Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Bases lithium amide

The formation of the above anions ("enolate type) depend on equilibria between the carbon compounds, the base, and the solvent. To ensure a substantial concentration of the anionic synthons in solution the pA" of both the conjugated acid of the base and of the solvent must be higher than the pAT -value of the carbon compound. Alkali hydroxides in water (p/T, 16), alkoxides in the corresponding alcohols (pAT, 20), sodium amide in liquid ammonia (pATj 35), dimsyl sodium in dimethyl sulfoxide (pAT, = 35), sodium hydride, lithium amides, or lithium alkyls in ether or hydrocarbon solvents (pAT, > 40) are common combinations used in synthesis. Sometimes the bases (e.g. methoxides, amides, lithium alkyls) react as nucleophiles, in other words they do not abstract a proton, but their anion undergoes addition and substitution reactions with the carbon compound. If such is the case, sterically hindered bases are employed. A few examples are given below (H.O. House, 1972 I. Kuwajima, 1976). [Pg.10]

In some cases, especially in the presence of strongly electron attracting substituents, isomerization to acid amides has been observed, probably preceded by deprotonation at ring carbon. Even (56), known for its stability towards common alkali, undergoes this rearrangement when a lithium amide is used as the base (80JOC1489). [Pg.208]

Alkyltrifluorosilanes and disubstituted difluorosilanes are themselves quite reactive with nucleophiles such as lithium amide bases [102, 103 104], alkyl-lithium reagents [1051, Gngnard reagents [105], or alkoxides [105] (equations 82 and 83)... [Pg.601]

Aromatic enamines were prepared by dehydroha logenation of /3-bromo-amines with strong base. While trans enamines were thus formed, one obtained mostly cis enamines from rearrangement of the corresponding allylic amines under similar reaction conditions (646). Vicinal endiamines were obtained from S-dichloroamines and lithium amides (647). [Pg.339]

Use of LTMP as base [52] in situ with Me3SiCl allows straightforward access to a variety of synthetically useful a, 3-epoxysilanes 232 at near ambient temperature directly from (enantiopure) terminal epoxides 231 (Scheme 5.55) [81]. This reaction relies on the fact that the hindered lithium amide LTMP is compatible with Me3SiCl under the reaction conditions and that the electrophile trapping of the nonstabilized lithiated epoxide intermediate must be very rapid, since the latter are usually thermally very labile. [Pg.172]

The aldol reaction of 2,2-dimethyl-3-pentanone, which is mediated by chiral lithium amide bases, is another route for the formation of nonracemic aldols. Indeed, (lS,2S)-l-hydroxy-2,4,4-trimethyl-l-phenyl-3-pentanone (21) is obtained in 68% ee, if the chiral lithiated amide (/ )-A-isopropyl-n-lithio-2-methoxy-l-phenylethanamine is used in order to chelate the (Z)-lithium cnolate, and which thus promotes the addition to benzaldehyde in an enantioselective manner. No anti-adduct is formed25. [Pg.583]

Unless a proton donor is added, the lithium-ammonia reduction of an cnone leads to the lithium enolate and lithium amide. The latter is a sufficiently strong base to rapidly convert the mono-alkylated ketone into its enolate, which can be further alkylated. The function of the... [Pg.56]

Enantioselective deprotonation of prochiral 4-alkylcyclohexanones using certain lithium amide bases derived from chiral amines such as (1) has been shown (73) to generate chiral lithium enolates, which can be trapped and used further as the corresponding trimethylsilyl enol ethers trapping was achieved using Corey s internal quench described above. [Pg.62]

By analogy, the acetylene aldehyde 500 gives, on addition of the chiral Li-enolate 501 [79-82], the chiral //-lactams 502 and 503 in 75% yield [80-82]. Similar (fhc-tam-forming reactions are discussed elsewhere [70, 83-88]. The ketone 504 affords, with the lithium salt of the silylated lithium amide 505, the Schiff base 506, in 74% yield (Scheme 5.27). The Schiff base 506 is also obtained in 25% yield by heating ketone 504 with (C6H5)3P=N-C6H4Me 507 in boiling toluene for 7 days... [Pg.97]

It is also possible to achieve enantioselective enolate formation by using chiral bases. Enantioselective deprotonation requires discrimination between two enantiotopic hydrogens, such as in d.v-2,6-dimethylcyclohexanone or 4-(/-butyl)cyclohcxanonc. Among the bases that have been studied are chiral lithium amides such as A to D.22... [Pg.13]

Imines can be deprotonated at the a-carbon by strong bases to give the nitrogen analogs of enolates. Originally, Grignard reagents were used for deprotonation but lithium amides are now usually employed. These anions, referred to as imine anions... [Pg.48]

Before the emergence in the mid-1980s of the asymmetric deprotonation of cA-dimethyl cyclohexanone using enantiomerically pure lithium amide bases, few reports pertaining to the chemistry of these chiral reagents appeared. Although it is not the focus of this chapter, the optically active metal amide bases are still considered to be useful tools in organic synthesis. Readers are advised to consult the appropriate literature on the application of enantiomerically pure lithium amides in asymmetric synthesis.6... [Pg.73]

Detailed investigations indicate that the enolization process (LDA, THF) affords enolates 37 and 38 with at/east 97% (Z)-stereoselection. Related observations have recently been reported on the stereoselective enolization of dialkylthioamides (38). In this latter study, the Ireland-Claisen strategy (34) was employed to assign enolate geometry. Table 10 summarizes the enolization stereo selection that has been observed for both esters and amides with LDA. Complementary kinetic enolization ratios for ketonic substrates are included in Table 7. Recent studies on the role of base structure and solvent are now beginning to appear in the literature (39,40), and the Ireland enolization model for lithium amide bases has been widely accepted, A tabular survey of the influence of the ester moiety (ORj) on a range of aldol condensations via the lithium enolates is provided in Table 11 (eq. [24]). Enolate ratios for some of the condensations illustrated may be found in Table 10. It is apparent from these data that ( )-enolates derived from alkyl propionates (Rj = CH3, t-C4H9) exhibit low aldol stereoselectivity. In contrast, the enolates derived from alkoxyalkyl esters (Rj = CHjOR ) exhibit 10 1 threo diastereo-... [Pg.28]

Thorpe reaction org chem The reaction by which, in presence of lithium amides, a,(rt-dinitriles undergo base-catalyzed condensation to cyclic iminonitriles, which can be hydrolyzed and decarboxylated to cyclic ketones. thorp re,ak-shan TMPC See tetrakis(hydroxymethyl)phosphonium chloride, thulia See thulium oxide. thu-le-a ... [Pg.379]

Irradiation of matrix-isolated imidazole-2-carboxylic acid gave the 2,3-dihydro-imidazol-2-ylidene-C02 complex (31) characterized by IR spectroscopy and calculated to lie 15.9 kcal mol above the starting material. A series of non-aromatic nucleophilic carbenes (32) were prepared by desulfurization of the corresponding thiones by molten potassium in boiling THF. The most hindered of the series (32 R = Bu) is stable indefinitely under exclusion of air and water and can be distilled without decomposition. The less hindered carbenes slowly dimerize to the corresponding alkenes. Stable aminoxy- and aminothiocarbenes (33 X = O, S) were prepared by deprotonation of iminium salts with lithium amide bases. The carbene carbon resonance appears at 260-297 ppm in the NMR spectrum and an X-ray structure determination of an aminooxycarbene indicated that electron donation from the nitrogen is more important than that from oxygen. These carbenes do not dimerize. [Pg.258]

Dioxolanones 100 and 101 were treated with two equivalents of lithium amide bases, whereupon various electrophiles were added in excess (Scheme 23 and Table 1). Unfortunately, addition of two equivalents of LDA... [Pg.210]


See other pages where Bases lithium amide is mentioned: [Pg.1188]    [Pg.589]    [Pg.57]    [Pg.102]    [Pg.1188]    [Pg.589]    [Pg.57]    [Pg.102]    [Pg.76]    [Pg.124]    [Pg.594]    [Pg.594]    [Pg.14]    [Pg.773]    [Pg.151]    [Pg.651]    [Pg.963]    [Pg.57]    [Pg.627]    [Pg.349]    [Pg.1230]    [Pg.54]    [Pg.627]    [Pg.16]    [Pg.35]    [Pg.27]    [Pg.48]    [Pg.48]    [Pg.72]    [Pg.125]    [Pg.238]    [Pg.9]    [Pg.225]    [Pg.14]    [Pg.58]    [Pg.96]    [Pg.113]    [Pg.365]   
See also in sourсe #XX -- [ Pg.578 , Pg.587 , Pg.588 , Pg.589 , Pg.590 , Pg.591 , Pg.620 , Pg.622 , Pg.629 ]




SEARCH



Amide bases

Bases Lithium isopropyl amide

Chiral lithium amide bases

Chiral lithium amide bases 2,3]-Wittig rearrangement

Chiral lithium amide bases enantioselective lithiation

Chiral lithium amides bulk bases

Lithium amide

Lithium amide bases, deprotonation with

Preparation of lithium amide bases

© 2024 chempedia.info