Benzene, alkylation reaction with

Friedel-Crafts Alkylation Reactions. The activation of glyoxylate esters,trifluoromethyl pyruvate esters, and unsaturated a-ketoesters by catalyst 2 converts these materials into effective electrophiles for asymmetric Friedel-Crafts alkylation reactions with activated arenes (eqs 16 and 17). In fact, bis(triflate) (2) is far superior to tbe bis(hexafluoroantimonate) complex at catalyzing the enantioselective alkylation of benzene derivatives. Aniline and anisole derivatives both give the reaction, as do heterocyclic aromatic compounds such as indole and furan. 

Alkyl mesylates undergo alkylation reaction with benzene rings in the presence of Sc(OTf)3. " Allylic acetates undergo alkylation with Mo(CO)g and allylic chlorides react in the presence of ZnCl2/Si02. " Montmorillonite clay (KIO) is an effective medium for alkylation reactions.Nafion-H, a super acidic perfluori-nated resin sulfonic acid, is a very good catalyst for gas phase alkylations with alkyl halides, alcohols,or alkenes. 

Commercially it is found to be economically attractive to transalkylate all the PEB formed as a result of successive alkylation reactions with benzene in a separate transalkylation reactor to produce additional EB. 

In continuous-flow, liquid phase runs, high conversions of 1-decene to mixtures of decylbenzene isomers occurred in reaction with benzene over REX catalyst (Fig. 25). In analogous benzene alkylation attempts with 1-decene or 1-decanol at atmospheric pressure, side reactions of... 

Several alkylation reactions with extremely high energy requirements have also been observed over zeolites. Small amounts of toluene and ethylbenzene, together with light paraffin gases, were observed in the alkylation of benzene with isobutane over REX catalyst at 371°. In a reaction that involved fragmentation of the benzene ring, Frilette and Rubin (129) observed the formation of toluene and ethylbenzene when benzene alone was passed over H-mordenite at 400°. 

To date, many electrophilic reagents, such as alkyl halides, alkenes, alkynes, carbonyl compounds, epoxides, alcohols, and ethers, have been investigated in AFC alkylation reactions. On the other hand, the reactive 5-membered heteroaromatic compounds, such as indole, pyrrole, furan, and thiophene derivatives, and electron-rich benzene derivatives have been successfully applied in AFC alkylation reactions. Indole and pyrrole derivatives are most popular substrates due to their high reactivity and account for almost 80% of the published methodologies. A variety of chiral organometal-lic catalysts and organocatalysts are employed in the catalytic AFC alkylation reactions with high enantiomeric control. 

Styrene is produced mainly by catalytic dehydrogenation of high-purity ethylbenzene in the vapor phase. A typical integrated process scheme for the manufacture of styrene and ethylbenzene is shown in Fig. 22.17, in the earlier section on ethylbenzene. The alkylation reaction, with excess benzene, takes place in a homogeneous system with an aluminum chloride catalyst. The ethylbenzene dehydrogenation also is catalytic, using a commercially available catalyst. The fractionation train separates high-purity styrene, unconverted ethylbenzene, and minor reaction by-products such as toluene. 

Acylated Corticoids. The corticoid side-chain of (30) was converted iato the cycHc ortho ester (96) by reaction with a lower alkyl ortho ester RC(OR )2 iu benzene solution ia the presence of i ra-toluenesulfonic acid (88). Acid hydrolysis of the product at room temperature led to the formation of the 17-monoesters (97) ia nearly quantitative yield. The 17-monoesters (97) underwent acyl migration to the 21-monoesters (98) on careful heating with. In this way, prednisolone 17a,21-methylorthovalerate was converted quantitatively iato prednisolone 17-valerate, which is a very active antiinflammatory agent (89). The iatermediate ortho esters also are active. Thus, 17a,21-(l -methoxy)-pentyhdenedioxy-l,4-pregnadiene-liP-ol-3,20-dione [(96), R = CH3, R = C Hg] is at least 70 times more potent than prednisolone (89). The above conversions... 

The following HF alkylation reactions are based on straight-chain olefins. A similar chemistry can be written for the branched-chain process. The main reaction is the alkylation of benzene with the straight-chain olefins to yield a linear alkylbenzene ... 

Friedel-Grafts Reactions. In the presence of Friedel-Crafts catalysts, succinic anhydride reacts with alkyl benzenes to form alkylben2oylpropionic acids (103), eg, the reaction with iadane gives a 97% yield of 4-oxo-(4,5-iQdanyl)butyric acid (eq. 6). 

Reactions other than those of the nucleophilic reactivity of alkyl sulfates iavolve reactions with hydrocarbons, thermal degradation, sulfonation, halogenation of the alkyl groups, and reduction of the sulfate groups. Aromatic hydrocarbons, eg, benzene and naphthalene, react with alkyl sulfates when cataly2ed by aluminum chloride to give Fhedel-Crafts-type alkylation product mixtures (59). Isobutane is readily alkylated by a dipropyl sulfate mixture from the reaction of propylene ia propane with sulfuric acid (60). 

All lation. Several alkylation reactions are known either the olefin or chloro- group may be involved. The reactions of aEyl chloride with benzene are typical of reactions involving the double bond. In the presence of ferric or zinc chloride, the products are 2-chloropropylbenzene [10304-81-1] and 1,2-diphenylpropane [5814-85-7]. ... 

Fig. 6. Key intermediates derived from benzene. The alkylation reaction shown employs ethylene oxide. Hydrazine condenses with acetoacetic acid to form...

A mild and effective method for obtaining N- acyl- and N- alkyl-pyrroles and -indoles is to carry out these reactions under phase-transfer conditions (80JOC3172). For example, A-benzenesulfonylpyrrole is best prepared from pyrrole under phase-transfer conditions rather than by intermediate generation of the potassium salt (81TL4901). In this case the softer nature of the tetraalkylammonium cation facilitates reaction on nitrogen. The thallium salts of indoles prepared by reaction with thallium(I) ethoxide, a benzene-soluble liquid. 

Because of the structural requirements of the bielectrophile, fully aromatized heterocycles are usually not readily available by this procedure. The dithiocarbamate (159) reacted with oxalyl chloride to give the substituted thiazolidine-4,5-dione (160) (see Chapter 4.19), and the same reagent reacted with iV-alkylbenzamidine (161) at 100-140 °C to give the 1 -alkyl-2-phenylimidazole-4,5-dione (162) (see Chapter 4.08). Iminochlorides of oxalic acid also react with iV,iV-disubstituted thioureas in this case the 2-dialkylaminothiazolidine-2,4-dione bis-imides are obtained. Thiobenzamide generally forms linear adducts, but 2-thiazolines will form under suitable conditions (70TL3781). Phenyliminooxalic acid dichloride, prepared from oxalic acid, phosphorus pentachloride and aniline in benzene, likewise yielded thiazolidine derivatives on reaction with thioureas (71KGS471). 

Monoesterification of a symmetrical dihydroxy aromatic compound can be effected by reaction with polymer-bound benzoyl chloride (Pyr, benzene, reflux, 15 h) to give a polymer-bound benzoate, which can be alkylated with diazomethane to form, after basic hydrolysis (0.5 M NaOH, dioxane, H2O, 25°, 20 h, or 60°, 3 h), a monomethyl ether. ... 

There are relatively few kinetic data on the Friedel-Crafts reaction. Alkylation of benzene or toluene with methyl bromide or ethyl bromide with gallium bromide as catalyst is first-order in each reactant and in catalyst. With aluminum bromide as catalyst, the rate of reaction changes with time, apparently because of heterogeneity of the reaction mixture. The initial rate data fit the kinetic expression ... 

Novolacs are often modified through alkylations based on reactions with monomers other than, and in addition to, aldehydes during their manufacture. Examples might be inclusion of styrene, divinyl benzene, dicyclopentadiene, drying oils, or various alcohols. Despite significant production of all of these variants, most novolac volume is produced using phenol and formaldehyde. 

The principal use of the alkylation process is the production of high octane aviation and motor gasoline blending stocks by the chemical addition of C2, C3, C4, or C5 olefins or mixtures of these olefins to an iso-paraffin, usually isobutane. Alkylation of benzene with olefins to produce styrene, cumene, and detergent alkylate are petrochemical processes. The alkylation reaction can be promoted by concentrated sulfuric acid, hydrofluoric acid, aluminum chloride, or boron fluoride at low temperatures. Thermal alkylation is possible at high temperatures and very high pressures. 

However, 17a,21-acetonides (103), as well as acetals of other ketones or aldehydes, can be easily prepared by acid-catalyzed exchange reaction with dimethoxypropane or other alkyl acetals in dimethylformamide or benzene. Enol etherification of the A -S-ketone also occurs with the former procedure. 

The pyrrolidine enamines of /l -3.]cetosteroids (111), on alkylation with methyl iodide, gave mainly the N-alkylated product (5,55) in nonpolar solvents such as benzene. The reaction in more polar solvents gave the 4-methylated product (5.S). The reaction of (111) with perchloryl fluoride involves attack at the C-4 atom to give, after acid hydrolysis, either 4-fluoro-zJ -3-ketone (119) or 4,4-difluoro-zJ -3-ketone 120), depending on the reaction conditions (59). 

The enamines derived from cyclic ketones give the normal alkylated products, although there is some evidence that unstable cycloadducts are initially formed (55b). Thus the enamine (28) derived from cyclohexanone and pyrrolidine on reaction with acrylonitrile, acrylate esters, or phenyl vinyl sulfone gave the 2-alkylated cyclohexanones (63) on hydrolysis of the intermediates (31,32,55,56). These additions are sensitive to the polarity of the solvent. Thus (28) in benzene or dioxane gave an 80% yield of the... 

If the alkyl halide contains more than one, equally reactive C-halogen centers, these will generally react each with one aromatic substrate molecule. For example dichloromethane reacts with benzene to give diphenylmethane, and chloroform will give triphenylmethane. The reaction of tetrachloromethane with benzene however stops with the formation of triphenyl chloromethane 7 (trityl chloride), because further reaction is sterically hindered ... 

In order to achieve high yields, the reaction usually is conducted by application of high pressure. For laboratory use, the need for high-pressure equipment, together with the toxicity of carbon monoxide, makes that reaction less practicable. The scope of that reaction is limited to benzene, alkyl substituted and certain other electron-rich aromatic compounds. With mono-substituted benzenes, thepara-for-mylated product is formed preferentially. Super-acidic catalysts have been developed, for example generated from trifluoromethanesulfonic acid, hydrogen fluoride and boron trifluoride the application of elevated pressure is then not necessary. 

---