Ultraviolet ionization

Microscopy Visible light, ultraviolet, ionizing radiationa All Delly (1988) Pluta (1989)... 

Finally, another indirect detection method for SRS involves ultraviolet ionization. The vibrationally-excited molecules are selectively ionized by a UV laser beam, and a Raman spectrum obtained by detecting the variation in the ionization signal while scanning one of the Raman lasers. Using this method, Esherick and Owyoung [38] claim to have achieved an increase in sensitivity over conventional SRS detection of three orders of magnitude without any loss of resolution ... 

Environmental hazards. According to process applications, environmental conditions may present hazards including dust vapours and fumes X-ray, laser, ultraviolet, ionizing and non-ionizing radiation and flammable and explosive atmospheres. 

Shu, J., D.S. Peterka, S.R. Leone, and M. Ahmed (2004), Tunable synchrotron vacuum ultraviolet ionization, time-of-flight investigation of the photodissociation of fran -crotonaldedhyde at 193 nm, J. Phys. Chem. A, 108, 7895-7902. 

Three-photon absorption has also been observed by multiphoton ionization, giving Rydberg states of atoms or molecules [36]. Such states usually require vacuum ultraviolet teclmiques for one-photon spectra, but can be done with a visible or near-ultraviolet laser by tluee-photon absorption. 

Ultraviolet photoelectron spectroscopy allows the determination of ionization potentials. For thiazole the first experimental measurement using this technique was preformed by Salmona et al. (189) who later studied various alkyl and functional derivatives in the 2-position (190,191). Substitution of an hydrogen atom by an alkyl group destabilizes the first ionization potential, the perturbation being constant for tso-propyl and heavier substituents. Introduction in the 2-position of an amino group strongly destabilizes the first band and only slightly the second. 

The so-called peak power delivered by a pulsed laser is often far greater than that for a continuous one. Whereas many substances absorb radiation in the ultraviolet and infrared regions of the electromagnetic spectrum, relatively few substances are colored. Therefore, a laser that emits only visible light will not be as generally useful as one that emits in the ultraviolet or infrared ends of the spectrum. Further, witli a visible-band laser, colored substances absorb more or less energy depending on the color. Thus two identical polymer samples, one dyed red and one blue, would desorb and ionize with very different efficiencies. 

Many kinds of detectors have been designed, ranging from the widely used, cheap but robust flame ionization (GC) or ultraviolet absorption type (LC) to the much more exciting and informative, if much more expensive, mass spectrometer. 

A monochromator is useful not only for removing unwanted lines from the X-ray source but also for narrowing the otherwise broad lines. For example, each of the MgXa and AlXa doublets is unresolved and about 1 cY wide at half-intensity. A monochromator can reduce this to about 0.2 cY This reduction of the line width is very important because in an XPS specttum, unlike an ultraviolet photoelectron specttum, the resolution is limited by the line width of the ionizing radiation. Unfortunately, even after line narrowing to 0.2 cY... 

The He I ultraviolet photoelectron spectra of Kr and Xe appear similar to that of Ar but the ionization energy decreases and the spin-orbit coupling increases with increasing atomic number, as illustrated by the data in Table 8.1. 

Instead of using a laser operating in the vacuum-ultraviolet region a laser operating at half the energy may be used. Then the ionization process in Figure 9.50(b) involves the... 

Addition to Olefins. OrganohydrosHanes can also be prepared by addition of halosHanes and organosilanes containing multiple Si—H bonds to olefins. These reactions are catalyzed by platinum, platinum salts, peroxides, ultraviolet light, or ionizing radiation. 

Analytical Techniques. Sorbic acid and potassium sorbate are assayed titrimetricaHy (51). The quantitative analysis of sorbic acid in food or beverages, which may require solvent extraction or steam distillation (52,53), employs various techniques. The two classical methods are both spectrophotometric (54—56). In the ultraviolet method, the prepared sample is acidified and the sorbic acid is measured at 250 260 nm. In the colorimetric method, the sorbic acid in the prepared sample is oxidized and then reacts with thiobarbituric acid the complex is measured at - 530 nm. Chromatographic techniques are also used for the analysis of sorbic acid. High pressure Hquid chromatography with ultraviolet detection is used to separate and quantify sorbic acid from other ultraviolet-absorbing species (57—59). Sorbic acid in food extracts is deterrnined by gas chromatography with flame ionization detection (60—62). 

Physical Chemical Characterization. Thiamine, its derivatives, and its degradation products have been fully characterized by spectroscopic methods (9,10). The ultraviolet spectmm of thiamine shows pH-dependent maxima (11). H, and nuclear magnetic resonance spectra show protonation occurs at the 1-nitrogen, and not the 4-amino position (12—14). The H spectmm in D2O shows no resonance for the thiazole 2-hydrogen, as this is acidic and readily exchanged via formation of the thiazole yUd (13) an important intermediate in the biochemical functions of thiamine. Recent work has revised the piC values for the two ionization reactions to 4.8 and 18 respectively (9,10,15). The mass spectmm of thiamine hydrochloride shows no molecular ion under standard electron impact ionization conditions, but fast atom bombardment and chemical ionization allow observation of both an intense peak for the patent cation and its major fragmentation ion, the pyrimidinylmethyl cation (16). 

In Laser Ionization Mass Spectrometry (LIMS, also LAMMA, LAMMS, and LIMA), a vacuum-compatible solid sample is irradiated with short pulses ("10 ns) of ultraviolet laser light. The laser pulse vaporizes a microvolume of material, and a fraction of the vaporized species are ionized and accelerated into a time-of-flight mass spectrometer which measures the signal intensity of the mass-separated ions. The instrument acquires a complete mass spectrum, typically covering the range 0— 250 atomic mass units (amu), with each laser pulse. A survey analysis of the material is performed in this way. The relative intensities of the signals can be converted to concentrations with the use of appropriate standards, and quantitative or semi-quantitative analyses are possible with the use of such standards. 

In Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES), a gaseous, solid (as fine particles), or liquid (as an aerosol) sample is directed into the center of a gaseous plasma. The sample is vaporized, atomized, and partially ionized in the plasma. Atoms and ions are excited and emit light at characteristic wavelengths in the ultraviolet or visible region of the spectrum. The emission line intensities are proportional to the concentration of each element in the sample. A grating spectrometer is used for either simultaneous or sequential multielement analysis. The concentration of each element is determined from measured intensities via calibration with standards. 

The basic function of lysis processes is to split molecules to permit further treatment. Hydrolysis is a chemical reaction in which water reacts with another substance. In the reaction, the water molecule is ionized while the other compound is split into ionic groups. Photolysis, another lysis process, breaks chemical bonds by irradiating a chemical with ultraviolet light. Catalysis uses a catalyst to achieve bond cleavage. 

---