used as templates in the synthesis of faujasite polymorphs has been studied in the framework they helped to form [4.297]. Polarized Raman spectra of p-nitroaniline molecules adsorbed in the channels of AIPO4-5 molecular sieves revealed their physical state and orientation - molecules within the channels formed either a phase of head-to-tail chains similar to that in the solid crystalline substance, with a characteristic 0J3 band at 1282 cm , or a second phase, which is characterized by a similarly strong band around 1295 cm . This second phase consisted of weakly interacting molecules in a pseudo-quinonoid state similar to that of molten p-nitroaniline [4.298]. 

The existence of the nitronium ion in sulfuric-nitric acid mixtures was demonstrated both by cryoscopic measurements and by spectroscopy. An increase in the strong acid concentration increases the rate of reaction by shifting the equilibrium of step 1 to the right. Addition of a nitrate salt has the opposite effect by suppressing the preequilibrium dissociation of nitric acid. It is possible to prepare crystalline salts of nitronium ions, such as nitronium tetrafluoroborate. Solutions of these salts in organic solvents rapidly nitrate aromatic compounds. ... 

---