Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Structure and basicity

Different di- and trihydroxy bile salts and drugs that differ in lipophilicity, basicity, and structure (HBA and HBD) have been compared in order to examine solvatochromic equilibria (30,31). [Pg.124]

Baeger-Villiger reaction, 311 Barbiturates, 358 Base peak in ms. 248 Bases, soft and hard. 121 Basicity and structure. 43 Basic Red. 428 Beckmann rearrangement. 406 Benzene, resonance structure. 192 structure, 189 Benzenonium ion, 205 Benzhydrol, 269 Benzidine rearrangement. 422 Benzyne. 217 Bicydic compounds. 162 Birch reduction, 200 Bischler-Napieralski reaction, 460 Boat and chair forms. 168 Boiling point, influences on, 212 Bond dissociation, 37 Bond order, 17 Bond stretching. 233 Bonding orbitals, 14 Bredt s rule. 168 Bromonium ion. 100 BrOnsted. 42... [Pg.464]

Microstructure. The characterization of coal-derived asphaltene is quite similar to that of petroleum-derived asphaltene. Since it is anticipated that coal-derived asphaltene will have acid/neutral and base characteristics (26, 36), the average structure of both must be considered. In Table III, Structure I is amphoteric (or slightly basic), and Structure II is an acid/neutral representation. A mixture of both may be typical of the average structure of a coal-derived asphaltene. At present, we will illustrate this by an asphaltene obtained from coal liquid of the Synthoil process. (The coal is hvAb, West Kentucky, Homestead Seam the coal liquid is obtained by catalytic hydrogenation at 450° C and 4000 psig having %C, 86.7 %H, 8.38 %N, 0.93 %S, 0.09 %Q, 3.2 and %Ash, 0.7.)... [Pg.49]

Baeger-Villiger reaction, 311 Barbiturates, 358 Base peak in ms. 248 Bases, soft and hard, 121 Basicity and structure, 43 Basic Red. 428... [Pg.464]

Korolev BA, Khardin AP, Radchenko SS, Novakov lA and Orlinson BS, Basicity and structure of mono- and diamino derivatives of adamantine, Zhumal Organicheskoi Khimii, 14(8), 1632-1634 (1978). CA 89 196776n."... [Pg.62]

Different di- and trihydroxy bile salts and drugs that differ in lipophilicity, basicity, and structure have been compared in order to examine solvatochromic equilibria. The principle exploited in the determination of thermodynamic equilibrium constants is the indirect measurement of the capacity factor affected by the tenside concentration (in this case, the bile acid concentration). A pronounced shift in the migration times and thus effective ionic mobility... [Pg.548]

Qe W, Conway B, Hevia E, McCall MD, Russo L, Mulvey RE. Closer insight into the reactivity ofTMP-dialkyl zincates in directed ortho-zincation of anisole experimental evidence of amido basicity and structural elucidation of Key reaction intermediates. JAm Chem Soc. 2009 131(6) 2375-2384. [Pg.45]

At this point, we have realized that neither the kinetic data nor the absence of KIE with labeled phenol are conclusive to decide which of the mechanisms proposed in Scheme 10.2 is more likely. The remaining available data are related to the effects of the amine basicity and structure on the rate of the formation of phenyl benzoate (Table 10.1). [Pg.67]

Molecular orbitals were one of the first molecular features that could be visualized with simple graphical hardware. The reason for this early representation is found in the complex theory of quantum chemistry. Basically, a structure is more attractive and easier to understand when orbitals are displayed, rather than numerical orbital coefficients. The molecular orbitals, calculated by semi-empirical or ab initio quantum mechanical methods, are represented by isosurfaces, corresponding to the electron density surfeces Figure 2-125a). [Pg.135]

A polymer is a macromolecule that is constructed by chemically linking together a sequent of molecular fragments. In simple synthetic polymers such as polyethylene or polystyrer all of the molecular fragments comprise the same basic unit (or monomer). Other poly me contain mixtures of monomers. Proteins, for example, are polypeptide chains in which eac unit is one of the twenty amino acids. Cross-linking between different chains gives rise to j-further variations in the constitution and structure of a polymer. All of these features me affect the overall properties of the molecule, sometimes in a dramatic way. Moreover, or... [Pg.439]

Theoretical and structural studies have been briefly reviewed as late as 1979 (79AHC(25)147) (discussed were the aromaticity, basicity, thermodynamic properties, molecular dimensions and tautomeric properties ) and also in the early 1960s (63ahC(2)365, 62hC(17)1, p. 117). Significant new data have not been added but refinements in the data have been recorded. Tables on electron density, density, refractive indexes, molar refractivity, surface data and dissociation constants of isoxazole and its derivatives have been compiled (62HC(17)l,p. 177). Short reviews on all aspects of the physical properties as applied to isoxazoles have appeared in the series Physical Methods in Heterocyclic Chemistry (1963-1976, vols. 1-6). [Pg.3]

S = basic allowable stress for materials, excluding casting, joint, or structural-grade quahty factors E = quahty factor. The quahty factor E is one or the product of more than one of the following quahty factors casting quality factor Ec, joint quahty factor Ej (see Fig. 10-164), and structural-grade quahty factor E, of 0.92. [Pg.981]

Air-cooled heat exchangers include a tube bundle, which generally has spiral-wound fins upon the tubes, and a fan, which moves air across the tubes and is provided with a driver. Electric motors are the most commonly usea drivers typical drive arrangements require a V belt or a direc t right-angle gear. A plenum and structural supports are basic components. Louvers are often used ... [Pg.1077]

One of the most striking results that has emerged from the high-resolution crystallographic studies of these icosahedral viruses is that their coat proteins have the same basic core structure, that of a jelly roll barrel, which was discussed in Chapter 5. This is true of plant, insect, and mammalian viruses. In the case of the picornaviruses, VPl, VP2, and VP3 all have the same jelly roll structure as the subunits of satellite tobacco necrosis virus, tomato bushy stunt virus, and the other T = 3 plant viruses. Not every spherical virus has subunit structures of the jelly roll type. As we will see, the subunits of the RNA bacteriophage, MS2, and those of alphavirus cores have quite different structures, although they do form regular icosahedral shells. [Pg.335]

Despite the fact that the two main components of UF-resins are urea and formaldehyde, a broad variety of possible reactions and structures in the resins can be obtained. At the molecular level, the basic characteristics of UF-resins can be explained as follows (1) high reactivity (2) water solubility and dispersibility, which renders the resins ideal for use in the woodworking industry and (3) the reversibility of the aminomethylene link, which also explains the low resistance of the UF-resins against the influence of water and moisture, especially at higher temperatures. This is also one of the reasons for the subsequent formaldehyde emission. [Pg.1046]

Herein, we summarize some of the basic electronic and structural properties expected of these nanotubes from theoretical grounds. First we will discuss the basic structures of the nanotubes, define the nomencla-... [Pg.37]

We will use Mathematica throughout the text. Most of what is necessary to know will be introduced at the time it is needed. Nonetheless, there is some motivation to begin with some very basic commands and structures so that the process is smooth. Therefore, this is the goal of this section—to make your introduction to Mathematica go smoothly. For more information of this type there are many texts that cover Mathematicam detail. [Pg.1]


See other pages where Structure and basicity is mentioned: [Pg.935]    [Pg.747]    [Pg.400]    [Pg.76]    [Pg.935]    [Pg.747]    [Pg.400]    [Pg.76]    [Pg.80]    [Pg.293]    [Pg.187]    [Pg.594]    [Pg.801]    [Pg.435]    [Pg.57]    [Pg.955]    [Pg.503]    [Pg.482]    [Pg.26]    [Pg.266]    [Pg.273]    [Pg.279]    [Pg.869]    [Pg.167]    [Pg.314]    [Pg.320]    [Pg.168]    [Pg.195]    [Pg.315]    [Pg.38]    [Pg.502]    [Pg.205]    [Pg.381]    [Pg.756]    [Pg.1]   
See also in sourсe #XX -- [ Pg.41 ]

See also in sourсe #XX -- [ Pg.43 ]




SEARCH



Basic Equations for Static and Dynamic Structure Factors

Basic Formalism Describing the Relation between Real-Space Structure and Scattering Intensity in a SAXS Experiment

Basic OFET structure and operation

Basic Principles of PEM Structure and Operation

Basic Quantum Mechanics and Atomic Structure

Basic structure

Basicity (Acidity) and Structure

Basicity structures

Basics of crystal structure and X-ray diffraction

Beryllium butyrate, basic, properties and structure

Beryllium formate, basic, properties and structure

Beryllium pivalate, basic, properties and structure

Crystalline Solids Unit Cells and Basic Structures

Design ideas and basic structure of SCISR

Electronic and structural features that influence basicity

Necessary Basics Elements, Isotopes, Ions, Chemical Reactions, Energy Metabolism, and Bacterial Structures

Relationships Between Structure and Energetics— Basic Conformational Analysis

Structure and Basic Mechanical Properties of Wrought Age-Hardenable Aluminium Alloys

Structure and Basic Mechanical Properties of Wrought Work-Hardenable Aluminium Alloys

THE STRUCTURE AND BASIC PROPERTIES OF PLASTICS

Timescales and basic equations of stellar structure

© 2024 chempedia.info