Chart display

Figure 4.3. NOAA Worksheet compatibility chart display.

For method development and display of the run status, a flow-chart of the TraceCon preconcentration system is used to visuahze the current system state. During the execution of a method the flow chart displays the current activity of the TraceCon apparatus in the run mode. Run errors can also be easily identified, so that runs can be aborted if parts of the system fail. 

A control chart displays statistically determined upper and lower limits drawn on either side of a proeess average. This chart shows if the eollected data are within upper and lower limits previously determined through statistical calculations of raw data from earlier trials. 

Figure 3. Bar chart display, detector coated with several exposed to various Structured rectangles reflect electrical vapor on a per mole basis for...

Control charts display the data (and variance) in the order they occur with statistically determined upper and lower control limits. The SPC charts are used to monitor the process for maintenance of the target to zero and then to determine whether process changes have accomplished their desired quality effect. ... 

The latter is the conventional definition of bnt, to the accnracy of chemical shift mea-snrements, Eq. (16) gives eqnivalent resnlts. Many NMR chart displays are calibrated both in 8 nnits and in freqnency shift nnits appropriate to the fixed freqnency sonrce (60 MHz... 

You will note some structure in the Stokes band near 460 which is due to chlorine isotopic frequency shifts. (See Exp. 37 for a discussion of isotope effects in diatomic molecules.) Rescan this region at higher resolution (1 cm or less) with an expansion of the chart display and measure the frequencies of each of the components. Record the ambient temperature near the Raman cell. 

Health insurance is financed by purchasers. In the U.S., purchasers are employers, government (federal, state, and local), and individuals. Figure 18.1 is a chart displaying the sources of health insurance for people in the U.S. in 2001. 

Fig. 2 MIE ranges for several API, in milliJoules. The chart displays the fraction of compounds in the set with MIE from 1-10, 10-30, and above 30mJ. Data courtesy of the Process Safety Laboratory, Merck and Co., Inc.

A correlation matrix of all the descriptors in a data set can be calculated, including a regression chart displaying the regression lines of the entries selected in the correlation matrix and a descriptor chart that shows both descriptors in comparison to the ASD. 

The context menu contains prediction methods that are available for particular training conditions. The set can either be self-tested (recall test) or the properties (or property vectors) can be predicted for individual objects in a data set or the complete data set. In a recall test or if a property vector was available in the input file but was not used for training, a chart displays the predicted property vector in comparison to the original vector. 

HVS to adapt) (32). Simultaneous use of numeric displays, color-scale plots, and strip-chart displays will provide sufficient information to the experimenter. 

Display equation on chart Display R-squared value on chart OK... 

Fill in the basic parameters for the Gaussian primitives in cells C 3 to E 4 and, then, the primitive quantum number in cell F 3, with the Slater exponent for the Is orbital in boron in cell G 3. Since the Slater function is to be included in the chart displaying the variations with radial distance, repeat these entries in cells G 7 and G 8. 

The chart display will be incorrect, in that the graph for the variation of the boron 2s orbital turns out to be the variations found for the Slater and sto-3g) approximations times — 1. This is fixed easily by... 

It is to be expected that the orthonormal function formed by applying equation 3.10, should be a good fit, when normalized, to the numerical radial function obtained by direct solution of the Schrodinger equation for the lithium atom. This proposition is examined in fig3-3.xls, in which the chart, displayed in Figure 3.3, incorporates the Herman-Skillman... 

What The frequency plot (or histogram) is a tool to display data. It presents to the user basic information about the location, shape, and spread of a set of data. The frequency plot is similar to the Pareto chart. The frequency plot displays quantitative data, while the Pareto chart displays categorical data. 

Ashby [16] has created material selection charts displaying property clusters for different material t5rpes by plotting one property against another (for example, modulus versus relative cost). These charts are overlaid with the contours for applications-based property indices (such as modulus over density times cost), as schematically displayed in Figure 5.5. This permits selection of materials according to application specifications. These charts have been developed for several important mechanical and thermal properties and for the easiest environmental effect to measure, namely energy. It would be feasible to expand these charts to include further environmental parameters, if quantitative measures of environmental impact were to be developed. 

Figure 5. Chart displaying the variation in both pH and measured force over time as the hydrogel responds to the oscillating reaction. Residence time 1000s, at room temperature. Input concentrations [SO3 ] - 0.075M, [BrOf] = 0,065M, [Fe(CN)f ] = 0,02M, [H2SO4] = O.OIM,...

If data on the control chart display wide fluctuations, with points both above and below the control limits, the chart is said to be out of control. In this case, it is up to... 

Fig. 29.11. Chart displaying the final volume deviation after 3D editing of seven scenes. As can be seen, the final deviation is well below 4%. An average time of only 10.8 min for 3D editing was necessary...

These equations are used in the construction of the most common type of control chart, a Shewhart chart (Figure 4.1). The vertical axis of a Shewhart chart displays the process mean, x, of the measured values, e.g. of the pesticide concentration in the fruit, and the horizontal axis is a time axis, so that the variation of these... 

Within a chart displaying the 300-29-1 ratios in the first edition, Heinrich writes The total of 330 accidents all have the same cause. Note that cause is singular (H-13). This statement, that all 330 incidents have the same cause, challenges credulity. Also, note that the sentence in quotations in this paragraph appears only in the first edition. It does not appear in later editions (H-14). 

Figure 19 Compression characteristics of recipe I. The second v-axis shows the influence of the nitrogen pressure on the porosity. Porosity was calculated by the quotient of upward pressure of the coated granules in silicon oil as a measure of the apparent density and the true density. The three different charts display the compression characteristics for three compression forces (5-15 kN).

Waveform graphs and charts display data typically acquired at a constant rate. When the data are plotted on a waveform graph, the previous data are discarded and the new data alone are displayed. A waveform graph is typically used for fast processes that acquire data continuously. When the data are plotted on a waveform graph, the previous data are appended with the new data. Hence, the waveform chart keeps a history of data that can be compared with present data. When more data are added than can be displayed on the chart, the chart scrolls so that new points are added to the right side of the chart while old points disappear to the left. 

---