Trimethylsilyl enolate

Two techniques have been described for producing trimethylsilyl enol ethers from aldehydes or ketones (10) reaction of (CH2)2SiCl and (C2H3)2N in DMF and reaction of LiN(C2H3)2, which generates enolate ions in the presence of... 

Me3SiI, CH2CI2, 25°, 15 min, 85-95% yield.Under these cleavage conditions i,3-dithiolanes, alkyl and trimethylsilyl enol ethers, and enol acetates are stable. 1,3-Dioxolanes give complex mixtures. Alcohols, epoxides, trityl, r-butyl, and benzyl ethers and esters are reactive. Most other ethers and esters, amines, amides, ketones, olefins, acetylenes, and halides are expected to be stable. 

Trimethylsilyl enol ethers can be used to protect ketones, but in general are not used for this purpose because they are reactive under both acidic and basic conditions. More highly hindered silyl enol ethers are much less susceptible to acid and base. A less hindered silyl enol can be hydrolyzed in the presence of a more hindered one. ... 

Me3SiCH2C02Et, cat. Bu4N F, 25°, 1-3 h, 90% yield. This reagent combination allows the isolation of pure products under nonaqueous conditions. The reagent also converts aldehydes and ketones to trimethylsilyl enol ethers.The analogous methyl trimethylsilylacetate has also been used. " ... 

Methoxyethoxymethyl, 365 Enamino Derivatives, 365 4-Methyl-1,3-dioxolanyl Enol Acetate, 365 Pyrrolidinyl Enamine, 365 Benzyl Enol Ether, 366 Butylthio Enol Ether, 366 Protection of Tetronic Acids, 366 Trimethylsilyl Enol Ether, 367... 

By using the directed aldol reaction, unsymmetrical ketones can be made to react regioselectively. After conversion into an appropriate enol derivative (e.g. trimethylsilyl enol ether 8) the ketone reacts at the desired a-carbon. 

For example in the so-called Mukaiyama aldol reaction of an aldehyde R -CHO and a trimethylsilyl enol ether 8, which is catalyzed by Lewis acids, the required asymmetric environment in the carbon-carbon bond forming step can be created by employing an asymmetric Lewis acid L in catalytic amounts. 

The synthetic problem is now reduced to cyclopentanone 16. This substance possesses two stereocenters, one of which is quaternary, and its constitution permits a productive retrosynthetic maneuver. Retrosynthetic disassembly of 16 by cleavage of the indicated bond furnishes compounds 17 and 18 as potential precursors. In the synthetic direction, a diastereoselective alkylation of the thermodynamic (more substituted) enolate derived from 18 with alkyl iodide 17 could afford intermediate 16. While trimethylsilyl enol ether 18 could arise through silylation of the enolate oxygen produced by a Michael addition of a divinyl cuprate reagent to 2-methylcyclopentenone (19), iodide 17 can be traced to the simple and readily available building blocks 7 and 20. The application of this basic plan to a synthesis of racemic estrone [( >1] is described below. 

An important stage in the synthesis has been reached. It was anticipated that cleavage of the trimethylsilyl enol ether in 18 using the procedure of Binkley and Heathcock18 would regiospecifically furnish the thermodynamic (more substituted) cyclopentanone enolate, a nucleophilic species that could then be alkylated with iodo-diyne 17. To secure what is to become the trans CD ring junction of the steroid nucleus, the diastereoisomer in which the vinyl and methyl substituents have a cis relationship must be formed. In the... 

Aldol reaction of the a-trimethylsilylated enolate 9 with aldehydes provides nearly equal amounts of chromatographically separable ( )- and (Z)-isomers of iron-acyl complexes 11 via silyloxide elimination from the intermedate aldolate 10 (Table 3). This methodology has been the most commonly employed entry to the (Z)-isomer series. 

The diastereoselectivity of the zinc iodide catalyzed reaction of the azetidinone I with the trimethylsilyl enolate derivatives of the chiral 3-(l-oxopropyI)oxazolidinones 6 was considerably lower (about 60 40), although independent generation of the zinc enolate, via exchange of the lithium enolate with zinc bromide, afforded the /9-Iactam carboximide derivatives in a ratio (RIS) 80 20177. 

Enantioselective deprotonation of prochiral 4-alkylcyclohexanones using certain lithium amide bases derived from chiral amines such as (1) has been shown (73) to generate chiral lithium enolates, which can be trapped and used further as the corresponding trimethylsilyl enol ethers trapping was achieved using Corey s internal quench described above. 

A solution of the trimethylsilyl enol ether of propionyl trimethylsilane (5 mmol) (Chapter 12) and benzaldehyde diethyl acetal (5 mmol) in dichloromethane (10ml) was added to a solution of BF3.OEt2 (5 mmol) in dichloromethane (5ml), cooled to —78 C. After being stirred for lh at -78°C and 2h at -30°C, the mixture was quenched with excess saturated sodium hydrogen carbonate solution, and extracted with ether. Concentration and distillation gave the product -ethoxy acylsilane, (4.6mmol, 95%). b.p. 105-106 C/2mmHg. Treatment of this alkoxy... 

Trimethylsilyl enol ethers, 94,133 Trimethylsilyl ketene acetals, 112-113 3-Trimethylsilyl -lactam, 71 Trimethylsilyl lithium, 51-2... 

Trimethylsilyl trimethylsilyl enol ethers, 15 Trimethylsilyl (45,)-N-ftrimethylsilyl)-... 

The few exceptions to this general rule arise when the a-carbon carries a substituent that can stabilize carbonium-ion development well, such as oxygen or sulphur. For example, 1-trimethylsilyl trimethylsilyl enol ethers give products (72) derived from electrophilic attack at the /J-carbon, and the vinylsilane (1) reacts with a/3-unsaturated acid chlorides in a Nazarov cyclization (13) to give cyclopentenones such as (2) the isomeric vinylsilane (3), in which the directing effects are additive, gives the cyclopentenone (4) ... 

The addition of sulphinyl chlorides to trimethylsilyl enol ether 138 affording a-ketosulphoxides 139 (equation 76) represents an extension of the reaction of sulphinyl chlorides with ketones. This reaction has attracted attention only recently. Sergeev and coworkers192 reported that treatment of sulphinyl chlorides with acyclic enol ethers afforded a-ketosulphoxides 139 in good to excellent yields. Meanwell and Johnson193 observed that in the case of cyclic enol ethers the corresponding sulphoxides were formed only in very low yields. They found, however, that the introduction of an equivalent amount of a Lewis acid into the reaction mixture markedly promotes the desired reaction, whereas the use of catalytic amounts of a Lewis acid led to a substantial reduction in the yield. This is most probably due to the formation of a complex, between the a-ketosulphoxide and the Lewis acid. 

This procedure illustrates a new three-step reaction sequence for the one-carbon ring expansion of cyclic ketones to the homologous tt,/3-unsaturated ketones. The key step in the sequence is the iron(III) chloride-induced cleavage of the central bond of trimethyl-silyloxycyclopropanes which me obtained by cyclopropanation of trimethylsilyl enol ethers. The procedure for the preparation of 1-trimethylsilyloxycyclohexene from cyclohexanone described in Part A is that of House, Czuba, Gall, and Olmstead. ... 

The cyclopropanation of 1-trimethylsilyloxycyclohexene in the present procedure is accomplished by reaction with diiodomethane and diethylzinc in ethyl ether." This modification of the usual Simmons-Smith reaction in which diiodomethane and activated zinc are used has the advantage of being homogeneous and is often more effective for the cyclopropanation of olefins such as enol ethers which polymerize readily. However, in the case of trimethylsilyl enol ethers, the heterogeneous procedures with either zinc-copper couple or zinc-silver couple are also successful. Attempts by the checkers to carry out Part B in benzene or toluene at reflux instead of ethyl ether afforded the trimethylsilyl ether of 2-methylenecyclohexanol, evidently owing to zinc iodide-catalyzed isomerization of the initially formed cyclopropyl ether. The preparation of l-trimethylsilyloxybicyclo[4.1.0]heptane by cyclopropanation with diethylzinc and chloroiodomethane in the presence of oxygen has been reported. "... 

Because the trimethylsilyl enol ether of cyclohexanone 107 a is considerably more bulky than the corresponding dimethylsilyl enolate 107b, only the latter reacts with the N-tosyhmine 108 in the presence of catalytic amounts of diisopropylamine in DMF/H2O at 78°C or at room temperature to give the Mannich type compounds 109 in high yields [39] (Scheme 3.4). 

Trimethylsilyl enol ethers can also be cleaved by tetraalkylammonium fluoride (Entry 2) The driving force for this reaction is the formation of the very strong Si-F bond, which has a bond energy of 142 kcal/mol.31 These conditions, too, lead to enolate equilibration. 

The composition of the enol ethers trimethylsilyl prepared from an enolate mixture reflects the enolate composition. If the enolate formation can be done with high regio-selection, the corresponding trimethylsilyl enol ether can be obtained in high purity. If not, the silyl enol ether mixture must be separated. Trimethylsilyl enol ethers can be prepared directly from ketones. One procedure involves reaction with trimethylsilyl... 

Trimethylsilyl enol ethers can also be prepared by 1,4-reduction of enones using silanes as reductants. Several effective catalysts have been found,38 of which the most versatile appears to be a Pt complex of divinyltetramethyldisiloxane.39 This catalyst gives good yields of substituted silyl enol ethers (e.g., Scheme 1.2, Entry 7). 

Titanium enolates can also be used under conditions in which the titanium exists as an ate species. Crossed aldehyde-aldehyde additions have been accomplished starting with trimethylsilyl enol ethers, which are converted to lithium enolates and then to ate species by addition of Ti(0- -Bu)4.26 These conditions show only modest stereoselectivity. 

Conditions for effecting conjugate addition of neutral enolate equivalents such as silyl enol ethers in the presence of Lewis acids have been developed and are called Mukaiyama-Michael reactions. Trimethylsilyl enol ethers can be caused to react with electrophilic alkenes by use of TiCl4. These reactions proceed rapidly even at -78° C.308... 

Danishefsky s diene).46 The two donor substituents provide strong regiochemical control. The D-A adducts are trimethylsilyl enol ethers that can be readily hydrolyzed to ketones. The (3-methoxy group is often eliminated during hydrolysis, resulting in formation of cyclohexenones. 

A similar procedure starting with trimethylsilyl esters generates trimethylsilyl enol... 

---