Solution transition metal ions

In an aquo-complex, loss of protons from the coordinated water molecules can occur, as with hydrated non-transition metal ions (p. 45). To prevent proton loss by aquo complexes, therefore, acid must usually be added. It is for these conditions that redox potentials in Chapter 4 are usually quoted. Thus, in acid solutions, we have... 

First, the use of water limits the choice of Lewis-acid catalysts. The most active Lewis acids such as BFj, TiQ4 and AlClj react violently with water and cannot be used However, bivalent transition metal ions and trivalent lanthanide ions have proven to be active catalysts in aqueous solution for other organic reactions and are anticipated to be good candidates for the catalysis of aqueous Diels-Alder reactions. 

The aromatic shifts that are induced by 5.1c, 5.If and S.lg on the H-NMR spectrum of SDS, CTAB and Zn(DS)2 have been determined. Zn(DS)2 is used as a model system for Cu(DS)2, which is paramagnetic. The cjkcs and counterion binding for Cu(DS)2 and Zn(DS)2 are similar and it has been demonstrated in Chapter 2 that Zn(II) ions are also capable of coordinating to 5.1, albeit somewhat less efficiently than copper ions. Figure 5.7 shows the results of the shift measurements. For comparison purposes also the data for chalcone (5.4) have been added. This compound has almost no tendency to coordinate to transition-metal ions in aqueous solutions. From Figure 5.7 a number of conclusions can be drawn. (1) The shifts induced by 5.1c on the NMR signals of SDS and CTAB... 

Alkyl hydroperoxides are among the most thermally stable organic peroxides. However, hydroperoxides are sensitive to chain decomposition reactions initiated by radicals and/or transition-metal ions. Such decompositions, if not controlled, can be auto accelerating and sometimes can lead to violent decompositions when neat hydroperoxides or concentrated solutions of hydroperoxides are involved. 

Even very small amounts of transition-metal ions like cobalt, nickel, and copper cause rapid decomposition. They form reactive intermediates that can decrease the stabiUty of oxidizable compounds in the bleach solution and increase the damage to substrates. Hypochlorite is also decomposed by uv light (24,25). Acidic solutions also lose available chlorine by the reverse of equations 1 and 2. 

Impurities such as chloride ion or other reducing agents generate chlorine dioxide when the chloric acid solution is heated. Transition-metal ions do not affect the stabiUty of pure chloric acid at room temperature. Thirty-five percent solutions of HCIO have been shown to be stable for 20 days at room temperature containing up to 1000 ppm Ni ", 800 ppm Zn ", 700 ppm Fe ", or 600 ppm Cr " (2). The solubiUty of chloric acid in water is shown in Figure 1. 

However, under anhydrous conditions and in the absence of catalytic impurities such as transition metal ions, solutions can be stored for several days with only a few per cent decomposition. Some reductions occur without bond cleavage as in the formation of alkali metal superoxides and peroxide (p. 84). 

Transition metal ions. Transition metal ions impart color to many of their compounds and solutions, (a) Bottom row (left to right) iron(lll) chloride. copper ll) sulfate, manganese(ll) chloride, cobalt(ll) chloride. Top row (left to right) chromium(lll) nitrate, iron(ll) sulfate, nickel(ll) sulfate, potassium dichromate, (b) Solutions of the compounds in (a) in the order listed above. 

Essentially all transition metal ions behave like Zn2+, forming a weakly acidic solution. Among the main-group cations, Al3+ and, to a lesser extent, Mg2+, act as weak acids. In contrast the cations in Group 1 show little or no tendency to react with water. 

This is only the beginning of a process which ultimately results in the formation of solid state hydroxides or oxides. Actually, the solution species present in neutral or alkaline solutions of transition-metal ions are relatively poorly characterized. The formation of numerous hydroxy- and oxy-bridged polynuclear species makes their investigation very difficult. However, it is clear that there is a near-continuous transition from mononuclear solution species, through polynuclear solution species to colloidal and solid state materials. By the way, the first example of a purely inorganic compound to exhibit chirality was the olated species 9.11. 

The latter reactions are catalyzed by a number of transition metal ions which can exist in several oxidation states in aqueous solution, e.g.,... 

Organic hydroperoxides have also been used for the oxidation of sulphoxides to sulphones. The reaction in neutral solution occurs at a reasonable rate in the presence of transition metal ion catalysts such as vanadium, molybdenum and titanium - , but does not occur in aqueous media . The usual reaction conditions involve dissolution of the sulphoxide in alcohols, ethers or benzene followed by dropwise addition of the hydroperoxide at temperatures of 50-80 °C. By this method dimethyl sulphoxide and methyl phenyl sulphoxide have been oxidized to the corresponding sulphone in greater than 90% yields . A similar method for the oxidation of sulphoxides has been patented . Unsaturated sulphoxides are oxidized to the sulphone without affecting the carbon-carbon double bonds. A further patent has also been obtained for the reaction of dimethyl sulphoxide with an organic hydroperoxide as shown in equation (19). 

Late transition metal or 3d-transition metal irons, such as cobalt, nickel, and copper, are important for catalysis, magnetism, and optics. Reduction of 3d-transition metal ions to zero-valent metals is quite difficult because of their lower redox potentials than those of noble metal ions. A production of bimetallic nanoparticles between 3d-transi-tion metal and noble metal, however, is not so difficult. In 1993, we successfully established a new preparation method of PVP-protected CuPd bimetallic nanoparticles [71-73]. In this method, bimetallic hydroxide colloid forms in the first step by adjusting the pH value with a sodium hydroxide solution before the reduction process, which is designed to overcome the problems caused by the difference in redox potentials. Then, the bimetallic species... 

The photolytic reduction of N2 at TiO -suspensions was at first reported by Schrauzer et al. Small amounts of NH3 and N2H4 were obtained as products. The highest activity was found with anatase containing 20-30 % rutile. Very low yields were also obtained with p-GaP electrodes under illumination It is much easier to produce NH3 from NO -solutions at CdS- and Ti02-particles using S -ions as hole scavengers . Efficiencies are not reported yet. Recently the formation of NH3 from NO was observed at p-GaAs electrodes under illumination. In this case NH3-formation was only found in the presence of transition metal ions or their complex with EDTA. 

The presence of salts and additives can have an important influence on the performance of an FBA. Traces of transition-metal ions such as iron and copper have an adverse effect on fluorescence [30], but this can be controlled using conventional polyphosphate or EDTA-type sequestering agents [31]. Other salts, even sodium sulphate or sodium chloride, have been claimed to enhance the fluorescence of FBAs in solution [32]. Apart from the normal... 

A measure of the Lewis acidity of a metal ion is determined by its affinity for a pair of electrons, and the greater this affinity, the more stable the complexes formed by the metal ion will be. However, removing electrons from a metal to produce an ion is also related to the attraction the metal atom has for electrons. Therefore, it seems reasonable to seek a correlation between the stability constants for complexes of several metals with a given ligand and the total energy necessary for ionization to produce the metal ions. The first-row transition metal ions react in solution with ethylenediamine, en, to form stable complexes. We will consider only the first two steps in complex formation, which can be shown as follows ... 

Chemiluminescence from lucigenin is observed even without the catalytic transition metal ions but it is more intense when these ions are used. In aqueous or predominately aqueous solutions the CL yield is 0.01-0.02, which makes it a slightly better emitter than luminol [35], The emission of lucigenin is also catalyzed by Pb(II), Bi(III), Tl(III), and Hg(I) ions, which do not catalyze the CL of luminol [36],... 

The thermodynamic functions (AH, AS, AG(298 K)) of hydrogen peroxide reactions with transition metal ions in aqueous solutions are presented in Table 10.1. We see that AG(298K) has negative values for reactions of hydroxyl radical generation with Cu1+, Cr2+, and Fe2+ ions and for reactions of hydroperoxyl radical generation with Ce4+, Co3+, and Mn3+. 

Enthalpies, Entropies, and Gibb s Energies of Transition Metal Ion Oxidation-Reduction Reactions with Hydrogen Peroxide in Aqueous Solution (T = 298 K) [23]... 

The values of the rate constants for the reactions of transition metal ions with hydrogen peroxide in an aqueous solution are presented in Table 10.2. 

Rate Constants of Transition Metal Ion Reactions with Hydrogen Peroxide in Aqueous Solutions... 

Peroxyl radicals with a strong oxidative effect along with ROOH are continuously generated in oxidized organic compounds. They rapidly react with ion-reducing agents such as transition metal cations. Hydroxyl radicals react with transition metal ions in an aqueous solution extremely rapidly. Alkyl radicals are oxidized by transition metal ions in the higher valence state. The rate constants of these reactions are collected in Table 10.5. 

Ketones are resistant to oxidation by dioxygen in aqueous solutions at T= 300-350 K. Transition metal ions and complexes catalyze their oxidation under mild conditions. The detailed kinetic study of butanone-2 oxidation catalyzed by ferric, cupric, and manganese complexes proved the important role of ketone enolization and one-electron transfer reactions with metal ions in the catalytic oxidation of ketones [190-194],... 

---