Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Acrylonitrile constants

Dir, whereas for small distances d < r), /r Did. The large effective obtainable enables fast heterogeneous reaction rates to be measured under steady-state conditions. Zhou and Bard measured a rate constant of 6 x 10 Ms for the electro-hydrodimerization of acrylonitrile (AN) and observed the short-lived intennediate AN for this process [65]. [Pg.1942]

The physical properties of cyanoacetic acid [372-09-8] and two of its ester derivatives are Hsted ia Table 11 (82). The parent acid is a strong organic acid with a dissociation constant at 25°C of 3.36 x 10. It is prepared by the reaction of chloroacetic acid with sodium cyanide. It is hygroscopic and highly soluble ia alcohols and diethyl ether but iasoluble ia both aromatic and aUphatic hydrocarbons. It undergoes typical nitrile and acid reactions but the presence of the nitrile and the carboxyUc acid on the same carbon cause the hydrogens on C-2 to be readily replaced. The resulting malonic acid derivative decarboxylates to a substituted acrylonitrile ... [Pg.225]

Monomer compositional drifts may also occur due to preferential solution of the styrene in the mbber phase or solution of the acrylonitrile in the aqueous phase (72). In emulsion systems, mbber particle size may also influence graft stmcture so that the number of graft chains per unit of mbber particle surface area tends to remain constant (73). Factors affecting the distribution (eg, core-sheU vs "wart-like" morphologies) of the grafted copolymer on the mbber particle surface have been studied in emulsion systems (74). Effects due to preferential solvation of the initiator by the polybutadiene have been described (75,76). [Pg.203]

Chain transfer is an important consideration in solution polymerizations. Chain transfer to solvent may reduce the rate of polymerization as well as the molecular weight of the polymer. Other chain-transfer reactions may iatroduce dye sites, branching, chromophoric groups, and stmctural defects which reduce thermal stabiUty. Many of the solvents used for acrylonitrile polymerization are very active in chain transfer. DMAC and DME have chain-transfer constants of 4.95-5.1 x lO " and 2.7-2.8 x lO " respectively, very high when compared to a value of only 0.05 x lO " for acrylonitrile itself DMSO (0.1-0.8 X lO " ) and aqueous zinc chloride (0.006 x lO " ), in contrast, have relatively low transfer constants hence, the relative desirabiUty of these two solvents over the former. DME, however, is used by several acryhc fiber producers as a solvent for solution polymerization. [Pg.277]

In studies of the polymerization kinetics of triaUyl citrate [6299-73-6] the cyclization constant was found to be intermediate between that of diaUyl succinate and DAP (86). Copolymerization reactivity ratios with vinyl monomers have been reported (87). At 60°C with benzoyl peroxide as initiator, triaUyl citrate retards polymerization of styrene, acrylonitrile, vinyl choloride, and vinyl acetate. Properties of polyfunctional aUyl esters are given in Table 7 some of these esters have sharp odors and cause skin irritation. [Pg.87]

In a copolymer of 33% acrylonitrile, the most common composition for commercial products, the butadiene occurs in the approximate ratio of 90% trans, 8% vinyl, and 2% cis. At higher acrylonitrile content the cis configuration disappears, and at lower levels it increases to about 5% the vinyl configuration remains approximately constant (6,7). Since actual compositions of commercial nitrile mbbers are between 15 and 50% acrylonitrile, they also vary somewhat in sequence distribution and in the content of the three isomeric butadiene configurations. [Pg.516]

Acetylene, clathrate in hydroquinone, 7 hydrate thermodynamic data and lattice constants, 8 Acrylamides, polymerization of, 181 Acrylonitrile, 155 Activity coefficients, 125... [Pg.403]

Giese and Kretzschmar7j found the rate of addition of hexenyl radicals to methyl acrylate increased 2-fold between aqueous tetrahydrofuran and aqueous ethanol, Salikhov and Fischer74 reported that the rate constant for /-butyl radical addition to acrylonitrile increased 3.6-fold between tetradecane and acetonitrile. Bednarek et al75 found that the relative reactivity of S vs MMA towards phenyl radicals was ca 20% greater in ketone solvents than it was in aromatic solvents. [Pg.26]

Absolute rate constants for addition reactions of cyanoalkyl radicals are significantly lower than for unsubstituted alkyl radicals falling in the range 103-104 M V1.341 The relative reactivity data demonstrate that they possess some electrophilic character. The more electron-rich VAc is very much less reactive than the electron-deficient AN or MA. The relative reactivity of styrene and acrylonitrile towards cyanoisopropyl radicals would seem to show a remarkable temperature dependence that must, from the data shown (Table 3.6), be attributed to a variation in the reactivity of acrylonitrile with temperature and/or other conditions. [Pg.116]

Waters61 have measured relative rates of p-toluenesulfonyl radical addition to substituted styrenes, deducing from the value of p + = — 0.50 in the Hammett plot that the sulfonyl radical has an electrophilic character (equation 21). Further indications that sulfonyl radicals are strongly electrophilic have been obtained by Takahara and coworkers62, who measured relative reactivities for the addition reactions of benzenesulfonyl radicals to various vinyl monomers and plotted rate constants versus Hammett s Alfrey-Price s e values these relative rates are spread over a wide range, for example, acrylonitrile (0.006), methyl methacrylate (0.08), styrene (1.00) and a-methylstyrene (3.21). The relative rates for the addition reaction of p-methylstyrene to styrene towards methane- and p-substituted benzenesulfonyl radicals are almost the same in accord with their type structure discussed earlier in this chapter. [Pg.1103]

Other substituted olefins such as acrylonitrile, fumaronitrile, crotono-nitrile, cinnamonitrile, and diethylfumarate also formed adducts with Co (DMG)2 complexes containing py, H2O, or PBuj and, in one case, with [Co (DMG-BF2)2py]. Second-order rate constants were reported for the formation of several Tr-olefin-Co(I) complexes from organocobalt(III) complexes containing, for example, NCCH2CH2- with DMG, DPG, DMG-BF, py, H2O, and PBuj. [Pg.400]

On the other hand, the use of a-cyclodextrin decreased the rate of the reaction. This inhibition was explained by the fact that the relatively smaller cavity can only accommodate the binding of cyclopentadiene, leaving no room for the dienophile. Similar results were observed between the reaction of cyclopentadiene and acrylonitrile. The reaction between hydroxymethylanthracene and N-ethylmaleimide in water at 45°C has a second-order rate constant over 200 times larger than in acetonitrile (Eq. 12.2). In this case, the P-cyclodextrin became an inhibitor rather than an activator due to the even larger transition state, which cannot fit into its cavity. A slight deactivation was also observed with a salting-in salt solution (e.g., quanidinium chloride aqueous solution). [Pg.377]

An ab initio MO calculation by Jorgensen revealed enhanced hydrogen bonding of a water molecule to the transition states for the Diels-Alder reactions of cyclopentadiene with methyl vinyl ketone and acrylonitrile, which indicates that the observed rate accelerations for Diels-Alder reactions in aqueous solution arise from the hydrogenbonding effect in addition to a relatively constant hydrophobic term.7,76 Ab initio calculation using a self-consistent reaction field continuum model shows that electronic and nuclear polarization effects in solution are crucial to explain the stereoselectivity of nonsymmetrical... [Pg.391]

The tendency of acrylonitrile to partition between air and water is described by Henry s law constant (H). The value of H for acrylonitrile has not been determined experimentally, but has been calculated to be 8.8 x 10 5 atm-m3/mole (Mabey et al. 1982). This value indicates that acrylonitrile will occur in both air and water, tending to transfer between air and water phases only slowly. Cupitt (1980) estimated the half-time of acrylonitrile clearance from air in wet precipitation to be greater than 10 months. [Pg.83]

The principal pathway leading to degradation of acrylonitrile in air is believed to be photooxidation, mainly by reaction with hydroxyl radicals (OH). The rate constant for acrylonitrile reaction with OH has been measured as 4.1 x 10" cm /molecule/second (Harris et al. 1981). This would correspond to an atmospheric half-life of about 5 to 50 hours. This is consistent with a value of 9 to 10 hours measured in a smog chamber (Suta 1979). [Pg.84]

Physical and Chemical Properties. Most of the important physical-chemical properties of acrylonitrile have been determined (see Chapter 3). However, the partitioning of acrylonitrile between the air and water has been evaluated by using an estimated value for a Henry s law constant. This general approach assumes that the concentration of the chemical in water is low. Because acrylonitrile is relatively soluble in water, this approach may not be accurate. Experimental measurement of the partition coefficient for acrylonitrile at water-air interfaces would be useful in refining models on the behavior of acrylonitrile in the environment. [Pg.89]

Thereafter, the reaction between the coordinated dienoate ligand in 106 and acrylonitrile was examined (Scheme 12). Surprisingly, this reaction is complete within 56 h (pseudo-first-order rate constant k — 1.4 x 10-5 s-1, ti/2 ca. 0.5 day) and affords only two products 107a and 107b in a ratio of 57 43 (or the correepsonding acids 103a,b via acid hydrolysis). Thus, in... [Pg.456]

The formation of the hydrogen bond between hydroperoxide and polar monomer, for example, methyl acrylate or acrylonitrile, does not influence the rate constant of the reaction of hydroperoxide with the double bond of monomer [101]. The values of the rate constants of the reaction of hydroperoxide with olefins are given in Table 4.13. The effect of multidipole interaction was observed for reactions of hydroperoxide with polyfunctional monomers (see Table 4.14, Ais the Gibbs energy of multidipole interaction in the transition state). [Pg.185]

The dependence of relative rates in radical addition reactions on the nucleophilicity of the attacking radical has also been demonstrated by Minisci and coworkers (Table 7)17. The evaluation of relative rate constants was in this case based on the product analysis in reactions, in which substituted alkyl radicals were first generated by oxidative decomposition of diacyl peroxides, then added to a mixture of two alkenes, one of them the diene. The final products were obtained by oxidation of the intermediate allyl radicals to cations which were trapped with methanol. The data for the acrylonitrile-butadiene... [Pg.624]

On treatment with acrylonitrile in 2% aqueous sodium hydroxide at 0°, tetrahydropyran-2-yl /3-D-glucopyranoside gave the 2-, 3-, 4-, and 6-0-(2-cyanoethyl) ethers (together with some diethers) in yields that, on extrapolation to zero reaction, showed3 9 k2 k3 k4 k6 to be in the ratios of 3 1 2 8 these values represent equilibrium, not rate, constants. The tendency for substitution at 0-6 is a consequence of the greater stability of an ether derived from a primary (compared to a secondary) hydroxyl group, as a result of lower steric interactions in the former. [Pg.67]

Methyl methacrylate (MMA), 16 227 Alfrey-Price parameters, 7 617t azeotropic mixtures with, 16 236t block copolymer synthesis, 7 647t C-2 routes to, 16 252-254 C-3 routes to, 16 246—252 C-4 routes to, 16 254—257 carbon monoxide in production of, 5 6 chain-transfer constants for, 16 284t comonomer with acrylonitrile, 1 451t cumene as feedstock, 8 156 in flame-retardant resin formulation,... [Pg.579]

TABLE 2. Rate constants for the Diels-Alder reaction of cyclopentadiene and acrylonitrile in different solvents... [Pg.1031]

Photolytic. In an aqueous solution at 50 °C, UV light photooxidized acrylonitrile to carbon dioxide. After 24 h, the concentration of acrylonitrile was reduced 24.2% (Knoevenagel and Himmelreich, 1976). A rate constant of 4.06 x 10 cmVmolecule-sec at 26 °C was reported for the vapor-phase reaction of acrylonitrile and OH radicals in air (Harris et al., 1981). [Pg.80]


See other pages where Acrylonitrile constants is mentioned: [Pg.192]    [Pg.279]    [Pg.280]    [Pg.540]    [Pg.366]    [Pg.568]    [Pg.21]    [Pg.249]    [Pg.1028]    [Pg.120]    [Pg.869]    [Pg.391]    [Pg.391]    [Pg.399]    [Pg.562]    [Pg.83]    [Pg.205]    [Pg.24]    [Pg.39]    [Pg.56]    [Pg.625]    [Pg.627]    [Pg.99]    [Pg.244]    [Pg.99]    [Pg.169]    [Pg.136]   
See also in sourсe #XX -- [ Pg.5 , Pg.11 ]




SEARCH



Acrylonitrile rate constants

Styrene-acrylonitrile copolymer constants

© 2024 chempedia.info