Acidity Lewis and

In in vitro experiments, Lipschitz and Bueding42 found that the liver, and, to a much lesser extent, the kidney were the only tissues of the rabbit, rat and guineapig which could conjugate various hydroxy compounds with D-glucuronic acid. Lewy and Storey43 48 found that mouse liver slices conjugate o-aminophenol with D-glucuronic acid, but that kidney was much less active and spleen inactive. 

The use of this simple technique has shed light on the mechanisms by which Azone and oleic acid may exert their well-documented enhancing effects. The study of mixed monolayers of dipalmitoylphosphatidylcholine (DPPC) and Azone or oleic acid (Lewis and Hadgraft, 1990) has revealed, in some detail, possible differences in the way in which these compounds may act as enhancers. Monolayer experiments have also been used to examine the behavior of a complex mixture of lipids (representing those in the stratum comeum) and the way in which these are affected by the presence of Azone (Schuckler and Lee, 1991). Although there are many interesting results in the literature arising from such experiments, it is perhaps these that are the most relevant. Therefore, it is on these results that this section will primarily concentrate. 

Still another type of adsorption system is that in which either a proton transfer occurs between the adsorbent site and the adsorbate or a Lewis acid-base type of reaction occurs. An important group of solids having acid sites is that of the various silica-aluminas, widely used as cracking catalysts. The sites center on surface aluminum ions but could be either proton donor (Brpnsted acid) or Lewis acid in type. The type of site can be distinguished by infrared spectroscopy, since an adsorbed base, such as ammonia or pyridine, should be either in the ammonium or pyridinium ion form or in coordinated form. The type of data obtainable is illustrated in Fig. XVIII-20, which shows a portion of the infrared spectrum of pyridine adsorbed on a Mo(IV)-Al203 catalyst. In the presence of some surface water both Lewis and Brpnsted types of adsorbed pyridine are seen, as marked in the figure. Thus the features at 1450 and 1620 cm are attributed to pyridine bound to Lewis acid sites, while those at 1540... 

Fig. XVIII-20. Spectra of pyridine adsorbed on a water-containing molybdenum oxide (IV)-Al203 catalyst L and B indicate features attributed to pyridine adsorbed on Lewis and Brpnsted acid sites, respectively. (Reprinted with permission from Ref. 191. Copyright 1976 American Chemical Society.)...

Boron trioxide is not particularly soluble in water but it slowly dissolves to form both dioxo(HB02)(meta) and trioxo(H3B03) (ortho) boric acids. It is a dimorphous oxide and exists as either a glassy or a crystalline solid. Boron trioxide is an acidic oxide and combines with metal oxides and hydroxides to form borates, some of which have characteristic colours—a fact utilised in analysis as the "borax bead test , cf alumina p. 150. Boric acid. H3BO3. properly called trioxoboric acid, may be prepared by adding excess hydrochloric or sulphuric acid to a hot saturated solution of borax, sodium heptaoxotetraborate, Na2B407, when the only moderately soluble boric acid separates as white flaky crystals on cooling. Boric acid is a very weak monobasic acid it is, in fact, a Lewis acid since its acidity is due to an initial acceptance of a lone pair of electrons from water rather than direct proton donation as in the case of Lowry-Bronsted acids, i.e. 

This chapter introduces the experimental work described in the following chapters. Some mechanistic aspects of the Diels-Alder reaction and Lewis-acid catalysis thereof are discussed. This chapter presents a critical survey of the literature on solvent ejfects on Diels-Alder reactions, with particular emphasis on the intriguing properties of water in connection with their effect on rate and selectivity. Similarly, the ejfects of water on Lewis acid - Lewis base interactions are discussed. Finally the aims of this thesis are outlined. 

The second important influence of the solvent on Lewis acid - Lewis base equilibria concerns the interactions with the Lewis base. Consequently the Lewis addity and, for hard Lewis bases, especially the hydrogen bond donor capacity of tire solvent are important parameters. The electron pair acceptor capacities, quantified by the acceptor number AN, together with the hydrogen bond donor addities. O, of some selected solvents are listed in Table 1.5. Water is among the solvents with the highest AN and, accordingly, interacts strongly witli Lewis bases. This seriously hampers die efficiency of Lewis-acid catalysis in water. 

Table 2.5. Apparent second-order rate constants for the catalysed Diels-Alder reaction between Ic and 2, equilibrinm constants for complexation of 2.4c to different Lewis-acids (Kj) and second-order rate constants for the reaction of these complexes with 2.5 (k at) in water at 2M ionic strength at 25°C.

Interestingly, at very low concentrations of micellised Qi(DS)2, the rate of the reaction of 5.1a with 5.2 was observed to be zero-order in 5.1 a and only depending on the concentration of Cu(DS)2 and 5.2. This is akin to the turn-over and saturation kinetics exhibited by enzymes. The acceleration relative to the reaction in organic media in the absence of catalyst, also approaches enzyme-like magnitudes compared to the process in acetonitrile (Chapter 2), Cu(DS)2 micelles accelerate the Diels-Alder reaction between 5.1a and 5.2 by a factor of 1.8710 . This extremely high catalytic efficiency shows how a combination of a beneficial aqueous solvent effect, Lewis-acid catalysis and micellar catalysis can lead to tremendous accelerations. 

In the final chapter ofi this thesis, the work described in the preceding chapters is evaluated. Furthermore, two pivotal themes ofi this work, Lewis acid - Lewis base interactions in water and hydrophobic fiects, are reviewed. Finally, the prospects ofi Lewis-acid catalysis in aqueous solution are discussed. 

First of all, given the well recognised promoting effects of Lewis-acids and of aqueous solvents on Diels-Alder reactions, we wanted to know if these two effects could be combined. If this would be possible, dramatic improvements of rate and endo-exo selectivity were envisaged Studies on the Diels-Alder reaction of a dienophile, specifically designed for this purpose are described in Chapter 2. It is demonstrated that Lewis-acid catalysis in an aqueous medium is indeed feasible and, as anticipated, can result in impressive enhancements of both rate and endo-exo selectivity. However, the influences of the Lewis-acid catalyst and the aqueous medium are not fully additive. It seems as if water diminishes the catalytic potential of Lewis acids just as coordination of a Lewis acid diminishes the beneficial effects of water. Still, overall, the rate of the catalysed reaction... 

Chapter 5 also demonstrates that a combination of Lewis-acid catalysis and micellar catalysis can lead to accelerations of enzyme-like magnitudes. Most likely, these accelerations are a consequence of an efficient interaction between the Lewis-acid catalyst and the dienophile, both of which have a high affinity for the Stem region of the micelle. Hence, hydrophobic interactions and Lewis-acid catalysis act cooperatively. Unfortunately, the strength of the hydrophobic interaction, as offered by the Cu(DS)2 micellar system, was not sufficient for extension of Lewis-acid catalysis to monodentate dienophiles. 

In Chapter 1 mechanistic aspects of Are Diels-Alder reaction are discussed. The literature on the effects of solvents and Lewis-acid catalysts on this reaction is surveyed. The special properties of water are reviewed and the effects of water on the Diels-Alder reaction is discussed. Finally, the effect of water on Lewis acid - Lewis base interactions is described. 

In Chapter 6 we survey what has been accomplished and indicate directions for future research. Furthermore, we critically review the influence of water on Lewis acid - Lewis base interactions. This influence has severe implications for catalysis, in particular when hard Lewis acids and bases are involved. We conclude that claims of Lewis-acid catalysis should be accompanied by evidence for a direct interaction between catalyst and substrate. 

The product of this reaction a Lewis acid Lewis base complex called informally boron tnfluonde etherate may look unusual but it is a stable species with properties different from those of the reactants Its boiling point (126°C) for example is much higher than that of boron tnfluonde—a gas with a boiling point of — 100°C—and diethyl ether a liquid that boils at 34°C... 

Clearly the two reactions are analogous and demonstrate that the reaction between hydroxide ion and hydrogen bromide is simultaneously a Brpnsted acid-base reaction and a Lewis acid Lewis base reaction Br0nsted acid-base reactions constitute a sub category of Lewis acid Lewis base reactions... 

Their polar carbon-oxygen bonds and the presence of unshared electron pairs at oxygen contribute to the ability of ethers to form Lewis acid Lewis base complexes with metal ions... 

The metal-ion complexmg properties of crown ethers are clearly evident m their effects on the solubility and reactivity of ionic compounds m nonpolar media Potassium fluoride (KF) is ionic and practically insoluble m benzene alone but dissolves m it when 18 crown 6 is present This happens because of the electron distribution of 18 crown 6 as shown m Figure 16 2a The electrostatic potential surface consists of essentially two regions an electron rich interior associated with the oxygens and a hydrocarbon like exterior associated with the CH2 groups When KF is added to a solution of 18 crown 6 m benzene potassium ion (K ) interacts with the oxygens of the crown ether to form a Lewis acid Lewis base complex As can be seen m the space filling model of this... 

Ethers form Lewis acid Lewis base complexes with metal ions Certain cyclic polyethers called crown ethers, are particularly effective m coor dinatmg with Na" and K" and salts of these cations can be dissolved m nonpolar solvents when crown ethers are present Under these conditions the rates of many reactions that involve anions are accelerated... 

Sulfur tetrafluoride [7783-60-0] SF, replaces halogen in haloalkanes, haloalkenes, and aryl chlorides, but is only effective (even at elevated temperatures) in the presence of a Lewis acid catalyst. The reagent is most often used in the replacement of carbonyl oxygen with fluorine (15,16). Aldehydes and ketones react readily, particularly if no alpha-hydrogen atoms are present (eg, benzal fluoride [455-31-2] from benzaldehyde), but acids, esters, acid chlorides, and anhydrides are very sluggish. However, these reactions can be catalyzed by Lewis acids (HP, BF, etc). 

Ultimately, as the stabilization reactions continue, the metallic salts or soaps are depleted and the by-product metal chlorides result. These metal chlorides are potential Lewis acid catalysts and can greatiy accelerate the undesired dehydrochlorination of PVC. Both zinc chloride and cadmium chloride are particularly strong Lewis acids compared to the weakly acidic organotin chlorides and lead chlorides. This significant complication is effectively dealt with in commercial practice by the co-addition of alkaline-earth soaps or salts, such as calcium stearate or barium stearate, ie, by the use of mixed metal stabilizers. 

Alkylation involving formaldehyde in the presence of hydrogen chloride is known as chloromethylation (eq. 3). The reagent may be a mixture of formalin and hydrochloric acid, paraformaldehyde and hydrochloric acid, a chloromethyl ether, or a formal. Zinc chloride is commonly employed as a catalyst, although many other Lewis acids can be used. Chloromethylation of sahcyhc acids yields primarily the 5-substituted product 5-chlotomethylsahcyhc acid [10192-87-7] (4). 

Nitrogen nucleophiles used to diplace the 3 -acetoxy group include substituted pyridines, quinolines, pyrimidines, triazoles, pyrazoles, azide, and even aniline and methylaniline if the pH is controlled at 7.5. Sulfur nucleophiles include aLkylthiols, thiosulfate, thio and dithio acids, carbamates and carbonates, thioureas, thioamides, and most importandy, from a biological viewpoint, heterocycHc thiols. The yields of the displacement reactions vary widely. Two general approaches for improving 3 -acetoxy displacement have been reported. One approach involves initial, or in situ conversion of the acetoxy moiety to a more facile leaving group. The other approach utilizes Lewis or Brmnsted acid activation (87). 

---