Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Combination drive

We represent the hydrated proton as H + (aq) rather than H30 + (aq) because we re interested here in electron transfer, not proton transfer as in Chapter 15.] The standard potential for this cell, 0.34 V at 25°C, is a measure of the combined driving forces of the oxidation and reduction half-reactions ... [Pg.773]

OSTRACH, S. 1980. Natural convection with combined driving forces. PhysicoChem. Hydrodynamics 1, 233—247. [Pg.339]

The movement of a chemical substance within the vapor phase occurs by the combined driving forces of flow and diffusion. An illustration of these effects can be visualized by considering a smokestack plume in the absence of wind, the plume will rise vertically in a more or less uniform column until it reaches an elevation where density considerations result in its spreading out into a relatively broad and flat mantle. When wind is factored into the equation, the plume may move in a more nearly horizontal direction, more or less parallel to the surface of the ground, and at certain wind speeds the plume structure can break up into loops or bends due to turbulent aerodynamic effects such as eddy formation. In addition, small eddies can result in the breakdown of the coherent plume structure, with the formation of... [Pg.8]

In this relationship the B factor has been computed based on combining driving results with CPT results from several North Sea locations. The typical range of values for B is 1.6 at the surface to 1.0 at a depth of 50 m (de Ruiter and Beringen, 1979). [Pg.412]

This approach should also lead to better single pulse quality of pure rotational CARS spectra since many frequency combinations drive each rotational transition as discussed earlier. If the quality were sufficiently high, it might eliminate the necessity of resonant referencing currently necessary in pure rotational CARS (or CARS in any constituent... [Pg.230]

Managers need to satisfy themselves that drivers will not be put at risk from fatigue caused by driving excessive distances without appropriate breaks. Combining driving with other methods of transport may make it possible for long road journeys to be eliminated or reduced. Employees should not be asked to work an exceptionally long day. [Pg.186]

An equilibrium concentration distribution of ions in an electrolyte can be derived by setting the net charge flux owing to combined driving forces caused by electrical potential gradient and concentration gradient to zero and solving as follows ... [Pg.295]

TABLE 3.34 Determination of the Quantum-SAR, seeEq. (3.131) with Eqs. (3.127) and (3.128), Associate With Certain Couple of Molecules Involved in Activating Specific Structural Quantum Indices (Or Their Combinations) Driving Spectral Paths of Table 3.32, By Employing Minimum Residue Recipe Throughout Table 3.33 for Each Considered Endpoint, As Well As the Associate Recorded Bioactivity Differences of... [Pg.378]

In rare cases compaction may be artificially Initiated by the withdrawal of oil, gas or water from the reservoir. The pressure exerted by the overburden may actually help production by squeezing out the hydrocarbons. This process is known as compaction drive and some shallow accumulations in Venezuela are produced In this manner in combination with EOR schemes like steam injection. [Pg.86]

It is possible that more than one of these drive mechanisms occur simultaneously the most common combination being gas cap drive and natural aquifer drive. Material balance techniques are applied to historic production data to estimate the contribution from each drive mechanism. [Pg.192]

We are confident that any user of this combined evaluation technique, as well as the development of future test standards for manual ultrasonic testing will benefit from this result, because it allows a greater flexibility in the applicable method without loosing reliability. Often an expensive production of a reference block can be avoided and therefore testing costs are reduced. Since all calculations are performed by a PC, the operator can fully concentrate on his most important duty scanning the workpiece and observing the A-scan. Additional time will be saved for the test documentation, since all testing results are stored in the instrument s memory (the PC s hard drive) with full link to the Software World (Microsoft Word, Excel, etc.). [Pg.818]

It is quite clear, first of all, that since emulsions present a large interfacial area, any reduction in interfacial tension must reduce the driving force toward coalescence and should promote stability. We have here, then, a simple thermodynamic basis for the role of emulsifying agents. Harkins [17] mentions, as an example, the case of the system paraffin oil-water. With pure liquids, the inter-facial tension was 41 dyn/cm, and this was reduced to 31 dyn/cm on making the aqueous phase 0.00 IM in oleic acid, under which conditions a reasonably stable emulsion could be formed. On neutralization by 0.001 M sodium hydroxide, the interfacial tension fell to 7.2 dyn/cm, and if also made O.OOIM in sodium chloride, it became less than 0.01 dyn/cm. With olive oil in place of the paraffin oil, the final interfacial tension was 0.002 dyn/cm. These last systems emulsified spontaneously—that is, on combining the oil and water phases, no agitation was needed for emulsification to occur. [Pg.504]

With broad-band pulses, pumping and probing processes become more complicated. With a broad-bandwidth pulse it is easy to drive fundamental and overtone transitions simultaneously, generating a complicated population distribution which depends on details of pulse stmcture [75], Broad-band probe pulses may be unable to distinguish between fundamental and overtone transitions. For example in IR-Raman experiments with broad-band probe pulses, excitation of the first overtone of a transition appears as a fundamental excitation with twice the intensity, and excitation of a combination band Q -t or appears as excitation of the two fundamentals 1761. [Pg.3040]

Write the rotational analog of Hooke s law for the torque x driving the oseillation in Problem 3. Write the rotational analog of Newton s second law. Combine the two laws to obtain the rotational analog of the Newton-Hooke equation, Eq. (4-1). [Pg.129]

Rate equations 28 and 30 combine the advantages of concentration-independent mass transfer coefficients, even in situations of multicomponent diffusion, and a familiar mathematical form involving concentration driving forces. The main inconvenience is the use of an effective diffusivity which may itself depend somewhat on the mixture composition and in certain cases even on the diffusion rates. This advantage can be eliminated by working with a different form of the MaxweU-Stefan equation (30—32). One thus obtains a set of rate equations of an unconventional form having concentration-independent mass transfer coefficients that are defined for each binary pair directiy based on the MaxweU-Stefan diffusivities. [Pg.23]

Other Substances. Driving under the influence of alcohol cases are compHcated because people sometimes consume alcohol with other substances (11—13). The most common iUicit substances taken with alcohol are marijuana and cocaine (see Table 1) (14). In combination with alcohol, some dmgs have an additive effect. When a blood or urine alcohol sample is tested for alcohol and the result is well below the legal concentration threshold yet the test results are not consistent with the arresting officers observation that the subject was stuporous, further toxicological tests for the possible presence of dmgs are indicated. [Pg.486]

Hydrostatic drives allow for selection of any travel speed up to the maximum without a concurrent variance in engine speed. The engine can be operated at the governed speed to provide proper operating speeds for auxiliary elements, eg, the threshing section of a combine. A frill range of travel speeds is available to adjust to terrain or crop conditions. Industrial applications for hydraulic systems and hydrostatic transmissions include the following (16) ... [Pg.271]

Conventional fossil fuel-fired power plants, nuclear power faciUties, cogeneration systems, and combined-cycle faciUties all have one key feature in common some type of steam generator is employed to produce steam. Except for simple-cycle cogeneration faciUties, the steam is used to drive one or... [Pg.3]


See other pages where Combination drive is mentioned: [Pg.192]    [Pg.336]    [Pg.65]    [Pg.115]    [Pg.608]    [Pg.229]    [Pg.545]    [Pg.192]    [Pg.336]    [Pg.65]    [Pg.115]    [Pg.608]    [Pg.229]    [Pg.545]    [Pg.51]    [Pg.333]    [Pg.604]    [Pg.1961]    [Pg.2350]    [Pg.2772]    [Pg.498]    [Pg.415]    [Pg.610]    [Pg.930]    [Pg.386]    [Pg.154]    [Pg.448]    [Pg.421]    [Pg.175]    [Pg.323]    [Pg.412]    [Pg.196]    [Pg.204]    [Pg.17]    [Pg.136]    [Pg.329]    [Pg.11]    [Pg.16]    [Pg.17]   
See also in sourсe #XX -- [ Pg.192 ]




SEARCH



© 2024 chempedia.info