Solvent, solvents toluene

The water and sediment contents of crude oils is measured according to the standard methods NF M 07-020, ASTM D 96 and D 1796, which determine the volume of water and sediments separated from the crude by centrifuging in the presence of a solvent (toluene) and of a demulsifylng agent Table 8.13 gives the bottom sediment and water content of a few crude oils. 

Sodamide may be readily pulverised by grinding in a glass mortar under an inert hydrocarbon solvent (benzene, toluene, xylene, etc.). 

Use as Solvent. Toluene is more important as a solvent than either benzene or xylene. Solvent use accounts for ca 14% of the total U.S. toluene demand for chemicals. About two-thirds of the solvent use is in paints and coatings the remainder is in adhesives, inks, pharmaceuticals, and other formulated products utilizing a solvent carrier. Use of toluene as solvent in surface coatings has been declining, primarily because of various environmental and health regulations. It is being replaced by other solvents, such as esters and ketones, and by changing the product formulation to use either fully soHd systems or water-based emulsion systems. 

The main advantages of the Cosorb process over the older copper ammonium salt process are low corrosion rate, abiHty to work in carbon dioxide atmospheres, and low energy consumption. The active CuAlCl C H CH complex is considerably more stable than the cuprous ammonium salt, and solvent toluene losses are much lower than the ammonia losses of the older process (94). 

Nucleophilic Aromatic Substitution. An activated aromatic haUde is heated at 100—200°C with the alkaU metal salt of the nucleophile (ArOy ROy Ey CN /Cu", carbanion, etc) and the catalyst in an inert solvent (toluene, chiorohen2ene) for a few minutes to a day (21—24). 

The catalyst commonly used in this method is 5 wt % palladium supported on barium sulfate inhibited with quinoline—sulfur, thiourea, or thiophene to prevent reduction of the product aldehyde. A procedure is found in the Hterature (57). Suitable solvents are toluene, benzene, and xylene used under reflux conditions. Interestingly, it is now thought that Rosenmund s method (59) originally was successful because of the presence of sulfur compounds in the xylene used, since the need for an inhibitor to reduce catalyst activity was not described until three years later (60). 

Epichlorohydrin Elastomers without AGE. Polymerization on a commercial scale is done as either a solution or slurry process at 40—130°C in an aromatic, ahphatic, or ether solvent. Typical solvents are toluene, benzene, heptane, and diethyl ether. Trialkylaluniinum-water and triaLkylaluminum—water—acetylacetone catalysts are employed. A cationic, coordination mechanism is proposed for chain propagation. The product is isolated by steam coagulation. Polymerization is done as a continuous process in which the solvent, catalyst, and monomer are fed to a back-mixed reactor. Pinal product composition of ECH—EO is determined by careful control of the unreacted, or background, monomer in the reactor. In the manufacture of copolymers, the relative reactivity ratios must be considered. The reactivity ratio of EO to ECH has been estimated to be approximately 7 (35—37). 

In benzonitrile both types of processes occur in parallel with similar efficiencies. In hydrogen-donating solvents (toluene, ether, dioxane, ethanol), hydrogen abstraction processes prevail [toluene (114) -> (123)]. 

It is evident from these results that the interactive properties of the investigated SEC PS/DVB or DVB gels are very different. Because polar electroneutral macromolecules of PMMA were more retained from a nonpolar solvent (toluene) than from polar ones (THF, chloroform), we conclude that the dipol-dipol interactions were operative. Columns No. 1 and No. 2 were very interactive and can be applied successfully to LC techniques that combine exclusion and interaction (adsorption) mechanisms. These emerging techniques are LC at the critical adsorption point (18), the already mentioned LC under limiting conditions of adsorption (15,18), and LC under limiting conditions of desorption (16). In these cases, the adsorptivity of the SEC columns may even be advantageous. In most conventional SEC applications, however, the interactive properties of columns may cause important problems. In any case, interactive properties of SEC columns should be considered when applying the universal calibration, especially for medium polar and polar polymers. It is therefore advisable to check the elution properties of SEC columns before use with the... 

Further investigations revealed that the disubstituted indolo[3,2-fl]carbazoles 117a-b may be conveniently obtained in moderate yields simply by heating 115 with dimethyl or diethyl acetylenedicarboxylate in xylene, while the use of lower-boiling solvents (benzene, toluene) led to the formation of the presumed intermediate Michael adducts 118a-b as the major products. The reaction of 115 with 2-chloroacrylonitrile furnished the indolo[3,2-fl]carbazole derivative 119 where aromatizaticRi did not take place (99T2371). 

Another issue important to the success of this chiral titanium reagent 31 was the discovery of a marked solvent effect. When the fumaric acid derivative is reacted with isoprene in the presence of 10 mol% of the titanium reagent 31 in toluene, poor optical purity results (36-68% ee). Interestingly the optical purity of the adduct greatly increased in the order benzene, toluene, xylenes, and mesitylene, with 92% ee obtained in the last. Mesitylene is difficult to remove, because of its high boiling point, and other solvents were screened in detail. As a result, the mixed solvent system toluene petroleum ether (1 1) was discovered to be very effective. 

For MMA-MAA copolymerizations carried out in the more hydrophobic solvents (toluene, dioxane), MAA is the more reactive towards both propagating species while in water MMA is the more reactive. In solvents of intermediate polarity (alcohols, dipolar aprotic solvents), there is a tendency towards alternation. For these systems, choice of solvent could offer a means of controlling copolymer structure. 

Solvent (toluene) molecules are excited by incident radiation ... 

With trifluoroacetic acid as solvent, toluene and o-xylene gave second-order kinetics and for the activation energy for toluene was 12.7 (from data at 1.6 and 25.2 °C), i.e. considerably less than for the zinc chloride-catalysed reaction in acetic acid330. 

Scheme 49 Total syntheses of epo490 (240d) and epoD (237d) by diene-ene RCM between CIO and Cl 1 favorable influence of solvent toluene or unprotected hydroxy groups in metathesis substrates 239 [113]...

The reaction is carried out with metallic sodium or sodium hydroxide in a solvent like toluene, xylene, or dioxane. The mono- or dialcoholate reacts with chloroacetic acid or the sodium salt. 

Fig. 2. Temperature dependence of EQ-H9 Solvent, A, toluene B, methylene chloride C, 1-nitropropane13)...

Efforts to identify the specific compounds responsible for the psychotropic effects of volatile solvents are complicated by the fact that many of these products contain more than one potentially psychoactive ingredient. Another factor obscuring the identity of the psychoactive ingredients of these agents is that patients addicted to these compounds frequendy seek the effects not of the product s primary ingredient but of a secondary ingredient such as the propellant gas (e.g., nitrous oxide). To date, the best-studied psychoactive compounds identified in volatile solvents include toluene, 1,1,1-trichloroethane, and trichloroethylene. However, other less well studied compounds, such as benzene, acetone, and methanol, also appear to have significant psychoactive effects. 

Bale AS, Smothers CT, Woodward JJ Inhibition of neuronal nicotinic acetylcholine receptors by the abused solvent, toluene. Br J Pharmacol 137 375-383, 2002... 

Cruz SE, Mirshahi T, Thomas B, et al Effects of the abused solvent toluene on recombinant N-methyl-D-aspartate and non-N-methyl-D-aspartate receptors expressed in Xenopus oocytes. J Pharmacol Exp Ther 286 334-340, 1998 De Rosa E, Bartolucci GB, Sigon M, et al Hippuric acid and ortho-cresol as biological indicators ofoccupational exposure to toluene. Am J Ind Med 11 529—537,1987 Delteil P, Stoesser F, Stoesser R L theromanie. Ann Med Psychol (Paris) 1 329-340, 1974... 

Solvents (solvent naphtha, toluene/xylene/isopropanol)... 

HydTOX5 proline-derived polyesters are usually readily soluble in a variety of organic solvents (benzene, toluene, chloroform, dichloro-methane, carbon tetrachloride, tetrahydrofuran, dimethylformamide, etc.) As expected, the solubility in hydrophobic solvents increased with increasing chain length of the N protecting group, while the solubility in polar solvents decreased. For example, poly(N-hexanoyl-hydroxyproline ester) is slightly soluble in ether but easily soluble in acetonitrile, while poly(N-palmitoylhydroxyproline ester) is readily soluble in ether but virtually insoluble in acetonitrile. 

The Strecker reaction has been performed on the aldehyde 182 prepared from L-cysteine [86] (Scheme 28). The imine was formed in situ by treatment with benzylamine, then TMS cyanide was added to afford prevalently in almost quantitative yield the syn-diamine 183, which is the precursor of (-l-)-biotin 184. The syn selectivity was largely affected by the solvent, toluene being the solvent of choice. Since the aldehyde 182 is chemically and configurationally unstable, a preferred protocol for the synthesis of 183 involved the prehminary formation of the water-soluble bisulfite adduct 185 and the subsequent treatment with sodium cyanide. Although in this case the syn selectivity was lower, both diastereomers could be transformed to (-l-)-biotin. 

The enantioselective Michael reaction of malonates to nitroolefins catalysed by bifunctional amino-thioureas has recently been reported by Take-moto [161]. Excellent ee (75-93%) were obtained with diethylmalonate after solvent optimisation, toluene being the best solvent both for the activity and for the selectivity. Substituted malonates were then reacted with various nitroolefins under the same conditions. Excellent enantioselectivities were observed (Scheme 45). 

A PPV derivative which is twofold phenylsubstituted at the vinylene unit, poly(l,4-phenylene-l,2-diphenylvinylene DP-PPV), (71b) (see also the discussion of dehydrochlorination of unsymmetrically substituted para-xylylene dichlorides in Section 3.1) was first synthesized by Smets et al., using acid-catalyzed elimination of nitrogen from l,4-bis(diazobenzyl)benzene 83 [106]. The yellow products obtained are fully soluble in common organic solvents (toluene, chloroform, ethylene chloride, DMF, THF). 

In this study, the absorption rates of carbon dioxide into the solution of GMA and Aliquat 336 in such organic solvents as toluene, N-methyl-2-pirrolidinone(NMP), and dimethyl sulfoxide(DMSO) was measured to determine the pseudo-first-order reaction constant, which was used to obtain the elementary reaction rate constants. 

The absorption rates of CO2 were measured in such non-aqueous solvents as toluene, NMP, and DMSO with GMA concentration ranging Ifom 0.5 to 3 kmol/m in a semi-batch flat-stirred agitated vessel constructed of pyrex glass of 0.075 m inside diameter and of 0.13 m in height. The apparatus and the experimental procedure are the same as those described by... 

Polymeriatioji conditions Ti = 20 timol, AVTi = 400, Solvent = toluene 30 ml, Temperatare = 40°C. BtaMspheric pressure. 

In a recent study, poly(aryl ether) dendritic branches terminated with triethyleneglycol chains were attached to Cgg [66] dendrimer 32 represents the fourth generation. The photophysical properties of these fullerodendrimers have been systematically investigated in three solvents, namely toluene, dichloromethane, and acetonitrile. On increasing dendrimer generation, it has been found that in each solvent (i) the maximum of the fullerene fluorescence band is red-shifted... 

---