Reservoirs cementation

An intermediate casing is usually set above the reservoir in order to protect the water bearing, hydrostatically pressured zones from influx of possibly overpressured hydrocarbons and to guarantee the integrity of the well bore above the objective zone. In mature fields where production has been ongoing for many years, the reservoir may show depletion pressures considerably lower than the hydrostatically pressured zones above. Casing and cementing operations are covered in section 3.6. 

The pore system is described by the volume fraction of pore space (the fractional porosity) and the shape of the pore space which is represented by m , known as the cementation exponent. The cementation exponent describes the complexity of the pore system i.e. how difficult it is for an electric current to find a path through the reservoir. 

When a production or injection well is drilled, it is common practice to cement in place a casing which extends across the reservoir interval. The alternative is to leave the reservoir uncased, in a so-called bare foot completion, which is rarely done. When the drilling department finishes its work on the well, it is often left in the state of a cased hole, as on the left of Figure 9.14. 

Oil and Petrochemicals. There are a variety of uses for defoamers in oil recovery. They are used in some of the materials used in oil extraction, such as in drilling muds and cement lining, and also directly with the cmde oil itself. In its natural state cmde oil contains dissolved gases held by high reservoir pressure. When this Hve cmde oil is extracted and passed into the low pressure environment of a gas-oil separator, the dissolved gases are... 

Unique problems were encountered in drilling wells in the Salton Sea field. The hot salt solution in the reservoir adversely affected drilling fluids and equipment, requiring the use of specially formulated drilling muds and cements developed by chemists and of special steels recommended by corrosion and materials engineers. 

Small-particle-size cement has found a number of uses in production and injection well casing repair jobs [440]. Oil-based cement is particularly useful for water shutoff jobs, because the hydrocarbon slurry sets only in the presence of water, so the oil-producing sections of a reservoir remain relatively damage free after water shutoff. The selective water shutoff with oil-based cement also has been used with polymers crosslinked by metal crosslinkers [442,1178]. 

Oil in the Cretaceous Dakota sandstone, a shallower aquifer than the Lyons, has migrated laterally as far as 150 km into present-day reservoirs (Clayton and Swetland, 1980). In contrast, oil has yet to be found in the Lyons outside the deep strata where it was generated. The formation of anhydrite and dolomite cements may have served to seal the oil into reservoirs, preventing it from migrating farther. 

The reservoir rock in our model is composed of quartz grains, carbonate cement, and clay minerals in the following proportions, by volume ... 

In both cases, the CaCb-rich brine is thought to have evolved from the NaCI-rich brine after fluid-rock interactions in the basement. The fault zones and the breccia bodies at the base of the basins represent active drainage zones where different fluid reservoirs were connected, and thus a highly favourable location for fluid mixing. Temperature and pressure changes, combined with the effects of fluid mixing, appear to be key-factors in the main stages of quartz cementation and U deposition in both Australian and... 

The abundance and nontoxic nature of carbon dioxide also make it an attractive carbon feedstock. Potential sources of carbon dioxide include the atmosphere (where it is present in concentrations of approximately 370 ppm), natural reservoirs including natural gas wells and pure CO2 wells, waste streams of fermentation reactions, and flue stacks from power plants, cement production, and so on. Because CO2 is not toxic, development of chemical processes in which CO2 can be used to... 

Just as important as evaluating the performance of the nuclear fuel cycle, one must also consider the size of the fluxes and reservoirs of the carbon cycle. Present CO2 emissions from fossil fuels and the production of cement are estimated to be 6.3 + 0.4 GtC/y emissions related to changes in land use (e.g., deforestation) are 1.6 0.8 GtC/y (Schimel et al. 2001). At present, the reduction of C02 emissions that can be attributed to the use of nuclear power is 0.5 GtC/y. Thus, the uncertainties in the major fluxes in the carbon cycle are approximately the same as the present impact of nuclear power on C02 emissions (Sarmiento Gruber 2002). To quote from Falkowski et al. (2000), Our knowledge is insufficient to describe the interactions between the components of the Earth system and the relationship between... 

The Rose Run Sandstone is the best characterized of the Cambrian sandstones because it is also an oil and gas reservoir (Fig. 3). It is also the only one of the Cambrian sandstones that is known to retain its sandstone composition in the eastern part of the state rather than passing laterally into carbonate. The Rose Run Sandstone is a sandy layer in the middle of the Knox Dolomite (Fig. 4), which across much of eastern Ohio lies at depths suitable for injection of supercritical C02 (Fig. 3). The Rose Run Sandstone was deposited in a passive margin phase of the Appalachian Basin and consists of interbedded layers of carbonate, primarily dolos-tone, and sandstone (Fig. 5). The sandstone is compositionally mature, consisting largely of quartz. Subordinate reactive minerals are the alkali feldspars and locally abundant glauconite (Fig. 5). Dolomite and quartz are the dominant cements (Janssens 1973 Riley et al. 1993). 

Jahjah [the prior art reference cited by the USPTO] combines the preformed foam into various cement and concrete mixtures wherein known aggregates may optionally be incorporated. The foam is introduced from a reservoir into a concrete mixer containing the cement mix, and, in our opinion, it would be obvious to a technician having ordinary skill in the art to add the foam gradually to the cement mix while it was being mixed, since, as pointed out by the Examiner, conventional cement mixers operate in this fashion. Further, Jahjah obtains uniform dispersion of the foam and produces a multicellular cementitious product not differentiated in this record from that obtained by appellant. 

---