Soap Analysis

Methods of Making Soaps—Special Textile Soaps—Relation of Soap to Water for Industrial Purposes—Soap Analysis—Fat in So —Animal and Vegetable Oils and Fats— Vegetable Soap, Oite and Fats—Glycerine—Textile Oils. 

The type of behavior shown by the ethanol-water system reaches an extreme in the case of higher-molecular-weight solutes of the polar-nonpolar type, such as, soaps and detergents [91]. As illustrated in Fig. Ul-9e, the decrease in surface tension now takes place at very low concentrations sometimes showing a point of abrupt change in slope in a y/C plot [92]. The surface tension becomes essentially constant beyond a certain concentration identified with micelle formation (see Section XIII-5). The lines in Fig. III-9e are fits to Eq. III-57. The authors combined this analysis with the Gibbs equation (Section III-SB) to obtain the surface excess of surfactant and an alcohol cosurfactant. 

The rupture process of a soap film is of some interest. In the case of a film spanning a frame, as in Fig. XIV-15, it is known that rupture tends to originate at the margin, as shown in the classic studies of Mysels [207, 211]. Rupture away from a border may occur spontaneously but is usually studied by using a spark [212] as a trigger (a-radia-tion will also initiate rupture [213]). An aureole or ridge of accumulated material may be seen on the rim of the growing hole [212, 214] (see also Refs. 215, 216). Theoretical analysis has been in the form of nucleation [217, 218] or thin-film instability [219]. 

Soluble pigments The most important pigments in this class are the metallic chromates, which range in solubilities from 17 0 to 0-00005 g/1 CrO . An examination has recently been carried out of the mechanism of inhibition by chromate ions and it has been shown by chemical analysis of the stripped film, Mdssbauer spectroscopy and electron microprobe analysis that the air-formed film is reinforced with a more protective material in the form of a chromium-containing spinel (Chapter 17). The situation is, however, complicated by the possibility that some chromates, particularly the basic ones, may inhibit through the formation of soaps. There is evidence that lead chromate can function in this way. 

In another study of the physical behavior of soap-LSDA blends, Weil and Linfield [35] showed that the mechanism of action of such mixtures is based on a close association between the two components. In deionized water this association is mixed micellar. Surface tension curves confirm the presence of mixed micelles in deionized water and show a combination of optimum surface active properties, such as low CMC, high surface concentration, and low surface concentration above the CMC. Solubilization of high Krafft point soap by an LSDA and of a difficulty soluble LSDA by soap are related results of this association. Analysis of dispersions of soap-LSDA mixtures in hard water shows that the dispersed particles are mixtures of soap and LSDA in the same proportion as they were originally added. These findings are inconsistent with the view that soap reacts separately with hard water ions and that the resulting lime soap is suspended by surface adsorption of LSDA. The suspended particles are responsible for surface-active properties and detergency and do not permit deposits on washed fabric unlike those found after washing with soap alone. 

The schematic diagram of the experimental setup is shown in Fig. 2 and the experimental conditions are shown in Table 2. Each gas was controlled its flow rate by a mass flow controller and supplied to the module at a pressure sli tly higher than the atmospheric pressure. Absorbent solution was suppUed to the module by a circulation pump. A small amount of absorbent solution, which did not permeate the membrane, overflowed and then it was introduced to the upper part of the permeate side. Permeation and returning liquid fell down to the reservoir and it was recycled to the feed side. The dry gas through condenser was discharged from the vacuum pump, and its flow rate was measured by a digital soap-film flow meter. The gas composition was determined by a gas chromatograph (Yanaco, GC-2800, column Porapak Q for CO2 and (N2+O2) analysis, and molecular sieve 5A for N2 and O2 analysis). The performance of the module was calculated by the same procedure reported in our previous paper [1]. 

Parris, N. (1978). Surfactant analysis by high performance liquid chromatography I. A rapid analysis for mixtures of amphoteric surfactants and soap. J. Am. Oil Chem. Soc. 55(9), 675-677. 

In the analysis of paint samples, a stepwise extraction of the various lipid and resinous components has been proposed [33] which uses isooctane, methanol, chloroform/methanol (7 3) and methanol/oxalic acid (10%). The last extraction releases FAs from the metal soaps. 

In addition to these numerous results, two other points are discussed by the authors fatty acid speciation and oil identification. These two aspects are developed in another publication written by the same authors [Keune et al. 2005]. The fatty acid speciation is based on the positive ion ToF-SIMS analysis and aims to prove if the fatty acids detected exist as free fatty acids, ester bound fatty acids or metal soaps. On account of the study of different standards, it is shown that when free fatty acids are present, the protonated molecular ion and its acylium ([M-OH]+) ion are detected. In cases of ester-bound fatty acid only the... 

Sodium compounds, 22 760-761, 762 as soap bar additives, 22 744 Sodium cyanamide, 8 184 Sodium cyanate, 8 184 Sodium cyanide, 8 183-184 analysis, 8 190 economic aspects, 8 189 health and safety factors, 8 190-191 manufacture, 8 187-189 properties, 8 184-187, 185t silver extraction via, 22 638, 646-647 uses, 8 191... 

These structures are extensively described in the current literature (Fanum, 2008 Friberg, 1976 Birdi, 2002 Holmberg, 2004 Somasundaran, 2006). Even within the same phases, their self-assembled structures are tunable by the concentration for example, in lamellar phases, the layer distances increase with the solvent volume. Lamellar structures are found in systems such as the common hand soap, which consists of ca. 0% soap + 20% water. The layers of soap molecules are separated by a region of water (including, salts etc.) as a kind of sandwich. The x-ray diffraction analysis shows this structure very clearly. Since lyotropic liquid crystals rely on a subtle balance of intermolecular interactions, it is more difficult to analyze their structures and properties than those of thermotropic liquid crystals. Similar phases and characteristics can be observed in immiscible diblock copolymers. 

The emulsion was then allowed to separate and it was found on analysis of the soap content of the aqueous lower layer and the concentrated emulsion in the upper layer that the emulsion had abstracted soap from the solution. Owing to the fact that the fatty acids are soluble in the oil the hydrolysis of the soaps and the subsequent removal of the fatty acid in the oil phase had to be eliminated by the addition of caustic soda. In this way the true quantity of soap at the oil-water interface could be determined. Some of the results, obtained are tabulated below. 

As with any analytical determination procedure, both quality assurance and quality control issues have to be built into the detection of PPCPs in the environment. For example, analysis of polycyclic musks (PCM) can be easily skewed during analysis as the compound might be present in laboratory soaps and creams, thus coating laboratory glassware used for the analysis. Therefore, programs that are designed to research... 

---