Two-step catalytic cycle

Mechanism of epoxidation The oxygen transfer occurs by a two-step catalytic cycle (Scheme 1.14). In the first step oxygen is transferred to the Mn(III) by an oxidant. The oxygen coordinates to the metal. In the second step the activated oxygen is delivered to the alkene. 

The following two-step catalytic cycle for dimerization of IB is proposed. 

In the olefin epoxidation, the mechanistic scheme commonly proposed for the oxygen-transfer reaction consists of a two-step catalytic cycle (Pig. 21) 123). In the first step, an oxygen atom is transferred from the primary oxidant to the Mn -salen catalyst, which in the second step carries the activated oxygen to the olefinic double bond. The main problem in Mn-salen catalyzed epoxidation with H2O2 was the formation of HO radicals by the homolytic cleavage of the weak 0-0 bond, leading to indiscriminate oxidation 124). Addition of Lewis bases, such as imidazole, pyridine, or... 

The approach taken here is drawn heavily on that of Boudart [2,3,10,11], which is based on the work of Temkin [12 14]. It begins by assuming the reaction can be expressed as a two-step catalytic cycle on a uniform surface of the form... 

A recent study has, however, unraveled a most intricate four-step catalytic cycle involving a bimetallic cyclic carbozirconation (Scheme 1.60) [150]. The stoichiometric conversion of EtZrCp2Cl and Et3Al into the five-membered bimetallic complex and its subsequent stoichiometric reaction with an alkyne to give an aluminacydopentene and EtZrCp2Cl were the two key experimental findings. 

Another variant of the explanation is the list of substances and the reaction mechanism is incomplete and so slow relaxations are explained by the slow steps that have not been taken into account. It must be emphasized that slow transition processes can also be caused by slow steps, in those cases in which the steady state rate of a catalytic reaction is high. This can be exemplified by two linear catalytic cycles connected by a slow step... 

Palladium catalysts with simple monodentate phosphine ligands (e.g. PPh3) can catalyze the methoxycarbonylation of ethylene. However, the Lucite process employs a bulky diphosphine, 1,2-( Bu2PCH2)2CgH4, and is highly active and selective under quite mild conditions (10 bar/80°C). Two alternative catalytic cycles are possible, based either upon a palladium hydride or a palladium methoxide complex (Figure 9), and mechanistic and spectroscopic studies indicate that the hydride cycle is dominant. The alkene and CO insertion steps are the same as those in the Pd-catalyzed co-polymerisation of CO and alkenes to polyketones (Section 4.4). 

The Stille-Kelly coupling consists of two connected catalytic cycles and the following steps 1) the oxidative addition of the Pd ° complex into one of the C-X bond of the aryl halide 2) transmetallatlon with the distannane followed by reductive elimination to afford the organostannane 3) oxidative addition of the Pd ° complex into the C-X bond of the organostannane 4) intramolecular transmetallatlon, and 5) reductive elimination to give the coupled product. 

Several non-noble metal-catalyzed iV-alkylation reactions have also been reported in recent years. In 2010, Ramon, Yus and co-workers reported Cu(OAc)2-catalyzed A-alkylation of poor nucleophilic amine derivatives and alcohols (Eq. 30) [125]. Control experiments indicated that a base was indispensable in the reaction to force the alcohol dehydrogenation step, which was later confirmed by DFT calculations reported by Liu, Huang and co-workers [63]. In 2011, Ramon and co-workers reported the results of their own mechanistic studies and proposed two possible catalytic cycles [126]. The main aldehyde-free cycle, depicted with plain arrows, requires the presence of a base. The minor cycle, depicted in dashed arrows, may proceed when an aldehyde exists in the reaction media (Scheme 23). In the same year, Li and co-workers also disclosed a CuCl-catalyzed A-alkylation of heteroarylamines [127]. 

In Grignard reactions, Mg(0) metal reacts with organic halides of. sp carbons (alkyl halides) more easily than halides of sp carbons (aryl and alkenyl halides). On the other hand. Pd(0) complexes react more easily with halides of carbons. In other words, alkenyl and aryl halides undergo facile oxidative additions to Pd(0) to form complexes 1 which have a Pd—C tr-bond as an initial step. Then mainly two transformations of these intermediate complexes are possible insertion and transmetallation. Unsaturated compounds such as alkenes. conjugated dienes, alkynes, and CO insert into the Pd—C bond. The final step of the reactions is reductive elimination or elimination of /J-hydro-gen. At the same time, the Pd(0) catalytic species is regenerated to start a new catalytic cycle. The transmetallation takes place with organometallic compounds of Li, Mg, Zn, B, Al, Sn, Si, Hg, etc., and the reaction terminates by reductive elimination. 

A plausible mechanism accounting for the catalytic role of nickel(n) chloride has been advanced (see Scheme 4).10 The process may be initiated by reduction of nickel(n) chloride to nickel(o) by two equivalents of chromium(n) chloride, followed by oxidative addition of the vinyl iodide (or related substrate) to give a vinyl nickel(n) reagent. The latter species may then undergo transmetala-tion with a chromium(m) salt leading to a vinyl chromium(m) reagent which then reacts with the aldehyde. The nickel(n) produced in the oxidative addition step reenters the catalytic cycle. 

The catalytic cycle of the Na+/K+-ATPase can be described by juxtaposition of distinct reaction sequences that are associated with two different conformational states termed Ei and E2 [1]. In the first step, the Ei conformation is that the enzyme binds Na+ and ATP with very high affinity (KD values of 0.19-0.26 mM and 0.1-0.2 pM, respectively) (Fig. 1A, Step 1). After autophosphorylation by ATP at the aspartic acid within the sequence DKTGS/T the enzyme occludes the 3 Na+ ions (Ei-P(3Na+) Fig. la, Step 2) and releases them into the extracellular space after attaining the E2-P 3Na+ conformation characterized by low affinity for Na+ (Kq5 = 14 mM) (Fig. la, Step 3). The following E2-P conformation binds 2 K+ ions with high affinity (KD approx. 0.1 mM Fig. la, Step 4). The binding of K+ to the enzyme induces a spontaneous dephosphorylation of the E2-P conformation and leads to the occlusion of 2 K+ ions (E2(2K+) Fig. la, Step 5). Intracellular ATP increases the extent of the release of K+ from the E2(2K+) conformation (Fig. la, Step 6) and thereby also the return of the E2(2K+) conformation to the EiATPNa conformation. The affinity ofthe E2(2K+) conformation for ATP, with a K0.5 value of 0.45 mM, is very low. 

As stated above, olefin metathesis is in principle reversible, because all steps of the catalytic cycle are reversible. In preparatively useful transformations, the equilibrium is shifted to one side. This is most commonly achieved by removal of a volatile alkene, mostly ethene, from the reaction mixture. An obvious and well-established way to classify olefin metathesis reactions is depicted in Scheme 2. Depending on the structure of the olefin, metathesis may occur either inter- or intramolecularly. Intermolecular metathesis of two alkenes is called cross metathesis (CM) (if the two alkenes are identical, as in the case of the Phillips triolefin process, the term self metathesis is sometimes used). The intermolecular metathesis of an a,co-diene leads to polymeric structures and ethene this mode of metathesis is called acyclic diene metathesis (ADMET). Intramolecular metathesis of these substrates gives cycloalkenes and ethene (ring-closing metathesis, RCM) the reverse reaction is the cleavage of a cyclo-... 

The possible mechanism for the reactions involving stoichiometric amount of preformed Ni(0) complexes is shown in Fig. 9.8. The first step of the mechanism involves the oxidative addition of aryl halides to Ni(0) to form aryl Ni(II) halides. Disproportion of two aryl Ni(II) species leads to a diaryl Ni(II) species and a Ni(II) halide. This diaryl Ni(II) species undergoes rapid reductive elimination to form the biaryl product. The generated Ni(0) species can reenter the catalytic cycle. 

Catalytic Cycles. In the unpolluted troposphere, the two step sequence Rl, R2 was early recognized as the dominant source of HO (20,91,92) and HO as the dominant reactant for CO removal (93,94). 

The initially formed tetra-alkylferrate(II) represents the reactive intermediate in both reactions that undergoes a carboferration of the triple bond in eq. 2, Scheme 29. Transmetallation from Fe to Mg yields a vinyl-magnesium species, which liberates the desired olefin upon hydrolysis within the acidic work-up procedure. In the above two reactions, a competing p-hydride elimination from the ferrate yields the unreactive Fe-H species and hence is considered to be the deactivation step in the catalytic cycle. 

As explained in Chapter 1, catalytic reactions occur when the reacting species are associated with the catalyst. In heterogeneous catalysis this happens at a surface, in homogeneous catalysis in a complex formed with the catalyst molecule. In terms of kinetics, the catalyst must be included as a participating species that leaves the reaction unaltered, as indicated schematically in Fig. 2.7, which shows the simplest conceivable catalytic cycle. We will investigate the kinetics of this simple two-step mech-... 

An unusual enhancement of catalytic activity in a two-phase system has been reported by Fremy et al. (1998) for the hydroformylation of acrylic esters using Rh complex of TPTS as catalyst. Even though acrylic esters have reasonable solubility in water, rate enhancements in two-phase systems by a factor of 2 to 14 have been reported. It seems that water is not an inert solvent but also acts as a reactant or a co-ordinating solvent which can modify elementary steps of the catalytic cycle (Cornilis, 1997). 

The half-wave potentials of (FTF4)Co2-mediated O2 reduction at pH 0-3 shifts by — 60 mV/pH [Durand et ah, 1983], which indicates that the turnover-determining part of the catalytic cycle contains a reversible electron transfer (ET) and a protonation, or two reversible ETs and two protonation steps. In contrast, if an irreversible ET step were present, the pH gradient would be 60/( + a) mV/pH, where n is the number of electrons transferred in redox equilibria prior to the irreversible ET and a is the transfer coefficient of the irreversible ET. The —60 mV/pH slope is identical to that manifested by simple Ee porphyrins (see Section 18.4.1). The turnover rate of ORR catalysis by (ETE4)Co2 was reported to be proportional to the bulk O2 concentration [Collman et ah, 1994], suggesting that the catalyst is not saturated with O2. 

The alternative mechanism (Fig. 18.16, mechanism B) is based on the fully reduced [(dipor)Co2] state as the redox-active form of the catalyst. The redox equilibrium between the mixed-valence and fully reduced forms is shifted toward the catalytically inactive mixed-valence state, and hence controls the amount of catalytically active species in the catalytic cycle and contributes to the — 60 mV/pH dependence. The fully reduced form is known to bind O2 (probably reversibly) in organic solvents [LeMest et al., 1997 Fukuzumi et al., 2004], and the resulting diamagnetic adducts are typically viewed as a pair of Co ions bridged by a peroxide, which are of course quite common in the O2 chemistry of nonporphyrin Co complexes. To obtain the —60 mV/pH dependence of the catalytic turnover rate, a protonation step is required either prior to the TDS or as the TDS. Mechanism B cannot be extended to monometallic cofacial porphyrins or heterometallic porphyrins with a redox-inert ion, but there is no reason to assume that the two classes of cofacial porphyrin catalysts, with rather different catalytic performance (Fig. 18.15), must follow the same mechanism. 

---