Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Uranium and plutonium

Thorium, uranium, and plutonium are well known for their role as the basic fuels (or sources of fuel) for the release of nuclear energy (5). The importance of the remainder of the actinide group Hes at present, for the most part, in the realm of pure research, but a number of practical appHcations are also known (6). The actinides present a storage-life problem in nuclear waste disposal and consideration is being given to separation methods for their recovery prior to disposal (see Waste treati nt, hazardous waste Nuclear reactors, waste managet nt). [Pg.212]

The wastes from uranium and plutonium processing of the reactor fuel usually contain the neptunium. Precipitation, solvent extraction, ion exchange, and volatihty procedures (see Diffusion separation methods) can be used to isolate and purify the neptunium. [Pg.213]

The simple box-type mixer—settler (113) has been used extensively in the UK for the separation and purification of uranium and plutonium (114). In this type of extractor, interstage flow is handled through a partitioned box constmction. Interstage pumping is not needed because the driving force is provided by the density difference between solutions in successive stages (see Plutoniumand plutonium compounds Uraniumand uranium compounds). [Pg.74]

Argon-40 [7440-37-1] is created by the decay of potassium-40. The various isotopes of radon, all having short half-Hves, are formed by the radioactive decay of radium, actinium, and thorium. Krypton and xenon are products of uranium and plutonium fission, and appreciable quantities of both are evolved during the reprocessing of spent fuel elements from nuclear reactors (qv) (see Radioactive tracers). [Pg.4]

Krypton and Xenon from Huclear Power Plants. Both xenon and krypton are products of the fission of uranium and plutonium. These gases are present in the spent fuel rods from nuclear power plants in the ratio 1 Kr 4 Xe. Recovered krypton contains ca 6% of the radioactive isotope Kr-85, with a 10.7 year half-life, but all radioactive xenon isotopes have short half-Hves. [Pg.11]

Chemical Separation. A reprocessing facility typically utilizes multiple extraction/reextraction (stripping) cycles for the recovery and purification of uranium and plutonium. For example, a co-decontamination and partitioning cycle is followed by one or more cycles of uranium and plutonium purification. The basic process is illustrated in Figure 3. [Pg.204]

Uranium—Plutonium Partitioning". The uranium and plutonium are separated in the partitioning column by reducing the plutonium to a less extractable valence state. The plutonium nitrate transfers back to the aqueous phase and the uranium remains with the organic. [Pg.205]

Uranium. The uranium product from the PUREX process is in the form of uranyl nitrate which must be converted to some other chemical depending on anticipated use. One route to MO fuel is to mix uranium and plutonium nitrates and perform a coprecipitation step. The precipitate is... [Pg.206]

By-Products. The PUREX process is efficient at separating uranium and plutonium from everything else in the spent fuel. Within the high level waste stream are a number of components which have, from time to time, been sufficiendy interesting to warrant their recovery. The decision to recover a particular isotope is usually based on a combination of market incentives and desired waste reduction. [Pg.206]

The geologic aspects of waste disposal (24—26), proceedings of an annual conference on high level waste management (27), and one from an annual conference on all types of radioactive waste (28) are available. An alternative to burial is to store the spent fuel against a long-term future energy demand. Uranium and plutonium contained in the fuel would be readily extracted as needed. [Pg.230]

Some of the heavy radioisotopes, namely those of uranium and plutonium, are used as the fuel ia nuclear reactors (qv) which are used by commercial power companies to produce electricity. These radioisotopes have also been used as the critical components ia nuclear weapons. [Pg.442]

Nuclear power reactors cause the transmutation of chemicals (uranium and plutonium) to fission products using neutrons as the catalyst to produce heat. Fossil furnaces use the chemical reaction of carbon and oxygen to produce CO2 and other wastes to produce heat. There is only one reaction and one purpose for nuclear power reactors there is one reaction but many puiposes for fossil-burning furnaces there are myriad chemical processes and purposes. [Pg.261]

Wlieii very heavy nuclei, such as those of uranium and plutonium, are split into lighter nuclei having less total mass than the very heavy nuclei, energy is released. The process is called nuclear fission. In either nuclear fission or nuclear fusion, much of the convened rest energy emerges as kinetic energy, heat, and light. [Pg.780]

Since the amount of fissile material in the fuel assemblies is only about 3 percent of the uranium present, it is obvious that there cannot be a large amount of radioactive material in the SNF after fission. The neutron flux produces some newly radioactive material in the form of uranium and plutonium isotopes. The amount of this other newly radioactive material is small compared to the volume of the fuel assembly. These facts prompt some to argue that SNF should be chemically processed and the various components separated into nonradioac-tive material, material that will be radioactive for a long time, and material that could be refabricated into new reactor fuel. Reprocessing the fuel to isolate the plutonium is seen as a reason not to proceed with this technology in the United States. [Pg.884]

Lemire, R.J. Tremaine, P. "Uranium and Plutonium Equilibria in Aqueous Solutions to 200°C" AECL-6655 Whiteshell Nucl. Res. Est. Pinawa, 1980. [Pg.294]

Bonnelle, C. Band and Localized States in Metallic Thorium, Uranium and Plutonium, and in Some Compounds, Studied by X-ray Spectroscopy. Vol. 31, pp. 23-48. [Pg.190]

Nuclear fuel reprocessing was first undertaken with the sole purpose of recovering plutonium, for weapons use, from uranium irradiated in nuclear reactors. These reactors, called the production reactors, were dedicated to transmuting as much of the uranium as possible to plutonium. From its original scope of recovering exclusively plutonium, with no attempts to either recover or recycle uranium, nuclear fuel reprocessing has since grown into a much more sophisticated and complex operation with expanded scope. It is now called upon to separate uranium and plutonium from the fission products, and to purify these elements to levels at which these fissile materials can be conveniently recycled for reuse. The present scope also extends to fission products separation and concentration. [Pg.529]

Stanley JA, Edison AF, Mewhinney JA. 1982. Distribution, retention and dosimetry of plutonium and americium in the rat, dog and monkey after inhalation of an industrial-mixed uranium and plutonium oxide aerosol. Health Phys 43(4) 521-530. [Pg.261]

Solvent extraction, also called liquid-liquid extraction, can be used to separate a substance from a solution by extraction into another solvent. It can be used ether to recover a valuable substance from the original solution, or to purify the original solvent by removing an unwanted component. Examples of solvent extraction are the extraction of uranium and plutonium salts from solution in nitric acid, in the nuclear industry and the purification of water. [Pg.447]

Thorium, uranium, and plutonium are used for many things, from medicine to atomic bombs. When these elements break apart, they release large amounts of energy. Chemists and physicists are learning to control this atomic energy and make it do useful work. [Pg.44]

Unlike other primary energy sources, the global consumption of uranium exceeds its production. Worldwide consumption in 2005 amounted to 66 500 tU (NEA/ IAEA, 2006b).9 As Fig. 4.3 shows, newly mined and processed uranium (primary supply) exceeded reactor-related uranium requirements until 1991. Since 1991, the gap between primary supply and uranium demand has been filled by secondary supply, i.e., material that has been held in inventory (both civilian and military in origin) or has been reprocessed. Besides reprocessed uranium and plutonium of spent... [Pg.124]


See other pages where Uranium and plutonium is mentioned: [Pg.183]    [Pg.425]    [Pg.80]    [Pg.80]    [Pg.179]    [Pg.201]    [Pg.202]    [Pg.202]    [Pg.205]    [Pg.222]    [Pg.241]    [Pg.177]    [Pg.1097]    [Pg.770]    [Pg.818]    [Pg.871]    [Pg.1097]    [Pg.419]    [Pg.354]    [Pg.242]    [Pg.529]    [Pg.530]    [Pg.20]    [Pg.1651]    [Pg.225]    [Pg.218]    [Pg.121]    [Pg.125]   


SEARCH



A few comments about uranium and plutonium elemental structures

Further Processing of Uranium and Plutonium Solutions

Natural Thorium, Uranium, and Plutonium

Plutonium and Uranium Recovery

Procedure 6. Separation of Plutonium from Uranium and Fission Products in Irradiated Reactor Targets

URANIUM, NEPTUNIUM, PLUTONIUM AND AMERICIUM

Uranium , and

Uranium plutonium

© 2024 chempedia.info