Solvents acid-catalyzed

Because of the mentioned leveling effect of the solvent (or excess acid itself acting as such) the acidity cannot exceed that of its conjugate acid. In the case of water the limiting acidity is that of HsO. Proton-ated water, H30 (hydronium ion), was first postulated in 1907, and its preeminent role in acid-catalyzed reactions in aqueous media was first realized in the acid-base theory of Bronsted and Lowry. Direct experimental evidence for the hydronium ion in solution and in the... 

The most commonly used protected derivatives of aldehydes and ketones are 1,3-dioxolanes and 1,3-oxathiolanes. They are obtained from the carbonyl compounds and 1,2-ethanediol or 2-mercaptoethanol, respectively, in aprotic solvents and in the presence of catalysts, e.g. BF, (L.F. Fieser, 1954 G.E. Wilson, Jr., 1968), and water scavengers, e.g. orthoesters (P. Doyle. 1965). Acid-catalyzed exchange dioxolanation with dioxolanes of low boiling ketones, e.g. acetone, which are distilled during the reaction, can also be applied (H. J. Dauben, Jr., 1954). Selective monoketalization of diketones is often used with good success (C. Mercier, 1973). Even from diketones with two keto groups of very similar reactivity monoketals may be obtained by repeated acid-catalyzed equilibration (W.S. Johnson, 1962 A.G. Hortmann, 1969). Most aldehydes are easily converted into acetals. The ketalization of ketones is more difficult for sterical reasons and often requires long reaction times at elevated temperatures. a, -Unsaturated ketones react more slowly than saturated ketones. 2-Mercaptoethanol is more reactive than 1,2-ethanediol (J. Romo, 1951 C. Djerassi, 1952 G.E. Wilson, Jr., 1968). 

Because they are widely used as solvents many simple dialkyl ethers are commercially available Diethyl ether and dibutyl ether for example are prepared by acid catalyzed condensation of the corresponding alcohols as described earlier m Section 15 7... 

The equation above suggests that one approach would be to use a pore Hquid that has a low surface tension. Indeed, two-step acid—base or acid—acid catalyzed sHica gels have been made, aged in ethanol or water, washed with various aprotic solvents, and finally evaporatively dried at 323 K for 48 hours and then at 383 K for 48 hours (43). The aprotic solvents used and their corresponding surface tension in N/m at room temperature (shown in... 

Direct, acid catalyzed esterification of acryhc acid is the main route for the manufacture of higher alkyl esters. The most important higher alkyl acrylate is 2-ethyIhexyi acrylate prepared from the available 0x0 alcohol 2-ethyl-1-hexanol (see Alcohols, higher aliphatic). The most common catalysts are sulfuric or toluenesulfonic acid and sulfonic acid functional cation-exchange resins. Solvents are used as entraining agents for the removal of water of reaction. The product is washed with base to remove unreacted acryhc acid and catalyst and then purified by distillation. The esters are obtained in 80—90% yield and in exceUent purity. 

DIBK can be produced by the hydrogenation of phorone which, in turn, is produced by the acid-catalyzed aldol condensation of acetone. It is also a by-product in the manufacture of methyl isobutyl ketone. Diisobutyl ketone ( 1.37/kg, October 1994) is produced in the United States by Union Carbide (Institute, West Virginia) and Eastman (Kingsport, Teimessee) (47), and is mainly used as a coating solvent. Catalytic hydrogenation of diisobutyl ketone produces the alcohol 2,6-dimethyl-4-heptanol [108-82-7]. 

Methyl Isopropyl Ketone. Methyl isopropyl ketone [563-80-4] (3-methyl-2-butanone) is a colorless Hquid with a characteristic odor of lower ketones. It can be produced by hydrating isoprene over an acidic catalyst at 200—300°C (150,151) or by acid-catalyzed condensation of methyl ethyl ketone and formaldehyde to 2-methyl-l-buten-3-one, foUowed by hydrogenation to the product (152). Other patented preparations are known (155,156). Methyl isopropyl ketone is used as an intermediate in the production of pharmaceuticals and fragrances (see Perfumes), and as a solvent (157). It is domestically available from Eastman (Longview, Texas) (47). 

DAG is treated with ethanol and hydrochloric acid in the presence of inert solvent, eg, chlorinated solvents, hydrocarbons, ketones, etc. The L-ascorbic acid precipitates from the mixture as it forms, minimising its decomposition (69). Cmde L-ascorbic acid is isolated through filtration and purified by recrystallization from water. The pure L-ascorbic acid is isolated, washed with ethanol, and dried. The mother Hquor from the recrystallization step is treated in the usual manner to recover the L-ascorbic acid and ethanol contained in it. The cmde L-ascorbic acid mother Hquor contains solvents and acetone Hberated in the DAG hydrolysis. The solvents are recovered by fractional distillation and recycled. Many solvent systems have been reported for the acid-catalyzed conversion of DAG to L-ascorbic acid (46). Rearrangement solvent systems are used which contain only the necessary amount of water required to give >80% yields of high purity cmde L-ascorbic acid (70). 

Molecular chlorine is believed to be the active electrophile in uncatalyzed chlorination of aromatic compounds. Simple second-order kinetics are observed in acetic acid. The reaction is much slower in nonpolar solvents such as dichloromethane and carbon tetrachloride. Chlorination in nonpolar solvents is catalyzed by added acid. The catalysis by acids is probably the result of assistance by proton transfer during the cleavage of the Cl-Cl bond. ... 

The advantages of m-chloroperbenzoic acid have already been emphasized it is commercially available, stable and highly selective when methylene dichloride is used as solvent, the m-chlorobenzoic acid precipitates from solution, thereby decreasing the danger of acid-catalyzed side reactions." ... 

The intervention of mesoionic intermediates is suggested by the facile transformation of steroidal dienones, and by a number of acid-catalyzed nonphotolytic reactions which either parallel the photoisomerizations or correlate photoproducts from reactions in protic and aprotic solvents. The isomerization (175) -> (176) -l- (177) has also beeen achieved in the dark by acetic and formic acid catalysis and clearly involves the conjugate acid of the proposed mesoionic intermediate (199) in the dark reaction. Further,... 

The predominant, if not exclusive, formation of 5/7-fused hydroxy ketones was observed in the case of 4-alkylated dienones [(204) (205) (R = CH3) 6 1 from (201) (R = CH3)] ° and of prednisone 21-acetate [(206)-> (207)]. It appears therefore likely that intermediates which represent the conjugate acids of the postulated zwitterionic intermediates in the dienone photoisomerizations [c/. (202), (203)] participate both in the acid-catalyzed transformations of (200) and in the dienone photochemistry in protic solvents. 

A monoacetate can be isolated by continuous extraction with organic solvents such as cyclohexane/CCI4. Monoacylation can also be achieved by ion exchange resin or acid-catalyzed transesterification. 

The 0X0 group, will tend to activate nucleophihc substitution when its oxygen atom is protonated (e.g., 201 when Z is H) in acid-catalyzed reactions 223b,298 qj. hydrogen bonding to the solvent. Acceleration... 

The reaction conditions for the ene reaction of simple starting materials are, for example, 220 °C for 20 h in an aromatic solvent like trichlorobenzene. Lewis acid-catalyzed intramolecular reactions have been described, e.g. with FeCls in dichloromethane at -78 °C." Yields strongly depend on substrate structure. 

The Prins reaction often yields stereospecifically the and-addition product this observation is not rationalized by the above mechanism. Investigations of the sulfuric acid-catalyzed reaction of cyclohexene 8 with formaldehyde in acetic acid as solvent suggest that the carbenium ion species 7 is stabilized by a neighboring-group effect as shown in 9. The further reaction then proceeds from the face opposite to the coordinating OH-group " ... 

Ethanol for nonbeverage use is obtained by acid-catalyzed hydration of ethylene. Approximately 110 million gallons of ethanol a year is produced in the United States for use as a solvent or as a chemical intermediate in other industrial reactions. 

Because of the usefulness of the reaction, a number of ways have been devised for carrying out dehydrations. One method that works particularly well for tertiary alcohols is the acid-catalyzed reaction discussed in Section 7.1. For example, treatment of 1-methylcyclohexanol with warm aqueous sulfuric acid in a solvent such as tetrahydrofuran results in loss of water and formation of 1-methylcydohexene. 

Esters can also be synthesized by an acid-catalyzed nucleophilic acyl substitution reaction of a carboxylic acid with an alcohol, a process called the Fischer esterification reaction. Unfortunately, the need to use an excess of a liquid alcohol as solvent effectively limits the method to the synthesis of methyl, ethyl, propyl, and butyl esters. 

Acid-catalyzed aminomethylations of 5W-dibenz[/>,/]azepine (5) in ethanolic solution with formaldehyde and a secondary amine yield the 2-(aminoalkyl) derivatives, e.g. 6.186 If acetic acid is used as the solvent, however, then 2,8-bis(aminoaIkylatiou), e.g. formation of 7, results. 

---