Scanning electron microscopy energy

R. S. White, and A. D. Owens, Automation of Gunshot Residue Detection and Analysis by Scanning Electron Microscopy/Energy Dispersive X-Ray Analysis (SEM/EDX), Journal of Forensic Sciences 32, no. 6 (November 1987) 1595. 

SEM/EDX scanning electron microscopy/energy dispersive X-ray analysis SPE solid phase extraction... 

Scanning electron microscopy/energy dispersive X-ray (SEM/EDX) analyses have been used to probe the migration of vanadium in model fluid cracking catalysts (FCC). At the experimental conditions used, vanadium can migrate either from a Eu3+-exchanged Y (EuY) zeolite to an AAA-alumina gel or vice versa, depending on the type of vanadium precursor used. 

Gilardoni, S., Fermo, P., Cariati, F., Gianelle, V., Pitea, D., Collina, E., andLasagni, M. (2004). MSWI fly ash particle analysis by scanning electron microscopy—energy dispersive X-ray spectroscopy. Environ. Sri. Technol. 38, 6669—6675. 

UV absorbance of a 0.5 im section in morphological region i Transmission electron microscopy Scanning electron microscopy Energy dispersive X-ray analysis... 

Historical Silk Flags Studied by Scanning Electron Microscopy-Energy Dispersive X-ray Spectrometry... 

Modes of occurrence of the elements in coal can be determined using a variety of procedures. Perhaps the most effective method is the use of scanning electron microscopy-energy dispersive X-ray analysis (SEM-EDX). This method can detect and analyze minerals as small as 1 pm in diameter (Figure 14). The SEM-EDX also provides useful information on the textural relationships of the minerals. Other microbeam techniques, such as the electron microprobe analyzer, ion microprobe, laser mass analyzer, and transmission electron microscopy, have also been used to determine modes of occurrence of elements in coal. 

HZSM5 (Si/AI = 27.5), HMOR (Si/AI = 10) and NaY (Si/AI = 2.65) zeolites were partially ion-exchanged with NiClg or CoClg solutions. The composition of the ion-exchanged zeolites (Table 1) was determined by Scanning Electron Microscopy -Energy Dispersive X-Ray Absorption Spectroscopy (SEM-EDS). 

The ingress of electrolyte cations into the MOF framework was confirmed by scanning electron microscopy/energy-dispersive x-ray (EDX) analysis of electrochemically treated deposits of Cu-MOF. Results obtained after application of a reductive potential step to Cu-MOF crystals in contact with acetate buffers are shown in Figure 5.3. Here, EDX spectra for (a) pristine Cu-MOF and (b) Cu-MOF after application of a constant potential of-1.0 V for 10 min are shown. EDX spectra of original Cu-MOF crystals exhibits prominent Cu peaks at 1.0, 8.0, and 8.4 keV accompanied by a Si signal at 1.9 keV. After the electrolysis step, an additional Na peak at 1.1 keV appears. 

Sherman, L. R., K. T. Roberson, and T. C. Thomas. 1989. Qualitative analysis of asbestos fibers in air, water and bulk samples by scanning electron microscopy-energy dispersive x-ray... 

A new method for preparing thin rubber sheet embedded with Ti02 from NR latex has been developed by ChavalSriwong et The characteristics of this thin and flexible Ti02 sheet were studied by X-ray diffraction (XRD) and scanning electron microscopy/energy-dispersive X-ray spectrometer (SEM/ EDS) techniques. 

---