Chemical oxide

At the anode, a chemical oxidation reaction is bound to take place. In normal fixers, sulfite (SOj ) is oxidized and acid (H ) is released as a consequence of this oxidation. Due to the decrease of the sulfite concentration and the decrease in the pH, the fixing solution becomes unstable and sulfur precipitation starts to occur when the pH of the fixer decreases below 4.0. In the case of hardening fixers, there is also an upper limit to the pH, since aluminum-hydroxides starts to precipitate when the pH exceeds 5.0. 

X-ray photoelectron spectroscopy (XPS), also called electron spectroscopy for chemical analysis (ESCA), is described in section Bl.25,2.1. The most connnonly employed x-rays are the Mg Ka (1253.6 eV) and the A1 Ka (1486.6 eV) lines, which are produced from a standard x-ray tube. Peaks are seen in XPS spectra that correspond to the bound core-level electrons in the material. The intensity of each peak is proportional to the abundance of the emitting atoms in the near-surface region, while the precise binding energy of each peak depends on the chemical oxidation state and local enviromnent of the emitting atoms. The Perkin-Elmer XPS handbook contains sample spectra of each element and bindmg energies for certain compounds [58]. 

Polythiophene can be synthesized by electrochemical polymerization or chemical oxidation of the monomer. A large number of substituted polythiophenes have been prepared, with the properties of the polymer depending on the nature of the substituent group. Oligomers of polythiophene such as (a-sexithienyl thiophene) can be prepared by oxidative linking of smaller thiophene units (33). These oligomers can be sublimed in vacuum to create polymer thin films for use in organic-based transistors. 

Chemical Oxidation of HCl. Chlorine can be produced from HCl usiag air or O2 foUowiag the overall reactioa... 

KrF+ AsF/, KrF+ SbF/, and KrF+ Sb2F, are moderately stable at room temperature. The KrF+ cation ranks as the most powerful chemical oxidizer known (120) and is capable of oxidizing gaseous xenon to XeF/, gaseous oxygen to O2, NF to NF, and chlorine, bromine, and iodine pentafluorides to... 

Mixtures of products are frequentiy observed. Oxidation by peroxycarboxylic acids usually give similar products (22). Several chemical oxidants give good yields of specific oxidation products. Dimethyl sulfoxide in aqueous acid gives oxindoles (23). In methanol, MoO HMPA (hexamethylphosphoramide) gives 3-hydroxy-2-methoxyindolines (24). 

P. A. VeUa, J. Munder, B. Patel, and B. Veronda, "Chemical Oxidation A Tool for Toxicity Reduction," Proceedings of the 47th Industrial Waste Conference, Purdue University, West Lafayette, Ind., 1992. 

G. S. Fonken and R. A. Johnson, Chemical Oxidations with Microorganisms, Marcel Dekker, Inc., New York, 1972. 

Decomposition of adducts such as triphenyl phosphite—ozone provides a convenient method for accomplishing chemical oxidations involving singlet oxygen and making it a useful oxygenating agent for synthetic and mechanistic appHcations. 

Turbidity. Turbidity in water is removed by ozonation (0.5—2 ppm) through a combination of chemical oxidation and charge neutralization. GoUoidal particles that cause turbidity are maintained in suspension by negatively charged particles which are neutralized by ozone. Ozone further alters the surface properties of coUoidal materials by oxidizing the organic materials that occur on the surface of the coUoidal spherical particles. 

Wet preparation of red iron oxides can involve either a hydrothermal process (see Hydrothermal processing) or a direct precipitation and growth of iron oxide particles on specially prepared nucleating seeds of Fe202- In the hydrothermal process, iron(II) salt is chemically oxidized to iron(III) salt, which is further treated by alkahes to precipitate a hydrated iron(III) oxide gel. The gel can be dehydrated to anhydrous hematite under pressure at a temperature around 150°C. 

Plutonium(III) in aqueous solution, Pu " ( 4)> is pale blue. Aqueous plutonium(IV) is tan or brown the nitrate complex is green. Pu(V) is pale red-violet or pink in aqueous solution and is beUeved to be the ion PuO Pu(VI) is tan or orange in acid solution, and exists as the ion PuO. In neutral or basic solution Pu(VI) is yellow cationic and anionic hydrolysis complexes form. Pu(VII) has been described as blue-black. Its stmcture is unknown but may be the same as the six-coordinate NpO (OH) (91). Aqueous solutions of each oxidation state can be prepared by chemical oxidants or reductants... 

Oxidation of polysaccharides is a far more attractive route to polycarboxylates, potentially cleaner and less cosdy than esterification. Selectivity at the 2,3-secondary hydroxyls and the 6-primary is possible. Total biodegradation with acceptable property balance has not yet been achieved. For the most part, oxidations have been with hypochlorite—periodate under alkaline conditions. In the 1990s, catalytic oxidation has appeared as a possibiUty, and chemical oxidations have also been developed that are specific for the 6-hydroxyl oxidation. 

Chemical oxidation with strong acid is reportedly selective at the 6-hydroxyl, either with nitric acid—sulfuric acid—vanadium salts (241) which is claimed as specific for the 6-hydroxyl up to 40% conversion, or with dinitrogen tetroxide ia carbon tetrachloride, with similar specificity up to 25% conversion (242). 

Most synthetic camphor (43) is produced from camphene (13) made from a-piuene. The conversion to isobomyl acetate followed by saponification produces isobomeol (42) ia good yield. Although chemical oxidations of isobomeol with sulfuric/nitric acid mixtures, chromic acid, and others have been developed, catalytic dehydrogenation methods are more suitable on an iadustrial scale. A copper chromite catalyst is usually used to dehydrogenate isobomeol to camphor (171). Dehydrogenation has also been performed over catalysts such as ziac, iadium, gallium, and thallium (172). 

Although an inherently more efficient process, the direct chemical oxidation of 3-methylpyridine does not have the same commercial significance as the oxidation of 2-methyl-5-ethylpyridine. Liquid-phase oxidation procedures are typically used (5). A Japanese patent describes a procedure that uses no solvent and avoids the use of acetic acid (6). In this procedure, 3-methylpyridine is combined with cobalt acetate, manganese acetate and aqueous hydrobromic acid in an autoclave. The mixture is pressurized to 101.3 kPa (100 atm) with air and allowed to react at 210°C. At a 32% conversion of the picoline, 19% of the acid was obtained. Electrochemical methods have also been described (7). 

U.S. Environmental Protection Agency, perox-pure Chemical Oxidation Technology Peroxidation Systems, Inc., Applications Analysis Keport, EPA/540/AR-93/501, Washington, D.C., 1993. 

Many volatiles can be chemically oxidi2ed using conventional or advanced chemical oxidants. 

Chemical Oxidation. Chemical oxidation can be appHed ia iadustrial wastewater pretreatment for reduction of toxicity, to oxidize metal complexes to enhance heavy metals removal from wastewaters, or as a posttreatment for toxicity reduction or priority pollutant removal. 

Complex organics and toxics are chemically oxidized to end products of CO2 and H2O or to iatermediate products which are nontoxic and biodegradable. 

Chemical precipitation Chemical oxidation/re duction Air and/or steam stripping Activated carbon adsorption Resin adsorption Ion exchange Ultrafiltra-tion and/or reverse osmosis Flo atation / ph ase separation... 

Chemiluminescent labels, in which the luminescence is generated by a chemical oxidation step, and bioluminescent labels, where the energy for light emission is produced by an enzyme-substrate reaction, are additional labeling types (39,42). Luminol [521 -31 -3] CgHyN202, and acridine [260-94-6] C H N, derivatives are often used as chemiluminescent labels. 

Sodium chlorite is used to produce chlorine dioxide by chemical oxidation, electrochemical oxidation methods, or by acidification with acids. Most of the commercial methods employ chlorine or sodium hypochlorite. 

M. G. Noack and S. A. lacovieUo, "The Chemistry of Chlorine Dioxide in Industrial and Wastewater Treatment AppHcations," 2nd International Symposium on Chemical Oxidation Technologies Tor the 90 s, Vanderbilt University, NashviUe, Term., Feb. 19—21,1992. 

Chemical oxidation is a more recent method of effluent treatment, especially chemical effluent. This procedure uses strong oxidi2ing agents like... 

Sulfur Dyes. These are a special case of vat dyes and behave in an analogous manner except that the reducing agent used is sodium sulfide. In order to obtain rapid oxidation chemical oxidizing agents are used. The main outlet for these dyes is in the economic production of navy and black shades on woven fabrics by continuous dyeing, often applying the pre-reduced form of the sulfur dye. 

---