Sodium surface area, effect

In most cases, the impregnation process is followed by an electrochemical formation where the plaques are assembled into large temporary cells filled with 20—30% sodium hydroxide solution, subjected to 1—3 charge—discharge cycles, and subsequentiy washed and dried. This eliminates nitrates and poorly adherent particles. It also increases the effective surface area of the active materials. 

Based on available results, it can be summarized that the particle size of tantalum powder increases (specific charge decreases) with the increase in temperature, K2TaF7 concentration and excess sodium. In addition, an increase in the specific surface area of the melt and Na/K ratio also leads to the formation of coarser tantalum powder. The most important conclusion is that for the production of finer tantalum powders with higher specific charges, the concentration of K2TaF7 in the melt must be relatively low. This effect is the opposite of that observed in the electrochemical reduction of melts. 

Molecular sieves (zeolites) are artificially prepared aluminosilicates of alXali metals. The most common types for gas chromatography are molecular sieve 5A, a calcium aluminosilicate with an effective pore diameter of 0.5 nm, and molecular sieve 13X, a sodium aluminosilicate with an effective pore diameter of 1 nm. The molecular sieves have a tunnel-liXe pore structure with the pore size being dependent on the geometrical structure of the zeolite and the size of the cation. The pores are essentially microporous as the cross-sectional diameter of the channels is of similar dimensions to those of small molecules. This also contrilsutes to the enormous surface area of these materials. Two features primarily govern retention on molecular sieves. The size of the analyte idiich determines whether it can enter the porous... 

Alcoholysis of the chloride on the plant scale was effected at 40°C (with brine cooling) by adding portions to the alcohol alternately with finely crystalline disodium phosphate to neutralise the hydrogen chloride produced. On one occasion, use of coarsely crystalline sodium phosphate (of low surface area) reduced the rate of neutralisation, the mixture became acid, and a runaway exotherm to 170°C developed leading to eruption of vessel contents. On another occasion, accidental addition of sodium sulfate instead of phosphate led to a similar situation beginning to develop, but an automatic pH alarm allowed remedial measures to be instituted successfully. See other neutralisation incidents... 

Other studies have been performed to investigate the effect of surface area and tablet lubricant efficacy. In a comparison study between sodium stearyl fumarate and magnesium stearate, it was found that sodium stearyl fumarate was effective as a lubricant to about the same degree as magnesium stearate [15]. It was also reported that the lubricating properties correlated better to the surface area of the lubricant than to the amount of lubricant used. A micronized lubricant was more efficient than a coarse fraction, and it was suggested that the surface area be standardized to obtain reproducible effects. 

Despite the gastrointestinal absorption characteristics discussed above, it is common for absorption from the alimentary tract to be facilitated by dilution of the toxicant. Borowitz et al. (1971) have suggested that the concentration effects they observed in atropine sulfate, aminopyrine, sodium salicylate, and sodium pentopar-bital were due to a combination of rapid stomach emptying and the large surface area for absorption of the drugs. 

Very few direct measurements of the reaction of surface silanol groups on quartz have been reported. This is apparently caused by the small effects due to the limited surface areas available. Adsorption of sodium ions on quartz was measured by radioactive tracer techniques by Gaudin et al. (293). Saturation was achieved at high pH (>10) and sodium ion concentrations above 0.07 Jlf. The calculated packing density of silanol groups was 4.25/100 A. Goates and Anderson (294) titrated quartz with aqueous sodium hydroxide and alcoholic sodium ethylate. The occurrence of two types of acidic groups was reported. 

Table 3.4 summarizes similar data, but also includes the sodium dodecylbenzene sulfonate type and the resultant effect on the specific surface area and computed spacing factor of the bubbles [14],... 

The specific surface area of bubbles entrained by each air-entraining agent is largely independent of its concentration and there are indications that sodium dodecyl sulfate, apart from being more effective as an air-... 

Stabilization of a radical anion of humic acid may be caused by an adsorption effect. Bijl (3) observed that solid barium hydroxide octahydrate turned blue when placed in a solution of quinhydrone the blue solid was highly paramagnetic. Under the conditions we used for preparing these salts, insoluble sodium humate (with a large surface area) could have stabilized the anion radical by adsorption from the basic solution. Weiss and McNeil (18) observed a similar phenomenon with base soluble xanthenes, and proposed that biradicals may be formed in such a system. His compounds, however, do not appear to have the structural requirements to satisfy such a stabilized system. The recent report by Weber (29) on the spin content increase associated with the basification of a naphthoquinone-naphthohydroquinone system seems to parallel our observations quite closely. 

Effect of cations other than TPA has also been studied and the results are given in Table 2 and Fig.3. The molar ratio of additional cation/CTA" was kept at 1.4. It can be seen that cations like tetramethylammonium or tetraethylammonium ions or even sodium also gives highly ordered MCM-41 structure The BET surface area of these samples was found to be >1000 m2/g. Fig.3 shows that the MCM-41 structures obtained with these additional cations have improved hydrothermal stability. The long range ordering was unaffected by 4 days of hydrothermal treatment. Moreover, the surface area and pore volume of the water-treated samples was only marginally lower than that of the calcined samples. 

---