2- vinyl ketones

The vinyl ketone partner used in the CM reaction can be of a size comparable to that of the other partner. For example, Cossy et al. recently described the synthesis of the monomeric counterpart of marinomycin A, isolated from the saHne culture of Marinospora strain CNQ-140, which shows significant antibiotic activity against Staphylococcus aureus or Enterococcus faecium, using a CM between a vinyl ketone and a type I olefin [14]. Another case of CM between a complex vinyl ketone and a type 1 olefin was reported by Rychnovsky and coworkers for the construction of the C1-C52 segment of amphidinol 3 [15], 

---

CH2 CH C CH. Colourless gas with a sweet odour b.p. 5°C. Manufactured by the controlled low-temperature telomerization of ethyne in the presence of an aqueous solution of CuCI and NH Cl. Reduced by hydrogen to butadiene and, finally, butane. Reacts with water in the presence of HgSO to give methyl vinyl ketone. Forms salts. Forms 2-chloro-butadiene (chloroprene) with hydrochloric acid and certain metallic chlorides. 

Figure A3.8.2 The correlation fimction k( ) for particular case of the reaction of methyl vinyl ketone with cyclopentadiene in water. The leveling-off of this function to reach a constant value at the plateau time tp is clearly seen.

Heating or steam distillation affords ethylenic compounds thus (I) yields pheuyl vinyl ketone (II) ... 

Robinson Annulation Sequential Michael addition/aldol condensation between a ketone enolate and an alkyl vinyl ketone (i.e. MVK) to give a cyclohex-2-en-l-one... 

Figure 1.2. Endo and exo pathway for the Diels-Alder reaction of cyclopentadiene with methyl vinyl ketone. As was first noticed by Berson, the polarity of the endo activated complex exceeds that of the exo counterpart due to alignment of the dipole moments of the diene and the dienophile K The symmetry-allowed secondary orbital interaction that is only possible in the endo activated complex is usually invoked as an explanation for the preference for endo adduct exhibited by most Diels-Alder reactions.

Figure 1.5. Chemical potential of the initial state, the transition state and the product of the Diels-Alder reaction between methyl vinyl ketone and cyclopentadiene in water as compared to 1-propanol The data are taken from r. 56.

Tire results of a study of the effect of these catalysts on the model Diels-Alder reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) are summarised in Table 4.1... 

Pyridyl)hydrazine (Aldrich), 4-acetylpyridine (Acros), N,N,N -trimethylethylenediamine (Aldrich), methylrhenium trioxide (Aldrich), InQj (Aldrich), Cu(N0j)2-3H20 (Merck), Ni(N03)2-6Il20 (Merck), Yb(OTf)3(Fluka), Sc(OTf)3 (Fluka), 2-(aminomethyl)pyridine (Acros), benzylideneacetone (Aldrich), and chalcone (Aldrich) were of the highest purity available. Borane dimethyl sulfide (2M solution in THE) was obtained from Aldrich. Methyl vinyl ketone was distilled prior to use. Cyclopentadiene was prepared from its dimer immediately before use. (R)-l-acetyl-5-isopropoxy-3-pyrrolin-2-one (4.15) has been kindly provided by Prof H. Hiemstra (University of Amsterdam). 

Kinetic measurements were performed employii UV-vis spectroscopy (Perkin Elmer "K2, X5 or 12 spectrophotometer) using quartz cuvettes of 1 cm pathlength at 25 0.1 C. Second-order rate constants of the reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) were determined from the pseudo-first-order rate constants obtained by followirg the absorption of 4.6 at 253-260 nm in the presence of an excess of 4.8. Typical concentrations were [4.8] = 18 mM and [4.6] = 0.1 mM. In order to ensure rapid dissolution of 4.6, this compound was added from a stock solution of 5.0 )j1 in 2.00 g of 1-propanol. In order to prevent evaporation of the extremely volatile 4.6, the cuvettes were filled almost completely and sealed carefully. The water used for the experiments with MeReOj was degassed by purging with argon for 0.5 hours prior to the measurements. All rate constants were reproducible to within 3%. 

Alkylation of the product (a Matinich Base A) gives a compound (B) which gives the required vinyl ketone on elimination in base. This last step is usually carried out in the basic medium of the Michael reaction itself so that the reactive vinyl ketone (TM 122) need never be isolated. 

There also exists an acidregioselective condensation of the aldol type, namely the Mannich reaction (B. Reichert, 1959 H. Hellmann, 1960 see also p. 291f.). The condensation of secondary amines with aldehydes yields Immonium salts, which react with ketones to give 3-amino ketones (=Mannich bases). Ketones with two enolizable CHj-groupings may form 1,5-diamino-3-pentanones, but monosubstitution products can always be obtained in high yield. Unsymmetrical ketones react preferentially at the most highly substituted carbon atom. Sterical hindrance can reverse this regioselectivity. Thermal elimination of amines leads to the a,)3-unsaturated ketone. Another efficient pathway to vinyl ketones starts with the addition of terminal alkynes to immonium salts. On mercury(ll) catalyzed hydration the product is converted to the Mannich base (H. Smith, 1964). 

Torgov introduced an important variation of the Michael addition allylic alcohols are used as vinylogous a -synthons and 1,3-dioxo compounds as d -reagents (S.N. Ananchenko, 1962, 1963 H. Smith, 1964 C. Rufer) 1967). Mild reaction conditions have been successful in the addition of ],3-dioxo compounds to vinyl ketones. Potassium fluoride can act as weakly basic, non-nudeophilic catalyst in such Michael additions under essentially non-acidic and non-basic conditions (Y. Kitabara, 1964). 

Finally a general approach to synthesize A -pyrrolines must be mentioned. This is tl acid-catalyzed (NH4CI or catalytic amounts of HBr) and thermally (150°C) induced tea rangement of cyclopropyl imines. These educts may be obtained from commercial cyan> acetate, cyclopropyl cyanide, or benzyl cyanide derivatives by the routes outlined below. Tl rearrangement is reminiscent of the rearrangement of 1-silyloxy-l-vinylcyclopropancs (p. 7 83) but since it is acid-catalyzed it occurs at much lower temperatures. A -Pyrrolines constitut reactive enamines and may be used in further addition reactions such as the Robinson anei lation with methyl vinyl ketone (R.V. Stevens, 1967, 1968, 1971). 

Thallation of aromatic compounds with thallium tris(trifluoroacetate) proceeds more easily than mercuration. Transmetallation of organothallium compounds with Pd(II) is used for synthetic purposes. The reaction of alkenes with arylthallium compounds in the presence of Pd(Il) salt gives styrene derivatives (433). The reaction can be made catalytic by use of CuCl7[393,394], The aryla-tion of methyl vinyl ketone was carried out with the arylthallium compound 434[395]. The /9-alkoxythallium compound 435, obtained by oxythallation of styrene, is converted into acetophenone by the treatment with PdCh[396]. 

The carbopalladation of allylamine with malonate affords the chelating complex 510, which undergoes insertion of methyl vinyl ketone to form the amino enone 511[463]. The allylic sulfide 512 has the same chelating effect to give the five-membered complex 513 by carbopalladation[463.464]. 

In the reaction of Q,/3-unsaturated ketones and esters, sometimes simple Michael-type addition (insertion and hydrogenolysis, or hydroarylation, and hydroalkenylation) of alkenes is observed[53,54]. For example, a simple addition product 56 to methyl vinyl ketone was obtained by the reaction of the heteroaromatic iodide 55[S5]. The corresponding bromide affords the usual insertion-elimination product. Saturated ketones are obtained cleanly by hydroarylation of o,/3l-unsaturated ketones with aryl halides in the presence of sodium formate, which hydrogenolyses the R—Pd—I intermediate to R— Pd—H[56]. Intramolecular hydroarylation is a useful reaction. The diiodide 57 reacts smoothly with sodium formate to give a model compound for the afla-toxin 58. (see Section 1.1.6)[57]. Use of triethylammonium formate and BU4NCI gives better results. 

A solution of l-methylpyrano[4,3-b]indol-3-one (1 mmol) and methyl vinyl ketone (5 ml) in toluene (5 ml) containing 5% Pd/C (40 mg) was heated for 48 h in a sealed tube at 110°C. The reaction mixture was evaporated in vacuo and the residue purified by silica gel chromatography to give the product in 80% yield. 

In this reaction the enolate of diethyl malonate adds to the p carbon of methyl vinyl ketone... 

A number of activated olefinic compounds react very weU in this scheme including methacrylates, crotonates, acrylonitrile, and vinyl ketones. These reactions are typicaHy mn in an etherial solvent and can be mn without the complications of undesirable side reactions leading to trialkylated tin species. 

---